• Proceedings of the IEEK Conference
• /
• 2003.11c
• /
• pp.64-67
• /
• 2003

This paper presents the design of dual-band VCO using PBG structure for IEEE 802.11A/B. By adding switch circuit to the single-band VCO, we could achieve a dual-band VCO. The center frequencies of dual-band VCO are 5.93GHz(-13dBm) and 2.37GHz (3.50dBm). The phase noise is improved about l0dB by using PBG Structure.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.13 no.1
• /
• pp.60-67
• /
• 2002

In this paper, the dual band VCO of mobile communication terminal using oscillation part switching circuit is proposed. In order to model the VCO accurately, the resonator is converted the equivalent circuit which is analyzed to use numerical method and designed optimal the dual band VCO operating GSM and DCS band. In order to demonstrate the objective theory of the proposed VCO, the dual band VCO is designed and experimented. The results of experiment, it is conformed that the VCO can be used mobile communication hand phone and components of three generation mobile communication systems.

• JSTS:Journal of Semiconductor Technology and Science
• /
• v.9 no.4
• /
• pp.192-197
• /
• 2009

This paper presents the design and measurement of a 2.4/5.2-GHz dual band VCO with a balanced frequency doubler in $0.18\;{\mu}m$ CMOS process. The topology of a 2.4 GHz VCO is a cross-coupled VCO with a LC tank and the frequency of the VCO is doubled by a frequency balanced doubler for a 5.2 GHz VCO. The gate bias matching network for class B operation in the balanced doubler is adopted to obtain as much power at 2nd harmonic output as possible. The average output powers of the 2.4 GHz and 5.2 GHz VCOs are -12 dBm and -13 dBm, respectively, the doubled VCO has fundamental harmonic suppression of -25 dB. The measured phase noises at 5 MHz frequency offset are -123 dBc /Hz from 2.6 GHz and -118 dBc /Hz from 5.1 GHz. The total size of the dual band VCO is $1.0\;mm{\times}0.9\;mm$ including pads.

• Journal of the Korean Institute of Illuminating and Electrical Installation Engineers
• /
• v.22 no.6
• /
• pp.116-126
• /
• 2008

This paper describes the Dual-band WLAN transmitter with 2.4[GHz], 5[GHz]. Dual-band WLAN transmitter was designed at 2.4[GHz] and 5[GHz]. The Dual-band WLAN transmitter has a amplifier which operate at 2.4[GHz] and 5[GHz] frequency and two VCO(Voltage Controlled Oscillator) or VCO has a wide scope of frequency. these problem cause a size and a power consumption, The Dual-band WLAN transmitter module was proposed to solve these. the transmitter was designed to get output signals of IEEE 802.11a's 5.8[GHz] band signal using frequency multiplication way or to act a amplifier about the 2.4[GHz] band signal of IEEE 802.11b/g, according to inputed frequency and bias voltage that a eve using single transmission block. The output spectrum get the improved specification of ACPR of 4[dB], 6[dB], 16[dB] at +11[MHz], +20[MHz], +30[MHz] offset of center frequency compared to no linearization, was satisfied to transmit spectrum mask of IEEE 802.11a wireless Lan.

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.41 no.2
• /
• pp.53-58
• /
• 2004

In this paper, the low-phase dual-band VCO, by adding switching circuit with PIN diode at feedback loop of the oscillation part having negative-resistance, is realized. In order to reduce the phase noise of the VCO, PBG structure applied to the ground plane of the resonator. When applying for PBG structure, output power is -9.17㏈m and phase noise is -102㏈c/Hz at 5.25㎓, output power is -5.17㏈m and phase noise is -101㏈c/Hz at 1.8㎓, respectively.

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.41 no.10
• /
• pp.79-86
• /
• 2004

This paper proposes a dual band Voltage Controlled Oscillator(VCO) with a standard 0.3${\mu}{\textrm}{m}$ CMOS process to generate 1.07GHz and 2.07GHz. The proposed VCO architecture with 50% duty cycle circuit and a half adder(HA) was capable of producing a frequency two times higher than that of the conventional VCOs. The measurement results demonstrate that the gain of VCO and power dissipation are 561MHz/V and 14.6mW, respectively. The phase noises of the dual band VCO are measured to be -102.55dBc/Hz and -95.88dBc/Hz at 2MHz offset from 1.07GHz and 2.07GHz, respectively.

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.44 no.12
• /
• pp.16-21
• /
• 2007

In this paper, the dual-band voltage-controled oscillator (VCO) using the composite right/left-handed (CRLH) transmission line (TL) and the tunable negative resistance based on the fin diode is presented. It is demonstrated that the CRLH TL can lead to metamaterial transmission line with the dual-band tuning capability. The dual-band operation of the CRLH TL is achieved by the frequency offset and the phase slope of the CRLH TL, and the frequency ratio of the two operating frequencies can be a non-integer. Each frequency band of VCO has to operate independently, so we have used the tunable negative resistance based on the pin diode. When the forward bias has been into the pin diode, the phase noise of VCO is $-108.34\sim-106.67$ dBc/Hz @ 100 kHz in the tuning range, $2.423\sim2.597$ GHz, whereas when the reverse bias has been fed into the pin diode, that of VCO is $-114.16\sim-113.33$ dBc/Hz @ 100 kHz in the tuning range, $5.137\sim5.354$ GHz.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.11 no.4
• /
• pp.634-641
• /
• 2000

A switchable VCO for DECT handset is designed and fabricated. In dual mode radios, a single VCO is desired to operate at two different frequencies to meet the requirement of two mode(Tx, Rx). The three design types of switchable VCO are switched resonator VCO, switched mode VCO and dual band VCO. In this paper, we use the switched resonator VCO type using pin diode switch to change the total amount of capacitance in the tank circuit. At the bias condition of 3 V and 13mA, the output power and phase noise are better than6.5dBm and -104dBc/Hz at 25khz offset from the carrier, respectively , across the operating frequency range. From these results, the fabricated switched VCO is applicable to the DECT handset.

• Proceedings of the IEEK Conference
• /
• 2005.11a
• /
• pp.277-280
• /
• 2005

In this paper, we propose a frequency synthesizer for dualband repeater. The dual-band RF technology for applications to the wireless repeater for CDMA and WCDMA mobile communications has been developed in this paper. The dualband PLL module consisted of dual-band VCO and one PLL IC has been developed. The main technological efforts for the dual-band PLL module is to suppress the intermodulation distortion by applying the miniature ceramic filter using the slow wave characteristics. The dual-band miniature RF module including dual-band PLL module and one MCU controller is very attractive for applications to the miniature dual-band RF mobile repeaters.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.23 no.2
• /
• pp.207-212
• /
• 2012

In this work, a 70/140 GHz dual-band push-push voltage controlled oscillator(VCO) has been developed based on a 0.18-${\mu}m$ SiGe BiCMOS technology. The lower band and the upper band oscillation frequency varied from 67.9 GHz to 76.9 GHz and from 134.3 GHz to 154.5 GHz, respectively, with tuning voltage swept from 0.2 to 2 V. The calibrated maximum output power for each band was -0.55 dBm and -15.45 dBm. The VCO draws DC current of 18 mA from 4 V supply.