• 지구물리와물리탐사
• /
• 제1권1호
• /
• pp.57-63
• /
• 1998

전기비저항 탐사는 역사가 깊으며 널리 사용되는 물리탐사 기술 중의 하나로서 최근에는 단순한 이상대의 확인이 아닌 지하 구조를 영상화하는 것으로 확대, 발전되면서 토목 및 환경 분야에 많은 적용이 시도되고 있다. 본 연구에서는 환경 분야에서의 전기비저항 탐사의 응용 가능성을 입증하기 위하여 전주시 소재의 폐기물 처분장에서 10 m 간격의 쌍극자 배열 전기비저항 탐사를 8개의 측선상에서 수행하였다. 자동 측정 소프트웨어를 개발하여 자료를 획득하였으며 자료처리 과정에서 지형 효과를 보정하였다. 처분장 내부는 대단히 낮은 저비저항대가 발달하고 있으며 삼천천 쪽을 제외하고는 처분장 부지와 저비저항대의 분포가 정확하게 일치하였다. 또한 오염물질의 수직적인 분포도 삼천천 방향으로 가면서 그 심도가 계속적으로 깊어진다. 이는 삼천천 쪽을 제외하고는 처분장의 방벽이 오염물질의 확산을 잘 막아주고 있으며 오염물질이 삼천천 방향으로 확산되었을 가능성이 높다는 것을 의미한다. 전기비저항 영상화 기법을 이용하여 오염대의 수평/수직적인 분포, 심도별 오염물질의 발달 경향, 폐기물 처분의 최대 심도등의 유추가 가능하며 이는 환경 분야에서 전기비저항 탐사의 응용 가능성을 입증하는 것이다.

• 한국세라믹학회지
• /
• 제25권4호
• /
• pp.341-348
• /
• 1988

Thin films of tin-oxide were prepared by chemical vapor deposition technique using the direct of SnCl4. Resistivity and carrier concentration of deposited SnO2 thin film were measured by 4-point probe method and Hall effect measurement. The results showed the remarkable dependence of electrical properties on the deposition temperature. As the deposition temperature increased, resistivity of deposited film initially decreased to a minimum value of ~10-3$\Omega$cm at 50$0^{\circ}C$, and then rapidly increased to ~10$\Omega$cm at $700^{\circ}C$. Electrical conductance of these films was measured in exposure to H2 gas. It was found that gas sensitivity was affected combination of film thickness and intrinsic resistivity of deposited film. Gas sensitivity increased with decrease of film thickness. Fairly high sensitivity to H2 gas was obtained for the film deposited at $700^{\circ}C$. Optimum operation temperature of sensing was 30$0^{\circ}C$ for H2 gas.

• KIEE International Transactions on Electrophysics and Applications
• /
• 제12C권4호
• /
• pp.214-219
• /
• 2002

The influence of ultraviolet (UV) irradiation and corona on the surface degradation of high temperature vulcanized (HTV) silicone rubber used for outdoor insulation through measuring surface voltage decay after corona charging, surface resistivity, contact angle and X-ray photoelectron spectroscopy (XPS) analysis was studied. The surface resistivity calculated by the surface voltage decay was compared with a value directly obtained from the three electrode method having the guard ring electrode. A good agreement between the two methods for surface resistivity was obtained. UV treated specimens showed the slower decrease of surface voltage decay, while the corona exposed specimens showed a dramatically faster decrease. Although both artificial treatments cause the same oxidative products, which was confirmed with XPS, we could distinguish the difference between the reactions of the two treatments by monitoring the surface voltage decay on corona-charged specimen. In addition, we could derive the specific surface states of the silicone rubber treated by accelerated artificial aging factors and the degradation process.

• 반도체디스플레이기술학회지
• /
• 제17권3호
• /
• pp.27-30
• /
• 2018

In this study, ZnO film was deposited on polycarbonate substrate by spin-spray method at low substrate temperature of $85^{\circ}C$. Surface morphology of ZnO films was changed by adding citrate from rod to dense structure. As-deposited ZnO film indicated high transmittance above 80%. In case of the resistivity, as-deposited ZnO film had high resistivity due to the existence of organic substance in the film. However, organic substance was removed and resistivity was decreased to $3.9{\times}10^{-2}{\Omega}{\cdot}cm$, after UV irradiation.

