• Journal of the Institute of Electronics Engineers of Korea SD
• /
• v.44 no.7 s.361
• /
• pp.37-44
• /
• 2007

A low-voltage high-linear bipolar OTA and its application to IF bandpass filter for GSM cellular telephone are presented. The OTA consists of a low-voltage linear transconductor, a translinear current gain cell, and three current mirrors. The bandpass filter is composed of two cascaded identical second-order bandpass filters, which consist of a resistor, a capacitor, and a grounded simulated inductor realized with two OTA's and a grounded capacitor. SPICE simulations using an 8 GHz bipolar transistor-array parameter show that the OTA with a transconductance of 1 mS exhibits a linearity error of less than ${\pm}2%$ over an input voltage range of ${\pm}0.65\;V$ at supply voltages of ${\pm}2.0\;V$. Temperature coefficient of the transconductance is less than $-90ppm/^{\circ}C$. The bandpass filter has a center frequency of 85 MHz and Q-factor of 80. Temperature coefficient of the center frequency is less than $-182ppm/^{\circ}C$. The power dissipation of the filter is 128 mW.

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.45 no.9
• /
• pp.8-12
• /
• 2008

In this paper, we proposes a D-STTD(Double-Space Time Transmit Diversity) communication system with AMC scheme and analyzes its performance using simulation experiments. The AMC scheme selects an optimal channel coding rate and modulation scheme based on the channel response data for signal transmission, creating a balance between error rate and throughput to improve the overall system throughput and transmission quality. The D-STTD scheme complements the conventional STTD(Space Time Transmit Diversity) scheme, yielding about twice the throughput. The simulation results show that the probability of selecting a high MCS(Modulation and Coding Scheme) level increased as the SNR(Signal to Noise Ratio) improved. Furthermore, the D-STTD communication system with AMC scheme provided a more uniform throughput distribution throughout the entire SNR range compared to its counterpart which did not apply AMC scheme. Also, the maximum throughput of the D-STTD communication system with AMC scheme was twice that of a conventional AMC communication system or a STTD communication system with AMC scheme.

• Journal of Forest and Environmental Science
• /
• v.32 no.3
• /
• pp.280-290
• /
• 2016

Stem diameter variability is an essential inventory result that provides useful information in forest management decisions. Little has been done to explore the modelling potentials of standard deviation (SDD) and coefficient of variation (CVD) of diameter at breast height (dbh). This study, therefore, was aimed at developing and testing models for predicting SDD and CVD in stands of Pinus caribaea Morelet (pine) in south west Nigeria. Sixty temporary sample plots of size $20m{\times}20m$, ranging between 15 and 37 years were sampled, covering the entire range of pine in south west Nigeria. The dbh (cm), total and merchantable heights (m), number of stems and age of trees were measured within each plot. Basal area ($m^2$), site index (m), relative spacing and percentile positions of dbh at $24^{th}$, $63^{rd}$, $76^{th}$ and $93^{rd}$ (i.e. $P_{24}$, $P_{63}$, $P_{76}$ and $P_{93}$) were computed from measured variables for each plot. Linear mixed model (LMM) was used to test the effects of locations (fixed) and plots (random). Six candidate models (3 for SDD and 3 for CVD), using three categories of explanatory variables (i.e. (i) only stand size measures, (ii) distribution measures, and (iii) combination of i and ii). The best model was chosen based on smaller relative standard error (RSE), prediction residual sum of squares (PRESS), corrected Akaike Information Criterion ($AIC_c$) and larger coefficient of determination ($R^2$). The results of the LMM indicated that location and plot effects were not significant. The CVD and SDD models having only measures of percentiles (i.e. $P_{24}$ and $P_{93}$) as predictors produced better predictions than others. However, CVD model produced the overall best predictions, because of the lower RSE and stability in measuring variability across different stand developments. The results demonstrate the potentials of CVD in modelling stem diameter variability in relationship with percentiles variables.

• Korean Journal of Optics and Photonics
• /
• v.19 no.3
• /
• pp.224-228
• /
• 2008

A highly sensitive integrated photonic temperature sensor was proposed and developed incorporating a polymeric microring resonator. The change in the ambient temperature was estimated by observing the shift in the resonant wavelength of the resonator induced via the thermooptic effect. For the purpose of enhancing its sensitivity, the sensor was built by implementing a polymeric resonator exhibiting a high thermooptic coefficient on a silicon substrate with a small coefficient of thermal expansion. For the range of from $20^{\circ}C$ to $30^{\circ}C$ near the room temperature, the fabricated sensor yielded a sensitivity of as high as 165 ${\pm}/^{\circ}C$ and a resolution of better than $0.1^{\circ}C$. And its performance was found to be hardly affected by the variation in the refractive index of the target analyte, which was applied to the surface of the sensor. It is hence expected that the sensor could be integrated with other refractormetric optical sensors, thereby compensating for the fatal error caused by the change in the ambient temperature.

