• Geomechanics and Engineering
• /
• 제1권2호
• /
• pp.155-168
• /
• 2009

Breakdown pressures obtained from the classic, linear elastic breakdown model are compared with the corresponding pressures obtained using a nonlinear material model. Compression test results obtained on sandstone and siltstone are used for that purpose together with previously formulated nonlinear model which introduces elasticity functions to address nonlinear stress-strain behaviour of rocks exhibiting stress-dependent mechanical properties. Linear and nonlinear collapse pressures are also compared and it is shown that material nonlinearities have significant effect on both breakdown and collapse pressures and on tangential stresses which control breakdown pressure around a borehole. This means that the estimates of ${\sigma}_H$ made using linear models give stress values which are different than the real values in the earth. Thus the importance of a more accurate analysis, such as provided by the nonlinear models, is emphasised. It is shown, however, that the linear elastic model does not necessarily over-predict borehole stresses and the opposite case can be true, depending on rock type and test interpretation.

• Wind and Structures
• /
• 제30권3호
• /
• pp.219-229
• /
• 2020

Net pressures on roofs and walls of buildings are dependent on the internal and external pressure fluctuations. The variation of internal and external pressures are influenced by the size and location of the openings. The correlation of external and internal pressure influences the net pressures acting on cladding on different parts of the roof and walls. The peak internal and peak external pressures do not occur simultaneously, therefore, a reduction can be applied to the peak internal and external pressures to obtain a peak net pressure for cladding design. A 1:200 scale wind tunnel model study was conducted to determine the correlations of external and internal pressures and effective reduction to net pressures (i.e., net pressure factors, F_C) for roof and wall cladding. The results show that external and internal pressures on the windward roof and wall edges are well correlated. The largest ${\mathcal{C}}_{{\check{p},net}$, highest correlation coefficient and the highest F_C are obtained for different wind directions within 90° ≤ θ ≤ 135°, where the large openings are on the windward wall. The study also gives net pressure factors F_C for areas on the roof and wall cladding for nominally sealed buildings and the buildings with a large windward wall opening. These factors indicate that a 5% to 10% reduction to the action combination factor, K_C specified in AS/NZS 1170.2(2011) is possible for some critical design scenarios.

• 대한기계학회논문집B
• /
• 제23권10호
• /
• pp.1240-1247
• /
• 1999

Particle motion through a disk type critical orifice placed in a 3.0cm diameter chamber has been studied numerically. In the simulation, the velocity field is solved using Pantankar's SIMPLER algorithm for the compressible flow and convergence of the computation is confirmed if the mass source at each control volume is smaller than $10^{-7}$. The particle motion in the flow field is solved in Lagrangian method. The particle trajectories showed that the particles injected away from the center line are expanded rapidly. At lower pressures, this expansion phenomena are more dominant. At lower pressures, the clear difference in particle and air speed is showed all the way down to the exit plan. It was found that particles with Stokes number of ca.2.5 tend to focus close to the center line very well except the particles travelling near the wall. However, particles with Stokes number greater than ca.2.5 show a tendency to cross the center line.

• Nuclear Engineering and Technology
• /
• 제34권4호
• /
• pp.269-285
• /
• 2002

Water heat transfer experiments were carried out in a uniformly heated annulus with a wide range of pressure conditions. The local heat transfer coefficients for saturated water (low boiling have been measured just before the occurrence of the critical heat flux (CHF) along the length of the heated section. The trends of the measured heat transfer coefficients were quite different from the conventional understanding for the heat transfer of saturated flow boiling. This discrepancy was explained from the nucleate boiling in the liquid film of annular flow under high heat flux conditions. The well-known correlations were compared with the measured heat transfer coefficients. The Shah and Kandlikar correlations gave better prediction than the Chen correlation. However, the modified Chen correlation proposed in the present work showed the best agreement with the present data among correlations examined .

• 설비공학논문집
• /
• 제16권6호
• /
• pp.538-545
• /
• 2004

This paper presents the experimental data for the heat transfer and pressure drop characteristics obtained during the gas cooling process of carbon dioxide in a horizontal tube. The tube in which carbon dioxide flows is made of copper with an inner diameter of 7.73 mm. Experiments were conducted for various mass fluxes and inlet pressures of carbon dioxide. Mass fluxes are controlled at 225, 337 and 450 kg/$m^2$s and inlet pressures are adjust-ed from 7.5 to 8.8 ㎫. The experimental results in this study are compared with the existing correlations for the supercritical heat transfer coefficient, which generally under-predict the measured data. Pressure drop data agree very well with those calculated by the Blasius' equation. Based on the experimental data, a new empirical correlation to estimate the near-critical heat transfer coefficients has been developed.

• Wind and Structures
• /
• 제29권6호
• /
• pp.471-488
• /
• 2019

Wind pressure is a critical argument for the wind-resistant design of structures. The attempt, however, to explore the wind pressure field on buildings still encounters challenges though a large body of researches utilizing wind tunnel tests and wind field simulations were carried out, due to the difficulty in logical treatments on the scale effect and the modeling error. The full-scale measurement has not yet received sufficient attention. By performing a field measurement, the present paper systematically addresses wind pressures on the rectangular attic of a double-tower building. The spatial and temporal correlations among wind speed and wind pressures at measured points are discussed. In order to better understand the wind pressure distribution on the attic facades and its relationship against the approaching flow, a full-scale CFD simulation on the similar rectangular attic is conducted as well. Comparative studies between wind pressure coefficients and those provided in wind-load codes are carried out. It is revealed that in the case of wind attack angle being zero, the wind pressure coefficient of the cross-wind facades exposes remarkable variations along both horizontal and vertical directions; while the wind pressure coefficient of the windward facade remains stable along horizontal direction but exposes remarkable variations along vertical direction. The pattern of wind pressure coefficients, however, is not properly described in the existing wind-load codes.

