• The Transactions of the Korean Institute of Electrical Engineers B
• /
• v.48 no.10
• /
• pp.537-543
• /
• 1999

We fabricated a resistive superconducting fault current limiter (SFCL) of a meander type based on a YBCO film with the meander cross section of 5 $\times$ $10^{-6}$$cm^2$, and performed current limitation experiments. The film was coated quench current was 9.6 Apeak at 60 Hz, and the fast quench time was 0.63 msec. The resistance of the limiter continuously increased for three cycles dut to the temperature rise in the gold layer. The temperature of the current limiting element reached the room temperature in 11 msec, $150^{\circ}C$ in 54 msec after quench, and was saturated afterwards. For $45^{\circ}$and $90^{\circ}$faults the fast quench times were 0.56 msec and 0.26 msec, respectively. The quench time is believed to be reduced because the fault occurred when the current was either increasing or at the peak value. This limiter effectively limited the fault current to about 1/5 of the potential current with no SFCL right after the fault and to about 1/8.5 in three cycles. We confirmed that the gold layer effectively carried out the role of heat dissipation as the SFCL was quenched.

• Journal of the Korean Regional Science Association
• /
• v.40 no.2
• /
• pp.107-130
• /
• 2024

Urban land surface temperature (LST) change is a major environmental factor that affects the thermal comfort, energy consumption, and health of urban residents. Most studies that explored the relationship between LST and urban built-environment form analyzed only midday LST. This study explores the diurnal variation of summertime LST in Seoul using ECOSTRESS data, which observes LST at various times of the day and analyzes whether the LST variation differs by built environment type. Launched in 2018, ECOSTRESS operates in a non-sun-synchronous orbit, observing LST with a high resolution of 70 meters. This study collected data from early morning (6:25) to evening (17:26) from 2019 to 2022 to build time-series LST. Based on greenery, water bodies, and building form data, eight types of Seoul's built environment were derived by hierarchical clustering, and the LST fluctuation characteristics of each cluster were compared. The results showed that the spatial disparity in LST increased after dawn, peaked at noon, and decreased again, highlighting areas with rapid versus stable LST changes. Low-rise and high-rise compact districts experienced fast, high temperature increases and high variability, while low-density apartments experienced moderate LST increases and low variability. These results suggest urban forms that can mitigate rapid daytime heating.

• Bulletin of the Korean Space Science Society
• /
• 2008.10a
• /
• pp.30.3-30.3
• /
• 2008

In this study, we investigate the magnetic latitude of phase reversal on the sudden commencement (SC)-associated preliminary impulse with 267 SC events using the ground magnetometer data of the IMAGE from 1997 to 2005. During SC event, geomagnetic fields are affected by various currents flowing in the magnetosphere and/or ionosphere. In particular, high-latitude geomagnetic field variations are significantly dominated by the change of SC-associated field aligned current (FAC). Until now, however, there are few studies to examine where the location of the FAC in the ionosphere is and what determines the location of the FAC. The location of the SC-associated FAC can be examined by using magnetometer data obtained from high-latitude stations distributed along the same magnetic meridian. The phase reversal locations are concentrated two regions, ~62 deg (L~4.5) and ~70 deg (L~8.5) in magnetic latitude. If FAC is a result of a mode conversion from fast mode to Alfven mode, then the FAC location could be determine by the duration time of the input energy. When we use the rise time, dT, as the input energy, there is no relationship between dT and the location where the first pulse of SC is reversed. We consider other factors such as local time and solar wind condition.

• Journal of Advanced Navigation Technology
• /
• v.12 no.2
• /
• pp.109-114
• /
• 2008

As the Ubiquitous times approach, an interest regarding a Ubiquitous sensor network to be the only during key technology is rising. Currently, The fast development which radio communication technique is creating new services from the industry sector which is various from convenient characteristic and the ease characteristic side. Specially, rise and development of the radio communication technique which is various from environment monitor ring field makes to be improved about sharp curtailment of establishment and logistics relation expense, and collection period of the data which occurs real-time from site, reliability and delivery characteristic. But continuous application and the success about the environment monitor ring field of radio communication technique will be able to trust And It is important to provide time information which is appropriate real-time.

