• Transactions of the Korean Society for Noise and Vibration Engineering
• /
• v.17 no.6 s.123
• /
• pp.539-546
• /
• 2007

Information storage devices using disks have a disk vibration at the frequency which is equivalent to the disk rotational speed. They also have a track vibration due to the disk eccentricity at the same frequency. In near field recording systems, the former affects the air-gap servo and the latter affects the tracking servo. In this paper, we introduce a novel control algorithm based on the internal model principle to both servos. A controller block designed by the principle is connected to the base lead-lag type compensator in parallel in order to cancel the repeatable run-out due to the disk vibration or eccentricity. Simulation and practical application of the algorithm on a near field recording system show good servo performance.

• The Bulletin of The Korean Astronomical Society
• /
• v.42 no.2
• /
• pp.43.4-44
• /
• 2017

Bar fractions depend on the properties of host galaxies. However, the observational studies did not provide consistent tendency. We investigated the bar fractions and their dependence on properties of host galaxies using three bar classifications: visual inspection, ellipse fitting method and Fourier analysis from a volume-limited sample of 1,698 disk galaxies brighter than Mr=-15.2 within z = 0.01 from the Sloan Digital Sky Survey (SDSS) Data Release 7 (DR7). We found two causes to make the discrepancy in previous studies. One is caused by the difficulty in automatically identifying bars for bulge-dominated galaxies. In particular, ellipse fitting methods could miss early-type barred galaxies when a large bulge weakens the transition between a bar and disk. The other is caused by the difference in the correlation between the bar types and host morphology for strong bars and weak bars. Strong bars are preponderant in early-type spirals which are red, bulge-dominated and highly concentrated, whereas weak bars are frequent in late-type spirals which are blue, disk-dominate and less-concentrated. Therefore, how much weak bars they contain affects the trend of bar fraction on host galaxy properties. We also discuss the effect of host properties on the formation, evolution, and destruction of bars.

• Korean Journal of Weed Science
• /
• v.30 no.4
• /
• pp.380-389
• /
• 2010

Transgenic herbicide-resistant sweet potato plants [Ipomoea batatas (L.) Lam.] produced through a biolistic transformation were used in this study. The objective of this research was to find out a rapid and reliable assay method for confirming glufosinate-ammonium resistance. The techniques tested include whole-plant bioassay, one leaf bioassay, and leaf disk bioassay. Parameters investigated in this study were leaf injury and ammonium accumulation at 1 and 5 days after treatment of glufosinate-ammonium. In the leaf disk bioassay, leaf injury of the transgenic line 7171 was 1.9-fold less affected by glufosinate-ammonium than the wild type. The leaf injury of 7171 in one leaf and whole-plant bioassays was 59- and 92-fold less affected by glufosinate-ammonium, respectively, compared with that of the wild type. Leaf disk, one leaf, and whole-plant bioassays showed that ammonium accumulation of the 7171 was 2 to 20-, 4 to 43-, and 6 to 115-fold less affected by 0.5-5 mM glufosinate-ammonium than that of the wild type. All three bioassays successfully distinguished the resistance from the transgenic lines, but one leaf bioassay is the simplest and quickest. Leaf injury and ammonium accumulation were the same in leaves 1, 3, 5, 7, and 10 of 3 mM glufosinate-ammonium treated plants or nontreated plants. The one leaf bioassay was chosen as the standard procedure for future confirmation of resistance in transgenic sweet potato because it is a rapid and reliable assay.

• Proceedings of the KSME Conference
• /
• 2000.04b
• /
• pp.555-560
• /
• 2000

An experimental study on pumping characteristics of various turbo-type drag pumps is purformed. The inlet pressures are measured for various outlet pressures of the test pump. The maximum compression ratios for nitrogen are 100,000(Disk-type drag pump+ turbo molecular pump), 10000(Helical-type drag pump+turbo molecular pump), 850 (Helical-type drag pump), 100(disk-type drag pump).

