• Proceedings of the KSR Conference
• /
• 2004.10a
• /
• pp.489-496
• /
• 2004

The effect of airconditioning and heating system when aircurtains installed in subway electrical rolling stock at entrance door. It blocks cold/hot air of outside. It is good for health with its blocking effect against dusts exhaust fumes, odor bugs and smoke from outside. It always maintains clean and pleasant atmosphere inside. It helps you to have health with its ever-equal temperature distribution at inside. It saves lots of maintenance cost for heating/cooling (about 86$\%$) since it cuts the loss of hot air under heating as well as of cold air under air-conditionin. Customers can feel pleasant go in and out (better than before) with the door. It is an indispensable product for the employers to cut the cost. It makes customers feel pleasant near doors, since it isnt influenced by temperature difference of cold/hot air when the door opens/closes. In electrical rolling stock passenger temperature is a lot different from that the door opens/closes. One of the main aims is to create an acceptable thermal environment without draught problem. Temperature, gradients when aircurtains installed in subway electrical rolling stock at entrance door have been studied. And the temperature measured at 0.1, 0.5, 1.3, 1.7m above the floor. It has been found that temperature, with large fluctuations caused more draught influence.

• Proceedings of the Korea Concrete Institute Conference
• /
• 2008.04a
• /
• pp.1001-1004
• /
• 2008

This study reviewed the results of utilization of insulation heat curing method using double layer bubble sheet in slab concrete and mass concrete in cold weather environment. First of all, when double layer bubble sheets are applied, it was shown that slab concrete was protected from early freezing by remaining between 6 and $10^{\circ}C$ even in case outside temperature drops $10^{\circ}C$ below zero until the 2nd day from piling, and in the case of mass concrete, with the maximum temperature difference between the center and surface less than $6^{\circ}C$, crack occurrence index was close to 2 and no hydration heat crack occurred by internal constraint. The insulation heat preservation curing method using the double bubble sheet applied in this field prevented early freezing owing to stable curing temperature management, deterring concrete strength development delay at low temperature, and obtained the needed strength. Also, it was proven that the method is highly effective and economic for cold weather concrete quality maintenance through curing cost reduction like construction period shortening and labor cost reduction, etc by reducing the process of temporary equipment installation and disassembling.

• The Bulletin of The Korean Astronomical Society
• /
• v.46 no.2
• /
• pp.70.1-70.1
• /
• 2021

We examine the HI gas kinematics and distributions of galaxy pairs in group or cluster environments from high-resolution Australian Square Kilometer Array Pathfinder (ASKAP) WALLABY pilot observations. We use 32 well-resolved close pair galaxies from the Hydra, Norma, and NGC 4636, two clusters and a group of which are identified by their spectroscopy information and additional visual inspection. We perform profile decomposition of HI velocity profiles of the galaxies using a new tool, BAYGAUD which allows us to separate a line-of-sight velocity profile into an optimal number of Gaussian components based on Bayesian MCMC techniques. Then, we construct super profiles via stacking of individual HI velocity profiles after aligning their central velocities. We fit a model which consists of double Gaussian components to the super profiles, and classify them as kinematically cold and warm HI gas components with respect to their velocity dispersions, narrower or wider 𝜎, respectively. The kinematically cold HI gas reservoir (M_cold/M_HI) of the paired galaxies is found to be relatively higher than that of unpaired control samples in the clusters and the group, showing a positive correlation with the HI mass in general. Additionally, we quantify the gravitational instability of the HI gas disk of the sample galaxies using their Toomre Q parameters and HI morphological disturbances. While no significant difference is found for the Q parameter values between the paired and unpaired galaxies, the paired galaxies tend to have larger HI asymmetry values which are derived using their moment0 map compared to those of the non-paired control sample galaxies in the distribution.

