• Analytical Science and Technology
• /
• v.20 no.4
• /
• pp.289-295
• /
• 2007

A simple electric circuit of an infrared photodiode electrode (IPDE) was utilized to monitor iron using square-wave (SW) anodic stripping voltammetry (SV) and cyclic voltammetry (CV). The optimum analytical conditions were determined and were compared with those of common working electrodes. The comparison showed that CV is more sensitive and convenient to use than the common voltammetry methods. At the optimized conditions, the working ranges of 0.1- to 0.8- and 0.85- to 6.0 mg/L iron was obtained. Relative standard deviation of 15 measurements of iron (0.4 mg/L) was 0.09%. The analytical detection limit was found to be $80{\pm}0.6ug/L$, which was applied to iron in waste water.

• Korean Journal of Agricultural Science
• /
• v.47 no.1
• /
• pp.163-171
• /
• 2020

In this study, a large laboratory model experiment was conducted with the aim of developing an embankment reinforcement method to prevent overtopping, which is the main cause for the failure of agricultural reservoirs. The model experiment was carried out with concrete and asphalt as a permanent reinforcement method and with geomembrane as the emergency method at a deteriorated homogeneous reservoir. Under the non-reinforced conditions, the pattern of the failure appeared in several scour directions from the downstream slope as the overtopping began, and the width and depth of the erosion were magnified as it gradually moved to the dam crest. Under the conditions reinforced with asphalt and concrete, the overtopping was stabilized. In the case of the concrete reinforcement, it was found that the slope of the riprap boundary exhibited downward erosion by the current; thus, it was necessary to construct an extension up to the riprap joint of the upstream and downstream sides to prevent the expansion of the failure. Under the conditions reinforced with the geomembrane sheet, the overtopping was stabilized, and no seepage was found that required the emergency reinforcement method. Asphalt, concrete, and geomembrane sheet reinforcements have been shown to be capable of delaying failure for about 1 hour and 40 minutes compared to the non-reinforcement conditions. The reinforcement method is considered to be a very effective method to prevent disasters during overtopping. The pore water pressure can be used as useful data to predict the risk of failure at an embankment.

• Journal of the Korean institute of surface engineering
• /
• v.51 no.2
• /
• pp.87-94
• /
• 2018

Various sealing techniques were applied to the anodized 5083 aluminum alloy for marine environment to reduce corrosion and cavitation erosion damage. Electrochemical experiments and cavitation erosion tests were conducted to evaluate the corrosion resistance and cavitation resistance of the anodic oxide film treated with sealing in natural seawater solution. Then, damaged surface morphology was analyzed by scanning electron microscope(SEM) and 3D microscope. As the results of the electrochemical experiments, it was observed that the surface damage of all the experimental conditions in the anodic polarization experiment was locally grown by the combination of crack and corrosion damage. In the Tafel analysis, the corrosion resistance of all sealing treatment conditions was improved compared to the anodizing. On the other hand, cavitation erosion tests showed that the anodizing and all the sealing treatment conditions generated local pit damage by cavitation erosion attack and grew to crater damage in the observation of damaged surface by SEM. Also, the weight loss and the surface damage depth measured with the experiment time presented that most of the sealing treatment conditions showed better cavitation erosion resistance than the anodizing, and they had an incubation period at the beginning of the experiment.

• Design & Manufacturing
• /
• v.15 no.4
• /
• pp.24-31
• /
• 2021

In this study, an artificial neural network model was constructed to convert CAE analysis data into similar experimental data. In the analysis and experiment, the injection molding data for 50 conditions were acquired through the design of experiment and random selection method. The injection molding conditions and the weight, height, and diameter of the product derived from CAE results were used as the input parameters for learning of the convert model. Also the product qualities of experimental results were used as the output parameters for learning of the convert model. The accuracy of the convert model showed RMSE values of 0.06g, 0.03mm, and 0.03mm in weight, height, and diameter, respectively. As the next step, additional randomly selected conditions were created and CAE analysis was performed. Then, the additional CAE analysis data were converted to similar experimental data through the conversion model. An artificial neural network model was constructed to predict the quality of injection molded product by using converted similar experimental data and injection molding experiment data. The injection molding conditions were used as input parameters for learning of the predicted model and weight, height, and diameter of the product were used as output parameters for learning. As a result of evaluating the performance of the prediction model, the predicted weight, height, and diameter showed RMSE values of 0.11g, 0.03mm, and 0.05mm and in terms of quality criteria of the target product, all of them showed accurate results satisfying the criteria range.

• Journal of Korean Elementary Science Education
• /
• v.23 no.2
• /
• pp.152-158
• /
• 2004

The purpose of this study was to find the difficulties and problems in the carbon dioxide production experiment and to suggest the device for the improvement. Many students have misconception for the smell of carbon dioxide. I found that the smell of carbon dioxide of producting through the experiment didn't concern with the quantity of calcium carbonate. I certificated that the smell of carbon dioxide was related with the concentration of hydrochloric acid. I built two trap applicaing suction in the gas production device to exclude fully the smell of carbon dioxide. So the smell of carbon dioxide was not present by passing the two trap. To find the ideal experimental conditions I perform the experiment step by step. As the result enough carbon dioxide to use for the property experiment was collected under the condition that is 60 mL of 3 molarity hydrochloric acid and 30 g calcium carbonate. I certificated to mesuring flowing quantity of carbon dioxide using the flow meter of carbon dioxide. In the improvement experiment of the property of carbon dioxide, I proposed the experiment device regarding as spreading of the gas and children's interest. To improve the problem of gas production experiment, I proposed the gas certification device using a thread.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 1994.05a
• /
• pp.71-73
• /
• 1994

