• Geophysics and Geophysical Exploration
• /
• v.21 no.2
• /
• pp.67-81
• /
• 2018

We acquired the magnetic and bathymetry data around the TA (Tofua Arc) 22 seamount in the Lau Basin for finding submarine hydrothermal deposits. From the data, we estimated the magnetic characteristics in the study area. The bathymetry shows that TA 22 seamount consists of the western and eastern summits. Each summit exhibits a caldera. The western caldera is smaller, but deeper than the eastern caldera. The slope gradients of the TA 22 are steeper around ~1000 m depth range and relatively gentle at the summit areas with the small difference of two calderas. The magnetic properties of TA 22 seamount present high anomalies at the summit and the vicinity of the caldera. Low magnetization zones appear over the outer flanks and center of the calderas. These magnetic patterns are similar to the previous studies which had represented high anomalies and low magnetization zones inside of the summit area or on the flank of the outside of the summit area. The results of the 2D magnetic forward modeling with seismic profiles show about 20 nT of RMSEs (root mean square error) between the modeled and observed values. The low RMSEs proposes a good correlation between the modeled 2D structure and the geophysical observation in this study area. Based on the modeling and magnetization distribution, hydrothermal deposits are predicted to be located at the inner area of the calderas or at small mounds around caldera rims.

• Journal of Korean Society of Environmental Engineers
• /
• v.36 no.10
• /
• pp.698-703
• /
• 2014

The structures of fresh water plume depending on estuarine geometries and wind directions (upwelling, onshore, downwelling, and offshore winds) were studied using the Regional Ocean Modeling System (ROMS). Four idealized estuaries, which are different in bathymetry, were considered. The results showed that the fresh water plume was restricted close to the shore line where a river was connected to the sloping shelf rather than the flat shelf due to the fast momentum exchanges from x, y to z momentums on the sloping shelf. Mild upwelling and offshore winds (${\mid}{\tau}_{\omega}{\mid}=0.01Pa$) enhanced stratification on the contrast to previous studies which showed that winds destroyed stratification by enhanced vertical mixing. However, downwelling and onshore winds had similar effects on the vertical structure of the fresh water plume as in previous studies enhancing vertical mixing. The plume was confined above the underneath submarine channel, thus the plume path was directly affected by the direction of the submarine channel on the shelf.

• Geophysics and Geophysical Exploration
• /
• v.10 no.3
• /
• pp.163-172
• /
• 2007

A seafloor curvature measurement method was developed to extract redundant topographic features from the multi-beam bathymetry data, and then applied to the data of abyssal plain area in the Pacific. Any seafloor might be modeled to a quadratic surface determined in a linear least squares sense, and its curvature could be derived from the eigen values related with quadratic model parameters. The curvature's magnitude as well as polarity showed distinct relationship with geometric characteristics of the seafloor like as ridge and valley. From the investigation of curvature's variation with the number of data in the quadratic surface, the optimal size of data aperture could be applied to real bathymetry data. The application to real data also required the determination of the accompanying threshold values to cope with corresponding topographic features. The calculation method of previous studies were reported to be sensitive to the background noise. The improved curvature measurement method, incorporating the sum of eigen values has reduced unwanted artifacts and enhanced ability to extract lineament features along strike direction. The result of application shows that the curvature measurement method is effective tool for the estimation of a possible mining area in the seamount free abyssal hill area.

• Journal of the Korean Association of Geographic Information Studies
• /
• v.18 no.1
• /
• pp.48-63
• /
• 2015

In this study, we introduce various hyperspectral data processing techniques for the monitoring of shallow and coastal waters to enlarge the application range and to improve the accuracy of the end results in Korea. Unlike land, more accurate atmospheric correction is needed in coastal region showing relatively low reflectance in visible wavelengths. Sun-glint which occurs due to a geometry of sun-sea surface-sensor is another issue for the data processing in the ocean application of hyperspectal imagery. After the preprocessing of the hyperspectral data, a semi-analytical algorithm based on a radiative transfer model and a spectral library can be used for bathymetry mapping in coastal area, type classification and status monitoring of benthos or substrate classification. In general, semi-analytical algorithms using spectral information obtained from hyperspectral imagey shows higher accuracy than an empirical method using multispectral data. The water depth and quality are constraint factors in the ocean application of optical data. Although a radiative transfer model suggests the theoretical limit of about 25m in depth for bathymetry and bottom classification, hyperspectral data have been used practically at depths of up to 10 m in shallow and coastal waters. It means we have to focus on the maximum depth of water and water quality conditions that affect the coastal applicability of hyperspectral data, and to define the spectral library of coastal waters to classify the types of benthos and substrates.

• Journal of the Korean Association of Geographic Information Studies
• /
• v.25 no.4
• /
• pp.136-150
• /
• 2022

In this study, a comparative review was conducted on how to use RGB images to obtain river topographic information, which is one of the most essential data for eco-friendly river management and flood level analysis. In terms of the topographic information of river zone, to obtain the topographic information of flow section is one of the difficult topic, therefore, this study focused on estimating the river topographic information of flow section through RGB images. For this study, the river topography surveying was directly conducted using ADCP and RTK-GPS, and at the same time, and orthomosiac image were created using high-resolution images obtained by drone photography. And then, the existing developed regression equations were applied to the result of channel topography surveying by ADCP and the band values of the RGB images, and the channel bathymetry in the study area was estimated using the regression equation that showed the best predictability. In addition, CCHE2D flow modeling was simulated to perform comparative verification of the topographical informations. The modeling result with the image-based topographical information provided better water depth and current velocity simulation results, when it compared to the directly measured topographical information for which measurement of the sub-section was not performed. It is concluded that river topographic information could be obtained from RGB images, and if additional research was conducted, it could be used as a method of obtaining efficient river topographic information for river management.

