• 대한토목학회논문집
• /
• 제11권1호
• /
• pp.45-53
• /
• 1991

지하구조물은 물체력과 초기응력이 지배적인 하중조건이 되며, 무한 또는 반무한영역을 경계로 한다. 또한 굴착면 주위에는 응력집중에 의해 비선형 거동이 발생한다. 본 논문에서는 경계요소법으로 물체력과 초기응력을 해석하기 위하여 영역적분은 경계 적분화하였다. 물체력에 대한 영역적분은 Galerkin텐서와 발산정리를 사용한 방법과 극좌표를 이용한 직접적분 방법으로 경계적분화하였고, 초기응력에 대한 영역적분은 극좌표를 이용한 직접적분 방법을 응용하여 경계적분화하였다. 경계요소해석 결과는 유한요소해석 결과와 비교하여 검증하였고 검증된 경계요소 프로그램을 비선형 유한요소 프로그램과 조합하여 굴착면 주위에 발생하는 비선형 거동을 합리적으로 해석하도록 하였다. 경계요소법에서 고려하기 어려운 물체력과 초기응력에 대한 영역적분을 경계적분화하여 효율적으로 해석할 수 있었으며, 조합해석 방법으로 비선형 거동을 합리적으로 해석할 수 있었다. 본 연구의 결과는 지하구조물의 해석에 유용하게 사용될 수 있을 것으로 기대된다.

• Journal of Power Electronics
• /
• 제9권4호
• /
• pp.582-592
• /
• 2009

This paper proposes a new speed sensorless direct torque and flux controlled interior permanent magnet synchronous motor (IPMSM) drive. Closed-loop control of both the torque and stator flux linkage are achieved by using two proportional-integral (PI) controllers. The reference voltage vectors are generated by a SVM unit. The drive uses an adaptive sliding mode observer for joint stator flux and rotor speed estimation. Global asymptotic stability of the observer is achieved via Lyapunov analysis. At low speeds, the observer is combined with the high frequency signal injection technique for stable operation down to standstill. Hence, the sensorless drive is capable of exhibiting high dynamic and steady-state performances over a wide speed range. The operating range of the direct torque and flux controlled (DTFC) drive is extended into the high speed region by incorporating field weakening. Experimental results confirm the effectiveness of the proposed method.

• Bulletin of the Korean Chemical Society
• /
• 제22권9호
• /
• pp.945-947
• /
• 2001

The He-Xe interaction potential has been determined using a direct inversion of the experimentally reduced-viscosity collision integrals obtained from the corresponding states correlation. The potential is in a good agreement with the previously determined potential. The potential predicts viscosity and diffusion coefficients and they are found to be in a good agreement with experiment.

• 대한기계학회논문집A
• /
• 제29권12권
• /
• pp.1597-1604
• /
• 2005

The identification of a moving noise source is important in reducing the source power of the transport systems such as airplanes or high speed trains. However, the direct measurement using a microphone running with noise source is usually difficult due to wind noise, white the source motion distorts the frequency characteristics of the pass-by sound measured at a fixed point. In this study the relationship between the spectra of the source and the pass-by sound signal is analyzed for an acoustic source moving at a constant velocity. Spectrum of the sound signal measured at a fixed point has an integral relationship with the source spectrum. Nevertheless direct conversion of the measured spectrum to the source spectrum is ill-posed due to the singularity of the integral kernel. Alternatively a differential equation approach is proposed, where the source characteristics can be recovered by solving a differential equation relating the source signal to the distorted measurement in time domain. The parameters such as the source speed and the time origin, required beforehand, are also determined only from the frequency-phase relationship using an auxiliary measurement. With the help of the regularization method, the source signal is successfully recovered. The effects of the parameter errors to the estimated frequency characteristics of the source are investigated through numerical simulations.

• 지구물리와물리탐사
• /
• 제3권4호
• /
• pp.125-128
• /
• 2000

본 연구에서는 탄성파 임펄스 반응 해를 구하는 하나의 대안으로서 시간적분(formal time-integration)을 이용하여 시간 영역에서의 이론 변위를 계산하는 방법에 대해 고찰하였다. 이는 복소 적분법을 이용하여 푸리에 적분식을 직접 적분하는 대신 우선 가속도에 대한 해를 유도하고, 이로부터 시간적분을 이용하여 변위에 대한 해를 유도하는 방법이다. 이 방법은 시간에 대한 푸리에 적분식을 복소적분을 이용하여 구하는 경우 야기되는 유인성과 관련된 혼란을 피할 수 있어, 변위에 대한 이론 임펄스 반응 해가 직관적인 델타함수와 층계함수에 대한 미적분 관계만을 사용하여 쉽게 구해진다.

