• 한국건축시공학회:학술대회논문집
• /
• 한국건축시공학회 2012년도 추계 학술논문 발표대회
• /
• pp.181-184
• /
• 2012

The Tuned Pendulum Slab Damper(TPSD)system is mainly composed of suspended pendulum slab which was hanging with cable wire from the top floor of building without any extra loads structurally, and can be helpful to reduce vibration with effect of tuned mass damper function by the principle of pendulum movement. The experiment was performed with miniatures of the 30stories of steel structure building by the forced vibration test using shaking table, and the result was reduced about 42% of vibration. The purpose of this study was to make analysis of application of the TPSD system to new building and exist building against strong wind or seismic wave. The result of this study was that the TPSD system shall be satisfactory in field of execution, process control, safety and economical efficiency with saving up to 70% of construction cost.

• Journal of the Korean Wood Science and Technology
• /
• 제19권1호
• /
• pp.71-80
• /
• 1991

This study was carried out to investigate replaceable species with the conventional sounding board sitka spruce. by comparing the dynamic properties such as density, dynamic Young's modulus and internal friction Dynamic Young's modulus. internal friction of longitudinal and radial direction measured in free mass-free boundary condition for facile vibration analysis and measured by forced vibration method. Dynamical properties of four species were measured on squared plate specimen that the four edges were hung vertically by threads and driven magnetically through an iron piece glued on the specimen, by the use of condenser microphone as vibration transducer, and analyzed by FFT analyzer. The results obtained were as follows: 1. Chaldni method using aluminum powder was proper to identify the vibration mode in the plate vibration and it was possible to verify the resornance mode. 2. It was considered that it was necessary to investigate the influence of adhesive part on the plate vibration when the sounding board was made by two or three small board adhesion. 3. It was considered that plate vibration method, which was a superior to the vibration test of beam, was suitable for selecting suounding board because dynamic Young's modulus and internal friction show different order according to longitudinal and radial direction. 4. Paulownia tomentosa Thunb.) Steudel has been considered to be replaceable species with sitka spruce because it has high dynamic Young's modulus compared with low density, low internal friction, and K value of Paulownia tomentosa (Thunb.) Steudel is greater than that of sitka spruce.

• 한국건축시공학회:학술대회논문집
• /
• 한국건축시공학회 2023년도 가을학술발표대회논문집
• /
• pp.227-228
• /
• 2023

A floating floor generally consists of mortar bed separated from the structural RC slab by a continuous resilient layer. It is known that the floating floors are a type of vibration-isolation system to improve the impact sound insulation performance. However, some researchers have demonstrated that the amplification of vibration response at a specific range of frequencies results in an increase in the impact sound level. This study carried out the forced vibration tests to obtain the frequency response function (FRF) of a floating floor compared with a bare RC slab. Test results shows that the additional peak occur in vibrational spectrum of the floating floor except natural vibration modes of the bare RC slab. This is because the relatively flexible resilient material and mass of the mortar bed offer an additional degree of freedom in the structural system. Therefore, it could be efficient for reduction of floor impact vibration and noise to control the additional mode frequency and response of floating floors.

• 대한토목학회논문집
• /
• 제8권2호
• /
• pp.41-50
• /
• 1988

본(本) 논문(論文)에서는, 국내(國內)에 가설(架設)되어 있는 30개(個) 교량(橋梁)들에 대한 정동적시험(靜動的試驗)으로부터 얻어진 동적특성(動的特性)에 관한 기본자료(基本資料)를 정리(整理)하여, 교량진동(橋梁振動)의 주(主)된 원인이 되는 사항에 대해 살펴보았다. 시험(試驗)은 교량(橋梁)의 중앙하부(中央下部)에 변위측정기(變位測定機)와 변형(變形)게이지를 설치(設置)한 뒤 단일만재차량(單一滿載車輛)을 주행(走行)시켜 실시(實施)하였으며, 이때 얻어지는 동적(動的)데이타는 강제진동(强制振動)과 자유진동(自由振動)으로 구분(區分)하여 시간영역해석(時間領域解析)을 통하여 분석(分析), 교량(橋梁)의 진동특성(振動特性)을 연구(硏究)하였다. 여기서 얻어진 자료(資料)는 국내(國內)에서 초보적 단계에 있는 도로교(道路橋)의 진동거동예측(振動擧動豫測)에 귀중한 자료(資料)를 제시할 것이다.

• 한국소음진동공학회논문집
• /
• 제19권12호
• /
• pp.1347-1355
• /
• 2009

This paper demonstrates the validity of spectral element analysis for modeling the high-frequency dynamic behaviors of a beam with a surface-bonded piezoelectric wafer through a laboratory test. In the spectral element analysis, the high-frequency electro-mechanical interaction can be considered properly with relatively low computational cost compared to the finite element analysis. In the verification test, a cantilever beam with a surface-bonded piezoelectric wafer is forced to be in steady-state motion by exerting the harmonic driving voltage signal on the piezoelectric wafer. A laser scanning vibrometer is used to obtain the overall dynamic responses of the structure such as resonance frequencies, the associated mode shapes, and frequency response functions up to 20 kHz. Then, these dynamic responses from the test are compared to those computed by the spectral element analysis. A two-dimensional finite analysis is conducted to obtain the asymptotic solutions for the comparison purpose as well.