In this paper we have investigated discharge conditions(parameters of this experiment) in facing targets sputtering system and fabricated $Al_{N}$ thin films. The parameters of this study are diameter of wing(d) and distance(L) between two facing targets. Varing discharge conditions, the discharge characteristics are wide different. The optimal conditions in this experiments are d = 6.5 [cm], L = 6.5[cm]

• Journal of radiological science and technology
• /
• v.37 no.1
• /
• pp.21-28
• /
• 2014

Cultured pancreatic beta cells and nerve cells, it is given normal condition of 10% FBS (fetal bovine serum), 11.1 mM glucose and hyperglycemia codition of 1% FBS, 30 mM glucose. For low LET X-ray irradiated with 0.5 Gy/hr dose-rate(total dose: 0.5 to 5 Gy). Survival rates were measured by MTT assay. When non irradiated, differentiated in the pancreatic beta cells experiment is hyperglycemia conditions survival rate compared to normal conditions survival rate seemed a small reduction. However increasing the total dose of X-ray, the survival rate of normal conditions decreased slightly compared to the survival rate of hyperglycemia conditions, the synergistic effect was drastically reduced. When non irradiated, undifferentiated in the nerve cells experiment is hyperglycemia conditions survival rate compared to normal conditions survival rate seemed a large reduction. As the cumulative dose of X-ray normal conditions and hyperglycemia were all relatively rapid cell death. But the rate of decreased survivals by almost parallel to the reduction proceed and it didn't show synergistic effect.

• Journal of Advanced Navigation Technology
• /
• v.28 no.1
• /
• pp.60-67
• /
• 2024

The majority of civil aviation accidents are caused by human factors, and especially for rotary-wing aircraft, accidents often occur in situations where pilots unexpectedly or unintentionally enter into instrument meteorological conditions (IIMC). This research analyzed the error rates of rotary-wing aircraft pilots under low visibility conditions from various angles to gain insights into flight characteristics and to explore measures to reduce accidents in IIMC situations. The occurrence rate of errors by pilots under low visibility conditions was examined using a flight simulator equipped with motion, with 65 pilots participating in the experiment. Flight data obtained through the experiment were used to aggregate and analyze the number of errors under various conditions, such as reductions in flight visibility, the presence or absence of spatial disorientation, and the pilot's qualifications. The analysis revealed peculiarities in flight characteristics under various conditions, and significant differences were found in the rate of error occurrence according to the pilot's qualification level, possession of instrument flight rules (IFR) qualifications, and during different phases of flight. The results of this research are expected to contribute significantly to the prevention of aircraft accidents in IIMC situations by improving pilot education and training programs.

• Journal of the Korean Society of Environmental Restoration Technology
• /
• v.18 no.3
• /
• pp.23-38
• /
• 2015

The study was initiated with Kentucky bluegrass (KB, Poa pratensis L.) to investigate germination and early establishment characteristics of new cultivars for a practical application to turfgrass establishment such as parks, athletic field and golf course etc. Fifteen cultivars were evaluated in different experiments. An alternative condition for a KB germination test required by International Seed Testing Association (ISTA) was applied in Experiment I, consisting of 8-hr light at $25^{\circ}C$ and 16-hr dark at $15^{\circ}C$ (ISTA conditions). Experiment II was conducted under a room temperature condition of 5 to $25^{\circ}C$ (natural conditions). Seed germinating vigor, germination speed and germination peak time were measured in both experiments. Significant differences were observed in seed germinating vigor, germination speed and germination peak time. Seed germinating vigor was variable with different environments and cultivars. It was 75.25 to 89.50% under ISTA conditions and 75.75 to 90.25% under natural conditions. There were considerable variations in early germination characteristics among KB cultivars according to different environments. Early germination characteristics showed that all cultivars were 3 to 5 days faster in germination under ISTA conditions, when compared with natural conditions. The germination speed, measured as days to seed germination of 50% to 80%, was much faster with 'Midnight II', 'Excursion' and 'Midnight' under ISTA conditions. But it was faster with 'Midnight II', 'Excursion' and 'Odyssey' under natural conditions. Differences was also observed in germination peak time with cultivars and growing conditions. It ranged 5.94 to 14.88 days under ISTA conditions and 4.71 to 13.06 days under natural conditions. Regardless of the environment conditions, the shortest cultivars were 'Odyssey' and 'Midnight II'. The longest ones were 'Nuglade' under ISTA condition and 'Moonlight' under natural conditions. Considering germinating vigor, germination speed and germination peak time, 'Midnight II', 'Excursion', 'Midnight', and 'Odyssey' were regarded as excellent cultivars under ISTA conditions in terms of early establishment characteristics, while 'Midnight II', 'Excursion', 'Odyssey', and 'Courtyard' under natural conditions. These results suggest that an intensive germination test be needed prior to planting, for investigating the early germinating vigor, germination speed and germination peak time. Also, a proper cultivar selection and comprehensive site analysis for the growing environmental conditions should be done before turfgrass establishment such as golf course construction.

• Proceedings of the KIEE Conference
• /
• 2009.07a
• /
• pp.478_479
• /
• 2009

It is important to find the maximum efficient conditions for the output of the photovoltaic(PV) system to determine the optimal installation location of the PV system. The output of PV system depends on the irradiance. Therefore, this paper introduces the pilot experiment set to track the output of PV system according to the variance of irradiance and analyzes the result of experiment using this set. The pilot experiment set consists of the PV modules and the inverter to convert DC power to AC power. For this experiment, the fixed and tracked modules are used.