• 대한수학회지
• /
• 제60권2호
• /
• pp.407-464
• /
• 2023

Let R be a commutative ring with identity. The structure theorem says that R is a PIR (resp., UFR, general ZPI-ring, π-ring) if and only if R is a finite direct product of PIDs (resp., UFDs, Dedekind domains, π-domains) and special primary rings. All of these four types of integral domains are Krull domains, so motivated by the structure theorem, we study the prime factorization of ideals in a ring that is a finite direct product of Krull domains and special primary rings. Such a ring will be called a general Krull ring. It is known that Krull domains can be characterized by the star operations v or t as follows: An integral domain R is a Krull domain if and only if every nonzero proper principal ideal of R can be written as a finite v- or t-product of prime ideals. However, this is not true for general Krull rings. In this paper, we introduce a new star operation u on R, so that R is a general Krull ring if and only if every proper principal ideal of R can be written as a finite u-product of prime ideals. We also study several ring-theoretic properties of general Krull rings including Kaplansky-type theorem, Mori-Nagata theorem, Nagata rings, and Noetherian property.

• Journal of Electrical Engineering and Technology
• /
• 제12권1호
• /
• pp.236-248
• /
• 2017

A direct stator flux vector control scheme in discrete-time domain is proposed in this paper for the interior permanent magnet synchronous motor (IPMSM) drive to remove the proportional-integral (PI) controller from the direct torque control (DTC) scheme applied to IPMSM and to obtain faster dynamic response and lower torque ripple output. The output of speed outer loop is used as the desired torque angle instead of the desired torque in the proposed scheme. The desired stator flux vector in dq coordinate is calculated with a given amplitude. The state-space equations in discrete-time for IPMSM are established, the actual stator flux vector is estimated in deadbeat manner by a full-order state observer, and then the closed-loop control is achieved by the pole placement. The stator flux error vector is utilized to calculate the reference stator voltage vector. Extracting the angle position and amplitude from the estimated stator flux vector and estimating the output torque are eliminated for the direct feedback control of the stator flux vector. The proposed scheme is comparatively investigated with a PI-SVM DTC scheme by experiment results. Experimental results show the feasibility and advantages of the proposed control scheme.

• Nuclear Engineering and Technology
• /
• 제54권8호
• /
• pp.3130-3139
• /
• 2022

Direct containment heating (DCH) is one of the potential factors leading to early containment failure. DCH is closely related to safety analysis and containment performance evaluation of nuclear power plants. In this study, a DCH prediction program was developed to analyze the DCH loads of containment vessel. The phenomenological model of debris dispersal, metal oxidation reaction, debris-atmospheric heat transfer and hydrogen jet burn was established. Code assessment was performed by comparing with several separate effect tests and integral effect tests. The comparison between the predicted results and experimental data shows that the program can predict the key parameters such as peak pressure, temperature, and hydrogen production in containment well, and for most comparisons the relative errors can be maintained within 20%. Among them, the prediction uncertainty of hydrogen production is slightly larger. The analysis shows that the main sources of the error are the difference of time scale and the oxidation of cavity debris.

• 조명전기설비학회논문지
• /
• 제27권9호
• /
• pp.74-82
• /
• 2013

This paper presents a novel maximum power point tracking for a photovoltaic power (PV) system with a direct control plan. Maximum power point tracking (MPPT) must usually be integrated with photovoltaic (PV) power systems so that the photovoltaic arrays are able to deliver maximum available power. The maximum available power is tracked using specialized algorithms such as Perturb and Observe (P&O) and incremental Conductance (indCond) methods. The proposed method has the direct control of the MPPT algorithm to change the duty cycle of a dc-dc converter. The main difference of the proposed system to existing MPPT systems includes elimination of the proportional-integral control loop and investigation of the effect of simplifying the control circuit. The proposed method thus has not only faster dynamic performance but also high tracking accuracy. Without a conventional controller, this method can control the dc-dc converter. A simulation model and the direct control of MPPT algorithm for the PV power system are developed by Matlab/Simulink, SimPowerSystems and Matlab/Stateflow.

• 한국초전도ㆍ저온공학회논문지
• /
• 제18권3호
• /
• pp.30-34
• /
• 2016

An integral crank driven Stirling cryocooler is solidly based on concepts of direct IR detector mounting on the cryocooler's cold finger, and the integral construction of the cryocooler and Dewar envelope. Performance factors of the cryocooler depend on operating conditions of the cryocooler such as a cyclic mean pressure of the working fluid, a rotational speed of driving mechanism, a thermal environment, a targeted operation temperature and etc.. At given charging condition of helium gas, the cyclic mean pressure of helium gas in the cryocooler changes with temperatures of the cold end and the environment. In this study, effects of the cyclic mean pressure of helium gas on performances of the Stirling cryocooler were investigated by numerical analyses using the Sage software. The simulation model takes into account thermodynamic losses due to an inefficiency of regenerator, a pressure drop, a shuttle heat transfer and solid conductions. Simulations are performed for the performance variation according to the cyclic mean pressure induced by the temperature of the cold end and the environment. This paper presents P-V works in the compression and expansion space, cooling capacity, contribution of losses in the expansion space.