• Journal of the Korean institute of surface engineering
• /
• v.56 no.4
• /
• pp.265-272
• /
• 2023

Photoelectrochemical (PEC) water splitting is one of the promising methods for hydrogen production by solar energy. Iron oxide has been effectively investigated as a photoelectrode material for PEC water splitting due to its intrinsic property such as short minority carrier diffusion length. However, iron oxide has a low PEC efficiency owing to a high recombination rate between photoexcited electrons and holes. In this study, we synthesized nanoporous structured iron oxide by anodization to overcome the drawbacks and to increase surface area. The anodized iron oxide was annealed in Ar atmosphere with different purging times. In conclusion, the highest current density of 0.032 mA/cm² at 1.23 V vs. RHE was obtained with 60 s of pursing for iron oxide(Fe-60), which was 3 times higher in photocurrent density compared to iron oxide annealed with 600 s of pursing(Fe-600). The resistances and donor densities were also evaluated for all the anodized iron oxide by electrochemical impedance spectra and Mott-Schottky plot analysis.

• Economic Analysis
• /
• v.17 no.1
• /
• pp.103-130
• /
• 2011

This paper intends to provide applied economists which study the effects of research and development with valuable information on econometric model selection. It includes extensive discussion on econometric models which have been applied for the study on the relationship between research and development and productivity. In particular, it compares various stochastic production frontier models which have been developed recently. The discussion decomposes them into models with scaling property and the ones with nonscaling property as well as models with monotonic and nonmonotonic relationships between research and development and productivity. Finally, this paper applies the models to two different panel data sets (firm level data and country level data) and compare estimation results from competing econometric models.

• Plant Journal
• /
• v.9 no.3
• /
• pp.43-47
• /
• 2013

Even if an expert who has majored energy engineering, it is a difficult concept to understand power output optimization and power efficiency optimization. In this study a diagram applying thermodynamic state value as specific exergy and exergy ratio was developed. Although general peoples who did not major energy engineering can be easily understand the concept of power output optimization and power efficiency through the developed diagram. A represented property that can identify the performance of power plant is the main steam temperature and pressure. At the developed diagram the maximum power output line and maximum power efficiency line are shown according to the temperature and pressure of main steam. Therefore we can identify how much a power plant approach to maximum power output and maximum power efficiency.

• Journal of the Korea Convergence Society
• /
• v.8 no.11
• /
• pp.7-13
• /
• 2017

In recent years, cloud computing technology has been socially emerged that provides services remotely as various devices are used. However, there are increasing attempts by some users to provide cloud computing services with malicious intent. In this paper, we propose a property - based multi - level hierarchical approach to facilitate authentication access for users accessing servers in cloud environment. The proposed method improves the security efficiency as well as the server efficiency by hierarchically distributing a set of attribute values by replacing the order of the user 's attribute values in the form of bits according to a certain rule. In the performance evaluation, the proposed method shows that the accuracy of authentication according to the number of attributes is higher than that of the existing method by an average of 15.8% or more, and the authentication delay time of the server is decreased by 10.7% on average. As the number of attributes increases, the average overhead change is 8.5% lower than that of the conventional method.

• Transactions of the Korean Society of Mechanical Engineers A
• /
• v.35 no.5
• /
• pp.555-559
• /
• 2011

Oil hydraulic piston pumps are extensively used worldwide because of their simple design, light weight, and cost effectiveness. However, an oil hydraulic pump is likely to have high leakage, friction, and low energy efficiency after long-term use. In oil hydraulic piston pumps the clearance between the valve block and the piston plays an important role in the volumetric and overall efficiency. We studied the wear property of the SACM645 material used in hydraulic piston pumps via experiments with different heat treatments. We prepared three different specimens. The maximum tensile strengths of the QT and QT-nitration specimens are similar (about 820 MPa), but the strains are significantly different. However, the fatigue characteristic depended on the heat treatment.

