• Proceedings of the KIPE Conference
• /
• 2014.07a
• /
• pp.213-214
• /
• 2014

This paper compares two instantaneous reactive power definitions in DFIG wind turbine with a back-to-back three-level neutral-point clamped voltage source converter under unbalanced grid conditions. In general, conventional definition of instantaneous reactive power is obtained by taking an imaginary component of complex power. The other definition of instantaneous reactive power can be developed based on a set of voltages lagging the grid input voltages by 90 degree. A complex quantity referred as a quadrature complex power is defined. Proposed definition of instantaneous reactive power is derived by taking a real component of quadrature complex power. The characteristics of two instantaneous reactive power definitions are compared using the ripple-free stator active power control algorithm in DFIG. Instantaneous reactive power definition based on quadrature complex power has a simpler current reference calculation control block. Ripple of instantaneous active and reactive power has the same magnitude unlike in conventional definition under grid unbalance. Comparison results of two instantaneous reactive power definitions are verified through simulation.

• Proceedings of the KIPE Conference
• /
• 2014.07a
• /
• pp.367-368
• /
• 2014

This paper investigates characteristics of high power semiconductor device losses in 5MW-class Permanent Magnet Synchronous Generator (PMSG) Medium Voltage (MV) wind turbines. High power semiconductor device of press-pack type IGCT of 6.5kV is considered in this paper. Analysis is performed based on neutral point clamped (NPC) 3-level back-to-back type voltage source converter (VSC) supplied from grid voltage of 4160V. This paper describes total loss distribution at worst case under inverter and rectifier operating mode for the power semiconductor switches. The loss analysis is confirmed through PLECS simulations. In addition, the loss factors due to di/dt snubber and ac input filter are presented. The investigation result shows that IGCT type semiconductor devices generate the total efficiency of 97.74% under the rated condition.

• Proceedings of the KIPE Conference
• /
• 2012.07a
• /
• pp.273-274
• /
• 2012

This paper investigates control algorithms for a doubly fed induction generator(DFIG) with a back-to-back three-level neutral-point clamped voltage source converter in medium voltage wind power system under unbalanced grid conditions. Two different control algorithms to compensate for unbalanced conditions are proposed. Evaluation factors of control algorithm are fault ride-through(FRT) capability, efficiency, harmonic distortions and torque pulsation. Zero regulated negative sequence stator current control algorithm has the most effective performance concerning FRT capability and efficiency. Ripple-free control algorithm nullifies oscillation component of active power and reactive power. Ripple-free control algorithm shows the least harmonic distortions and torque pulsation. Combination of zero regulated negative sequence stator current and ripple-free control algorithm control algorithm depending on the operating requirements and depth of grid unbalance presents the most optimized performance factors under the generalized unbalanced operating conditions leading to high performance DFIG wind turbine system.

• Journal of Chest Surgery
• /
• v.5 no.2
• /
• pp.135-140
• /
• 1972

Papilloma of the upper respiratory tract, particularly larynx and vocal cords are relatively common disease. However, solitary papilloma of the bronchus is extremely rare condition and only a handful cases were reported in the literature. The patient is a 39 year old housewife who has been suffering from productive cough and occasional hemoptysis in the past one year. X-ray of the chest showed complete atelectasis of the right upper lobe. Bronchography revealed a hemispherical protruding mass in the right main bronchus with complete occlusion of the upper lobe bronchus. Bronchoscopy showed a whitish friable mass in the lumen of the right main bronchus biopsy of which was reported as benign papilloma. Right upper lobectomy together with wedge resection of the portion of right main bronchus to include the tumor was done. Cut-edges of the bronchus were stitched together with interrupted fine dacron sutures. During this procedure, right main bronchus was gently clamped with non-crushing Satinsky type clamp. Patient has had uneventful recovery from surgery and was discharged without symptom. Patientis doing well three months following the operation.

• Proceedings of the Korean Society for Noise and Vibration Engineering Conference
• /
• 2013.10a
• /
• pp.730-735
• /
• 2013

This paper contains various vibration analysis of multi-stage shaft shape such as the bending, torsional and axial vibration. The shaft system is modeled as Timoshenko beam with the transverse shear and rotary inertia effect and the equation of motion is derived by Hamilton's principle with considering clamped-free boundary condition. Then, eigenvalue problem of discrete equation of motion for multi-stage shaft model is solved and got results of the natural frequency through the numerical analysis. Obtained numerical analysis results through Matlab program were compared with those of FEM analysis to verify the results. This study suggests that design of shaft system be consider torsional and axial vibration as well as bending vibration.

