• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.29 no.9A
• /
• pp.991-997
• /
• 2004

In this paper, we propose the architecture of modem receiver to fabricate HomePNA 2.0 chip. HomePNA suffers from inferior channel because of bridge tap, the effect of amateur HAM band and so on. To transfer data over such channel, HomePNA 2.0 uses training sequence to equalize channel and uses FD-QAM optionally as modulation method. So modem receiver demodulate QAM based signal and needs optimum architecture that fully uses these transmission feature. As a result of research, we define 2 mode function of modem receiver depending on TX/RX state. In this paper, particularly, we show the algorithm of equalizer, carrier phase recovery and frame synchromzationblock and propose architecture that improve the performance of channel equalization and is stable in operation. In the end, we estimate the performance of proposed HomePNA2.0 modem receiver over HomePNA TEST LOOP using SPW program.

• Journal of the Institute of Electronics Engineers of Korea CI
• /
• v.45 no.1
• /
• pp.70-77
• /
• 2008

On the wireless sensor network MAC protocols, one of main issues is energy enciency. Since several asynchronous wireless sensor network MAC protocols with short preamble sampling scheme can be operated without setting the timing synchronization among neighbor nodes, it consumes a little energy for maintaining protocols. However, each node encounters either preamble or data overhearing problem, because each node wakes up in a different time and must check whether the frame is being sent to itself or not. To solve this overhearing problem, we newly propose B-MAC++ that can reduce the overhearing energy consumption by using short preambles with destination address and payload length. from simulation results, we show that the proposed B-MAC++ has advantageous in terms of power consumption efficiency over other asynchronous wireless sensor network MAC protocols.

• Journal of the Institute of Electronics Engineers of Korea SD
• /
• v.38 no.1
• /
• pp.69-78
• /
• 2001

This paper presents the design and FPGA implementation of a FLEX PSP(Protocol Signal Processor) for the portable high speed paging system. In this approach, two algorithms are newly proposed for implementing the PSP which provides capabilities of the maximum 6,400bps at speed, high-channel throughput, real time error correction and an effective frame search function. One is an accurate symbol synchronization algorithm which is applied for synchronizing the interleaved 4-level bit symbols which are received at input stage of A/D converter, and the other is a modified fast decoding algorithm which is provided for realizing double error correction of (31,21)BCH signal. The PSP is composed of six functional modules, and each module is modelled in VHDL(VHSIC Hardware Description Language). Both functional simulation and logic synthesis have performed for the proposed PSP through the use of Synopsys$^{TM}$ tools on a Axil-320 Workstation, and where Altera 10K libraries are used for logic synthesis. From logic synthesis, we can see that the number of gates is about 2,631. For FPGA implementation, timing simulation is performed by using Altera MAX+ PLUS II, and its results will be also given. The PSP which is implemented in 6 FPGA devices on a PCB has been verified by means of Logic Analyzer.r.

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.43 no.12 s.354
• /
• pp.9-15
• /
• 2006

In this paper, signal processing techniques for noncoherent impulse-radio-based UWB (IR-UWB) communication system are proposed to provide system implementation of low power consumption and low complexity. The proposed system adopts a simple modulation technique of OOK (on-oft-keying) and noncoherent signal detection based on signal amplitude. In particular, a technique of a novel high speed digital sampler using a stable, lower reference clock is developed to detect nano-second pulses and recover digital signals from the pulses. Also, a 32 bits Turyn code for data frame synchronization and a convolution code as FEC are applied, respectively. To verify the proposed signal processing techniques for low power, low complexity noncoherent IR-UWB system, the proposed signal processing technique is implemented in FPGA and then a short-range communication system for wireless transmission of high quality MP3 data is designed and tested.

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.37 no.3
• /
• pp.9-17
• /
• 2000

In this paper we implement computer simulation system of 4FSK signal MODEM using Quadrature detector and analyze overall tranceiver system. We follow the FLEX wireless paging system standards and construct premodulation filter and data frame. We propose an efficient open loop symbol timing recovery algorithm which takes advantage of 128 bit length preamble pattern and also propose a 32 bit UW pattern which Is based on the optimal UW detection method, and excellent aperiodic autocorrelation characteristic. The BER simulation in the fading channel as well as AWGN is performed with BCH coding and Interleaving to the Quadrature detector system and it is shown that a high coding fain occurs in the fading channel rather than AWGN channel.

