• Journal of the Korean Chemical Society
• /
• v.7 no.2
• /
• pp.96-105
• /
• 1963

The weight decrease curves of 18 kinds of polymers have been measured by thermobalance at the same condition where temperature is increased $1^{\circ}C$ per minutes under nitrogen or air atmosphere. The curves are further differentiated to obtain rate curve of weight decrease. Those curve offer a method to compare relative thermal stability, effects of oxygen or modes of thermal degradation of polymers qualitatively. The curves could be classified into following four types: Polystyrene, polymethylmethacrylate and acetal polymer belong to the first type. Those polymers depolymerize mainly into corresponding monomers, weight decrease curves are steepy up to perfect vaporization of polymers and rate curves show a relatively sharp peak. (Type I) Polyvinyl chloride represents the second type. This polymer decomposes with splitting off of hydrogen chloride. The thermogravimetric curve rises rapidly at first, then level off at the moderate weight decrease and gradually rises. Polyvinyl acetate also belongs to this class. (Type II) The modification of the second type is represented by polyester. The curve at the early stage is less steep, the leveling off at the next stage is less clear and the final rising of the curve is steeper than the normal second type. Polyamide, polyurethane, and polycarbonate belong to this type. (Type II') The thermal decomposition of the third type polymers is more complex than that of others. Various irregular chain scissions including side chain splitting and depolymerization to monomers occur simultaneously. The weight of the polymer decreases gradually and the rate curve does not show sharp peaks. Polyvinyl alcohol and diene polymers belong to this type. (Type III) Generally, polycondensation polymers are more stable toward heat than addition polymers and polymers having aromatic nucleus show good thermal stability. Polymers having tertiary carbon atoms such as polystyrene or polypropylene and acetal resin start decomposition under airatmosphere at the temprature below $50^{\circ}C$ or more of the temperature where the polymers start decomposition under nitrogen atmosphere.

• Elastomers and Composites
• /
• v.44 no.2
• /
• pp.122-133
• /
• 2009

Rubbers, such as natural rubber, polybutadiene, styrene-butadiene rubber, nitrile-butadiene rubber, chlorinated rubber and EPDM, have been continuously improved in response to a heavy demand and a new property requirement from industry. One of the best ways to realize the improvement is the modification of rubbers through chemical reactions, which produce materials with novel properties. In this review, chemical modification reactions of rubbers that contain carbon-carbon double bond units either in their main backbone or as a side group were briefly summarized. The chemical reactions introduce functional groups or functional polymer chains to polymer backbone, which transform a classical rubber to a highly functional material. Especially, we focused on a controlled/"living" radical polymerization techniques, with which a revolutionary broadening of the spectrum of the materials with well defined molecular weight, molecular weight distribution, chain end-functionality and architectures become possible.

• Korean Journal of Fisheries and Aquatic Sciences
• /
• v.9 no.3
• /
• pp.195-202
• /
• 1976

The present investigation was performed to find the lipid composition of the total lipids, the fatty acid components of the neutral lipids and the phospholipids, and the composition of sterols, from Spisula sachalinensis. The results obtained are as follows ; 1) The main components of the total lipids are phospholipids$(43.1\%)$, triglyceride$(36.2\%) $, and sterol $(10.3\%)$. 2) The phospholipids are mainly composed of phosphatidyl choline, phosphatidyl ethanols, mine, phosphatidal ethanolamine and phosphatidyl serine. 3) The main fatty acids of the neutral lipids, the ethanolamine phospholipids and choline phospholpids, are C20:5, C16:1, C16:0, C20:5, C18:0, C22:6 and C16:0, C20:5, C22:6, respectively. Oleic acid content of all fractions is very small compared with one of gastropoda lipids and fish oil. 4) Most of plasmalogen are present in the ethanolamine phospholipids and only trace of plasmalogen in the choline phospholipids. 5) Sterols to be found are 22-trans-norcholesta-5, 22-diene-$3\beta$-ol, 22-dehydrocholesterol, cholesterol, brassicasterol, 24-methylenecho-lesterol and $\beta-sitosterol$.

