• Journal of Korean Ophthalmic Optics Society
• /
• v.5 no.2
• /
• pp.145-150
• /
• 2000

The adaptation for a right source on the retina consists of the light-dark adaptation's two curves for a time by the rod-cone receptor. We obtained the adaptation for a time to measure the threshold intensities, it was two decay curves by the center of a rod-cone break. It could be represented the dark adaptation by a exponential decay function consisting of $T_{min}$, $a_r$, $a_c$, $T_{0(r)}$, $T_{0(c)}$, $t_b$, $t_c$'s parameters. The curves of a $t_b$ below and a $t_b$ above showed the adaptation sensitivity of the cone and the rod. The exponential decay function was well applied to the dark adaptation in difference retinal positions, in contrally fixated fields, in luminous, as age etc. It could be used the decay parameter as the index because of representing the properties of the dark adaptation's function.

• Progress in Superconductivity
• /
• v.14 no.1
• /
• pp.1-10
• /
• 2012

We fabricated a closed coils by using resistive-joint method and the joint resistance of the coils were estimated by field decay technique in liquid nitrogen. We used the Runge-kutta method for the numerical analysis to calculate the decay properties. The closed coil was wound by $(Bi,Pb)_2Sr_2Ca_2Cu_3O_x$/Ag tape. Both ends the tape were overlapped and soldered to each other. The current was induced in a closed coils by external magnetic flux density. Its decay characteristic was observed by means of measuring the magnetic flux density generated by induced current at the center of the closed coil with hall sensor. The joint resistance was calculated as the ratio of the inductance of the loop to the time constants. The joint resistances were evaluated as a function of critical current of loop, contact length, sweep time, and external magnetic flux density in a contact length of 7 cm. It was observed that joint resistance was dependent on contact length of a closed coil, but independent of critical current, sweep time, and external magnetic flux density. The joint resistance was measured to be higher for a standard four-probe method, compared with that for the field decay technique. This implies that noise of measurement in a standard four-probe method is larger than that of field decay technique. It was estimated that joint resistance was $8.0{\times}10^{-9}{\Omega}$ to $11.4{\times}10^{-9}{\Omega}$ for coils of contact length for 7 cm. It was found that 40Pb/60Sn solder are unsuitable for persistent mode.

• Journal of Korean Ophthalmic Optics Society
• /
• v.16 no.3
• /
• pp.283-291
• /
• 2011

Purpose: To find an empirical fitting curve to represent the relationship between the luminous transmittance and tinted time in tinted lenses using exponential decay curves. Methods: Total ninety tinted lenses were prepared with CR-39 lenses and six different colored dyes. Single, double and triple exponential decay curves were used as trial curves in order to find the empirical fitting curve. Result: The results showed that the best empirical fitting curve was triple exponential decay curves. Conclusions: We propose triple exponential decay curves as proper empirical fitting curves to represent the tinted-time dependence of the luminous transmittance in tinted lenses.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2003.05e
• /
• pp.1-5
• /
• 2003

This paper presented the effects of accumulation of surface charges on hydrophobicity level and the surface states of silicone polymer used for outdoor insulator treated by ultraviolet irradiation and corona discharge through measuring surface voltage decay of a corona-charged specimen were investigated. The surface resistivity by the method of the surface potential decay was compared with the value by the three electrodes methods. From this study, it was found that the accumulation of surface charges above a critical surface voltage on silicone insulating materials could lead to the temporary loss of surface hydrophobicity. In addtion, uv stress lead to a longer decay time of surface charges. We could conclude that the effects of surface charges on hydrophocity level and the changes of surface state by various artificial treatments were understood through a trend of surface potential decay.

• Proceedings of the Korean Society for Noise and Vibration Engineering Conference
• /
• 2004.05a
• /
• pp.147-150
• /
• 2004

The reverberation characteristics of the Korean Traditional buildings aren't well-known, but there could be many particular properties. In this study, we compare the reverberation characteristics of a Korean traditional building of a temple, ‘Magoksa’, with three modern buildings. We use 5 parameters which have been widely studied in architectural acoustics such as reverberation time, early decay time, clarity, initial-time delay gap and R/D ratio.

