• Transactions of the Korean Society of Automotive Engineers
• /
• v.16 no.5
• /
• pp.171-178
• /
• 2008

The combustion and exhaust emission characteristics were investigated in an DME fueled HCCI engine. Carbon dioxide, nitrogen and mixed gas, which was composed of carbon dioxide and nitrogen, were used as control parameters of combustion and exhaust emission. As the oxygen concentration in induction air, which was occurred by carbon dioxide, nitrogen and mixed gas, was reduced, the start of auto-ignition was retarded and the burn duration was extended due to obstruction of combustion and reduction of combustion temperature. Due to these fact, indicated mean effective pressure was increased and indicated combustion efficiency was decreased by carbon dioxide, nitrogen and mixed gas. In case of exhaust emission, hydrocarbon and carbon monoxide was increased by reduction of oxygen concentration in induction air. Especially, partial burning was appeared at lower than about 18% of oxygen concentration by supplying carbon dioxide. However it was overcome by intake air heating.

• KOREAN JOURNAL OF PACKAGING SCIENCE & TECHNOLOGY
• /
• v.25 no.2
• /
• pp.31-35
• /
• 2019

Kimchi is a refreshing sour food which gives sour and carbonic acid taste of carbon dioxide produced during the fermentation process. So, carbon dioxide injection was tried to raise carbonic acid taste of kimchi stored in the airtight container. First, carbon dioxide injection times of a given gas supply system were determined experimentally to attain initial concentration of 80% for different solid/liquid ratios. Since carbon dioxide is dissolved in kimchi to decrease its concentration during storage, periodical carbon dioxide injection conditions were needed and determined to keep the $CO_2$ concentration above 70%. For the initial flushing to 80% $CO_2$ concentration in model system filled with water, the injection time ranged from 40 to 89 seconds for free volumes of 2-8 L. $CO_2$ injection conditions for the under-ripened storage at $10^{\circ}C$ consisted of longer time at more frequent cycles for watery kimchi than for Chinese cabbage kimchi. At $0^{\circ}C$ of subsequent ripened stage storage of watery kimchi, the periodical injection at 3 hour interval was required because of continuous dissolution of carbon dioxide. However, Chinese cabbage kimchi did not require subsequent $CO_2$ injection during the ripened state storage and needed only flushing to 80% $CO_2$ at time of the container opening and closing. These results can be used as basic information for the programmed control of $CO_2$ injection in the kimchi container system.

• Applied Chemistry for Engineering
• /
• v.10 no.2
• /
• pp.177-182
• /
• 1999

The electrolyte was brought into contact with air and potassium carbonate concentration was measured with various contact time in order to check the effect of carbon dioxide in the air on zinc-air cell. The relationship between potassium carbonate concentration in electrolyte and battery capacity was also studied. The potassium carbonate concentration increased due to carbon dioxide absorption with increasing contact time with air, but the cell capacity linearly decreased with increasing potassium carbonate concentration in the electrolyte. The rate of carbon dioxide absorption was mainly affected by the pore size of hydrophobic membrane. Our study showed that adapting the pore of hydrophobic membrane decreased the loss of cell discharge performance due to the presence of carbon dioxide or water vapor in the atmosphere.

• Fire Science and Engineering
• /
• v.23 no.5
• /
• pp.24-31
• /
• 2009

Based on fallen leaves of major Korean conifer species 'Pinus densiflora' and major Korean broadleaved species 'Quercus variabilis', this study sought to identify combustion emission gas types and measure their concentration by means of FTIR (Fourier Transform Infrared) spectrometer. As a result, it was found that there were total 13 types of combustion gas detected from fallen leaves of Pinus densiflora and Quercus variabilis, such as carbon monoxide, carbon dioxide, acetic acid, butyl acetate, ethylene, methane, methanol, nitrogen dioxide, ammonia, hydrogen fluoride, sulfur dioxide and hydrogen bromide. Notably, nitrogen monoxide was additionally detected from fallen leaves of Quercus variabilis. It was found that the overall concentration of combustion gas emitted from the fallen leaves of Pinus densiflora was 4.5 times higher than that from fallen leaves of Quercus variabilis. Particularly, it was found that emission concentration of some combustion emission gas types like carbon monoxide, carbon dioxide and butyl acetate exceeded the upper limit of their time-weighted average (TWA, ppm), while the emission concentration of carbon monoxide and carbon dioxide exceeded their short-term exposure limit (STEL, ppm) for both species. Thus, it was found that carbon monoxide and carbon dioxide have higher hazard to health than other gas types, because these two gas types account for higher than 99% of overall gas emission due to combustion of surface fire starting from litter layer in forest.

• Journal of the Korean GEO-environmental Society
• /
• v.23 no.12
• /
• pp.55-61
• /
• 2022

Carbon dioxide is one of the greenhouse gases in the atmosphere and much research is underperforming in reducing carbon dioxide. Geological carbon dioxide storage is considered the primary technique for global warming prevention. So, technic development for storing carbon dioxide is required. Using surfactant is considered an effective material for geological carbon dioxide storage. However, research on using surfactants for carbon dioxide sequestration is not enough. In this study, a 2D micromodel experiment depends on the surfactant type (sodium dodecyl sulfate and sodium dodecylbenzene sulfonate), concentration and carbon dioxide injection rate. As result, geological carbon dioxide sequestration efficiency is increased according to surfactant concentration and carbon dioxide injection rate increase. However, efficiency no more increases after critical concentration and rate.