• 한국건축시공학회:학술대회논문집
• /
• 한국건축시공학회 2023년도 가을학술발표대회논문집
• /
• pp.161-162
• /
• 2023

Limestone slag cement is a green and sustainable building material with huge market potential. However, its shortcoming of low early compressive strength needs to be improved. A method of using aluminum sulfate to improve the early strength of ternary mixed mortar was proposed, and its effect and optimal dosage were tested. Macroscopic properties such as mechanical properties and surface electrical resistivity were measured at different dosages (0%, 1%, 2%, 3%). The microstructure and products of the mixtures were tested in detail, including by scanning electron microscopy, thermogravimetric analysis, and X-ray diffraction. The results show aluminum sulfate enhances mechanical properties and significantly increases surface electrical resistivity. The 1% and 2% doses had no adverse effects on the 28-day mechanical properties, while the 3% dose reduced the 28-day strength. Considering the changes in mechanical properties and surface electrical resistivity, 1% aluminum sulfate is the optimal dosage.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 2011년도 제42회 하계학술대회
• /
• pp.1461-1462
• /
• 2011

In this paper, in order to obtain the excellent transparent conducting film with low resistivity and high optical transmittance for dye sensitized solar cell, ITiO thin films were deposited on Corning glass substrate by rf magnetron sputtering method. The effects of the discharge power and gas pressure on the electrical and optical properties were investigated experimentally. Particularly in order to lower the electrical resistivity, the effect of heat treatment and bias voltage on the morphological properties of ITiO thin film were also studied and discussed. The concentration ratio (%) for In, Ti, and O was 27 : 2 : 42. The electrical resistivity of $2{\times}10^{-4}{\Omega}{\cdot}cm$ and 90% of optical transmittance were obtained under the conditions of 5mTorr of gas pressure, 300W of discharge power, $300^{\circ}C$ of substrate temperature.

• 조명전기설비학회논문지
• /
• 제19권3호
• /
• pp.119-126
• /
• 2005

Electrical resistance tomography(ERT)는 적절하게 설계된 전류를 대지 지하에 주입하여 이에 따른 인가전압을 대지 경계에서 측정한 후 이를 근거로 ERT의 영상복원 알고리즘에서 대지 지하의 대지저항률 분포를 얻고 대지 지하에 뭍힌 물체를 크기와 위치, 그리고 저항률에 대한 특성을 파악할 수 있는 기술이다. 본 논문에서는 ERT의 영상복원 기법으로 Gauss-Newton, TLS와 SIRT 방법들을 살펴본다. 컴퓨터 시뮬레이션을 통해 TLS 방법을 이용한 ERT 영상복원의 성능이 Gauss-Newton와 SIRT방법에 의해 얻어진 결과보다 향상되는 것을 보이도록 한다.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 2009년도 제40회 하계학술대회
• /
• pp.223_224
• /
• 2009

This paper investigates a normal induced voltage according to earth resistivity from distribution lines using calculation method of the normal induced voltage on telecommunication line. The induced voltage according to earth resistivity from distribution lines is verified by vector analysis and EMTP(Electro-Magnetic Transients Program).

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 1997년도 추계학술대회 논문집 학회본부
• /
• pp.391-393
• /
• 1997

Two kinds of the calculation technique are Investigated with 3D triangular SCM for the arrangement of the dielectric sphere with different resistivity under a uniform electric field. The calculation error of Method I is small outside the sphere, but considerably high Inside. On the other hand, the accuracy is much Improved even Inside the solid dielectric by Method II, which uses double layers of triangular charges on the dielectric boundary.

• 한국전기전자재료학회논문지
• /
• 제18권1호
• /
• pp.75-80
• /
• 2005

In this thesis, We Fabricated Cu thin films of 1000 $\AA$, 3000 $\AA$, and 6000 $\AA$ thickness on the single crystal sapphire, polycrystal alumina, and amorphous slide glass substrates deposited by electron beam evaporation(EBE) method. We investigated properties of resistivity and adhesion of these Cu thin films under various conditions, substrate temperature(room temperature, 10$0^{\circ}C$, 20$0^{\circ}C$ under vacuum) and annealing temperatures(400 $^{\circ}C$, 600 $^{\circ}C$ for 30 min after the deposition). We found that these adhesion was increased in order of slide glass, sapphire, and alumina. The adhesion of the Cu thin films on alumina was high value about 4 times, compared with that of the Cu thin films on slide glass. We found that these resistivities were decreased with increasing substrate temperature and thin film thickness. The resistivity(2.05 $\mu$Ω\ulcornercm) of the Cu thin films with 6000 $\AA$ thickness at 200 $^{\circ}C$ on the slide glass was low value, compared with that of aluminum(2.66 $\mu$Ω\ulcornercm).