• The Journal of Korea Institute of Information, Electronics, and Communication Technology
• /
• v.13 no.5
• /
• pp.359-369
• /
• 2020

In this paper, we proposed a charge pump (CP) circuit that has a wide operating range while reducing the current mismatch for the PLL that generates the main clock of the CMOS X-Ray detector. The operating range and current mismatch of the CP circuit are determined by the characteristics of the current source circuit for the CP circuit. The proposed CP circuit is implemented with a wide operating current mirror bias circuit to secure a wide operating range and a cascode structure with a large output resistance to reduce current mismatch. The proposed wide operating range cascode CP circuit was fabricated as a chip using a 350nm CMOS process, and current matching characteristics were measured using a source measurement unit. At this time, the power supply voltage was 3.3 V and the CP circuit current ICP = 100 ㎂. The operating range of the proposed CP circuit is △VO_Swing=2.7V, and the maximum current mismatch is 5.15 % and the maximum current deviation is 2.64 %. The proposed CP circuit has low current mismatch characteristics and can cope with a wide frequency range, so it can be applied to systems requiring various clock speed.

• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.22 no.6
• /
• pp.512-515
• /
• 2009

We have fabricated blue phosphorescent organic light emitting diodes (PHOLEDs) using a 3,5'-N,N'-dicarbazole-benzene (mCP) host and iridium (III) bis[(4,6-difluorophenyl)-pyridinato-N,$C^{2'}$] picolinate (Flrpic) guest materials, The Flrpic was partially doped into the mCP host layer, for investigating recombination zone, current efficiency, and emission characteristics of the blue PHOLEDs. The recombination of electrons and holes takes place inside the mCP layer adjacent to the mCP/hole blocking layer interface. The best current efficiency was obtained in a device with an emission layer structure of mCP (10 nm)/mCP:Flrpic (20 nm, 10%). The high current efficiency in this device was attributed to the confinement of Ffrpic triplet excitons by the undoped mCP layer with high triplet energy, which blocks diffusion of Ffrpic excitons to the adjacent hole transport layer with a lower triplet energy.

• Journal of the Korean Institute of Illuminating and Electrical Installation Engineers
• /
• v.23 no.1
• /
• pp.36-40
• /
• 2009

Concrete poles(CP) are popular supports for distribution lines. Various types of grounding electrode, such as copper-clad rods, have been used to maintain CP's ground resistance under the required value. The buried part of CP can also have structural grounding effect because of its iron reinforcing rods inside CPs. In this paper, we measured the total ground current injected into CP ground while measuring the ground current splitting to the metal electrode as well as the total injecting current. By this, it was able to measure the ground current splitting to CP structure. Based on the measured results, interrelationship between ground resistance of metal electrodes and current split factor to CP structure was analyzed.

• Journal of Advanced Marine Engineering and Technology
• /
• v.37 no.3
• /
• pp.260-265
• /
• 2013

Impressed current cathodic protection (ICCP) system is one of the most promising corrosion protection methods. The Effect of ICCP system can be changed at diverse conditions. Particularly, temperature and relative humidity plays a crucial role in CP (Cathodic Protection) effect. Thus, in this study, the influence of temperature and relative humidity on concrete specimens was investigated. Specimens were concrete slab type with a base of $400mm{\times}400mm$ and height of 70mm. To enhance the effect of CP system, seawater was used as an electrolyte. Used anode for ICCP system was mixed metal oxide (MMO) titanium. Test factors were natural potential, CP potential, CP current, and 4-hour depolarization potential. From this study, it could be confirm that CP potential and current were highly influenced by temperature and relative humidity.

• International Journal of Ocean System Engineering
• /
• v.3 no.2
• /
• pp.90-94
• /
• 2013

This study represents the recent laboratory results from cathodic protection (CP) system with the use of sacrificial anodes at different environmental conditions (temperature of $10^{\circ}C$ and $40^{\circ}C$). Specimens were slab type with a dimension of $500mm{\times}50mm{\times}100mm$, and concrete cover thickness were 25mm. Zinc mesh and/or bulk type anodes were installed at the center of specimen to confirm the distance that CP system has influences on the specimen to distribute uniform CP current to rebar. Two different kinds of temperature condition were applied to verify the effect of temperature. Experiments were conducted for 60 days, and the distribution of potential and current that supplied from anode to rebar was measured. From the results, CP potential was varied with time, and temperature played an important role in CP potential variations. Current was also changed with time, and current distribution could be improved by installing additional bulk type anode.

