• Journal of the Institute of Electronics and Information Engineers
• /
• v.49 no.9
• /
• pp.251-258
• /
• 2012

Recently, NAND Flash memory structure is evolving from SDR (Single Data Rate) to high speed DDR(Double Data Rate) to fulfill the high performance requirement of SSD and SSS. Accordingly, the proper ways of transferring data that latches valid data stably and minimizing data skew between pins by using PHY(Physical layer) circuit techniques have became new issues. Also, rapid growth of speed in NAND flash increases the operating frequency and power consumption of NAND flash controller. Internal voltage variation margin of NAND flash controller will be narrowed through the smaller geometry and lower internal operating voltage below 1.5V. Therefore, the increase of power budge deviation limits the normal operation range of internal circuit. Affection of OCV(On Chip Variation) deteriorates the voltage variation problem and thus causes internal logic errors. In this case, it is too hard to debug, because it is not functional faults. In this paper, we propose new architecture that maintains the valid timing window in cost effective way under sudden power fluctuation cases. Simulation results show that the proposed technique minimizes the data skew by 379% with reduced area by 20% compared to using PHY circuits.

• Journal of the Korean Society for Aeronautical & Space Sciences
• /
• v.45 no.4
• /
• pp.300-309
• /
• 2017

A spacecraft obtains a reaction momentum required for an orbit correction and an attitude control by exhausting a combustion gas through a small thruster in space. If the exhaust plume collides with spacecraft surfaces, it is very important to predict the exhaust plume behavior of the thruster when designing a satellite, because a generated disturbance force/torque, a heat load and a surface contamination can yield a life shortening and a reduction of the spacecraft function. The purpose of the present study is to ensure the core technology required for the spacecraft design by analyzing numerically the exhaust gas behavior of the 10 N class bipropellant thruster for an attitude control of the spacecraft. To do this, calculation results of chemical equilibrium reaction between a MMH for fuel and a NTO for oxidizer, and continuum region of the nozzle inside are implemented as inlet conditions of the DSMC method for the exhaust plume analysis. From these results, it is possible to predict a nonequilibrium expansion such as a species separation and a backflow in the vicinity of the bipropellant thruster nozzle.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.20 no.1
• /
• pp.45-51
• /
• 2009

The propagation characteristics in parallel plate waveguide with dielectric layer having periodic metal strip pattern are investigated. PIN diode ON/OFF states are regarded as the short and open circuit, respectively, in the simulation using CST's MWS. The $11.25^{\circ}$, $22.5^{\circ}$, and $45^{\circ}$ layers which can be used for X-band 4-bit Radant lens phase shifter, are designed. The simulated results for each dielectric layer are $11.28^{\circ}$, $23.2^{\circ}$, and $46.22^{\circ}$, respectively. Also, the equivalent circuit of each layer at the operating band is realized and simulated using Agilent's ADS. The ADS simulated results are compared with the MWS simulated ones. Measured differential phase shills at the center frequency are $9.6^{\circ}$, $22.4^{\circ}$, and $43^{\circ}$, respectively.

• Journal of Korean Society of Environmental Engineers
• /
• v.28 no.8
• /
• pp.860-865
• /
• 2006

The characteristics of flow field and turbulent mixing efficiency of SS in non-aerated contacting reactor are critical design parameters directly affecting on the efficiency of the overall process of wastewater treatment system. To this end, in this study numerical fluid dynamic calculation has been made to investigate the flow field and concentration distribution of SS in terms of specification(shape and dimension) of impeller and other operating conditions. As the first step, the performance of the computer program developed was successfully evaluated by the comparison of the typical flow field with the type of impeller with that appeared in open literature. Further, a series of parametric investigations are made in terms of interesting parameters such as the type and dimension of impeller, location, and number of impeller, etc. A number of useful conclusions obtained by numerical calculation are the superiority of mixing efficiency of pitched type than the flat one together with the visible increase of the overall mixing effect by the employment of the larger impeller and increase of the impeller number, etc.

• Korean Chemical Engineering Research
• /
• v.46 no.2
• /
• pp.348-355
• /
• 2008

Recently, an understanding of new sources of liquid hydrocarbons such as bio-ethanol is economically very important. The present dissertation is also designed with purpose of developing the energy-saving process for the separation of bio-ethanol. In order to illustrate the predictability of proposed process for the separation of bio-ethanol, the experimental data from literatures and real plant data are used. Application of the thermodynamics of multicomponent mixtures and phase equilibria to the extractive distillation process with syntheses of heat exchanger network has enabled the development of energy-saving process for different separating agents. Developed process is capable of minimizing the energy usage and the environmental effect. This extractive process is also able to properly describe the effect of impurities, the choice of separating agent. Simulation results of extractive distillation using ethylene glycol show that impurities do not affect to extractive distillation operation and agent, ethylene glycol, was recycled without any loss. It is possible that extraction distillation has various heat network for anhydride ethanol and recovery of ethanol is maximized. Ethylene glycol as separating agent has a high boiling point to eliminate azeotropic point and on the contrary solubility of agent is low to be almost completed recovered. Proposed process is also the energy efficient process configuration in which 99.85mole% anhydride ethanol can be produced with low energy of 1.37198 (kg steam/kg anhydride ethanol).

