• Journal of the Korean Professional Engineers Association
• /
• v.38 no.1
• /
• pp.44-51
• /
• 2005

A recent study conducted by KOTI reported that regional and urban read congestion costs in Korea are continually rising in the ranges between 3.1% thru 4.1% of GDP in the every respective year during the past 10 years. The report explicates that the congestion problem has motivated sharp raise of the logistics expenditure from 4.4% of GDP in the year of 1998 to 16% in the year of 2003. Even though, the government has allotted annual budget in the ranges between 2.7% and 3.7% of GDP to the SOC investment for the consecutive years of past decade, the amounts are however far less and insufficient to meet with social requirements and its demands. The cost of logistics has been excessively went up much higher rate than that of other industries and that of 9.6% in Japan and United States respectively It is obvious that the high logistics cost could be a detrimental factor to fierce emulation with others in the global trade market. Therefore it is an essential matter to eliminate or exclude all the probable sources that might cause or create extra costs on logistics. In consideration of such situation in Korea, the SOC investment with private capital could be a best cogitable scheme to acquire its prompt demand solutions and stimulate the emulation ability in the international trade market what's more betterment for all of our quality life in the near future.

• ETRI Journal
• /
• v.43 no.5
• /
• pp.799-811
• /
• 2021

This paper considers a challenging problem: to simultaneously optimize the cost and the quality of service in opaque wavelength division multiplexing (WDM) networks. An optimization problem is proposed that takes the information including network topology, traffic between end nodes, and the target level of congestion at each link/ node in WDM networks. The outputs of this problem include routing, link channel capacities, and the optimum number of switch ports locally added/dropped at all switch nodes. The total network cost is reduced to maintain a minimum congestion level on all links, which provides an efficient trade-off solution for the network design problem. The optimal information is utilized for dynamic traffic in WDM networks, which is shown to achieve the desired performance with the guaranteed quality of service in different networks. It was found that for an average link blocking probability equal to 0.015, the proposed model achieves a net channel gain in terms of wavelength channels (𝛾_w) equal to 35.72 %, 39.09 %, and 36.93 % compared to shortest path first routing and 𝛾_w equal to 29.41 %, 37.35 %, and 27.47 % compared to alternate routing in three different networks.

• Journal of Korean Port Research
• /
• v.6 no.1
• /
• pp.49-68
• /
• 1992

Recently changes in the technological environment of marine transportation and the increase of traffic volume have fostered a revolution in the design and operation of port and also playing a major role in the development of new types of port in Asian. These changes are dynamic and will continue to influence port physical distribution system. The port of Pusan has been hardly able to handle the traffic increases in recent years by expansion increased mechanization and other operational and institutional improvements but, further traffic increases bring about critical congestion and such congestion is an economic cost to the country in terms of cost of physical distribution. This paper treats the development of entirely new port of Pusan and related transportation system by considering the existing or expected need for improved port capacity and services. The western part of GADUK island is selected as the optimum port site through the detailed analysis of the physical requirement and careful consideration of regional development and since the lead time of the national development plan including the port project from initial planning to implementation is considered as long as 7 to 10 years the aggregated master plan for port development is made and implemented in the year of 2012.

• Journal of Korean Society for Geospatial Information Science
• /
• v.12 no.4 s.31
• /
• pp.53-60
• /
• 2004

Congestion index is needed for quantifying congestion level for various areas. So far, the index has been calculated based on multiple vehicle data for specified time interval. Such being the case, it was costly to build it and the usage of it was focused on policy development and evaluation rather than on traffic information provision. This study focuses on a development on a single vehicle based congestion index which can be a representative value for link congestion level and link speed information at the same time for dual purposes of traditional usages and information provision. A new term has been added for representing real time based arterial congestion level and it has been verified on a real time basis. The index was based on single vehicle GPS data and seemed to be cost effective in deriving the index. With the help of the index, the traffic information contents can be diversified in a constructive way in providing real time traffic information for ITS area and in using congestion level determination for traditional transportation areas.

• The Journal of The Korea Institute of Intelligent Transport Systems
• /
• v.13 no.4
• /
• pp.1-11
• /
• 2014

Traffic congestion cost is more likely to occur in the inner city than interregional road, and it accounts for about 63.39% of the whole. Therefore, it is important to mitigate traffic congestion of the inner city. Traffic congestion in the urban could be divided into Recurrent congestion and Non-recurrent congestion. Quick and accurate detection of Non-recurrent congestion is also important in order to relieve traffic congestion. The existing studies about incident detection have been variously conducted, however it was limited to Uninterrupted Traffic Flow Facilities such as freeway. Moreover study of incident detection on the interrupted Traffic Flow Facilities is still inadequate due to complex geometric structure such as traffic signals and intersections. Therefore, in this study, incident detection model was constructed using by Artificial Neural Network to aim at urban arterial road that is interrupted traffic flow facility. In the result of the reliability assessment, the detection rate were 46.15% and false alarm rate were 25.00%. These results have a meaning as a result of the initial study aimed at interrupted traffic flow. Furthermore, it demonstrates the possibility that Non-recurrent congestion can be detected by using car navigation data such as car navigator system device.

