• 한국정보통신설비학회:학술대회논문집
• /
• 2008.08a
• /
• pp.469-472
• /
• 2008

In this paper, we discuss the recent trends on the passive UHF RFID tag chip design techniques and several important system parameters. We also summarize link budget studies on both conventional and modem UHF RFID communications. The paper highlights the reverse link limited case, which has known to be the minor concern if reader continuous wave (CW) can reach the tag in sufficient level. This makes sense when the tag sensitivity is rather high (over 10-12${\mu}W$); however, since the tag chip fabrication technologies have been developed by time, the tag chip threshold levels are now less-dominant in determining link margin. If the tag limitation can be alleviated, the forward link limited case can be resolved; thus, we rather focus on the path-loss problem. Since the path-losses are still exist in both forward and reverse links, and it can be doubled while CW travels the reader-tag-reader path because forward link and reverse link are on the same distance. Consider if reader receiver sensitivity is very high in the worst case. In this case, weaken tag response (i.e., backscatters) cannot reach the level that reader receiver can process tag data; bit-error rate can be higher. Overall, backscatter levels should be high enough so that reader receiver can correctly function. After discussing link budget, we carried out practical measurements on fading effects between two circularly polarized UHF RFID antennas in a small scale area.

• Journal of IKEEE
• /
• v.2 no.1 s.2
• /
• pp.122-133
• /
• 1998

The CL network fer CBDS(Connectionless Broadband Data Service) defined by ITU-(International Telecommunication Union-Telecommunication) consists of CL(ConnectionLess) servers which route frames and links which connect between CL user and CL server or between CL servers[1][2]. In this configuration, two kinds of congestion, CL link congestion and CL server congestion may occur. Therefore this paper has proposed the scheme that can deal with the above congestion state of LAN traffic efficiently in interworking LANs in ATM network. Proposed schemes ale link-by-link scheme and hybrid scheme. Link-by-link scheme uses the ABR feedback loops of AIM layer between CL user and CL server or between CL servers, and the header translation table carrying out the routing function of frame. And hybrid scheme is the scheme that adds end-to-end loop to link-by-link scheme and then uses RM message using CLNAP-PDU(ConnectionLess Network Access Protocol - Protocol Data Units) of CL layer. These schemes can be implemented easily because of using the ABR loop of ATM layer, end-to-end loop of CL layer, and the routing function of CL server. In this paper the characteristic and effects of two schemes in CL server bas been compared and analyzed.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.9 no.7
• /
• pp.1425-1431
• /
• 2005

In this paper, we consider the ISR(Intelligence, Surveillance, and Reconnaissance) system which collects the imagery intelligence from an airplane and CDL(common data link) communication system which transports the information obtained by the ISR system. The IMINT(imagery intelligence) consists of MPEG-2 transport stream packets and they transmit through CDL. We have some simulations for communication performances of CDL and show performance improvements using convolutional coding. We have compared BER performances under AWGN channel and fading channel which is caused by the velocity of an airplane.

• Aerospace Engineering and Technology
• /
• v.8 no.2
• /
• pp.105-112
• /
• 2009

Telemetry data is very important for the Launch Mission and Flight Safety Control during the Space Launch. In Naro Space Center, several telemetry stations such as a small station in the NARO space center, two stations in Jeju and a downrange station on a ship are deployed for the stable acquisition/receiving of the telemetry signals. In this paper, the Link Margin and Reliability for the telemetry are analyzed to evaluate the probability of the signal receiving of each station. Even though the proper analysis is to using the on-board EIRP(Effective Isotropic Radiation Power) values in the direction of the ground station considering the predicted flight trajectory and the locations of the stations, the global EIRP of 95% spatial coverage has been used for the analysis, due to the limitation of the available data.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.36 no.12B
• /
• pp.1728-1735
• /
• 2011

In this paper, satellite data link waveform is proposed which is based on the waveform of Link-16 but LDPC code is studied instead of CCSK code in order to be optimized to satellite nonlinear channel environment and transmission characteristics. And the DSM (Demux, Selective CH switch, and Mux) transponder structure is suggested which can remove all of the jamming signal out of the transmission signal band and convert uplink hopping frequency to desired ones of downlink. The results of BER and anti-jamming performance analysis shows that the required Eb/No and processing gain in the worst case partial band jammer of the proposed waveform are 2.5dB and 52dB respectively and the anti-jamming capacity improvement of DSM transponder is maximum 2dB.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.41 no.12
• /
• pp.1876-1883
• /
• 2016

The new channel model for high data rate common data link(CDL) is proposed. The Two-ray channel, which is composed of the reflected signals on the front ground of the receiver, is considered in this paper. This channel arises due to the curvature of the earth when the altitude of the transmitter is tens of kilometers and distance between the transmitter and the receiver is hundreds of kilometers. The Two-ray channel is modeled by estimating the maximum delay profile and the power delay profile, depending on the transmitting and receiving beamforming angle and the radiation pattern of antenna. The power delay profile has a larger effect on the bit error rate(BER) over signal to noise ratio(SNR) than the maximum delay profile, because the distance range is too long in the proposed channel model.

• The Korean Journal of Applied Statistics
• /
• v.30 no.5
• /
• pp.775-791
• /
• 2017

We frequently encounter binary data in real life. Logistic, Probit, Cauchit, Complementary log-log models are often used for binary data analysis. In order to analyze binary data, Liu (2004) proposed a Robit model, in which the inverse of cdf of the Student's t distribution is used as a link function. Kim et al. (2008) also proposed a generalized t-link model to make the binary regression model more flexible. The more flexible skewed distributions allow more flexible link functions in generalized linear models. In the sense, we propose a binary data regression model using skewed generalized t distributions introduced in Theodossiou (1998). We implement R code of the proposed models using the glm function included in R base and R sgt package. We also analyze Pima Indian data using the proposed model in R.

• 제어로봇시스템학회:학술대회논문집
• /
• 1991.10a
• /
• pp.337-341
• /
• 1991

Fieldbus is a low level serial digital network which will be used for factory automation. This paper describes lower layer implementation of a Fieldbus network interface. Physical layer provides hardware interface between IBM-PC and Fieldbus. Also, physical layer uses manchester coding, shielded twisted pair lines and RS-485 electrical standard. Data link layer includes Intel's iDCX96 real time executive for 8797 one chip microcontroller and Fieldbus data link protocol software.

• 제어로봇시스템학회:학술대회논문집
• /
• 2000.10a
• /
• pp.93-93
• /
• 2000

In this study, physical and data link layer protocols of FOUNDATION Fieldbus are implemented. INTEL386EX and 80196KC are used fer the CPU of PC interface board and sensor interface module, respectively The physical layer protocol of FOUNDATION Fieldbus is developed by using FB3050 chip, the fieldbus communication controller ASIC. The data Link layer protocol of FOUNDATION Fieldbus is implemented by software.

• Proceedings of the Korean Society of Computer Information Conference
• /
• 2018.07a
• /
• pp.121-122
• /
• 2018

본 논문에서는 데이터링크(Data Link)의 메시지 종류에 따른 다중 큐 처리와 종류를 고려하지 않은 단일 큐 처리의 효율적인 측면을 비교분석한다. 데이터링크는 작전에 필요한 자료의 실시간 및 근실시간 교환을 위해 사용되는 체계이다. 무인 공용 데이터링크나 전술 데이터링크는 데이터의 타입이 다양해졌고 데이터의 양이 크게 증가하였다. 이러한 이유로 다양한 데이터의 우선 순위에 따른 다중 큐 처리를 제안하여 데이터링크 개발의 방향을 제시한다.