• Journal of Korean Society of Coastal and Ocean Engineers
• /
• v.27 no.6
• /
• pp.382-390
• /
• 2015

To simulate a complicated hydrodynamic phenomena in the surf zone, the SWASH model is used in Haeundae Beach. The SWASH model is well known as a model competing with the Boussinesq-type model in terms of near shore waves and wave-induced currents modelling. This study is aimed to the detailed analysis of seasonal waves and wave-induced current simulation in Haeundae Beach, where the representative seasonal wave conditions was obtained from hourly measured wave data in 2014 by Korea Hydrographic and Oceanographic Administration( KHOA). Incident wave conditions were given as irregular waves by JONSWAP spectrum. The calculated seasonal wave-induced current patterns were compared with the field observation data. In summer season, a dominant longshore current toward the east of the beach appears due to the effect of incident waves from the South and the bottom bathymetry, then some rip currents occurs at the central part of the beach. In the winter season, ESE incident waves generates a strong westward longshore currents. However, a weak eastward longshore currents appears at the restricted east side areas of the beach.

• Economic and Environmental Geology
• /
• v.55 no.3
• /
• pp.295-307
• /
• 2022

We studied the Cretaceous Jeonggaksan Formation to determine depositional processes of pyroclastic density currents entering into the lacustrine environments. This formation is composed largely of sandstone-mudstone couplets and (tuffaceous) normally graded sandstones deposited in lacustrine environments, interbedded with two pyroclastic beds: welded massive lapilli tuff and normally graded lapilli tuff. The welded massive lapilli tuff (10 m thick) is composed of poorly sorted, structureless lapilli supported by a welded ash matrix. The normally graded lapilli tuff (4 m thick) is characterized by moderately to well sorted natures and multiple normally graded divisions in the lower part of the bed with internal boundaries. The contrasting depositional features between these lapilli tuff are suggestive of different physical characteristics and depositional processes of pyroclastic density currents in the lake. Overall poorly sorted and massive natures of the thick, welded massive lapilli tuff are interpreted to have been formed by rapid settling of pyroclastic sediments from highly concentrated and sustained pyroclastic density currents. In this case, the pyroclastic density currents were able to displace lake water from shoreline and the pyrolclastic density currents preserved their own heat except for frontal parts of the currents. As a result, welded textures can be formed despite entrance of pyroclastic density currents into the lake. The internal boundaries of the normally graded lapilli tuff reflect unsteady natures of the pyroclastic density currents at the time of the deposition and the pyroclastic density currents can not provide sufficient pressure to displace lake water. As a consequence, the pyroclastic density currents transformed into water-saturated turbidity currents, forming relatively well sorted, normally graded lapilli tuff.

• Transactions on Electrical and Electronic Materials
• /
• v.15 no.6
• /
• pp.348-352
• /
• 2014

In light of the sure protection function, the most important factors of a varistor are the clamping voltage ratio and degradation characteristics. The degradation characteristics of Pr/Co/Cr/Er co-doped zinc oxide varistors were investigated by impulse currents (0.4~2.1 kA) stress for the specified content of $Er_2O_3$ (0.5 and 2.0 mol%). The varistor doped with 2.0 mol% $Er_2O_3$ exhibited the best clamp characteristics, with the clamp voltage ratio (K) in the range of K = 1.63~1.88 at the impulse currents of 5-50 A. However, the varistor doped with 0.5 mol% exhibited excellent electrical stability, with variation rates for the breakdown field, for the nonlinear coefficient, and for the leakage current density of -6.9%, -12.6%, and -14.3%, respectively, after application of an impulse current of 2.1 kA. In contrast, the varistor doped with 2.0 mol% was destroyed after application of an impulse current of 1.2 kA.

• The Transactions of the Korean Institute of Electrical Engineers C
• /
• v.54 no.1
• /
• pp.23-29
• /
• 2005

This paper presents the characteristics of leakage currents flowing through ZinC Oxide(ZnO) surge arrester blocks under mixed direct and 60 Hz alternating voltages. A mixed voltage, in which an alternating voltage is superimposed upon a direct voltage, appears on the HVDC system network. The mixed direct and alternating voltage generator with a peak open-circuit of 10 kV was designed and fabricated. The leakage currents and V-I curves for the fine and used ZnO surge arrester blocks were measured as a function of the voltage ratio k, where the voltage ratio k is defined as the ratio of the peak of alternating voltage to the peak of the mixed voltages. The resistive component in the leakage current in the low conduction region is significantly increased with increasing the voltage ratio k. The V-I characteristic curves for the mixed voltages lies between the direct and alternating characteristics, and the cross-over phenomenon in the high conduction region was appeared.

• Journal of the Korean Institute of Illuminating and Electrical Installation Engineers
• /
• v.24 no.8
• /
• pp.94-100
• /
• 2010

Grounding system insures a reference potential point for electric devices and also provides a low impedance path for fault currents or transient currents in the earth. The ground impedance as function of frequency is necessary for determining its performance since fault currents could contain a wide range of frequencies. In this paper, the grounding resistance, grounding impedance and transient grounding impedance are measured by using 3-point fall-of-potential method in order to analyse grounding characteristics of the stainless-steel plate grounding electrode. An equivalent transfer function model of the grounding impedance and transient grounding impedance are identified from the measured values by using ARMA method and evaluated by comparing conventional grounding impedances.

