• 한국토양비료학회지
• /
• 제35권6호
• /
• pp.335-343
• /
• 2002

우리나라 유통상토에 대한 물리적 표준분석법을 설정하기 위한 연구를 실시하였다. 국내 시중에 유통되고 있는 53개의 원예용 상토와 9개의 수도용 상토를 대상으로 설정된 분석법을적용하여 실험하였다. 수분함량은 $105^{\circ}C$ 건조기에서 16시간 건조하여 수도용상토는 (건조전 무게-건조 후 무게) / (건조 후 무게) ${\times}100$으로, 원예용상토는 (건조 전 무게 - 건조 후 무게 ) / (건조전 무게) ${\times}100$ 으로 하였다. 보수력은 주로 저 압용으로서 Eijkelkamp사의 Sandbox법을 사용하여 0.5, 1, 3, 5, 7, 10 kPa의 수분장력 상태의 수분함량을 조사하였다. 포화수리전도도는 직경 5cm${\times}$높이 20cm인 아크릴 원통을 이용하여 정수위별에 의한 포화수리전도도를 측정하였다. 신분석법에 의한 유통상토의 수분함량은 원예용이 평균 46.34%, 수도용이 평균 16.89%이었고 원에용 상토의 EAW는 28.4%, WBC 7.01%, OMP는 5.60 kPa로 나타났으며, 육묘를 위한 적정 수분함량은 44.41% 이었고 포화수리전도도는 $1.71cm\;min^{-1}$이었다.

• 한국대기환경학회지
• /
• 제20권3호
• /
• pp.421-426
• /
• 2004

Dry deposition fluxes of inorganic acidic species to the waterbody were measured by the dry deposition sampler (DDS). DDS was composed of three pans filled with pure water. An average concentration increase during the sampling time, after removing an abnormal value if existed, was considered as the input by deposition. Important operation parameters such as the amount of water used and sampling time were determined through a series of laboratory experiments. The deposition flux measured by DDS was compared with that by the water surface sampler developed by Yi et ai. (1997a,b).

• 한국물환경학회지
• /
• 제23권6호
• /
• pp.889-896
• /
• 2007

From the direct outflow of Chungju Dam to the junction of water body and watershed in Paldang lake is the scope of this research. This study performed to investigate the main cause of water quality deterioration and the influenced region in the middle field range of the Namhan river Basin with the onsite measurement of water quality and flow rate simultaneously during spring dry season. The purpose of this study is to find out the time-spatial variation characteristics of water quality and flow rate. Following the flow direction $BOD_5$ and $COD_{Mn}$ concentration increased to the highest value of 3.7 mg/L, 5.9 mg/L at Wolgesa respectively. Chl.a concentration increased to $50mg/m^3$ or so at Kangsang, after that it decreased to $37mg/m^3$ at the junction of Paldang lake. Organic matter concentration variation trend showed similar than that of Chl.a. Also $BOD_5$ concentration tendency was similar to Chl.a in every measuring sites except Paldang lake mixing zone. The major factors of water quality deterioration in Namhan river and Paldang lake during dry season were algal bloom and followed internal production. High phosphorus load from Dalcheon and Seom river caused dry season algal bloom and internal production in transitional zone which was stagnant area in downstream of Namhan river.

• Tribology and Lubricants
• /
• 제35권6호
• /
• pp.396-402
• /
• 2019

Materials made from plastics are increasingly utilized in constructing greenhouses and setting up shield structures. Polyester fabrics have a wide range of use in horticulture and other fields of agriculture. They are utilized as a greenhouse cover and also help in combating intense climate variation in the field. Over time, these fabrics may experience friction against other surfaces. Owing to this, the surface framework of the material degenerates. This study examines the frictional characteristics of aluminized polyester fabric in both dry- and water-lubricated environments under changing applied loads and sliding speeds. Friction experiments are performed at room temperature by employing a pin on a disk. The experiments reveal that the friction coefficient decreases with increase in applied load in both dry sliding and water-lubricated environment. However, the friction coefficient decreases more under the water-lubricated setting than in the dry state. At the maximum applied load, the highest friction coefficient is discovered in the dry state with a range of 0.282 to 0.237, whereas a friction coefficient of 0.229 to 0.189 is observed in the water-lubricated state. Additionally, it is observed that the friction coefficient increases with an increase in sliding speed under both experimental environments. The examination of specimen surfaces reveals that the abrasion is minor in the water-lubricated setting compared with that in the dry state.

• Membrane and Water Treatment
• /
• 제4권3호
• /
• pp.215-222
• /
• 2013

The maximum current density that can be achieved in bipolar membrane electrodialysis is limited by the sharp increase in resistance that is experienced when the water content at the membrane interface is not adequately replenished and the membranes dry out. In this paper we show how the water content near the interface depends on the properties of the membranes. A water retaining parameter is introduced, which characterizes the thermodynamic properties of the membrane material and may be used to guide the choice of polymers for mitigation of the dry-out problem.