• Steel and Composite Structures
• /
• v.48 no.1
• /
• pp.27-41
• /
• 2023

Under the long-term effect of corrosive environment, many cold-formed steel (CFS) structures have serious corrosion problems. Corrosion leads to the change of surface morphology and the loss of section thickness, which results in the change of instability mode and failure mechanism of CFS structure. This paper mainly investigates the elastic local buckling behavior of corroded CFS columns. The surface morphology scanning test was carried out for eight CFS columns accelerated corrosion by the outdoor periodic spray test. The thin shell finite element (FE) eigen-buckling analysis was also carried out to reveal the influence of corrosion surface characteristics, corrosion depth, corrosion location and corrosion area on the elastic local buckling behaviour of the plates with four simply supported edges. The accuracy of the proposed formulas for calculating the elastic local buckling stress of the corroded plates and columns was assessed through extensive parameter studies. The results indicated that for the plates considering corrosion surface characteristics, the maximum deformation area of local buckling was located at the plates with the minimum average section area. For the plates with localized corrosion, the main buckling shape of the plates changed from one half-wave to two half-wave with the increase in corrosion area length. The elastic local buckling stress decreased gradually with the increase in corrosion area width and length. In addition, the elastic local buckling stress decreased slowly when corrosion area thickness was relatively large, and then tends to accelerate with the reduction in corrosion area thickness. The distance from the corrosion area to the transverse and longitudinal centerline of the plate had little effect on the elastic local buckling stress. Finally, the calculation formula of the elastic local buckling stress of the corroded plates and CFS columns was proposed.

• Transactions of the Korean Society of Pressure Vessels and Piping
• /
• v.19 no.2
• /
• pp.102-108
• /
• 2023

A Chloride-induced stress corrosion cracking (CISCC) of austenite stainless steel in dry cask storage system (DCSS) can occur with extending service time than originally designed. Cold spray coating (CSC) not only form a very dense microstructure that can protect from corrosive environments, but also can generate compressive stress on the surface. This characteristic of CSC process is very helpful to increase the resistance for CISCC. CSC with several powders, such as 304L, 316L and Ni can be optimized to form very dense coating layer. In addition, the impact energy generated as the CSC powder collides with the surface of base metal at a speed of Mach 2 or more can remove the residual tensile stress of welding area and serve the compress stress. CSC layers include no oxidation and no contamination with under 0.2% porosity, which is enough to protect from the penetration of corrosive chloride. Therefore, the CSC coating layer can be accompanied by a function that can be disconnected from the corrosive environment and an effect of improving the residual stress that causes CISCC, so the canister's CISCC resistance can be increased.

• Journal of the korean society of oceanography
• /
• v.37 no.4
• /
• pp.212-223
• /
• 2002

Cochlodinium polykrikoides bloom in 1995 was studied with a focus on an unusual coastal environment in the South Sea of Korea. Data on temperature, salinity, and zooplankton biomass during 1965-1998 and nutrients during 1990-1998 and chlorophyll-a during 1995-1998 were used in this study. These data were obtained from the serial oceanographic observations in Korean waters carried out by the National Fisheries Research and Development Institute. In 1995 the C. polykrikoides bloom began in the coastal area around Narodo Island in August and consequently occurred to the whole coastal area of the South and East Seas of Korea. During June-October 1995, the coastal environment was unusual compared with the long-term means during 1965-1998. In June 1995, sea surface temperature was 1-2$^{\circ}C$ warmer than in other years in all coastal areas, while salinity was high only to the east of Jeju Island. In August 1995, a strong coastal front appeared inshore of a line between Jeju and Tsushima Islands. In particular, a strong coastal front which showed the characteristics of upwelling front occurred in the coastal area around Narodo and Sorido Islands, not only because of a strong intrusion of the Tsushima Warm Current but also because of the upwelling of cold bottom water. Salinity was low in the neighboring waters of western side of Jeju Island. Nutrients and chlorophyll-a were high in the inshore area between Narodo and Sorido Islands in 1995 in contrast with the other years and areas. Zooplankton showed an unusually high abundance in the coastal area in October 1995. We conclude that the Tsushima Warm Current strongly influenced the South Sea of Korea in 1995 and created strong upwelling front bordering cold upwelled water in the coastal area around Narodo and Sorido Islands. It leads us that these physical structures introduce the favorable environment for the development of C. polykrikoides blooms. We suggest that C. polykrikoides has a bio-physical tolerance of high shear and stress and prefers frontal and upwelling relaxed areas as its habitat. We also find that nutrients were not supplied to the coastal area from the offshore where a low salinity water mass with high nutrients appeared around Jeju Island. Because the strong upwelling front protect the reach of offshore low saline water mass. The main source of nutrients was the upwelled water mass in the coastal area of Wando-Narodo-Sorido.

