• The Research Journal of the Costume Culture
• /
• v.22 no.2
• /
• pp.339-345
• /
• 2014

This study analyzes and compares Hanji made with loess to Hanji made with kaolin, two yellow-based inorganic pigments, in terms of its physical properties, optical properties, and color fastness to light with the aim of using it as a fashion material. Hanji made by adding inorganic pigments showed an approximately 20% retention ratio on average. This figure was similar to those of loess and kaolin. Physical properties were analyzed, with the following results. A higher amount of additives lowered the apparent density and increased thickness and bulk. In general, inorganic pigment-added Hanji had lower tensile strength, bursting strength, and folding endurance compared to non-additive Hanji. The analysis of optical properties showed a lower brightness index for Hanji made with inorganic pigments compared to non-additive Hanji. When comparing the two inorganic pigments, the brightness of Hanji made with kaolin was higher. Regarding color fastness to light, loess showed level 4 and kaolin showed level 5 when 25% inorganic pigments on pulp were added to Hanji. Thus, Hanji made by adding inorganic pigments during the manufacturing process may perform well as materials for fashion because the additives enhanced both the color fastness to light and the bulk while maintaining the strength. In addition, Hanji dyed with inorganic pigments may have the potential to serve as materials for the fashion industry while still retaining the characteristics of Hanji.

• Journal of Fashion Business
• /
• v.20 no.4
• /
• pp.128-140
• /
• 2016

In this study, dyeability of Urtica Dioica L. extract, which is relatively less studied, was measured. The extract of this plant was used to dye cellulose and protein fiber to check its usage as a natural green dye. Three different methods were used to produce extract. Dried Urtica Dioica L. was extracted with 100% ethanol, 50% ethanol with 50% distilled water and 100% distilled water. Then dyeing solution was obtained by blending with distilled water at 1-to-1 ratio. The maximum dyeability was obtained when 100% ethanol extract of dried Urtica Dioica L. used to dye fabrics at 60 degrees celsius for 60 minutes without mordant treatment. Cotton, rayon, wool and silk were dyed and dyeability for each fiber was measured for color difference value then compared to its control. The results show that dyeability of rayon and dyeability of wool are stronger, and that when color position for each mordant is measured, color difference is most diverse on cotton with pre-mordant treatment. Color fastness to wash, perspiration and rubbing crockmeter were superb, but color fastness to light was low, therefore, additional study on this is needed to improve. Urtica Dioica L. is now expected to be used practically as green color dye as well as medicinally and edible.

• Journal of the Korea Fashion and Costume Design Association
• /
• v.24 no.3
• /
• pp.63-71
• /
• 2022

This paper aims to compare and verify the antibacterial effects of cotton fabrics naturally dyed with extracts of Ulmus davidiana var. japonica Nakai, Caesalpinia sappan, Saururus chinensis, and Artemisia princeps against antibiotic-resistant strains of bacteria. After natural dyeing of the test fabric, Al, Cu, Fe mordants were used. The color fastness against washing, rubbing, and perspiration of the cotton fabrics dyed with the 4 types of extracts were mostly excellent. However, the color fastness against light showed poor results for all four types. As for the antibacterial test method, MRSA (ATCC 33591) was applied to the cotton fabrics dyed with the four kinds of extracts and cultured for 24 hours. After that, the bacteria that proliferated on the fabrics were collected and spread on a solid medium. The bacteria were measured to find out the bacteriostatic reduction rate for the antibiotic-resistant strains. As a result of the analysis, all four extracts showed a high bacteriostatic reduction rate of more than 99% when the copper mordant was used. Even with the lack of a mordant, the bacteriostatic reduction rate was high, at 99.9% for Caesalpinia sappan and 94.6% for Saururus chinensis.

• Textile Coloration and Finishing
• /
• v.3 no.2
• /
• pp.16-24
• /
• 1991

The textile fabric have the functions of sanitation, decoration, wearing style and washing in the practical use. Among various texitle fiber, silk has less utilities than synthetic fiber in practical use although silk has good benefits of the high quality. Thus no textile fiber, neither natural nor synthetic, has all the functions. In this sence, many blend yarns have been improved various functions of fabric. However, this has been disturbed with the problem of dyeing, especially in the case of blend fabric of silk. In this study, we dyed silk/PET blend fabric in one step useing one bath dyeing method by acid dyes/disperse dyes. The results of the experiments can be summarized as follows; 1) Yellow index of silk fabric treated at $130^{\circ}C$ increased about 7.8 (color difference 4.5 NBS) and whiteness decrease about 5%. 2) Both elongation and tensile strength of silk fabric treated at $130^{\circ}C$ of pH 5-6 decreased about 10% and tensile strength of silk spun yarn treated at $60^{\circ}C$ of pH 10 have little changed. 3) While silk/PET blend frbric dyeing, silk soiling of disperse dyes causes from difference of dyeing rate and degree of silk soiling with dyes. 4) Fastness and soiling of silk/PET blend fabric dyed by one bath dyeing method of acid dyes/disperse dyes was same as two bath dyeing method.