• 한국전산구조공학회:학술대회논문집
• /
• 한국전산구조공학회 2009년도 정기 학술대회
• /
• pp.425-428
• /
• 2009

This paper presents a sensitivity-based finite element (FE)-model update procedure for prestressed concrete (PSC) girder bridge model using vibration test results. Firstly, the stiffness parameters of the structure such as flexural rigidity of concrete and flexural rigidity of tendon are chosen as updating parameters. Next, the numerical frequencies of first two bending modes are calculated using a three-dimensional FE model which is established for the PSC girder. Then, the corresponding experimental frequencies which are obtained from forced vibration tests are selected. In order to perform the model update, the eigensensitivity-based method is employed. Finally, the effect of prestress-loss on the stiffness parameters is evaluated.

• Ocean Systems Engineering
• /
• 제3권3호
• /
• pp.167-180
• /
• 2013

Hydrodynamic characteristics of a bluff cylinder oscillating along transverse direction in steady flow were experimentally investigated at Reynolds number of $2{\times}10^5$. The effects of non-dimensional frequency, oscillating amplitude and Reynolds number on drag force, lift force and phase angle are studied. Vortex shedding mechanics is applied to explain the experimental results. The results show that explicit similarities exist for hydrodynamic characteristics of an oscillating cylinder in high and low Reynolds number within subcritical regime. Consequently, it is reasonable to utilize the test data at low Reynolds number to predict vortex induced vibration of risers in real sea state when the Reynolds numbers are in the same regime.

• 한국소음진동공학회:학술대회논문집
• /
• 한국소음진동공학회 2008년도 춘계학술대회논문집
• /
• pp.510-518
• /
• 2008

This paper presents recent development of (semi)-active steering bogies for railway vehicles and introduce the state-of-art of related technologies. Steering bogies have been studied in various researchers since they can offer high ride quality for passengers and reduce the maintenance costs of wheel and rail wear. Especially, they are considered to be a fundamental solution to dramatically reduce the squeal noise on tight curves. However, passive steering bogies such as self-steering bogies and forced steering bogies have shown their limits to cope with the various running conditions. Therefore, (Semi)-active steering bogies have been studied to overcome the drawbacks of the passive steering bogies. As a result, an active steering bogie, so called mechatronic bogie, is developed successfully in Europe and it has shown remarkable performance in test line.

• 한국지진공학회논문집
• /
• 제15권6호
• /
• pp.11-18
• /
• 2011

원자력발전소(이하, 원전)에 설치되는 안전관련 전기기기들의 합리적인 내진검증을 위해서는 사전에 정확한 동특성분석이 필요하다. 이 연구에서는 원전에 설치되는 전기기기 캐비닛 구조를 대상으로 입력 진동의 수준에 따른 모드특성의 변화를 평가하였다. 이를 위해, 실제 전기기기 캐비닛을 시편으로 선정하고 가진 시험기를 이용하여 입력진동에너지의 크기를 변화시켜 가면서 진동시험을 수행하였다. 시험은 캐비닛의 문짝을 부착한 경우와 탈거한 경우로 구분하여 수행하였다. 진동시험을 통하여 계측된 시편의 가속도응답신호와 입력운동신호로부터 진동의 크기에 따라 진동수응답함수를 작성하였다. 다항식회귀분석기법을 이용한 모드분석기법으로 시편의 진동수응답함수를 분석하여 모드특성을 추출하고, 진동수준에 따른 시편의 동특성 변화를 검토하였다. 연구결과, 대상 기기는 입력진동의 크기가 증가할수록 모드진동수와 모드감쇠비가 비선형적으로 변화하는 것을 확인하였다. 문짝이 부착된 경우에는 문짝이 탈거된 경우에 비하여 캐비닛의 모드감쇠가 증가한다.

• 한국전산구조공학회:학술대회논문집
• /
• 한국전산구조공학회 1995년도 봄 학술발표회 논문집
• /
• pp.107-113
• /
• 1995

This paper presents the earthquake response analysis results on the Large-Scale Seismic Test (LSST)structure which was built at Hualien in Taiwan. The seismic analysis is carried out using a computer code KIESSI, which has been developed based on the three-dimensional axisymmetric finite element method incorporating infinite elements for the far field soil region. The soil and structural properties obtained from the post-correlation study of the forced vibration tests (FVT) are utilized to predict seismic responses. The ground accelerations recorded at a site 56.5 m from the test structure are used as control motions. It has been found that the predicted responses are reasonably compared with the observed responses.