• The Transactions of The Korean Institute of Electrical Engineers
• /
• v.61 no.1
• /
• pp.22-27
• /
• 2012

Correct and fast detection of a micro-grid (MG) islanding is essential to the MG since operation, control and protection of the MG depend on an operating mode i.e., an interconnected mode or an islanding mode. When islanding occurs, the frequency of the point of common coupling (PCC) is not the nominal frequency during the transient state owing to the frequency rise or drop of generators in the MG. Thus, the active and reactive power calculated by the frequency domain based method such as Fourier Transform might contain some errors. This paper proposes an islanding detection algorithm for the MG based on the instantaneous active and reactive powers delivered to the dedicated line in the time domain. During the islanding mode, the instantaneous active and reactive powers delivered to the dedicated line are constants, which depend on the voltage of the PCC and the impedance of the dedicated line. In this paper, the instantaneous active and reactive powers are calculated in the time domain and used to detect islanding. The performance of the proposed algorithm is verified under various scenarios including islanding conditions, fault conditions and load variation using the PSCAD/EMTDC simulator. The results indicate that the algorithm successfully detects islanding for the MG.

• 제어로봇시스템학회:학술대회논문집
• /
• 1997.10a
• /
• pp.32-35
• /
• 1997

A recent development in the Flat Panel Display(FPD) industry requires an auto-alignment system which is operated in high speed and high precision. In the FPD production process, aligning photo-mask with respect to guide mark printed in the glass should be accomplished in the accuracy of sub-micron order. So the system has high bandwidth and needs a dedicated control system which is fast and robust enough to control linear motors in precise manner. Proposed auto-alignment system structure in this presentation which consists of the master controller board, the DSP position controller board which controls 3 axis precision linear motors, the servo system and the man machine interface software. Designed and tuned under repeated experiments, the proposed system showed a reasonable performance in the aspect of rise time and steady state error.

• Proceedings of the KIEE Conference
• /
• 2011.07a
• /
• pp.1632-1633
• /
• 2011

In IEC 62305-1 standard, the simple circuit consisting of RLC is used in order to form the fast rise time of 0.25/100 ${\mu}s$. But this circuit is very expensive system because the system is needed very high charging voltage up to 3.5 MV. In this paper, we suggest the generator which generates the current up to 10 kA by using the low charging voltage of the dozen kV. Therefore the generator was installed then we compared measure results with calculated results.

• 제어로봇시스템학회:학술대회논문집
• /
• 2001.10a
• /
• pp.108.2-108
• /
• 2001

This paper presents the application of adaptive phase-locked loop (adaptive PLL) technique to control the process variable of the process control system. The adaptive algorithm is related to the error. When the error of the system is changed, the adaptive gain will be directly changed according to the error. If the value of the adaptive gain is large, the value of the error will be large. In this experiment, the reference input is 50% step input. The experimental result in controlling the first order lag process by the adaptive PLL shows that the response of the controlled system has no overshoot, short rise time, and zero steady-state error. The experimental result also shows that when the output disturbance enters to the process control system, the adaptive PLL can maintain the stability of the system and the effect of the output disturbance can also be fast rejected. The adaptive PLL has better performance ...

• Proceedings of the KIEE Conference
• /
• 1997.11a
• /
• pp.130-132
• /
• 1997

This paper proposes a reference model following control system using fuzzy logic controller and genetic algorithm. A fuzzy logic controller is designed such that plant output follows the output generated by a reference model. In this paper, First-order and second-order reference model with no overshoot and fast rise time is designed. Experiment results show the effectiveness of the proposed controller in tracking property and robustness.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2002.05c
• /
• pp.160-164
• /
• 2002

A special discharge cell containing a free conducting particle was used to generate the discharges in $SF_6$. The analog bandwidth of the measurement system exceeded 5 GHz. The measured signals were processed to compensate for the response of the measurement system. The discharge current rise time was in the range of 70 ps, while its full-width half-maximum was 120 ps. Single and double current pulses of positive and negative polarities were measured. Likewise, these pulses were compared with the measurement obtained using a conventional partial discharge detector of the IEC60270 type