• Transactions of the Korean Society of Mechanical Engineers B
• /
• v.27 no.8
• /
• pp.1051-1060
• /
• 2003

The heat and mass transfer on two kinds of tube surfaces (bare stainless steel tube and Teflon coated tube) in steam-air mixture flow are experimentally studied to obtain design data for the heat exchanger of the latent heat recovery from flue gas. In the test section, 3-tubes are horizontally installed, and steam-air mixture is vertically flowed from the top to the bottom. The pitch between tubes is 67mm, the out-diameter of tube is 25.4mm, and the thickness is 1.2mm ; blockage factor (cross sectional tube area over the cross sectional area of the test section) is about 0.38. All of sensors and measurement systems (RTD, pressure sensor, flow-meter, relative humidity sensor, etc.) are calibrated with certificated standard sensors and the uncertainty for the heat transfer measurement is surveyed to have the uncertainty within 7%. As experimental results, overall heat transfer coefficient of the Teflon (FEP) coated tube is degraded about 20% compared to bare stainless tube. The degradation of overall heat transfer coefficient of Teflon coated tube comes from the additional heat transfer resistance due to Teflon coating. Its magnitude of heat transfer resistance is comparable to the in-tube heat transfer resistance. Nusselt and Sherwood numbers on Teflon (FEP) coated surface and bare stainless steel surface are discussed in detail with the contact angles of the condensate.

• Proceedings of the Korean Vacuum Society Conference
• /
• 2013.02a
• /
• pp.230-230
• /
• 2013

In amorphous or microcrystalline thin-film silicon solar cells, p-i-n structure is used instead of p/n junction structure as in wafer-based Si solar cells. Hence, these p-i-n structured solar cells inevitably consist of many interfaces and the cell efficiency critically depends on the effective control of these interfaces. In this study, in-situ plasma treatment process of the interfaces was developed to improve the efficiency of a-Si:H solar cell. The p-i-n cell was deposited using a single-chamber VHF-PECVD system, which was driven by a pulsed-RF generator at 80 MHz. In order to solve the cross-contamination problem of p-i layer, high RF power was applied without supplying SiH4 gas after p-layer deposition, which effectively cleaned B contamination inside chamber wall from p-layer deposition. In addition to the p-i interface control, various interface control techniques such as thin layer of TiO2 deposition to prevent H2 plasma reduction of FTO layer, multiple applications of thin i-layer deposition and H2 plasma treatment, H2 plasma treatment of i-layer prior to n-layer deposition, etc. were developed. In order to reduce the reflection at the air-glass interface, anti-reflective SiO2 coating was also adopted. The initial solar cell efficiency over 11% could be achieved for test cell area of 0.2 $cm^2$.

• Journal of the Korean Professional Engineers Association
• /
• v.15 no.4
• /
• pp.12-24
• /
• 1982

East Parts of Bangladesh have been benifited by low cost energy generated by domestic natural gas but West parts where energy generated by imported fuel. Bangladesh Government authority has very much concerned to transmit the low cost electricity to the West from the East for past several years. To solve such concerns, cross-country 230kv double circuits Power transmission line was proposed, however there was a big obstacle for the realization of this line to cross the Jamuna river which has 12 km long width with a deep muddy river bed. A consultant engineering firm named Merz-Mclellan anyway finalized this plan and a world-wide bid was announced on June 31, 1979. Due to the expected difficulty to construct the towers on sea like area, only three construction groups have participated. including a Korean joint venture organization of Samsung-Korean Developement corporation-Kolon Electric Machinery company. After 3 months bid evaluation, contract was awarded to Korean Consosium and KEM Co was in charge of designing steel towers with anchor bolts and base plates beside to electrical engineering field. Then KEM Co have faced and over-comed many unenpected technical difficulties such as forced eccentricity joint on base plate, distorsion issue of 60mm thick plates welding, threading anchor bolts, tad heat treatment of some anchor bolts, disagreement from Consultant Engineer on multiplying factor of leg stresses for 45$^{\circ}$ wind and on reducing O.L.F for wind loads on cables for such 1220km long spans. After spending two years long period for designing and engineering towers, base plates, and anchor bolts, first shipment of tower was finally realized on Nov. 8, 1981 and on the other hand KDD has proceeded concrete caisson work on schedule at Jamuna river site and expected to complete tower erection and stringing of cables within this year of 1982 which was original completion target.

