• Proceedings of the Korea Concrete Institute Conference
• /
• 1996.10a
• /
• pp.175-182
• /
• 1996

This paper deals with the properties of water permeability and porosity of cement mortar substrate coated with siliceous slurry coating under the exposure environment. Conditions of exposure enviornment are four kinds of in constant temperature water and humidity box, in indoor and outdoor exposure. Coated mortar substrate was expected continually increase in water and humidity condition, but was not in dry condition. Watertightness effect of siliceous coating was better in the condition of humidity then the dry condition, and the pore volume was decreased in that condition.

• Geophysics and Geophysical Exploration
• /
• v.21 no.4
• /
• pp.220-230
• /
• 2018

When thermal conductivity of rock is measured with PEDB (Portable Electronic Divided Bar) in a laboratory, it can be greatly influenced by the change of room temperature. Therefore, measuring the thermal conductivity in a thermo-hygrostat is necessary, where it can remain in its constant temperature and humidity condition. In this study, a system for thermal conductivity measurement in a thermo-hygrostat has been set up and the thermal conductivities for the 45 samples collected from GH3 and GH4 boreholes in Ulleung Island have been measured both in dry and saturated conditions. Also, the correlations between those thermal conductivities, density, and effective porosity have been discussed. As a result of correlation analysis among the thermal conductivity, density, and effective porosity, it showed higher correlation with dry samples than saturated samples. Especially, thermal conductivity ratio between saturated and dry conditions shows very high correlation ($R^2=0.90$) with effective porosity.

• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.23 no.9
• /
• pp.718-723
• /
• 2010

In this paper, the following results were obtained from the experiment in which electrification voltage of silicone rubber specimen for thermal bonding were measured under various time, temperature ($10{\sim}40^{\circ}C$), and humidity (30~90%) conditions and different amount of carbon additives (0~15 phr (per hundred resin)). Electrostatics electrification voltage decreased when carbon is up to 10 phr, and there was no electrification voltage in 15 phr condition. The electrostatics electrification voltage did not change over time. When the temperature was constant, electrostatics electrification voltage sharply dropped when the humidity was around 70%. That means, this condition might be appropriate for prevention of charging. The electrification voltage decreased as humidity and amount of carbon increased.

• Korean Journal of Agricultural Science
• /
• v.35 no.1
• /
• pp.19-24
• /
• 2008

A new compressive strength test specimen for linerboard and medium was developed, and tested for its agreement with conventional testing methods such as RCT and STFI. The new specimen enables compressive testing under the changing humidity and temperature. Experimental results showed that the new specimen gave equivalent compressive strengths as the other conventional methods at a constant temperature and humidity. We'll apply the methods under the cyclic humidity and temperature conditions.

• Journal of the Korean Geographical Society
• /
• v.48 no.1
• /
• pp.19-36
• /
• 2013

This study aimed to investigate the change of humidity by city size in South Korea. Using daily mean relative humidity and water vapor pressure during the period of 1954~2011 for 14 weather stations in South Korea, the change of humidity by city size was analyzed. The change of relative humidity had a continuous decreasing trend for the period of 1954~2011. The decreasing trend in large city was bigger than these of rural one. The seasonal relative humidity was significantly changed in spring and winter. The change of water vapor pressure was rarely changed significance of the results by city size. It was not shown the result to constant trend by city size. There was a negative correlation between relative humidity and mean temperature. And change of relative humidity was correlated with city size. Moreover, there was not correlation between relative humidity and water vapor pressure by city size. The decreasing trend of relative humidity was similar to increasing trend of temperature by urbanization. However, there was not shown significant result of water vapor pressure.

• International Journal of Industrial Entomology and Biomaterials
• /
• v.20 no.2
• /
• pp.93-98
• /
• 2010

Bumblebees are widely used to pollinate various crops, especially tomato, in greenhouses and fields. An artificial hibernation is essential for year-round rearing of the bumblebee, which passes through one generation per year. Here, we investigated whether a chilling temperature and humidity affect artificial hibernation of the bumblebee queen Bombus terrestris. In chilling temperature regimes of $0^{\circ}C$, $2.5^{\circ}C$, $5^{\circ}C$, $7.5^{\circ}C$ or $12.5^{\circ}C$ under constant humidity >70%, the queens stored at $2.5^{\circ}C$ exhibited the highest rate of survival, which was 74.0% at one month, 67.0% at two months, 60.0% at three months, 46.0% at 4 months, 33.0% at 5 months, and 24.0% at 6 months. Rates of survival decreased at the following temperatures: $0^{\circ}C$, $5^{\circ}C$, $7.5^{\circ}C$ and $12.5^{\circ}C$. Colony developmental characteristics after diapause were 1.2- to 1.5-fold higher than those of queens stored at $5^{\circ}C$. In terms of chilling humidity, the queens hibernated at 70% under $2.5^{\circ}C$ exhibited the highest rate of survival, which was $93.3{\pm}3.4%$ at one month, $83.3{\pm}0.0%$ at two months, $76.7{\pm}0.0%$ at 3 months and $36.7{\pm}12.1%$ at 5 months. The rates of oviposition, colony foundation and progeny-queen production of queens hibernated at 70% were 80.8%, 30.8% and 30.8%, respectively. These values correspond to 1.7- to 3.3-fold increases in comparison to queens stored at 50% humidity. Therefore, $2.5^{\circ}C$ and 70% R.H. were the favorable chilling temperature and humidity conditions for diapause break of B. terrestris queens.