• Elastomers and Composites
• /
• v.47 no.3
• /
• pp.216-222
• /
• 2012

In this study, p-acryloyloxybenzoic acid(ABA) was synthesized with p-hydroxybenzoic acid(HBA) and acryloyl chloride(AC). The synthesized ABA monomer was grafted onto ethylene-propylene-diene rubber(EPDM) in toluene using benzoyl peroxide(BPO) as an initiator. The structures of ABA and EPDM-g-ABA were characterized by FT-IR, $^1H$-NMR, and $^{13}C$-NMR spectrometer. The graft ratio of EPDM-g-ABA increased with increasing the concentration of the initiator and the monomer. Mechanical properties such as tensile strength and compression set of the EPDM-g-ABA were improved with increasing the graft ratio. The $T_g$ and initial decomposition temperature were also increased with increasing the graft ratio.

• Advances in Traditional Medicine
• /
• v.4 no.1
• /
• pp.28-36
• /
• 2004

The purpose of this study was to investigate the pharmacological effects of low-esterified pectin on carbon tetrachloride $(CCL_4)-induced$ hepatotoxicity in rats. The study included two experiments. In the first experiment the animals were given daily $CCL_4$ through gavage for 7 days and then 10, 50, or 250 mg/kg b.w. of pectin for 21 days. At the end of experiment rats were killed within 24 hours. The increased bilirubin level, enhanced alanine aminotransferase and aspartate aminotransferase activity in plasma induced by $CCL_4$ were partly normalized by pectin administration in a dose-dependent manner. The pectin treatment also resulted in significant recovery of $CCL_4-induced$ decrease of the liver glycogen content. In addition, pectin significantly improved $CCL_4-induced$ alterations of pro-oxidant and antioxidant biochemical parameters in liver and plasma compared to those of rats administered $CCL_4$. In the second experiment the animals were given daily 10, 50 or 250 mg/ kg b.w. of pectin for 21 days before a 7-day administration of $CCL_4$. Rats were killed 24 hours after the end of experiment. Pretreatment with pectin before $CCL_4$ administration resulted in significantly inhibited increase of the blood enzymatic activities of alanine and aspartate aminotransferases and bilirubin level in a dose-dependent manner. Also, preliminary administration of pectin prevented elevation of malondialdehyde and conjugated diene levels in liver and plasma as well as a reduction of glutathione content in liver of rats given $CCL_4$. These results suggest that low-esterified pectin exert healing and preventive effects on $CCL_4-induced$ hepatotoxicity in rats.

• Elastomers and Composites
• /
• v.44 no.3
• /
• pp.315-322
• /
• 2009

Influence of blend mode of extender oil on the properties of thermoplastic vulcanizates (TPVs), based on an ethylene-propylene-diene copolymer (EPDM) and a polypropylene (PP), was studied. The EPDM/PP TPVs were prepared in an open roll mill using two different modes in blending sequence of paraffinic oil and phenolic curative, i.e., Oil-Cure and Cure-Oil modes. Degree of cross-linking by gel fraction and properties such as hardness, tensile strength, elongation at break, and melt flow rate were investigated as a function of extender oil content for the two modes. Little influence of the blend mode of extender oil on the degree of cross-linking and mechanical behaviors was observed. However, the use of Cure-Oil mode in the preparation of EPDM/PP TPVs resulted in a marked increase in the level of processability as reflected by melt flow index, as compared to the use of Oil-Cure mode.