• Journal of the Korean Institute of Illuminating and Electrical Installation Engineers
• /
• v.29 no.10
• /
• pp.73-82
• /
• 2015

This paper proposes an ripple reduction algorithm and analyzes the effects of offset and scale errors generated by voltage sensor while measuring grid voltage in grid-tied single-phase inverters. Generally, the grid-connected inverter needs to detect the phase angle information by measuring grid voltage for synchronization, so that the single-phase inverter can be accurately driven based on estimated phase angle information. However, offset and scale errors are inevitably generated owing to the non-linear characteristics of voltage sensor and these errors affect that the phase angle includes 1st harmonic component under using SRF-PLL(Synchronous Reference Frame - Phase Locked Loop) system for detecting grid phase angle. Also, the performance of the overall system is degraded from the distorted phase angle including the specific harmonic component. As a result, in this paper, offset and scale error due to the voltage sensor in single-phase grid connected inverter under SRF-PLL is analyzed in detail and proportional resonant controller is used to reduce the ripples caused by the offset error. Especially, the integrator output of PI(Proportional Integral) controller in SRF-PLL is selected as an input signal of the proportional resonant controller. Simulation and experiment are performed to verify the effectiveness of the proposed algorithm.

• The Journal of the Acoustical Society of Korea
• /
• v.41 no.2
• /
• pp.150-158
• /
• 2022

This paper presents the results of a sea trial for very long range spread spectrum underwater acoustic communication conducted in the East Sea in September 2021. Signals were collected through 8 vertical sensors, and the range between the transmitter and receiver was about 160 km. 30 bps Multi-Code Spread Spectrum (MCSS) method and 100 bps Chirp Spread Spectrum method were used for the transmitting signal generation. The results show that when the channel coding technique was not used in a single channel, the uncoded bit error rate was high, but when the Equal Gain Combining (EGC) diversity technique was used after frame synchronization in each receiving channel, the uncoded bit error rate was reduced to 0.1 or less.

• Smart Structures and Systems
• /
• v.31 no.3
• /
• pp.259-273
• /
• 2023

Real-time hybrid simulation (RTHS) is an effective experimental technique for structural dynamic assessment. However, time delay causes displacement de-synchronization at the interface between the numerical and physical substructures, negatively affecting the accuracy and stability of RTHS. To this end, the authors have proposed a model-based adaptive control strategy with a Kalman filter (MAC-KF). In the proposed method, the time delay is mainly mitigated by a parameterized feedforward controller, which is designed using the discrete inverse model of the control plant and adjusted using the KF based on the displacement command and measurement. A feedback controller is employed to improve the robustness of the controller. The objective of this study is to further validate the power of dealing with a nonlinear control plant and to investigate the potential challenges of the proposed method through actual experiments. In particular, the effect of the order of the feedforward controller on tracking performance was numerically investigated using a nonlinear control plant; a series of actual RTHS of a frame structure equipped with a magnetorheological damper was performed using the proposed method. The findings reveal significant improvement in tracking accuracy, demonstrating that the proposed method effectively suppresses the time delay in RTHS. In addition, the parameters of the control plant are timely updated, indicating that it is feasible to estimate the control plant parameter by KF. The order of the feedforward controller has a limited effect on the control performance of the MAC-KF method, and the feedback controller is beneficial to promote the accuracy of RTHS.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.35 no.3C
• /
• pp.302-313
• /
• 2010

In this paper, we propose an enhanced AGC (Automatic Gain Control) structure and P-SCH detection method for initial cell search in 3GPP (3rdGenerationPartnershipProject) LTE (Long Term Evolution) FDD(Frequency Division Duplex) / TDD (Time Division Duplex) dual mode system. Since TDD frame structure consists of uplink subframe and downlink subframe, conventional AGC structure causes P-SCH detection performance degradation by increase of AGC variation due to signal power difference between uplink and downlink subframe. Also, P-SCH detection performance is degraded by distortion of P-SCH correlation characteristic in frequency offset and multipath fading channel environments. Therefore, we propose an AGC structure which can minimize P-SCH detection performance degradation with stable operation in 3GPP LTE TDD mode as well as FDD mode. Also we propose a P-SCH detection method which can reduce distortion of correlation chareteristics in frequency offset and multipath fading environments and obtain good P-SCH detection performance. Simulation results show that the proposed AGC structure and P-SCH detection method have stable AGC operation and excellent P-SCH detection performance for 3GPP LTE TDD / FDD dual mode downlink receiver in various channel environments.