• Journal of the Korean Home Economics Association
• /
• v.39 no.4
• /
• pp.49-59
• /
• 2001

Natural red and yellow dyestuff was extracted from safflower (Carthamus tinctorius Linnaeus) by a new process of cellulase extraction compared with the conventional hot water extraction. Dyestuffs were extracted from safflower easily and repeatedly by means of cellulose as safflower cell wall destroyer. It means that new dyestuff extraction by cellulase improves not only yields of dyestuff from safflower successfully but also the rate of repetition of extraction. From the above experiments, the conclusions of this study were summarized as follows. 1. The optimum conditions of dyestuff extraction from safflower by general extraction method were that the solvent was the water of pH 6.0 on yellow dyestuff and 3% $K_2CO_3$ solution on red dyestuff, extraction temperature was $55^{\circ}C$, and extraction time was 30 min. 2. Among various cellulase, the NOVO cellulase was the best cell wall destroyer of safflower and finally produced the largest amount of dyestuff from safflower by cellulase extraction method. 3. The optimum conditions of dyestuff extraction by cellulase extraction method were conducted on 10 unit of cellulase per gram of safflower at $100m{\ell}$ water of pH 5.0 at $50^{\circ}C$ for 30 min.

• YAKHAK HOEJI
• /
• v.3 no.1
• /
• pp.26-34
• /
• 1957

The solar evaporation method is one of the most important and popular salt manufecturing method in Korea. The rate of evaporation of sea water depends on a complex climate factors. Of these factors, the most important is solar radiation and in particular the extent to which it is absorbed in the brine. By the addition of suitable dyestuff, a further increase in absorption is obtained and can result in all the radiation entering the brine being made available as heat. "Solivap Green", one of several dyestuffs which have been suggested for accelerating solar evaporation, was tested in this experiment. The results of the experiment. 1. Increase the evaporation rate of brine up to 20-25%. 2. Elevate the temperature of brine 2-$4^{\circ}C$. higher than that of brine adding no dyestuff. 3. Optimum dyestuff concentration is 25-30 mg/L and allowable maximum concentration can not exceeded 1000 mg/$m^2$ (50 mg/L). 4. Addition of dyestuff does not cause the degradation of salt produced. 5. A conversion table which indicates the concentrations for various depths of brine was prepared for engineering purpose. 6. Absorption spectrum of the dyestuff was studies, but toxicological and structural studies for the dyestuff have not been done in this experiment.

• Proceedings of the Korean Society of Dyers and Finishers Conference
• /
• 2004.04a
• /
• pp.199-203
• /
• 2004

The azo red pigments for textile printing containing amino-N-substituted benzamide derivatives as diazo components and 2-hydroxy-3-naphthoyl derivatives as coupling components were prepared. They have been printed on cotton, and the fastness, such as light, washing, dry cleaning, rubbing and heat stability was estimated. The new azo red pigments were valuable colorants in case of textile printing.

• Applied Chemistry for Engineering
• /
• v.33 no.6
• /
• pp.606-612
• /
• 2022

The purpose of this study is to convert hydrophobic dyestuff to hydrophilic dyestuff by reacting cationic collector with anionic dyestuff and reaction anionic collector with cationic dyestuff. The removal of colors from aqueous solutions and/or dispersions has been studied by dispersed-air flotation in a batch column. In this studies used generated micro bubble by ceramic gas diffuser having micro pore size for air flotation process. In this study, a ceramic gas diffuser with micro pore size was used to generate micro bubbles for the air flotation process. Two colours were used for the experiments: Basic Yellow 1 (cationic dyestuff) and Direct Orange 10 (anionic dyestuff). All two were effectively removed by flotation within 8 mins. Sodium dodecyl sulfate, sodium oleate (an anionic collector), and amines (a cationic collector) were found to be effective as collectors in the removal of color, which was found to be related to the pH of the solution and the amount of collector added to it, with high collector dosages causing the process to become pH-independent.

• Proceedings of the Korean Society of Dyers and Finishers Conference
• /
• 2004.11a
• /
• pp.274-275
• /
• 2004

The majority of dyes belong to the chromophoric class known as donor-acceptor systems, the essential structural feature of such systems being the presence of one or more electron donating groups conjugated to one or more electron withdrawing groups via an unsaturated bridge. The indigo molecule may be formally divided into two identical electron donor/acceptor subsystems, each containing an add number of pi electrons, two subsystems being joined by carbon-carbon double bond. Indigoid type dyes which show a strong colour change on protonation or dissociation have many potential functional applications, for example as analytical pH indicators, solvent polarity indicators, and in various imaging and reprographic systems.