• The Journal of the Korea Contents Association
• /
• v.20 no.9
• /
• pp.187-194
• /
• 2020

The purpose of this study is to examine the effect of police investigation environment on perception toward legalization of private investigation. To enhance the completeness, this study conducted a survey on police officers in service and analyzed the survey data through statistical technique. The results for examination on how police investigation environment influence on perception toward legalization of private investigation were as follows. When the 'work burden from long-term cold case' composing the police investigation environment is high, the police officer highly evaluated the growth potential of private investigation, showed positive perception toward private investigation market, and showed intention for re-employment at private investigation agency after retirement. When the police officer experiences more difficulties from 'investigation other than criminal case', the police officer highly evaluated the growth potential of private investigation and showed intention for re-employment at private investigation agency. In addition, when the police officer thinks that there are a lot of difficulties for "Limited investigation on specialized area", the police officer showed positive perception toward growth potential of private investigation and private investigation market. In addition, police investigation environment showed significant result on legalization of private investigation. The result also verifies that as the difficulty of crime investigated by the police is getting higher quantitatively and qualitatively, it is necessary to introduce private investigation system which is specialized and able to investigate for a long time. This study hopes that this study result would be utilized as the grounds in signing the bill for introducing the private investigation system.

• Applied Chemistry for Engineering
• /
• v.20 no.3
• /
• pp.301-306
• /
• 2009

This research was carried out to establish the effective treatment condition and characteristic of wastewater from the electroplating plant of cold rolling mill by using microorganism. Alkaline wastewater and acidic heavy metal wastewater accounted for 64%, 30%, respectively, of the total wastewater. Highly concentrated thiocyanate was 53890 mg/L as COD and it was 53% of total COD, even though it was 0.03% of wastewater from the electroplating plant. When treating mixed wastewater with microorganism, it was easy to remove when SCN concentrations of mixed wastewater was 200 mg/L or less. While the treatment effect of COD-causing materials was low at the concentration of 400 mg/L or less, it implies that highly concentrated thiocyanate contains a large amount of slowly biodegradable organics. When treating with mixed wastewater, pH was 7.33 at the beginning, but after 8 hours it increased to 7.99. This is caused by ammonia which is generated when SCN of highly concentrated thiocyanate was degraded by microorganism.

• Journal of computational fluids engineering
• /
• v.20 no.3
• /
• pp.8-14
• /
• 2015

More and more, spaces are decreasing which satisfy multiple requirements for wind power plants. However, areas which have excellent wind resources and are free to civil complaints occupy a large space, although they are exposed to the cryogenic environment. This study conducted a thermal-fluid analysis of a cryogenic chamber for testing large wind turbine parts exposed to the cryogenic environment. The position of supply air is placed to the upper area to compare each cooling performance for each location of various outlets in mixing ventilated conditions. The study carried out CFD analysis for the chamber both with and without a test object. For the cases without the test object, the air temperature of the upper supply and down extract type chamber was cooled faster by 5-100% than the others. However, for the cases with the test object, the object temperature of upper supply and center extract on the opposite side type chamber was cooled faster by 33-132% than the others. The cooling performance by the air inside the chamber and the test object did not show the same pattern, which implicates the need to consider the cooling performance by not only the air but also the test object in the large cryogenic chamber design for testing large parts.

• Journal of the Korean Society for Marine Environment & Energy
• /
• v.11 no.2
• /
• pp.92-97
• /
• 2008

Salt wedge into the river from the sea or fresh water flume (fresh wedge) in the ocean from the sea has density current characteristics. However, when temperature and salinity simultaneously determine the density of wedges, one of salinity and temperature can distributed in the reversed profiles against gravity, even though the density profile is stable. In this case, the double diffusive process is critical in determining mixing rate. The present work studies relative contribution of shear driven mechanical mixing component and double diffusive layering process, when warm salty denser water is introduced into the cold fresh lighter water column. Laboratory experiment releases warm salty denser water into cold fresh lighter water controlling discharge amount to achieve the steady state of density current. When longitudinal density rate becomes 15, the released amount ratio of salt and heat changes sharply and in the releasing point, vigorous mixing occurs with increase of discharged amount due to double diffusion. Double diffusion distabilizes gravitational stability and enhances the mixing rate up to $6{\times}10$ times at the lower density ratio comparing to the higher density ratio.