• Journal of the Korean Society of Clothing and Textiles
• /
• v.35 no.2
• /
• pp.218-229
• /
• 2011

Dyeing properties of cotton and ramie fabrics with pine needles colorants were studied by investigating the analysis of pine needles colorants, the effect of dyeing conditions (such as dye concentration, dyeing temperatures and times on dye uptakes), effect of mordants, and color change. The various colorfastness of dyed fabrics were evaluated for practical use; in addition, the antimicrobial ability, ultraviolet-cut ability, and deodorant ability were estimated. In the UV-Visible spectrum, the wavelength of the maximum absorption for pine needles extract was 285nm, and pine needles colorants produced a yellow color. From FT-IR and GC-MS results, it was assumed that chromophoric substance from pine needles extracts were mixed with flavonol tannin and flavanol tannin. An increased dyeing concentration resulted in a larger dye uptake and a Freundlich absorption isotherm was obtained. A larger dye uptake occurred as the dyeing time and temperature increased. Post-mordanting was more effective than pre-mordanting and the dye uptake of fabrics improved by mordanting. The colorfastness of dyed fabrics showed a low rating; however, colorfastness to washing and dry cleaning of cotton fabrics mordanted with N.Cu, and friction fastness of ramie fabric mordanted with Cu improved. The dyed fabrics showed very good antimicrobial abilities of 99.9%. In addition, the ultraviolet-cut ability and deodorant ability improved in fabrics dyed with pine needles extracts.

• Journal of the Korean Society of Clothing and Textiles
• /
• v.35 no.2
• /
• pp.206-217
• /
• 2011

The dyeing properties of cotton fabrics with bamboo colorants were studied by investigating the analysis of bamboo colorants, the effect of dyeing conditions (dye concentrations, dyeing temperatures and times on dye uptakes), effect of mordants, and color change. The various colorfastness of dyed fabrics were evaluated for practical use; in addition, the antimicrobial ability, ultraviolet-cut ability, and deodorant ability were also estimated. In the UV-Visible spectrum, the wavelength of the maximum absorption for bamboo stems and leaves extracts was found to be 280nm and 295nm, respectively; in addition, bamboo colorants produced a yellow color. From the FT-IR and GC-MS results, it was assumed that the chromophoric substance from bamboo extracts was composed of flavones substances with tricin. An increased dyeing concentration resulted in a larger dye uptake and a Freundlich absorption isotherm was obtained. A larger dye uptake occurred as the dyeing time and temperature increased. The post-mordanting was more effective than pre-mordanting. Mordants, Fe and N.Fe, were effective for an increased dye uptake. The color of fabrics mordanted with Cu and N.Cu changed to GY. Regardless of mordanting, the colorfastness on the washing of dyed fabrics showed a low rating compared to other fastness. Mordanting adversely affected the lightfastness of dyed fabric. The dyed fabric showed very good antimicrobial abilities of 99.9%. In addition, the ultraviolet-cut ability and deodorant ability improved in cotton fabric dyed with bamboo extracts.

• Proceedings of the Korean Society of Dyers and Finishers Conference
• /
• 2008.04a
• /
• pp.117-119
• /
• 2008

This study was investigated for the dyeing properties of silk fabrics with Annatto Extract. The dye stuff was extracted by distilled water at 60$^{\circ}C$, 10minutes, 100:1 of bath ratio. The highest K/S value was showed at 25% dye concentration, 60minutes of dyed time at 50$^{\circ}C$ in the temperature. The post mordant conditions were better than that of pre mordant, especially post-Fe mordant showed highest K/S value. The laundering fastness was relatively good by Cu-mordant. Drying cleaning fastness appeared 4-5 grades.

• Textile Coloration and Finishing
• /
• v.7 no.3
• /
• pp.1-10
• /
• 1995

The optical behavior of coloring matter extracted from onion's coats, the depression effects of destruction, yellowing and W transmittance of silk treated with color solution of onion's coats color difference of silk fabrics dyed with acid dyes and drycleaning fastness of silk treated with color solution has been investigated. The results are as follows : 1) The coloring matter extracted from onion's coats by alkali-acid method appeared properties of aglycon type. 2) &{\lambda}_{max}&of color solution extracted by distilled water was found at 280 and 327nm. 3) The decrease of tensile strength and the elongation of the silk treated with color solution were depressed but those of untreated silk were increased by irradiation of UV light. 4) The yellowness index of silk treated with color solution showed a little change by irradiation. 5) The UV transmittance of silk treated with color solution was decreased as increasing concentration of color solution. 6) The color difference after dyeing with several acid dyes on treated and untreated silk fabrics showed remarkable changes. 7) Drycleaning fastness of silk treated by color solution was excellent.

• Textile Coloration and Finishing
• /
• v.22 no.1
• /
• pp.1-7
• /
• 2010

The five new red disperse dyes for unmodified pure polypropylene fibers were synthesized. As a coupling component, a di-n-hexyl substituent was used in common, while various substituents were used for the diazo component. The dye having electron donating group at diazo component showed hypsochromic shift compared to the unsubstituted dye, while the dyes having electron withdrawing groups showed bathochromic shift. Owing to their extreme hydrophobicity caused by the di-n-hexyl substituent, all dyes exhibited very high affinity toward pure polypropylene fibers. Fastness to washing was very good for all dyes and fastness to light was good except two purplish red dyes.

• Proceedings of the Korean Society of Dyers and Finishers Conference
• /
• 2009.11a
• /
• pp.79-80
• /
• 2009

Aramid fabrics were photooxidized by UV/$O_3$ irradiation. The UV irradiation caused the oxygen content of the aramid fabric surface to increase and reduced the surface zeta potential, coupled with improved water wettability. The modified aramid fabrics showed higher affinity to cationic dyes which may be resultd from the newly introduced electrostatic interaction between cationic dyes and anionic dyeing sites on the photooxidized surface layers. Although color fastness to both staining and rubbing were good to excellent, color fastness to shade change was moderate.