• Journal of Digital Contents Society
• /
• v.8 no.4
• /
• pp.491-497
• /
• 2007

RPersonal area networking technology is becoming increasingly important in enabling useful wireless home applications. For example, Bluetooth and IEEE 802.11b standards are the most commonly deployed technologies for wireless home applications. However, because both standards share the same unlicensed ISM (Industrial, Scientific, Medical) radio spectrum, severe interference is inevitable and performance can be impaired significantly when heterogeneous devices using the two technologies come into close proximity. In this paper, we research Gaussian FSK Bluetooth system, which is an open specification technology for short-range wireless connectivity between electronic devices. In this paper, we analyzes the effects of co-channel interference on the performance of a Gaussian FSK Bluetooth system. Performance criteria used in the study are the signal to interference power ratio (SIR), interference index, and the bit error rate (BER) in the wireless channel. The effect of co-channel interference from various sources on the performance of a Gaussian FSK Bluetooth system is analyzed using an IGA(Impulsive Gaussian Approximation) method, and these quantities are plotted against Eb/No, $\rho$ and SIR for various channel conditions in figures.

• The Journal of the Acoustical Society of Korea
• /
• v.24 no.5
• /
• pp.294-300
• /
• 2005

Generally, traditional approaches to track the target position are to estimate ranges and bearings by 2-D MUSIC (MUltiple 519na1 Classification) method. and to associate estimates of 2-D MUSIC made at different time points with the right targets by JPDA (Joint Probabilistic Data Association) filter in the near field. However, the disadvantages of these approaches are that these have the data association Problem in tracking multiple targets. and that these require the heavy computational load in estimating a 2-D range/bearing spectrum. In case multiple targets are adjacent. the tracking performance degrades seriously because the estimate of each target's Position has a large error. In this paper, we proposed a new tracking algorithm using Position innovations extracted from the senor output covariance matrix in the near field. The proposed algorithm is demonstrated by the computer simulations dealing with the tracking of multiple closing and crossing targets.

• Aerospace Engineering and Technology
• /
• v.9 no.1
• /
• pp.60-66
• /
• 2010

This paper deals with a post-processing of GPS receiver data in order to acquire a reference flight trajectory of an aircraft test. The flight test using an aircraft that is carried out several times since 2007 is the integrated test to verify the performance of the tracking and communications facilities in Naro Space Center and Jeju Tracking Center. In order to analyze performance of the tracking and navigation equipments, true reference data should be used for performance comparisons. Therefore off-the-shelf commercial GPS receiver, DL-V3 made by NovAtel Inc., is operated on the test to collect the GPS navigation data and the collected data is post-processed by GrafNav which is the off-the-shelf post-processing program made by NovAtel Inc. Through the post-processing of the collected data, a reference trajectory is generated with small error range about several decade centimeter level.

• Journal of the Korean Chemical Society
• /
• v.28 no.5
• /
• pp.293-301
• /
• 1984

-ray fluorescence analysis of $Ta_2O_5$, $Nb_2O_5$ and $ZrO_2$ in tin-slag samples using the simple dilution method was studied. The method is to correct mathematically the calibration curve to the linear line by the dilution. One synthesized standard having similar composition to the sample and tin slag samples were diluted with anhydrous $Li_2B_4O_7$ at the level of 1%, 2% and 3% of the sample content respectively. The diluted samples were fused at $1150^{\circ}C$ for 30 minutes and these glass beads were finely ground and pelletized. Measuring the X-ray intensities with these pellets, analytical results were calculated by the equation derived from J. Scherman's equation for the characteristic X-ray intensity of an element. Analytical results agreed with the reference values obtained by the standard calibration method within allowable error range and were reproducible.

• Journal of the Korean Chemical Society
• /
• v.28 no.5
• /
• pp.302-308
• /
• 1984

X-ray spectrometric determination of $Ta_2O_54, $Nb_2O_5$ and $ZrO_2$ in tin-slag samples using the double dilution technique was conducted. Tin-slag samples and one synthesized standard sample having similar composition to the samples were diluted with anhydrous $Li_2B_4O_7$ at the level of 1.00, 2.00 and 3.00% of the sample content, respectively. The diluted samples were fused at $1,150^{\circ}C$ for 30 minutes, and these glass beads were finely ground and pelletized. With the X-ray intensities measured, analytical results were calculated by the double dilution equation. The results agreed to the reference values obtained by the standard calibration method and the simple dilution technique within allowable error range and were reproducible.

• Journal of the Korean Chemical Society
• /
• v.32 no.3
• /
• pp.211-226
• /
• 1988

Liquid chromatographic behavior of several metal ions in dithiocarbamate(DTC) chelates were investigated by reversed phase high performance liquid chromatography on Novapak $C_{18}$ and ${\mu}$-Bondapak $C_{18}$ columns. The optimum conditions for the separation of DTC-metal chelate were examined with respect to the pH, shaking time, flow rate, extraction solvent, and mobile phase strength. The metal ions in mixtures at trace level, chelated with some dithiocarbamate derivatives were separated successfully on Novapak $C_{18}$ column using acetonitrile/methanol/water or acetonitril/water mixtures as mobile phases. It was found that all DTC metal chelates studied were eluted in an acceptable range of capacity factor values ($0{\leqq}log\;k'{\leqq}1$). Although several foreign metal ions were coexisted, high recovery and good precision were attained ; 97.0-106.7 % for the recovery and 0.98-3.41% for the coefficient of variation. Under the optimum analytical conditions, trace metal ions in the composite water samples were determined sucessfully with in relative error of about {\pm}$6.7 %.