• Fashion & Textile Research Journal
• /
• v.15 no.3
• /
• pp.467-476
• /
• 2013

This study investigates the dyeability and the fastness of flame retardant polyester fabric developed by a thermal bonding with a low melting component of flame retardant bicomponent filament (LMFRPC). The fabrics were prepared with flame retardant polyester filaments (FRP) as warp and blended filaments of FRP and LMFRPC as weft. The LMFRPC have a sheath and a core where the core comprises a flame retardant polyester and the sheath comprises a thermoplastic polyester with a low-melting point. The thermal bonding of fabric was conducted in a pin tenter at $170^{\circ}C$ for 60 seconds. Fabric dyeing was conducted with an infrared dyeing machine at various dyeing temperatures and dyeing times. The dyestuffs used in this study were CI disperse Yellow 54, Red 60 and Blue 56 of E-type dyestuff and Orange 30, Red 167 and Blue 79 of S-type dyestuff. This study investigated the morphology of thermal bonded fabric, dyeability and fastness of dyed fabric. Dyeability increased with an increased dyeing temperature. The thermal bonded area increased with the increased LMFRPC content. The dyeability of S-type dyestuff was higher than E-type dyestuff; in addition, the saturated dyeing time was about 20minutes at $130^{\circ}C$ for E and S-type dyestuff. The fastness to washing and rubbing were excellent at a 4-5 Grade.

• Journal of the Korean Society of Fashion and Beauty
• /
• v.4 no.2 s.8
• /
• pp.31-41
• /
• 2006

As chemistry dyes has considerably developed with industrial society, natural dyeing has gone out of people's head for a long time. But the serious problems from environmental pollutions and ecological damages make people look far Well-being. Natural dyeing also has concentrated again and the interests about it are growing larger and larger. Well-being that a modern person pursues and a Natural dyeing walk along a same string of connection. That is, people want their life to change from quantity matters into qualities. The relations of the natural dying which has the color of nature and Well-being phenomenons are analyzed through dissertations and references. The study about the correlations between natural dying and well-being shows that many advantages of natural dyestuff and the effects of dyestuff are definitely needed to people living in modern times. Also for the protection of an ecosystem, rapid popularization and the development of new design is completely required.

• Journal of the Korean Society of Clothing and Textiles
• /
• v.22 no.8
• /
• pp.1011-1019
• /
• 1998

The natural dyestuff(squid ink) was manufactured from squid ink by boiling in 0.1% NaOH solution and powdering in freeze dryer. Cotton, wool, silk and nylon fabrics were dyed under several conditions using the manufactured squid ink to investigate the dyeability and color fastness. Dyeing was operated in acidic dyebath of pH 4 because the squid ink is anionic. Dyeabilities on wool, silk and nylon fabrics were good, especially silk fabrics were dyed deeper than others because of being amine group. But dyeability on cotton fabrics was low and developed with chitosan treatment. All the dyed fabrics showed excellent in color fastness to crocking and laundering. Also light fastness of them were excellent except nylon. The light fastness of dyed-nylon fabrics was as poor as grade 1, but they could be improved to grade 4 by aftertreatment with gallicacid. Useing the natural dyestuff-squid ink powder, we could execute whenever we want to dye fabrics in the adequate concentration. Dyeabilities were developed according to repeating times of dyeing and the increased dye concentration. We could recycle the wasting sources.

• Clean Technology
• /
• v.15 no.2
• /
• pp.91-101
• /
• 2009

The metal complex dyes that are mainly used for good color fastness in dyeing amide fibers with highly concentrated colors usually contain toxic chromium. The remaining dye in th dyebath containing $Cr^{6+}$ causes not only environmental problems but also serious damages to human health. In this study, we applied reactive dyestuff for dyeing wool and nylon in order to substitute heavy metal dyestuff. The dyeing properties of reactive dyestuff in fibers as well as their absorption rates and fastness according to color concentration were investigated. By analyzing the quantity of heavy metals and toxic amine of reactive dyestuff, we investigated their harmfulness trends quantitatively. By comparing the reactive dyes with traditional metal complex dyes, we tried to find out the possibility of the reactive dye being a clean dyes in the future.

• Proceedings of the Korean Society of Dyers and Finishers Conference
• /
• 2007.11a
• /
• pp.139-140
• /
• 2007