• The Korean Journal of Ceramics
• /
• v.4 no.1
• /
• pp.28-32
• /
• 1998

This paper reports on photoluminescence (PL), luminescence decay curves, and compositional analysis of porous silicon(PS) which is aged under air ambient by Fourier transform infrared vibrational spectroscopy (FTIR) and by Auger electron spectroscopy (AES). Porous silicos which has been aged under air ambient yields two PL band structures, i.e. blue/violet PL and red PL. The evolution of a blue/violet band is pronounced, especially for thin PS film which is prepared in dilute HF solution. The blue/violet PL band has been observed initially to increrase rapidly with aging, then saturated with further atmospheric aging. The ambient air aged PS exhibits a fast decay time of sub-nanosecond at room temperature and shows appreciably faster decay time than that at 20K. Atmospheric aging of this thin blue/violet luminescing PS yield non-stoichiometric oxide judging from the vibrational spectra of Si-O and AES analysis.

• Applied Science and Convergence Technology
• /
• v.25 no.4
• /
• pp.81-84
• /
• 2016

InP/InGaP quantum structures (QSs) grown on GaAs substrates by a migration-enhanced molecular beam epitaxy method were studied as a function of growth temperature (T) using photoluminescence (PL) and emission-wavelength-dependent time-resolved PL (TRPL). The growth T were varied from $440^{\circ}C$ to $520^{\circ}C$ for the formation of InP/InGaP QSs. As growth T increases from $440^{\circ}C$ to $520^{\circ}C$, the PL peak position is blue-shifted, the PL intensity increases except for the sample grown at $520^{\circ}C$, and the PL decay becomes fast at 10 K. Emission-wavelength-dependent TRPL results of all QS samples show that the decay times at 10 K are slightly changed, exhibiting the longest time around at the PL peak, while at high T, the decay times increase rapidly with increasing wavelength, indicating carrier relaxation from smaller QSs to larger QSs via wetting layer/barrier. InP/InGaP QS sample grown at $460^{\circ}C$ shows the strongest PL intensity at 300 K and the longest decay time at 10 K, signifying the optimum growth T of $460^{\circ}C$.

• Current Optics and Photonics
• /
• v.2 no.6
• /
• pp.589-594
• /
• 2018

We have investigated the dimensional nature of center-of-mass exciton confinement states in a CdMnTe/CdTe/CdMnTe heterostructure, where the CdTe well is too wide (144 nm) to confine both electrons and holes but able to confine whole excitons in the center-of-mass coordinate. Fine multiple photoluminescence spectra with a few meV separation were observed at 6 K. From the thickness dependence of the transition rate, they were attributed to even numbered center-of-mass exciton confinement states (N = 2, 4, 6, ${\cdots}$, 18). Dimensionality of the center-of-mass exciton confinement states was also investigated in terms of temperature dependence of radiative decay time. At low temperatures (${\leq}12K$), we found that the ground state excitons are likely localized possibly due to the barrier interface fluctuation, resulting in a constant decay time (~350 ps). With increased temperature (${\geq}12K$), localized excitons are thermally released, giving rise to a linear temperature dependence of radiative decay time as an evidence of two-dimensional nature.

• Agricultural and Biosystems Engineering
• /
• v.1 no.1
• /
• pp.38-42
• /
• 2000

Though the freshness for agricultural products is an important factor related to their quality management, this terminology is being used restrictedly because it is very subjective. In this study, a dimensionless index which had the span of the maximum of 1 through the minimum of 0 was proposed to describe freshness of the product with time-variant quality and was applied to Tsugaru and Fuji apples. First, the compressive properties having the linearity in their change regarding time elapsed after harvest were selected. For Tsugaru apple, bio-yield and rupture forces had high correlation with time while for Fuji, bio-yield and rupture deformations had high correlations. When the slope, or ratio of force to deformation, was considered, the effect of cultivar could be neglected. When the linearly time-variant compressive properties for Tsugaru and Fuji apples were involved in the freshness indices, they described well freshness of apples. Also, the freshness decay constant depicted a characteristic which related to freshness decay rate. Therefore, the freshness index can be utilized to manage the quality during storage and distribution of apples.

• Bulletin of the Korean Mathematical Society
• /
• v.57 no.6
• /
• pp.1393-1408
• /
• 2020

In this paper we mainly study existence and regularity of mild solutions to the parabolic-elliptic system of drift-diffusion type with small initial data in Fourier-Besov spaces. To be more detailed, we will explain that global-in-time mild solutions are well-posed and Gevrey regular by means of multilinear singular integrals and Fourier localization argument. Furthermore, we can get time decay rate estimate of mild solutions in Fourier-Besov spaces.