• Journal of Electrical Engineering and Technology
• /
• v.7 no.4
• /
• pp.501-512
• /
• 2012

Social welfare maximization in a double-sided auction market is performed by implementing an aggregation-based particle swarm optimization (CAPSO) algorithm for optimal placement and sizing of one Static Synchronous Series Compensator (SSSC) device. Dallied simulation results (without/with line flow constraints and without/with SSSC) are generated to demonstrate the impact of SSSC on the congestion levels of the modified IEEE 14-bus test system. The proposed CAPSO algorithm employs conventional quadratic smooth and augmented quadratic nonsmooth generator cost curves with sine components to improve the accurate of the model by incorporating the valve loading effects. CAPSO also employs quadratic smooth consumer benefit functions. The proposed approach relies on particle swarm optimization to capture the near-optimal GenCos and DisCos, as well as the location and rating of SSSC while the Newton based load flow solution minimizes the mismatch equations. Simulation results of the proposed CAPSO algorithm are compared to solutions obtained by sequential quadratic programming (SQP) and a recently implemented Fuzzy based genetic algorithm (Fuzzy-GA). The main contributions are inclusion of customer benefit in the congestion management objective function, consideration of nonsmooth generator characteristics and the utilization of a coordinated aggregation-based PSO for locating/sizing of SSSC.

• Structural Engineering and Mechanics
• /
• v.47 no.2
• /
• pp.227-245
• /
• 2013

The term "constructability" in regard to cast-in-place concrete construction refers mainly to the ease of reinforcing steel placement. Bar congestion complicates steel placement, hinders concrete placement and as a result leads to improper consolidation of concrete around bars affecting the integrity of the structure. In this paper, a multi-objective approach, based on the non-dominated sorting genetic algorithm (NSGA-II) is developed for optimal design of reinforced concrete cantilever retaining walls, considering minimization of the economic cost and reinforcing bar congestion as the objective functions. The structural model to be optimized involves 35 design variables, which define the geometry, the type of concrete grades, and the reinforcement used. The seismic response of the retaining walls is investigated using the well-known Mononobe-Okabe analysis method to define the dynamic lateral earth pressure. The results obtained from numerical application of the proposed framework demonstrate its capabilities in solving the present multi-objective optimization problem.

• Journal of the Korean Professional Engineers Association
• /
• v.42 no.4
• /
• pp.45-50
• /
• 2009

The modal split structure of the Korea's transportation system has been dominated by road-oriented structure. The shortage of the inftrastructure to accommodate the rapidly increasing travel demand has brought about socio-economic losses such as severe traffic congestion and high logistic costs, and thereby weakened the competitiveness of the country. Highway transportation sector is more vulnerable to energy consumption comparing with railway sector since the highway sector is dependent mostly on fossil fuels for its energy source. In 2006 annual road cogestion costs in Korea reached 24.6 trillion won, with an average annual growth rate of 5.4%. The annual road congestion cost of intercity highways were 9.2 trillion won. As the new cities that recently developed are located far from Seoul area, the boundary of commuting in Seoul metropolitan area is extended. It makes passengers have longer trips with longer travel time, and the congestion problem to be more serious. In this regards, Gyeonggi Provincial Government proposed a deeper underground metropolitan express train system for the greater Metropolitan area. which is named as GTX. Gyeonggi Province suggested 3 key underground lines, based on the outcome of the feasibility study conducted by the Korea Society of Transportation, and submitted to the Ministry of Land Transportation and Maritime Affairs for its review. If the project is approved for construction and completed in 2016, the daily volume of surface traffic bound for Seoul will be reduced substantially and therefore the users will be benefitted for time savings by an annual amount of 2 trilion won every year.

• Journal of the Korea Society for Simulation
• /
• v.10 no.3
• /
• pp.47-58
• /
• 2001

Evaluation of Freeway Congestion Management Using Mesoscopic Traffic Simulator A mesoscopic simulation study to measure the effects of trip generation caused by rampant expansion of residential area around the Kyungbu corridor has been conducted. Some alternatives, which seem to be judgememtally plausible and technically feasible to mitigate such congestion, have been carefully examined and evaluated by the simulation model called INTEGRATION. Alternatives are mostly network improvements. Banpo IC dedicated ramp construction (A1), Seocho IC TSM based weaving elimination (A2), dedicated local and express separation over Seocho-Yangjae segment (A3), Heonleung IC (A4) and Daewang If installations (A5), Pangyo IC improvement (A6), Baikhyun IC (A7) and Dongbaek IC installations (A8) along with Shingal-Pangyo segment capacity addition (A9). The most capital intensive ones are A9, A5, and A4 in that order. A1, A6, A7, and A8 are short in distance but they are also capital intensive and need some construction periods. The least capital driven alternatives are h2 and A3, the h2 is easier to do, but A3 needs traffic diversion scheme during construction. The A1, A7, and A8 have been identified cost effective in terms of speed increase and travel time saving. Along with these results, some limitations and future research agenda regarding simulation have also been presented.

• International Journal of Internet, Broadcasting and Communication
• /
• v.14 no.1
• /
• pp.152-161
• /
• 2022

Recently, it is recognized as a high-cost and inefficient logistics system that increases traffic congestion and environmental problems due to an increase in traffic volume due to the activation of the online market. In order to solve inefficient problems such as unavoidable traffic congestion and environmental problems caused by the increase in traffic volume, it is necessary to develop a freight transport system technology using the existing urban railway infrastructure and freight-only urban railway. The urban subway logistics system is a logistics system that requires a combination of various technologies to solve the nationwide demand for urban logistics and road traffic problems. This paper recognized the existing traffic congestion and environmental pollution of road traffic as problems, and supplemented the contact point requirements presented above by identifying the sub-systems constituting the target system and supplementary points for each part-level contact point. In this study, as a complex system operated for one purpose by grafting various technologies, a plan is required to secure the reliability and safety of operation from various viewpoints. The results of this study can contribute to the initial configuration and basic data to solve the interface bottleneck of the urban subway logistics system to be promoted in the future.