• 한국농공학회:학술대회논문집
• /
• 한국농공학회 2005년도 학술발표논문집
• /
• pp.97-101
• /
• 2005

High strength concretes utilizing EVA with micro particles were prepared by varying polymer/binder mass ratio and curing conditions with a constant water/binder mass ratio of 0.3. The EVA modified concretes on the compressive and flexural strength, microstructure, ultrapulse modulus in curing condition(dry and water curing) were studied. Also, scanning electron microscope analysis(SEM) was performed to reveal the presence of polymer film and cement hydrates in the concrete. The compressive strength of the EVA modified concretes cured at water conditions ere higher than that of the EVA modified concretes cured at dry conditions. But, the flexural strength of the specimens cured at dry conditions were higher than that of the specimens cured at water conditions. Due to the interaction of the cement hydrates and polymer film, an interpenetrating network originated in which the aggregates were embedded. The curing of the polymer modified concrete involves two step of cement hydrates and polymer modification, and cement hydrates was promoted in water conditions and polymer film formation take place when water evaporates and was thereby was favored in dry conditions. By SEM analysis, influences of polymer modification was strengthening of the transition zone between the aggregate and the paste, and the porosity of transition zone decreases. By spring analysis, it could known that polymer film affects in porosity decrease and strengthening of transition zone.

• 한국축산식품학회지
• /
• 제38권5호
• /
• pp.950-958
• /
• 2018

The physicochemical characteristics and oxidative stability of wet-aged and dry-aged pork cuts were investigated at different aging periods (1, 7, 14 and 21 d). Samples were assigned into four groups in terms of shoulder blade-wet aging (SW), shoulder blade-dry aging (SD), belly-wet aging (BW), and belly-dry aging (BD). SD showed significantly higher pH at 21 d of aging than the other samples. Wet-aged cuts had significantly higher released water (RW) %, lightness ($L^*$) and shear force compared to the dry-aged meats. Sodium dodecyl sulfate-polyacrylamide gel electrophoresis (SDS-PAGE) analysis showed greater degradation of proteins for dry-aged cuts than the wet-aged cuts. At the end of aging, wet-aged cuts showed significantly lower thiobarbituric acid-reactive substances (TBARS) value than the dry-aged samples, indicating higher oxidative stability for wet-aged pork cuts. However, dry-aging led to higher degradation of proteins resulting in increased water-holding capacity (WHC) and decreased shear force value.

• 터널과지하공간
• /
• 제20권2호
• /
• pp.119-124
• /
• 2010

암석의 인장강도에 미치는 변형률 속도 및 수분포화의 영향을 파악하기 위하여 건조상태 및 포화상태 3종류의 암석에 대해서 여러 가지 변형률 속도에서의 홉킨슨효과를 이용한 인장파괴실험을 실시하였다. 실험결과 건조상태뿐만 아니라 포화상태에서도 변형률 속도가 증가할수록 암석의 인장강도는 증가하였다. 특히, 건조 상태에 있어서 암석의 동적인장강도는 암석의 종류와는 상관없이 변형률 속도의 약 1/3승에 비례하는 경향을 나타내었다. 또한, 수분포화의 영향으로 공극률이 높은 사암과 응회암은 건조상태와 비교하여 인장강도가 감소하였으나, 공극률이 0.49%로 낮은 화강암은 건조상태와 포화상태와의 사이에 유의한 차이는 없었다.

• 한국작물학회지
• /
• 제48권2호
• /
• pp.81-88
• /
• 2003

Soybeans [Glycine max (L.) Merr.] are frequently exposed to unfavorable environments during growing seasons and water is the most important factor limiting for the production system. The purpose of this study was to determine the leaf water potential changes by irrigation, and to evaluate the relationships of leaf water potential, growth and yield in soybeans. Three soybean cultivars, Hwangkeumkong, Shinpaldalkong 2, and Pungsannamulkong, were planted in growth chamber and field with irrigated treatments. Leaf water potential of three soybean cultivars was positively correlated with leaf water content during vegetative and reproductive growth stages in growth chamber and field experiments. Leaf water potentials measured for three soybean cultivars under growth chamber were higher than those of under field conditions. Higher leaf water potential with irrigated plots under field was observed compared to conventional plots during reproductive growth stages. Leaf water potentials of three soybean cultivars were continually decreased during reproductive growth stages under field and there was no significant difference among them. Number of leaves, leaf water content, pod dry weight, number of seeds and seed dry weight with irrigated plots were higher than those of conventional plots. The results of this study suggested that leaf water potential could be used as an important growth indicator during the growing season of soybean plants.

• 한국전기전자재료학회:학술대회논문집
• /
• 한국전기전자재료학회 1999년도 춘계학술대회 논문집
• /
• pp.300-303
• /
• 1999

For the fast dry of the aqueous tape, the process which water was replaced by organic solvent was proposed. So-called, it was the solvent washing dry, Three organic solvents (methanol, ethanol, and acetone) were selected for the washing solvent. The weight loss of the washed tapes was measured to evaluate the dry rate of the tapes and dried tapes were examined the generation of the cracks with the variations of the organic solvent and the washing time. Methanol, ethanol, and acetone were all available organic solvents for this method. The tapes washed in methanol, ethanol, and acetone were dried rapidly for twenty minutes. After thirty minutes, the weight losses were not any more. The solvent of the lower surface tension can decreases the crack of dried tape. If solvent substitutes water completely, though it was fast dried, crack can be eliminated. The tape casting system was designed for the solvent washing dry and prepared. An homogeneous tape was established by continuous tape casting process.