• Journal of the Institute of Electronics and Information Engineers
• /
• v.49 no.12
• /
• pp.64-72
• /
• 2012

Synchronization including timing recovery, frequency offset compensation, and frame synchronization is most important signal processing block in all wireless/wired communication systems. In most communication systems, synchronization schemes based on training sequences or preambles are used. WLAN standards of 802.11a/g/n released by IEEE are based on OFDM systems. OFDM systems are known to be much more sensitive to frequency and timing synchronization errors than single carrier systems. A loss of orthogonality between the multiplexed subcarriers can result in severe performance degradations. The starting position of the frame and the beginning of the symbol and training symbol can be estimated using correlation methods. Correlation processing functionality is usually complex because of large number of multipliers in implementation especially when the reference signal is non-binary. In this paper, a simple correlation based synchronization scheme is proposed for IEEE 802.11a/g/n systems. Existing property of a periodicity in the training symbols are exploited. Simulation and implementation results show that the proposed method has much smaller complexity without any performance degradation than the existing schemes.

• Journal of the Institute of Electronics Engineers of Korea SD
• /
• v.42 no.8 s.338
• /
• pp.35-42
• /
• 2005

This paper describes novel flip-flops with improved robustness and reduced power consumption. Variable sampling window flip-flop (VSWFF) adjusts the width of the sampling window according to input data, providing robust data latching as well as shorter hold time. The flip-flop also reduces power consumption for higher input switching activities as compared to the conventional low-power flip-flop. Clock swing-reduced variable sampling window flip-flop (CSR-VSWFF) reduces clock power consumption by allowing the use of a small swing clock. Unlike conventional reduced clock swing flip-flops, it requires no additional voltage higher than the supply voltage, eliminating design overhead related to the generation and distribution of this voltage. Simulation results indicate that the proposed flip-flops provide uniform latency for narrower sampling window and improved power-delay product as compared to conventional flip-flops. To evaluate the performance of the proposed flip-flops, test structures were designed and implemented in a $0.3\mu m$ CMOS process technology. Experimental result indicates that VSWFF yields power reduction for the maximum input switching activity, and a synchronous counter designed with CSR-VSWFF improves performance in terms of power consumption with no use of extra voltage higher than the supply voltage.

• The Journal of Korea Institute of Information, Electronics, and Communication Technology
• /
• v.12 no.6
• /
• pp.619-628
• /
• 2019

In this paper, we designed a beta ray sensor for a true random number generator. Instead of biasing the gate of the PMOS feedback transistor to a DC voltage, the current flowing through the PMOS feedback transistor is mirrored through a current bias circuit designed to be insensitive to PVT fluctuations, thereby minimizing fluctuations in the signal voltage of the CSA. In addition, by using the constant current supplied by the BGR (Bandgap Reference) circuit, the signal voltage is charged to the VCOM voltage level, thereby reducing the change in charge time to enable high-speed sensing. The beta ray sensor designed with 0.18㎛ CMOS process shows that the minimum signal voltage and maximum signal voltage of the CSA circuit which are resulted from corner simulation are 205mV and 303mV, respectively. and the minimum and maximum widths of the pulses generated by comparing the output signal through the pulse shaper with the threshold voltage (VTHR) voltage of the comparator, were 0.592㎲ and 1.247㎲, respectively. resulting in high-speed detection of 100kHz. Thus, it is designed to count up to 100 kilo pulses per second.

• Journal of KIISE:Computer Systems and Theory
• /
• v.33 no.12
• /
• pp.867-879
• /
• 2006

This paper concerns fast and time accurate HW/SW cosimulation for MPSoC(Multi-Processor System-on-chip) architecture where multiple software and/or hardware components exist. It is becoming more and more common to use MPSoC architecture to design complex embedded systems. In cosimulation of such architecture, as the number of the component simulators participating in the cosimulation increases, the time synchronization overhead among simulators increases, thereby resulting in low overall cosimulation performance. Although SystemC cosimulation frameworks show high cosimulation performance, it is in inverse proportion to the number of simulators. In this paper, we extend the novel technique, called virtual synchronization, which boosts cosimulation speed by reducing time synchronization overhead: (1) SystemC simulation is supported seamlessly in the virtual synchronization framework without requiring the modification on SystemC kernel (2) Parallel execution of component simulators with virtual synchronization is supported. We compared the performance and accuracy of the proposed parallel SystemC cosimulation framework with MaxSim, a well-known commercial SystemC cosimulation framework, and the proposed one showed 11 times faster performance for H.263 decoder example, while the accuracy was maintained below 5%.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.37C no.11
• /
• pp.1077-1083
• /
• 2012

The jamming countermeasures in GNSS includes anti-jamming technique and jammer localization technique. In both techniques, direction of jamming signal is important and generally the MUSIC algorithm is used to find the direction of jamming signal. The MUSIC is super-resolution algorithm for detecting incident direction of signal. But, the search time of MUSIC algorithm is too long because all candidates of incidence angle are searched. This paper proposes the new method that has less computational burdens and therefore faster than the conventional MUSIC algorithm. The proposed method improves performance speed by reducing unnecessary calculations. In the proposed method, the cost function of conventional MUSIC algorithm is decomposed into the sum of squares and if the partial sum of cost function is larger than the minimum cost function so far, then the candidate is rejected and next candidates are searched. If the computed cost function is less than the minimum cost function so far, the minimum cost function so far is replaced with newly computed value. The performance of the proposed method was compared with the conventional MUSIC algorithm using the simulation. The accuracy of the estimaed direction of jamming signal was same as the conventional MUSIC while the search speed of the proposed method was 1.15 times faster than the conventional MUSIC.