• The Sea:JOURNAL OF THE KOREAN SOCIETY OF OCEANOGRAPHY
• /
• v.13 no.3
• /
• pp.295-301
• /
• 2008

Bathymetric data collected using a multi-beam echo sounder during marine scientific survey is essential for geologic and oceanographic research works. Accurate measurment of sound velocity profile(SVP) in water-column is important for bathymetric data processing. SVP can vary at different locations during the survey undertaken for wide areas. In addition, an observational error can occur when different equipments(Sound Velocity Profiler, Conductivity Temperature Depth, eXpendable BathyThermograph) are used for measuring SVP at the same water column. In this study, we used an MB-system software to show changes in bathymetry caused by variation of SVP. The analyses showed that the sound velocity(SV) changes due to the depth and thickness of thermocline had more significant effects on the resulting bathymetric data than those of surface mixed layer. The observational errors between SVP measuring instruments did not cause much differneces in the processed bathymetric data. Bathymetric survey line is better to be established to the direction that the change of temperature can be minimize to reduce the variation of SVP during the data acquisition along the survey line.

• Journal of Ocean Engineering and Technology
• /
• v.23 no.2
• /
• pp.28-36
• /
• 2009

Many researches have been done to define the physical parameters for the wave generation and transformation over a coastal region. However, most of these have been limited to the application of particular conditions, as they are generally too empirical. To yield more reasonable wave estimation using a spectral wave model, it is important to understand how they work for the wave estimation. This study involved a comprehensive sensitivity test against the spectral resolution and the physical source/sink terms of the spectral wave model using SWAN and TOMAWAC, which have the same physical background with several different empirical/theoretical formulations. The tests were conducted for the East Anglian coast, UK, which is characterized by a complex bathymetry due to several shoals and offshore sandbanks. For the quantitative and qualitative evaluation of the models' performance with different input conditions, the wave elements and spectrums predicted at representative sites the East Anglia coast were compared/analyzed. The spectral resolution had no significant effect on the model results, but the lowest resolution on the frequency and direction induced underestimations of the wave height and period. The bottom friction and depth-induced breaking terms produced relatively high variations in the wave prediction, depending on which formulation was applied. The terms for the quadruplet and whitecapping had little effect on the wave estimation, whereas the triads tended to predict shorter and higher waves by energy transferring to higher frequencies.

• 한국해양학회지
• /
• v.11 no.1
• /
• pp.9-17
• /
• 1976

Multispectral scanner data collected by LANDSAT-1 over the mid West Sea of Korea were analyzed and interpreted for delineation of coastal features and turbidity distribution patterns during different portions of the tidal cycle. Imagery from two successful LANDSAT-1 overpasses of the area in October 1972 and in October 1973 had been used to prepare schematic maps of coastal features and turbidity distributions. Color composite imagery of LANDSAT MSS 4, 5 and 7 gave the best representation of shorelines, coastlines and tidal flats. MSS 5 imagery was most effective in differentiating relative turbidity levels through density slicing techniques. Referring to the tidal power development of Garolim Bay, the basin area measurements assuming dyke construction at the bay entrance, have been carried out on the coastal reature maps comiled from LANDSAT imagery, and those results were correlated with existing data. General areal patterns of surface turbidity distribution in the study area revealed close similarity with bathymetry of the area. Synoptic circulation patterns were also well discriminated from the LANDSAT imagery using the suspended sediment as a tracer.

• Journal of Korean Society of Coastal and Ocean Engineers
• /
• v.18 no.1
• /
• pp.21-34
• /
• 2006

The simulation of tsunami inundation using detailed bathymetry and topography is required to establish the countermeasure of disaster mitigation and the tsunami hazard map. In this study, a simulation of the 1983 tsunami event in the East Sea using parallel finite element model, which is possible to simulate with suitable accuracy by the Beowulf parallel computation method, is performed to produce detailed features of coastal inundation. Results of simulations are compared with measured data. The evolution of statistic distribution of tsunami heights is studied numerically and the distribution functions of tsunami heights show a tendency to the log-normal curve along coastal area.

• Proceedings of the KSRS Conference
• /
• v.2
• /
• pp.525-528
• /
• 2006

The remote sensing data can be used to calculate the water depth especially in the clear and shallow water area. In this study, the SPOT data was used for bathymetric mapping in Dong-Sha atoll, located in northern South China Sea. The in situ sea depth was collected by echo sounder as well. A global positioning system was employed to locate the accurate sampling points for sea depth. An empirical model between measurement sea depth and band digital count was determined and based on least squares regression analysis. Both non-classification and unsupervised classification were used in this study. The results show that the standard error is less than 0.9m for non-classification. Besides, the 10% error related to the measurement water depth can be satisfied for more than 85% in situ data points. Otherwise, the 10% relative error can reach more than 97%, 69%, and 51% data points at class 4, 5, and 6 respectively if supervised classification is applied. Meanwhile, we also find that the unsupervised classification can get more accuracy to estimate water depth with standard error less than 0.63, 0.93, and 0.68m at class 4, 5, and 6 respectively.