• Journal of Korea Soil Environment Society
• /
• v.1 no.2
• /
• pp.83-90
• /
• 1996

A diffusion process is often the main mechanism of soil gas/vapor movement in the vadose zone. The diffusion coefficients in the porous soil media are different from those in the free air phase by the reduction of available area for diffusion, tortuous diffusion path and variable cross section area along the diffusion path. To take account those effects of the diffusion process in the porous media, usually the terms of effective diffusion coefficient and tortuosity are have been used. However, as there are many differents definitions for the tortuosity, when the term of tortuosity is used, it is necessary to examine it throughly. Moreover, there are many different equations for the effective diffusion coefficient according to the investigators and the differences in the values of effective diffusion coefficients between the equations are not insignificant, the selection of the equation should be done with caution. In this paper, the different definitions of effective diffusion coefficient are examined and discussed. As well as definitions, the lots of availabe models for the diffusion coefficient in terms of porosities are compared. Also, the constrictiviy which explains the effect of cross sectional area change over the diffusion path was discussed.

• Journal of Korean Tunnelling and Underground Space Association
• /
• v.11 no.3
• /
• pp.223-228
• /
• 2009

The aim of this research is to analyse the dynamic characteristics of the hot upper smoke layer in case of fire in a tunnel. In order to get the result, computer simulation technique has been used. The fire scenarios were set on the basis of standard cross section of national and express highways through NIST's FDS. As the area of a tunnel increased, the influence of the wind velocity decreased. Furthermore, the influence of the slope of a road was reduced as the wind velocity increased. On the other hand, as the wind velocity increased, the influence of the slope of a road decreased. This phenomena is believed to be caused by the cooling effect of wind which is over 1 m/s in speed, hence, reducing the influence of the effect of slope.

• Journal of the Korean Vacuum Society
• /
• v.11 no.1
• /
• pp.16-21
• /
• 2002

Selective epitaxial growth(SEG) of silicon were performed at low temperature under an ultraclean environment below $1000^{\circ}C$ using ultraclean $Si_2H_6$ and $H_2$ gases ambient in low pressure chemical vapor deposition(LPCVD). As a result of ultraclean processing, epitaxial Si layers with good quality were obtained for uniform and SEG wafer at temperatures range 600~$710^{\circ}C$ and an incubation period of Si deposition only on $SiO_2$ was found. Low-temperature Si selectivity deposition condition and epitaxy on Si were achieved without addition of HCl. The epitaxial layer was found to be thicker than the poly layer deposited over the oxide. Incubation period prolonged for 20~30 sec can be obtained by $O_2$addition. The surface morphologies & cross sections of the deposited films were observed with SEM, The structure of the Si films was evaluated XRD.

• Journal of the Korean Society of Propulsion Engineers
• /
• v.1 no.2
• /
• pp.41-47
• /
• 1997

The flow choking in a double orifice is expected to depend on cross-sectional area ratios of the orifices, upstream Mach number and total pressure loss between the orifices. However, no research has been reported on the problems of the compressible flow through a double orifice so far. The present study investigated analytically the choke conditions of the compressible gas through a double orifice, using a simple compressible theory. The orifice area ratio, upstream Mach number, and total pressure loss were involved to find the effects that they have on the flow choking. The results of analytical method show that for orifice area ratios below 1.0, flow choking moves from the first to the second orifice as the total pressure loss increases, however, for orifice area ratios over 1.0, it occurs only at the second orifice.

• 한국신재생에너지학회:학술대회논문집
• /
• 2007.11a
• /
• pp.221-223
• /
• 2007

고분자전해질연료전지의 효율과 수명은 고분자 전해질 막과 밀접하게 관련되어있다. 연료전지 상용화를 위해 내구성과 안정성은 반드시 확보되어야 한다. 본 연구에서는 고분자전해질연료전지용 막전극접합체에 대해서 제작과정, 체결과정 및 운전 중에 발생할 수 있는 물리적 손상이 연료전지에 미치는 영향을 알아보고자 하였다. 실제 고분자전해질연료전지 조건에서 구멍이 생기는 경우를 모사하기 위해 막전극접합체에 다양한 크기 및 형상의 물리적 손상을 형성시켰다. 또한 여러 위치에서의 손상도 비교하였다. 손상시킨 막전극접합체에 대해 단위전지 성능평가와 순환전압전류 실험을 비교 분석하였다. 막전극접합체의 결함이 커질수록 수소기체투과도는 증가하고, OCV와 성능은 감소하였다. 또한 성능과 수소기체투과도는 서로 관련이 있음을 알 수 있었다.