• Membrane Journal
• /
• v.22 no.1
• /
• pp.54-61
• /
• 2012

To separate and recover of VOCs, supporting membranes using PEI were prepared by phase separation method and it was coated with PDMS to prepare PEI-PDMS hollow composite membrane. To investigate characteristic of prepared membrane, pure gas permeability was measured using oxygen and nitrogen, the stage cut and permeance property with feed concentration were evaluated using xylene, ethyl benzene, toluene and cyclohexane. Also, to check solvent resistance on VOCs, stress-strain property of membrane with immersion time in solvent were measured by DMA. The permeance value of $O_2$ and $N_2$ showed 63 GPU and 30 GPU respectively. Permeated VOCs concentration was decreased with increasing stage cut. But, conversely, recovery efficiency that was increased with increasing stage cut. As a result of DMA test, the stress and strain were 11.93 MPa and 13.52%, respectively.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.9 no.1
• /
• pp.93-99
• /
• 2008

In this paper, we propose new modulation schemes using the conventional CACB modulation with constant amplitude property. Also the proposed modulation schemes supports high transmission data rate by increasing the spectral efficiency. In order to obtain the high spectral efficiency, the $Q^2$PSK and CA-$Q^2$PSK are used. We explain the simplest combining modulation scheme of CACB and $Q^2$PSK (i.e., CACB-$Q^2$PSK). However, this modulation scheme cannot support the constant amplitude property. Hence the first CACB-CA-$Q^2$PSK (or CACB-CA-$Q^2$PSK I) modulation scheme is proposed for the constant amplitude property. In the modulation scheme, the redundant constant amplitude encoding (spectral efficiency decrease) is required. Therefore, the second CACB-CA-$Q^2$PSK (or CACB-CA-$Q^2$PSK II) modulation scheme is proposed retaining the constant amplitude and the spectral efficiency. Computer simulations show that the proposed CACB-CA-$Q^2$PSK II is the efficient modulation scheme.

• Journal of Korean Society for Atmospheric Environment
• /
• v.16 no.E
• /
• pp.59-68
• /
• 2000

In this paper Various aerosol cyclones that are developed recently form Kwangju Institute of Science and Technology(KJIST) for increasing collection efficiency or for decreasing pressure drop are reviewed. For the first time, new sets of experimental data are reported on the particle collection efficiency of cyclones with modified surface bodies namely, spiral guide body, circumferential groove body, and vertical groove body. Multi-cylinder cyclones by adding one or two additional cylindrical walls into the conventional cyclone are also described. Ad an attempt to increase the collection efficiency of small particles, electrocyclone using an externally applied electric field was designed and operated. In addition, factors affecting the cyclone performance were studied including flowrate, body and outlet sizes, cyclone dust outlet, and gas property.

• Textile Coloration and Finishing
• /
• v.16 no.4
• /
• pp.19-25
• /
• 2004

Both poly(vinyl alcohol)$(PVA)-I_2$ and PVA-dye polarizing film were prepared using PVA with number-average degree of polymerization of 1,700, 2,300, 2,600. The optical property of used dye in this study closed to the that of iodine. The PVA-dye polarizing film was prepared through the dyeing process. In comparison of the result of the measurement of the heat and humidity resistance of two types polarizing films, it of PVA-dye polarizing film was higher than that of a conventional $PVA-I_2$polarizing film. The transmittance and the polarization efficiency of PVA-dye polarizing film was significantly influenced by dye concentration, dipping time, salt concentration, and temperature of dye bath. The PVA-dye polarizing film exhibited a high polarization efficiency of 99.3% and a good transmittance of 42.4%.

• Journal of Korea Society of Digital Industry and Information Management
• /
• v.5 no.3
• /
• pp.59-67
• /
• 2009

This paper proposes a improved bitmap routing protocol, which finds the best energy efficient routing path by minimizing the network overheads and prolongs the overall network lifetime. Jung proposed a bitmap scheme for sensor networks. His scheme uses a bitmap table to represent the connection information between nodes. However, it has a problem that the table size is depends on the number of nodes in the sensor networks. The problem is very serious in the sensor node with a limited memory. Thereby, this paper proposes a improved bitmap routing protocol to solve the problem in Jung's scheme. Proposed protocol over the memory restricted sensor network could optimize the size of bitmap table by applying the deployed network property. Proposed protocol could be used in the diversity of sensor networks due to it has minimum memory overheads.