• 대한화학회지
• /
• 제11권3호
• /
• pp.105-110
• /
• 1967

액체구조의 천이상태이론을 아산화질소($N_2O$)와 사산화질소($N_2O_4$)에 적용하여 이 액체들의 상태합을 유도하였다. 이상태합들을 써서 각 액체의 몰부피, 증기압, 증발엔트로피, 임계점에서의 성질 등, 여러가지 열역학적양들을 계산한 결과 모두 실험치와 좋은 일치를 얻었다.

• 산학경영연구
• /
• 제2권
• /
• pp.141-169
• /
• 1989

Most of the theories of collective bargaining outcomes start with a set of economic variables. The economic constraints, pressures, and incentives influence the bargaining power relationship between labor union and employer. In this paper, the critical macro and micro economic variables that need to be considered in analyzing the economic context of collective bargaining power relationship is outlined. The focus is on the role that economic forces play in shaping the results of bargaining, that is the outcome of negotiations. In this study, the elasticity of the demand for labor is introduced as one of the most important economic aspects that influence bargaining power. Unions will be most successful in increasing wages when they enjoy an inelastic demand for labor. If the demand for labor is not naturally inelastic, some institutional arrangement for "taking wages out of competition" must be sought. Inflation, business cycle, and income policy are influential in shaping both parties' goals and expectations as well. In addition to the analysis of the economic variables, the nature of power is diagonized with some introductory notions about its care and feeding before proceeding to the details of the above issues.

• 한국결정성장학회:학술대회논문집
• /
• 한국결정성장학회 1998년도 PROCEEDINGS OF THE 14TH KACG TECHNICAL MEETING AND THE 5TH KOREA-JAPAN EMGS (ELECTRONIC MATERIALS GROWTH SYMPOSIUM)
• /
• pp.49-54
• /
• 1998

The growth of diamond films in plasma enhanced chemical vapor deposition(PECVD) processes requires high substrate temperatures and gas pressures, as well as high-power excitation of the gas source. Thus determining the substrate temperature in this severe environment is a challenge. The issue is a critical one since substrate temperature is a key parameter for understanding and optimizing diamond film growth. The precise Si substrate temperature calibration based on rapid-scanning spectroscopic ellipsometry have been developed and utilized. Using the true temperature of the top 200 ${\AA}$ of the Si substrate under diamond growth conditions, real time spectroellipsometry (RTSE) has been performed during the nucleation and growth of nanocrystallind thin films prepared by PECVD. RTSE shows that a significant volume fraction of nondiamond(or{{{{ {sp }^{2 } -bonded}}}}) carbon forms during thin film coalescence and is trapped near the substrate interface between ∼300 ${\AA}$ diamond nuclei.

• 지구물리와물리탐사
• /
• 제9권1호
• /
• pp.60-66
• /
• 2006

세 개의 서로 다른 사암 샘플들 -두 개의 합성 샘플과 한 개의 현장 샘플- 에 대해 현장 저류층의 대표적인 구속압력과 공극압력하에서 초음파 시험이 수행되었다. 세가지 사암 샘플들은 (a) 캘사이트 시멘트(calcite intergranula. cement (CIPS))로 만든 합성사암, (b) 실리카 시멘트(silica intergranular cement)로 만든 합성 사암 (c) Otway Basin 의 Boggy Creek 1 시추공에서 시도되는 $CO_2$ 파일럿 프로젝트의 대상 암석층 중 Waarre 층으로부터 추출한 코아 샘플로 구성되어 있다. 공극률은 각각 32%, 33%, 26%이다. 초기시험은 실내건조(room-dried) 상태에 있는 코아들에 대해 구속응력을 5 MPa 씩 단계별로 65 MPa 까지 증가시키며 이루어졌다. 그리고 나서 모든 코아들에 처음에는 온도 $22^{\circ}C$에서 6 MPa 공극압력으로 기체상의 $CO_2$를, 그 다음에는 온도 $22^{\circ}C$ 에서 7 MPa 부터 17 MPa 까지 5 MPa 씩 증가시키면서 액체상의 $CO_2$를 주입하였다. 구속응력은 10MPa부터 65 MPa까지 달리 하였다. P와 S 초음파 파형들이 유효응력이 증가할 때마다 기록되었다. 속도-유효응력 반응들이 P 파와 S 파에 대해 실험 자료들로부터 계산되었으며, 감쇠(1/Qp)들은 스펙트럼 비 방법을 이용하여 파형들로부터 계산되었다. 각각의 사암들에 대한 이론적인 속도-유효응력 계산은 $CO_2$ 압력-밀도 와 $CO_2$ 체적계수-압력 상 다이어그램(phasediagram), Gassmann 유효 매질 이론(effective medium theory)을 이용하여 구하였다. 기체상의 $CO_2$ 주입은 속도-유효응력에서 건조상태(공기로 포화된 상태)에 비해 거의 무시할만한 변화를 가져왔다. 다양한 공극압력에서 액체상의 $CO_2$ 주입은 공기로 포화된 상태에 비해 속도-유효응력 반응을 평균 약 8% 정도 낮게 한다. 실험자료들은 높은 유효응력에서 Gassmann 계산들과 일치한다. 이러한 이론과 일치하는 "임계" 유효응력은 사암의 종류에 따라 달라진다. 이 차이는 각각의 사암 종류의 미세구조에서 미세 균열 수의 차이에 기인한 것이라 생각된다. 높은 유효응력에서의 이론과 의미있게 일치하였으며, $CO_2$ 주입 시 현장에서의 탄성파 거동을 예상하는데 있어서 어느 정도 확신을 준다.