• Korean Journal of Occupational Health Nursing
• /
• v.25 no.2
• /
• pp.85-95
• /
• 2016

Purpose: The purpose of this study was to examine the burn characteristics of female patients hospitalized in a burn center. Methods: This is a retrospective descriptive study. The subjects were 222 female patients aged over 19 years old having burn injuries from work sites between January 1, 2012 and December 31, 2014. Data were collected using electronic medical records about the burn-related characteristics. The data were analyzed descriptively. Results: Many of the subjects were in their forties and fifties. Most subjects showed burns with an area of less than 10% of the body surface with a severity of second degree. Scalding burns were the most frequent. Contact burns were usually of third-degree severity and occurred on hands and wrists. Flame burns affected the largest body surface area and frequently occurred on the face and mainly caused by explosion of a stove or kitchen gas. Chemical burns frequently occurred on the lower limbs. Conclusion: Female workers are exposed to the hazards of burn injuries in industrial accidents. Types of burn differ depending on the workplace conditions. Therefore, preventative measures for burn injuries should be established in accordance with the characteristics of each industry to which female workers belong.

• Journal of Astronomy and Space Sciences
• /
• v.36 no.1
• /
• pp.21-33
• /
• 2019

This paper focuses on the interpretation of radiation fluxes from active galactic nuclei. The advantage of positron annihilation spectroscopy over other methods of spectral diagnostics of active galactic nuclei (therefore AGN) is demonstrated. A relationship between regular and random components in both bolometric and spectral composition of fluxes of quanta and particles generated in AGN is found. We consider their diffuse component separately and also detect radiative feedback after the passage of high-velocity cosmic rays and hard quanta through gas-and-dust aggregates surrounding massive black holes in AGN. The motion of relativistic positrons and electrons in such complex systems produces secondary radiation throughout the whole investigated region of active galactic nuclei in form of cylinder with radius R= 400-1000 pc and height H=200-400 pc, thus causing their visible luminescence across all spectral bands. We obtain radiation and electron energy distribution functions depending on the spatial distribution of the investigated bulk of matter in AGN. Radiation luminescence of the non-central part of AGN is a response to the effects of particles and quanta falling from its center created by atoms, molecules and dust of its diffuse component. The cross-sections for the single-photon annihilation of positrons of different energies with atoms in these active galactic nuclei are determined. For the first time we use the data on the change in chemical composition due to spallation reactions induced by high-energy particles. We establish or define more accurately how the energies of the incident positron, emitted ${\gamma}-quantum$ and recoiling nucleus correlate with the atomic number and weight of the target nucleus. For light elements, we provide detailed tables of all indicated parameters. A new criterion is proposed, based on the use of the ratio of the fluxes of ${\gamma}-quanta$ formed in one- and two-photon annihilation of positrons in a diffuse medium. It is concluded that, as is the case in young supernova remnants, the two-photon annihilation tends to occur in solid-state grains as a result of active loss of kinetic energy of positrons due to ionisation down to thermal energy of free electrons. The single-photon annihilation of positrons manifests itself in the gas component of active galactic nuclei. Such annihilation occurs as interaction between positrons and K-shell electrons; hence, it is suitable for identification of the chemical state of substances comprising the gas component of the investigated media. Specific physical media producing high fluxes of positrons are discussed; it allowed a significant reduction in the number of reaction channels generating positrons. We estimate the brightness distribution in the ${\gamma}-ray$ spectra of the gas-and-dust media through which positron fluxes travel with the energy range similar to that recorded by the Payload for Antimatter Matter Exploration and Light-nuclei Astrophysics (PAMELA) research module. Based on the results of our calculations, we analyse the reasons for such a high power of positrons to penetrate through gas-and-dust aggregates. The energy loss of positrons by ionisation is compared to the production of secondary positrons by high-energy cosmic rays in order to determine the depth of their penetration into gas-and-dust aggregations clustered in active galactic nuclei. The relationship between the energy of ${\gamma}-quanta$ emitted upon the single-photon annihilation and the energy of incident electrons is established. The obtained cross sections for positron interactions with bound electrons of the diffuse component of the non-central, peripheral AGN regions allowed us to obtain new spectroscopic characteristics of the atoms involved in single-photon annihilation.