• Elastomers and Composites
• /
• v.44 no.1
• /
• pp.47-54
• /
• 2009

EPDM(Ethylene-propylene-diene-terpolymer) compound reinforced with carbon black having four different particle size, acetylene black(thermal conductivity carbon black), and silica were manufactured by internal mix and open mill. To investigate the effect of particle size of filler and filler type on far-infrared vulcanization, intermal temperature of compound, degree of curing, infrared spectroscopy, and thermal analysis were measured. The thermal conductivity of far-infrared vulcanized EPDM compound increased with increasing particle size of carbon filler, but hot air vulcanized EPDM compound is not affected by particle size. The thermal conductivity was increased in the order of carbon black < silica < acetylene black(thermal conductivity carbon black).

• Elastomers and Composites
• /
• v.45 no.3
• /
• pp.212-216
• /
• 2010

The materials of the lithium ion battery gasket require chemical resistance to the electrolyte, electrical insulating, compression set, anti-contamination and heat resistance. To estimate suitability for rubber which has better performance to compression set than PFA, each compound were made with various rubbers, such as EPDM, NBR, FKM, FVMQ, VMQ and we checked the characteristics of each compound. Samples from each compound was deposited in Propylene Carbonate and tested for changing of Hardness and Volume during 1,000 hr with $80^{\circ}C$. EPDM and VMQ showed good performance to chemical resistance to the electrolyte, and also we could get the values over $10^{10}{\Omega}cm$ on volume resistance basis in electrical insulating. EPDM and VMQ were judged as the most suitable material.

• Journal of the Society of Cosmetic Scientists of Korea
• /
• v.18 no.1
• /
• pp.1-41
• /
• 1992

A new and unique class of nonionic surfactants was synthesized by reacting biological a-tocopherol with ethylene oxide for functional cosmetics. The structures were confirmed by Hl-UMR, FT-lR, TLC and elemental analysis. POV and conjugated diene value study for EPO showed POE(n)TE had antioxidative effect similar to tocopheryl acetate Protective effect on cell membrane in photohemolysis of POE(5)TE, POE(10)TE and POE(18)TE were slightly lower than tocopherol but higher than nonoxynol-12, and POE(10)TE had UV absorption power comparable with tocopherol and homosalate. Biological activity of the hydrophobic group of the new surfactants make them unique and different from those of conventional nonionic surfactants Systematic safety evaluations of POE(n)TEs on the skin and eye proved that they are as safe as tocopherol. The results of physicochemical study showed POE(10)TE had the lowest CMC value, POE(18)TE had the maximum surface tension reduction and the highest foam volume and POE(n)TEs had various HLB values by the degree of ethoxylation. The test resul Is of technological and practical applications of these surfactants for cosmetics showed some POE(n)TEs were superior to conventional surfactants. POE(5)TE in W/O emulsions, POE(10)TE and POE(12)TE in O/W emulsions, POE(12)TE in dispersions, POE(18)TE in solubilizations and POE(50)TE in gelations were shown to be excellent which was considered due to the structural characteristic and formation of liquid crystals of POE(n)TEs. By the development and applications of these excel lent multi-functional surfactants, innovative functional cosmetics were successfully formulated.

• Journal of the Korean Chemical Society
• /
• v.28 no.5
• /
• pp.284-292
• /
• 1984

This paper aims to predict the substituent and Lewis acid catalysis effect or reactivity on the regioselectivity of (4+2) cycloaddition reaction of the substituted-E-arene-diazocyanides and nitrosobenzenes. Frontier orbital theory (FMO) has been applied to thermal and catalyzed Diels-Alder reaction by means of CNDO/2 and EHT-SPD methods. It has been found that: (1) The above reaction is positive rho(${\rho}$) values in Hammett equation, so it takes normal electron demand reaction, and four-frontier orbitals and Anh methods are identical with experimental major regioisomer.(2) When electron withdrawing radicals are substituted HOMO and LUMO energies of dienophiles are reduced, and the reactivity is increased. (3) The major regioisomer is predicted as B type, as the Lewis acid makes complexes of dienophile, and polaries LUMO coefficients of dienophile in an opposite way. (4) The linear correlation of Hammett is indicated in the graph of stabilized energies(${\Delta}$E) and sigma(${\sigma}$).