• Proceedings of the KSME Conference
• /
• 2003.11a
• /
• pp.634-639
• /
• 2003

It has been studied the flow near a rotating disk with surface topography. The system Ekman number is assumed very small, i.e., $E[{\equiv}\frac{\nu}{{\Omega}^{\ast}L^{\ast2}}]<<1$ in which $L^{\ast}$ denotes a disk radius, ${\nu}$ kinematic viscosity of the fluid and ${\Omega}^{\ast}$ angular velocity of the basic state. Disk surface has a sinusoidal topographic variation along radial coordinate, i.e., $z={\delta}cos(2{\pi}{\omega}r)$, where ${\delta}$ and ${\omega}$ are, respectively, nondimensional amplitude and wave number of the disk surface. Analytic solutions, being useful over the parametric ranges of ${\delta}{\sim}O$( $E^{1/2}$ ) and ${\omega}{\leq}O$ ( $E^{1/2}$ ), are secured in a series-function form of Fourier-Bessel type. An asymptotic behavior, when $E{\rightarrow}0$, is clarified as : for a disk with surface roughness, in contrast to the case of a flat disk, the azimuthal velocity increases in magnitude, together with the thickening boundary layer. The radial velocity, however, decreases in magnitude as the amplitude of surface waviness increases. Consequently, the overall Ekman pumping at the edge of the boundary layer remains unchanged, maintaining the constant value equal to that of the flat disk.

• International journal of advanced smart convergence
• /
• v.11 no.3
• /
• pp.206-214
• /
• 2022

Automobile manufacturers in each country are spurring the development of electric vehicles that use electric energy, an eco-friendly energy, as a futuristic vehicle. Electric vehicles have the advantage of no harmful gas or environmental pollution and low noise. Unlike automobiles using existing internal combustion engines using fossil fuels, electric vehicles use the electricity of batteries to cause rotational motion of motors. In the electric vehicle driven by the motor, it is indispensable to develop a controller for controlling the motor. One of the areas where automobile manufacturers are concentrating is the development of small electric vehicles as a personal transportation means. Small electric vehicles such as electric motorcycles, one-seat electric vehicles and two-seat electric vehicles are expanding the market as a means of operating throughout the city. In the domestic road conditions with many hills, it is effective to have a separate transmission system for small electric vehicles to drive smoothly. In this study, we propose a new type of continuously variable transmission(CVT) system to ensure that small electric vehicles can be driven smoothly in hilly domestic terrain. The proposed CVT system is equipped with a basic disk and a rotational disk in the driving pulley and the driven pulley, respectively, and is applied with a sloping spline to rotate the rotational disk. To commercialize the proposed CVT system, an experimental device was developed to examine the power transmission efficiency and the configuration of the CVT system was proposed.

• Journal of the Korean Institute of Illuminating and Electrical Installation Engineers
• /
• v.30 no.1
• /
• pp.72-78
• /
• 2016

In terms of power components which use environmentally-friendly dry air that can substitute SF6, there have been studies on the electrical properties of the solid insulation "spacer" for the purpose of securing dielectric strength as they become smaller. This study laminated solid insulation to keep the creeping distance the same in the dry air and investigated vertical surface discharge characteristics by shape. The three sheets of disk-type solid insulation(Bakelite) were laminated in a manner to keep the creeping distance the same. The lamination was categorized as follows: "Type A" in which the insulations with the same disk diameter were laminated; "Type B" in which the insulations whose middle disk diameter was large were laminated; and "Type C" in which the ones whose middle disk diameter was small were laminated. For a vertical surface discharge experiment, dry air was injected into the test chamber depending on the shape of the laminated solid insulation, and chamber pressure was adjusted in a range of 0.1-0.6MPa. As volume decreased, surface discharging voltage by unit volume increased. This was because of dielectric polarization according to the structural characteristics of the shape of lamination. The highest surface discharging voltage was found in "Type C."

• Journal of the Korean Mathematical Society
• /
• v.43 no.2
• /
• pp.425-443
• /
• 2006

The aim of this paper is to obtain several results in approximation by Jackson-type generalizations of complex Picard, Poisson-Cauchy and Gauss-Weierstrass singular integrals in terms of higher order moduli of smoothness. In addition, these generalized integrals preserve some sufficient conditions for starlikeness and univalence of analytic functions. Also approximation results for vector-valued functions defined on the unit disk are given.

• Proceedings of the Korean Society of Tribologists and Lubrication Engineers Conference
• /
• 1998.10a
• /
• pp.285-291
• /
• 1998

A hydraulic pin-on-disk type tribotester was developed and it's performance was investigated experimentally. The estimate of the performance was accomplished by comparing those of the pneumatic and the dead-weight loading method. The reliability to the performance was conformed. By hydraulic loading method more accra'ate friction coefficient could be got.

• Proceedings of the SAREK Conference
• /
• 2005.06a
• /
• pp.80-80
• /
• 2005