• Proceedings of the Korean Society for Noise and Vibration Engineering Conference
• /
• 1997.10a
• /
• pp.160-165
• /
• 1997

Structural boundary condition is very important as a part of a structural system because it determines the dynamic characteristics of the structure. It is often to experience that experimental measurements of structural dynamic characteristics are somewhat different from the analytical predictions in which idealized boundary conditions are usually assumed. However, real structural boundary conditions are not so ideal; not perfectly clamped, for instance. Thus this paper introduces a new method to determine the non-ideal structural boundary conditions in the frequency domain. In this method, structural boundary conditions are modeled by both extensional (vertical) and torsional elastic springs. The effective springs are then determined from experimental FRFs (frequency response functions) by using the spectral element method (SEM). For a cantilevered beam experiments are conducted to determine the real boundary conditions in terms of effective springs. Dynamic characteristics (analytically predicted) based on identified boundary conditions are found to be much closer to experimental measurements when compared with those based on ideal boundary conditions.

• Steel and Composite Structures
• /
• v.30 no.6
• /
• pp.577-589
• /
• 2019

In this study, on-site testing was carried out to investigate the vibration performance of a composite steel-bar truss slab with steel girder system. Ambient vibration was performed to capture the primary vibration parameters (natural frequencies, damping ratios, and mode shapes). The composite floor possesses low frequency (< 10 Hz) and damping (< 2%). Based on experimental, theoretical, and numerical analyses on natural frequencies and mode shapes, the boundary condition of SCSC (i.e., two opposite edges simply-supported and the other two edges clamped) is deemed more reasonable for the composite floor. Walking excitations by one person (single excitation), two persons (dual excitation), and three persons (triple excitation) were considered to evaluate the vibration serviceability of the composite floor. The measured acceleration results show a satisfactory vibration perceptibility. For design convenience and safety, a crest factor ${\beta}_{rp}$ describing the ratio of peak acceleration to root-mean-square acceleration induced from the walking excitations is proposed. The comparisons of the modal parameters determined by ambient vibration and walking tests reveal the interaction effect between the human excitation and the composite floor.

• Journal of the Korean Society for Precision Engineering
• /
• v.10 no.4
• /
• pp.163-169
• /
• 1993

A flexible manipulator can move in the high speed even with the small driving torque. The dymanic equations of flexible manipulator which include 2 vibrational modes are derived using the clamped-free boundary condition. Simulation results of the 6th order model are well matched with experimental results. The hub angle of the flexible mainpulator can be controlled without vibration of the beam by the feedback of both hub angle and strain. The overshoot of the hub angle in the step response is reduced without sacrificing the rise time using the cycloidal function instead of the step function as the referenmce input.

• Journal of Korean Association for Spatial Structures
• /
• v.24 no.1
• /
• pp.37-45
• /
• 2024

Steel plate shear walls (SPSWs) have been recognized as an effective seismic-force resisting systems due to their excellent strength and stiffness characteristics. The infill steel plate in a SPSW is constrained by a boundary frame consisting of vertical and horizontal structural members. The main purpose of this study was to investigate deformation modes and hysteretic characteristics of steel plate shear walls (SPSWs) to consider the effects of their aspect ratios and width-to-thicness ratios. The finite element model (FEM) was establish in order to simulate cyclic responses of SPSWs which have the two-side clamped boundary condition and made of conventional steel grade. The stress distribution obtained from the FEA results demonstrated that the principal stresses on steel plate with large thickness-to-width ratio were more uniformly distributed along its horizontal cross section due to the formation of multiple struts.

• Journal of Yeungnam Medical Science
• /
• v.12 no.2
• /
• pp.269-281
• /
• 1995

The effect of persistant mild hyperglycemic hyperinsulinemia on the development of the insulin resistance in rats was studied in vivo. Also, the characteristics of the insulin resistance compared with the insulin resistance of STZ diabetic rats. Persistant mild hyperglycemic hyperinsulinemic rat model was produced by ingestion of glucose polymer for 8 days. The glucose disappearance and infusion rate was measured by hyperinsulinemic euglycemic clamp technique at steady state of blood glucose and insulin levels. The clamped level of blood glucose was 100 mg/dl, and the clamped levels of insulin were $70{\mu}U/ml$ (physiologic condition) and $3000{\mu}U/ml$ (supramaximal condition). Hepatic glucose producticon rate was calculated using measured data. And the glycogen synthetic capacity of skeletal muscle(soleus) and liver was measured after 2 hours of hyperinsulinemic euglycemic clamp study. The glucose disappearance and glucose infusion rate in glucose polymer group was decreased in the both physiological and supramaximal insulin level compared to the rate of the normal control group. The rate of STZ diabetic group wase lowest at supramaximal insulin level among two another experimental groups. The hepatic glucose production rate of glucose polymer group was decreased compared to normal control but increased in STZ diabetic group. The glycogen synthetic capacity of skeletal muscle and liver of glucose polymer group was not significantly different from normal control group, but it was markdly decreased in STZ diabetic group. These results suggest that persistant mild hyperglycemic hyperinsulinemia may induce insulin resistance, but glycogen synthetic capacity is intact.