• The Journal of the Korea institute of electronic communication sciences
• /
• v.16 no.1
• /
• pp.157-164
• /
• 2021

Wind and temperature were measured with a three-dimensional ultrasonic anemometer and the carbon dioxide concentration was measured using an infrared sensor in the tidal flat of Suncheon Bay. In general, as the temperature increases, the concentration of carbon dioxide increases, and as the temperature decreases, the carbon dioxide also decreases in the atmosphere. However, since photosynthesis declined immediately after the sunset, the concentration of carbon dioxide increased as the temperature decreased. In addition, near the high tide when the tidal flat is covered with seawater, the atmospheric turbulence was strong despite an increase in temperature, resulting in a decrease in carbon dioxide concentration. It is necessary to quantitatively evaluated the effects of photosynthesis, respiration and atmospheric turbulence on the change of carbon dioxide concentration over tidal flat ecosystems.

• Journal of Environmental Science International
• /
• v.31 no.11
• /
• pp.951-958
• /
• 2022

The aim of this study was to determine the optimum level of carbon dioxide to maximize the quality and yields of strawberries cultivated in a greenhouse. Specifically, two strawberry cultivars, namely, 'Seolhyang' and 'Maehyang', were subjected to varying concentrations of carbon dioxide and patterns linked to their productivity were noted. Both cultivars showed improvements across various physical variables (i.e., leaf area, crown diameter, plant height, fresh weight, and dry weight) when carbon dioxide concentrations were at 1,500 ppm. The optimum carbon dioxide concentration for increased fruit yields and quality was 1,000 ppm. When carbon dioxide was at 1,000 ppm the yields of 'Seolhyang' and 'Maehyang' increased by 1.99 and 1.78 times, respectively, compared to control plants. The influence of carbon dioxide on fruit color was negligible. However, the carbon dioxide increased the sugar content and sugar-acid ratio of the experimental fruits compared to control plants. Specifically, the sugar-acid ratio, which is directly related to taste, was at its highest when the concentration of carbon dioxide was at 1,000 ppm (i.e., for both 'Seolhyang' and 'Maehyang'). Overall, the application of carbon dioxide culminated in improved yields and fruit quality for both cultivars of interest.

• Journal of Korean Elementary Science Education
• /
• v.23 no.2
• /
• pp.152-158
• /
• 2004

The purpose of this study was to find the difficulties and problems in the carbon dioxide production experiment and to suggest the device for the improvement. Many students have misconception for the smell of carbon dioxide. I found that the smell of carbon dioxide of producting through the experiment didn't concern with the quantity of calcium carbonate. I certificated that the smell of carbon dioxide was related with the concentration of hydrochloric acid. I built two trap applicaing suction in the gas production device to exclude fully the smell of carbon dioxide. So the smell of carbon dioxide was not present by passing the two trap. To find the ideal experimental conditions I perform the experiment step by step. As the result enough carbon dioxide to use for the property experiment was collected under the condition that is 60 mL of 3 molarity hydrochloric acid and 30 g calcium carbonate. I certificated to mesuring flowing quantity of carbon dioxide using the flow meter of carbon dioxide. In the improvement experiment of the property of carbon dioxide, I proposed the experiment device regarding as spreading of the gas and children's interest. To improve the problem of gas production experiment, I proposed the gas certification device using a thread.

• Korean Journal of Optics and Photonics
• /
• v.35 no.2
• /
• pp.71-80
• /
• 2024

We developed a Raman lidar system for remote measurement of carbon dioxide present in atmospheric space. An air-cooled laser with 355-nm wavelength and a 6-inch optical receiver was used to miniaturize the Raman lidar system, and a scanning Raman lidar system was developed using a two-axis scanning device and a photon counter. To verify the performance of the developed Raman lidar system, a gas chamber capable of maintaining a concentration was located at a distance of about 87 m, and the change in Raman signal according to the change in the concentration of carbon dioxide was measured. As a result, it was confirmed that the change in the Raman scattering signal of carbon dioxide that appeared for a change in carbon dioxide concentration from about 0.67 to 40 vol% was linear, and the coefficient of determination (R²) value, which indicates the correlation between the carbon dioxide concentration and Raman scattering signal, showed a high linearity of 0.9999.

• Journal of Korean Society for Atmospheric Environment
• /
• v.29 no.3
• /
• pp.287-296
• /
• 2013

To decompose carbon dioxide, which is a representative greenhouse gas, a plasma torch was designed and manufactured. To examine the characteristics of carbon dioxide decomposition via plasma discharge, a case wherein pure carbon dioxide was supplied and a case wherein methane and/or $TiCl_4$ were injected as additives were investigated and compared. The carbon dioxide and methane conversion rate, energy decomposition efficiency, produced gas concentration, carbon monoxide and hydrogen selectivity, carbon-black and $TiO_2$ were also investigated. The maximum carbon dioxide conversion rate was 28.9% when pure carbon dioxide was supplied; 44.6% when $TiCl_4$ was injected as am additive; and 100% percent when methane was injected as an additive. Therefore, this could be explained that the methane injection showed the highest carbon dioxide decomposition. Furthermore, the carbon-black and $TiO_2$ were compared with each commercial materials through XRD and SEM. It was found that the carbon-black that was produced in this study is similar for commercial materials. It was found that the $TiO_2$ that was produced in this study is suitable for photocatalyst and pigment because it has mixed anataze and rutile.