• Journal of the Korean Society of Fisheries and Ocean Technology
• /
• v.55 no.3
• /
• pp.252-263
• /
• 2019

In order to understand the tidal current and mean flow at the west channel of Yeoja Bay in the South Sea of Korea, numerical model experiments and vorticity analysis were carried out. The currents flow north at flood and south at ebb respectively and have the reversing form in the west channel. Topographical eddies are found in the surroundings of Dunbyong Island in the east of the channel. The flood currents flow from the waters near Naro Islands through the west channel and the coastal waters near Geumo Islands through the east channel. The ebb currents from the Yeoja Bay flow out along the west and the east channels separately. The south of Nang Island have weak flows because the island is located in the rear of main tidal stream. Currents are converged at ebb and diverged at flood in the northwest of Jeokgum Island. Tidal current ellipses show reversing form in the west channel but a kind of rotational form in the east channel. As the results of tide induced mean flows, cyclonic and anticyclonic topographical eddies at the northern tip but eddies with opposite spin at the southern tip are found in the west channel of Yeoja Bay. The topographical eddies around the islands and narrow channels are created from the vorticity formed at the land shore by the friction between tidal currents and the west channel.

• The Transactions of The Korean Institute of Electrical Engineers
• /
• v.57 no.8
• /
• pp.1362-1370
• /
• 2008

This paper describes the design and characteristic analysis of a novel 3-DOF(Degree of Freedom) spherical motor. For multi DOF actuating, several numbers of motors have been used. By the using of normal motors they connected each other in single joint, is necessary to a several type of complex power transmission devices. The 3-DOF spherical motor can drive roll, pitch, and yaw motion in only one unit and it is not necessary to use additional gears and links parts. Therefore the using of 3-DOF spherical motor can eliminate; combined effects of inertia, backlash, non-linear friction, and elastic deformation of gears. In this paper, we propose the novel structured 3-DOF spherical motor and derive its principles of operation. Firstly, we designed concept model of novel structured 3-DOF spherical motor. Next, we derive the control method by calculating the currents. Also, to have intuitive driving control, we express the rotor position in equivalent angle-axis system and determine the exciting period of currents from the calculation result of the currents. To verify the control method, we calculated the currents by the position of rotor. and then we analyzed the characteristics by 3D Finite Element Method when the calculated currents are excited.

• Journal of the Korean Institute of Illuminating and Electrical Installation Engineers
• /
• v.26 no.5
• /
• pp.79-84
• /
• 2012

As the huge economical loss and function paralysis of information technology-based systems can be caused by the misoperation of residual current devices(RCDs) due to surge voltages and currents, RCDs shall not operate by surge currents. In this paper, in order to evaluate the reliability of residual current operated circuit-breakers with integral overcurrent protection for household and similar uses((RCBOs) stressed by surges, the unintended trip characteristics of RCBOs under surge currents were experimentally investigated using the combination wave generator. Seven different types of single-phase RCBOs being present on the domestic market were investigated according to KS C IEC 61009-1 standard. As a result, all kinds of specimens were satisfied the requirements for 0.5 [${\mu}s$]/100[kHz] ring wave impulse currents. Most of specimens stressed by the 8/20[${\mu}s$] impulse current tripped at least one or more, and some of them were broken down during consecutive tests. It was found that only one type of specimens meets the L-N mode immunity to the combination wave of 1.2/50[${\mu}s$] impulse voltage and 8/20[${\mu}s$] impulse current.

• Journal of the Korean Society for Marine Environment & Energy
• /
• v.4 no.1
• /
• pp.14-23
• /
• 2001

The characteristics of tidal circulation with Hyungsan River discharges in Youngil Bay by the numerical experiments is elucidated. For the simulation of tidal residual currents related to inflow by the river discharges in Youngil Bay located in the southeastern part of Korean Peninsula, the two-dimensional numerical experiment is peformed. The tidal elevation boundary conditions of the 4 main tidal harmonic constituents (M₂, S₂, K₁ and O₁) on the open boundary and river discharges at the river boundary are considered. The computed results obtained from numerical experiment showed good agreements with the field observation ones. The residual currents generally flow toward the inner bay through the western (Dalman-Gap) and central areas of the bay, and then the currents go toward the outer bay along the eastern shore (Changgi-Gap) of the bay with anti-clockwise circulation. Especially, in the numerical experiment without Hyungsan River discharges, these flow patterns are disappeared. Based on the results, it showed that the Hyungsan River discharges play the dominant role in the patterns of tidal residual currents. This flow pattern of tidal residual currents are important mechanism of water quality, material transport in Youngil Bay.

• 한국해양학회지
• /
• v.30 no.5
• /
• pp.467-479
• /
• 1995

To investigate the current structures and diffusion characteristics in Youngil Bay, a systematic field observations of current velocity, drogue tracking, dye diffusion experiment and aerial photographing were performed. The flow patterns in the surface layer of the bay depend more strongly on the wind and ocean current than the tidal current, and the patterns in the middle are predominated by the ocean current. The residual currents in the surface generally flow toward the inner bay through the western and central areas of the bay, and then the currents go toward the ocean along the eastern shore of the bay with anti-clock-wise circulation. The residual currents in the surface of the eastern cease are not nearly influenced by the wind, and the currents always move northward to northeastward. However, the currents in the western shore depend strongly on the wind and the outflow of the Huntsman River, that is, the residual currents go northward to northeastward when the southerly to westerly winds blow or a large amount of flow from the river discharge. The residual currents in the middle layer flow toward the inner bay along the western shore of the bay, and the incomed currents go out to the ocean along the eastern shore with anticlockwise circulation. The diffusion of dye patch by the instantaneous point source shows a similar pattern to the drogue trajectory, and the apparent diffusion coefficients of the dye patch by Fick's theory is 1.14${\times}$10$^4$ cm$^2$/s. The behavior of the river discharges in flood shows a band type's effluent pattern toward the outer bay along the western coast.