• Food Science and Preservation
• /
• v.24 no.4
• /
• pp.505-509
• /
• 2017

Water vapor adsorption kinetics of vacuum-dried jujube powder were investigated in temperature and relative humidity ranges of 10 to $40^{\circ}C$ and 32 to 75%, respectively. Water vapor was initially adsorbed rapidly and then reached equilibrium condition slowly. Reaction rate constant for water vapor adsorption of vacuum-dried jujube powder increased with an increase in temperature. The temperature dependency of water activity followed the Clausius-Clapeyron equation. The net isosteric heat of sorption increased with an increase in water activity. Good straight lines were obtained with plotting of $1/(m-m_0)$ vs. 1/t. It was found that water vapor adsorption kinetics of vacuum-dried jujube powder was accurately described by a simple empirical model, and temperature dependency of the reaction rate constant followed the Arrhenius-type equation. The activation energy ranged from 50.90 to 56.00 kJ/mol depending on relative humidity. Arrhenius kinetic parameters ($E_a$ and $k_0$) for water vapor adsorption by vacuum-dried jujube powder showed an effect between the parameters with the isokinetic temperature of 302.51 K. The information on water vapor adsorption kinetics of vacuum-dried jujube powder can be used to establish the optimum condition for storage and processing of jujube.

• Journal of the Korea Institute of Building Construction
• /
• v.4 no.4
• /
• pp.71-77
• /
• 2004

Drying Shrinkage has much complexity as it has relations with both internal elements of concrete and external factors. Therefore, experiments on Concrete Drying Shrinkage are carried out in this study under simplified circumstances applying temperature & Humidity test chamber which enables constant temperature and humidity. Comparative analyses have been made respectively according to the consequences aiming at modelling for prediction of Concrete Drying Shrinkage and making out measures to reduce it. Strain Rate of Drying Shrinkage of concrete under the condition of dry air appears to rise by about 20%-30% in proportion as the temperature rises $5^{\circ}C$ when the humidity was held below 10% compared under the condition of dry temperature & Humidity test chamber. Strain Rate of Drying Shrinkage in pit sand concrete increased 20% higher than measured when in river sand under the condition of 90-day material age. A general formula with two variables is derived as follow ${\varepsilon}={\alpha}_1＋{\beta}_1x_1＋{\beta}_2x_2＋{\beta}_3x_1^2＋{\beta}_5x_2^2$. and also graphed in 3 dimensions, enabling to apply to actual design and predict Strain Rate of Drying Shrinkage in concrete. The results of prediction of Rate of Drying Shrinkage by Response Surface Analysis are as follows. The coefficient of correlation of Drying Shrinkage in Concrete was over 90%.

• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.28 no.9
• /
• pp.587-592
• /
• 2015

In this study, the electrification voltage of electrostatics for silicone rubber sample($4cm{\times}4cm{\times}0.103cm$) following immersion with contaminants of 2 ml, 5 ml, 10 ml for six hours has been measured in through the applied voltage of 10 kV DC at temperature of $80^{\circ}C{\sim}110^{\circ}C$, humidity of 50%~90%. The results of this study are as follows. In case the contaminants is constant, it found that the electrification voltage of electrostatic decreased with increasing temperature and humidity to $35^{\circ}C$, 90%. In case of 2 ml of contaminants concentration, it found that the electrification voltage of electrostatic decreased with increasing temperature and humidity to $35^{\circ}C$, 50%. In case of the sample at temperature of $15^{\circ}C$ and humidity of 50%, it found that the electrification voltage of electrostatic decreased with increasing contaminants to 10 ml.

• Journal of the Korean Data and Information Science Society
• /
• v.15 no.4
• /
• pp.935-943
• /
• 2004

Most of the accelerated life tests deal with tests that use only one accelerating variable and no other explanatory variables. Frequently, however, there is a test to use more than one accelerating or other experimental variables, such as, for examples, a test of capacitors at higher than usual conditions of temperature and voltage, a test of circuit boards at higher than usual conditions of temperature, humidity and voltage. A accelerated life test is extended to M-level stress accelerated life test with k-stress variables. The optimal design for Weibull distribution is studied with k-stress variables.