• Proceedings of the KIEE Conference
• /
• 2008.07a
• /
• pp.464-465
• /
• 2008

Concrete poles(CP) are popular supports for distribution lines. Various types of grounding electrode, such as copper-clad rods, have been used to maintain CP's ground resistance under the required value. The buried part of CP can also have structural grounding effect because of its iron reinforcing rods inside CPs. In this paper, we measured the total ground current injected into CP ground while measuring the ground current splitting to the metal electrode as well as the total injecting current. By this, it was able to measure the ground current splitting to CP structure. Based on the measured results, interrelationship between ground resistance of metal electrodes and current split factor to CP structure was analyzed.

• Corrosion Science and Technology
• /
• v.11 no.6
• /
• pp.242-246
• /
• 2012

This measurement represents the effectiveness of sacrificial anode cathodic protection (SACP) system in a coastal bridge structure. To verify the cathodic protection (CP) effect, the monitoring sensor (DMS-100) that could measure potential, corrosion rate, current, concrete resistivity, and temperature was embedded. The measurement conducted for three years after CP system was installed. Specifically, due to the fact that fresh water and sea water was repeated in the bridge structure, this bridge structure presented special CP behavior. Measurement factors were CP potential, CP current, concrete resistivity, and depolarization potential. In addition, visual inspection was also carried out. As a result of current and depolarization measurement, CP system was well activated in most piers.

• Transactions on Electrical and Electronic Materials
• /
• v.16 no.5
• /
• pp.241-249
• /
• 2015

Phase-locked-loops (PLL) have been employed in high-speed data transmission systems like wireless transceivers, disk read/write channels and high-speed interfaces. The majority of the researchers use a charge pump (CP) to obtain high performance from PLLs. This paper presents a review of various CMOS CP schemes that have been implemented for PLLs and the relationship between the CP parameters with PLL performance. The CP architecture is evaluated by its current matching, charge sharing, voltage output range, linearity and power consumption characteristics. This review shows that the CP has significant impact on the quality performance of CP PLLs.

• Corrosion Science and Technology
• /
• v.6 no.6
• /
• pp.269-274
• /
• 2007

The corrosion of steel in concrete is significant in marine environment. Salt damage is one of the most detrimental causes to concrete bridges and port structures. Especially, the splash and tidal zones around water line are comparatively important in terms of safety and life-time point of view. During the last several decades, cathodic protection (cp) has been commonly accepted as an effective technique for corrosion control in concrete structures. Zn-mesh sacrificial anode has been recently developed and started to apply to the bridge column cp in marine condition. The detailed parameters regarding Zn-mesh cp technique, however, have not well understood so far. This study is to investigate how much Zn-mesh cp influences along the concrete column at elevated temperature. About 100 cm column specimens with eight of 10 cm segment rebars have been used to measure the variation of cp potential with the distance from Zn-mesh anode at both $10^{\circ}C$ and $40^{\circ}C$ in natural seawater. The cp potential change and current diminishment along the column specimens have been discussed for the optimum design of cp by Zn-mesh sacrificial anode.

• The Journal of Pediatrics of Korean Medicine
• /
• v.17 no.2
• /
• pp.173-198
• /
• 2003

Back ground : Cerebral palsy(CP) is a static encephalopathy caused by an insult to the brain during the prenatal, perinatal, or postnatal period (ie, up to 2 years). CP can lead to global dysfunction but always includes motor problems Objective : The purpose of this study is to investigate the current tendency of oriental approach to the CP and promote oriental treatment of CP in Korea Method : Investigation of current literature and clinical paper in Korea and Chinese Result and Conclusion : 1) CP fall under the category of wu-chi(five kinds of retardations : 五遲), wu-ruan(five kinds of flaccidity : 五軟), wu-ying(five kinds of Stiffness : 五硬) in oriental medicine and correspond to naoxing-tanhuan in current chinese medicine. 2) CP is mainly caused by weakness of the liver and kidney(肝腎不足), weakness of the spleen and stomach(脾胃虛弱), and the method of treatment is tonify the liver and kidney(補益肝腎), tonify the spleen and replenish qi(補脾益氣), but yu-chi(the faculty of speech : 語遲) is caused by deficiency of the heart(心虛) so that treated with method of invigorating the heart and nourishing blood(補心養血). Recently blood stagnancy the stagnation of qi(氣滯血瘀) is considered as the cause of CP, promoting qi circulation to invigorate blood(行氣活血) is mentioned the treatment of method. 3) In addtion to a herbal medication and acupuncture, the various treatments of scalp acupuncture(頭鍼), acupoint injection(穴位注射), catgut embedding therapy(埋鍼) etc. had been applicated to CP and for the objective evaluation of remedial value, TCD, EEG, BMD have been used.