• Current Optics and Photonics
• /
• v.5 no.2
• /
• pp.141-146
• /
• 2021

We have evaluated the suppression effect of atmospheric-turbulence-induced optical scintillation in terrestrial free-space optical (FSO) communication systems using a gain-saturated erbium-doped fiber amplifier (EDFA). The variation of EDFA output signal power has been measured with different amounts of gain saturation and modulation indices of the optical input signal. From the measured results, we have found that the peak-to-peak power variation was decreased drastically below 2 kHz of modulation frequency, in both 3-dB and 6-dB gain compression cases. Then, the power spectral density (PSD) of optical scintillation has been calculated with Butterworth-type transfer function. In the calculation, different levels of atmospheric-turbulence-induced optical scintillation have been taken into account with different values of the Butterworth cut-off frequency. Finally, the suppression effect of optical scintillation has been estimated with the measured frequency response of the EDFA and the calculated PSD of the optical scintillation. From our estimated results, the atmospheric-turbulence-induced optical scintillation could be suppressed efficiently, as long as the EDFA were operated in a deeply gain-saturated region.

• Atmosphere
• /
• v.19 no.3
• /
• pp.255-268
• /
• 2009

Based on the pilot reports (PIREPs) collected in South Korea from 2003 to 2008 and corresponding Regional Data Assimilation and Prediction System (RDAPS) analysis data of 30 km resolution, we validate the Korean Integrated Turbulence Forecasting Algorithm (KITFA) system that predicts clear-air turbulence (CAT) above the Korean peninsula. The CATs considered in this study are the upper level (higher than 20000 ft) turbulence excluding convectively induced turbulences. In the KITFA system, there are two main processes for predicting CATs: to select CAT indices and to determine their weighting scores. With the PIREPs observed for much longer period than those used in the current operational version of the KITFA system (March 4-April 8 of 2002), three improvable processes of the current KITFA system, re-calculation of weighting scores, change of method to calculate weighting scores, and re-selection of CAT indices, are tested. The largest increase of predictability is presented when CAT indices are selected by using longer PIREP data, with the minor change using different methods in calculation of weighting scores. The predictability is the largest in wintertime, and it is likely due to that most CAT indices are related to the jet stream that is strongest in wintertime. This result suggests that selecting proper CAT indices and calculating their weighting scores based on the longer PIREPs used in this study are required to improve the current KITFA.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.39B no.12
• /
• pp.856-863
• /
• 2014

In the terrestrial optical wireless communication(OWC), the performance is affected by atmospheric turbulence and particles in the air. The received signal power loss mainly is caused by turbulence and scattering. To minimize the adverse atmospheric effects, the OWC used optical signal modulation, such as OOK, PPM and DPIM. In this paper, the packet error rate(PER) was analyzed above three modulation methods to ground optical link in atmospheric turbulence, scattering and link distance. The OWC system used three wavelengths which are 850nm, 1310nm and 1550nm. I assumed the atmospheric turbulence intensity is weak, so the refractive index is $Cn2{\approx}10-14m-2/3$ and the visibility is 2km. The numerical results shown that the L-DPIM scheme and the wavelength 1550nm are better than other modulation methods and wavelengths.

• Korean Journal of Optics and Photonics
• /
• v.35 no.2
• /
• pp.49-60
• /
• 2024

We analyze the number of phase screens required for the simulation of a high-energy laser beam's propagation over an atmospheric channel. For high-energy lasers exceeding tens of kilowatts (kW) in power, the laser beam is mainly affected by atmospheric turbulence and thermal blooming. When using the split-step method to implement losses due to atmospheric absorption and scattering and distortion of the beam due to turbulence and thermal blooming, the number of phase screens is a critical factor in determining the accuracy and time required for the simulation. By comparing simulation results obtained using a large number of phase screens (e.g., 150 screens) under a wide range of atmospheric turbulence conditions, we provide new guidelines for the number of phase screens required for simulating the beam propagation of a high-power laser below 2.5×10⁶ W/m² (e.g., a 500-kW laser beam having a 50-cm diameter).

• Journal of Korean Society for Atmospheric Environment
• /
• v.20 no.1
• /
• pp.47-58
• /
• 2004

The $textsc{k}$-$\varepsilon$ algebraic stress model (KEASM) was applied to atmospheric dispersion simulation using the Lagrangian particle dispersion model and was compared with the most popular turbulence closure model in the field of atmospheric simulation, the Mellor-Yamada (MY) model. KEASM has been rarely applied to atmospheric simulation, but it includes the pressure redistribution effect of buoyancy due to heat and momentum fluxes. On the other hand, such effect is excluded from MY model. In the simulation study, the difference in the two turbulence models was reflected to both the turbulent velocity and the Lagrangian time scale. There was little difference in the vertical diffusion coefficient $\sigma$$_{z}$. However, the horizontal diffusion coefficient or calculated by KEASM was larger than that by MY model, coincided with the Pasquill-Gifford (PG) chart. The applicability of KEASM to atmospheric simulations was demonstrated by the simulations.s.

• Korean Journal of Optics and Photonics
• /
• v.16 no.5
• /
• pp.417-422
• /
• 2005

When an optical pulse propagates through the atmospheric channel, it is attenuated and spreaded by the atmospheric turbulence. This pulse broadening produces the intersymbol interference(ISI) between adjacent pulses. Therefore, adjacent pulses are overlapped, and the bit rates and the repeaterless transmission length are limited by the ISI. In this paper, the ISI as a function of the refractive index structure constant that presents the strength of atmospheric turbulence is found using the temporal momentum function, and is numerically analyzed fer the basic SONET transmission rates. The numerical results show that ISI is gradually increasing at the lower transmission rate than the OC-192(9.953 Gb/s) system and is slowly converging after rapid increasing at the higher transmission rate than the OC-768(39.813 Gb/s) system as the turbulence is stronger. Also, we know that accurate information transmission is possible to 10[km] at the OC-48(2.488 Gb/s) system under any atmospheric turbulence, but is impossible under the stronger turbulence than $10^{-14}[m^{-2/3}]$ at the 100 Gb/s system, $10^{-13}[m^{-2/3}]$ at the OC-768 system, and $10^{-12}[m^{-2/3}]$ at the OC-192 system, because the ISI is seriously induced.

• ETRI Journal
• /
• v.40 no.3
• /
• pp.330-336
• /
• 2018

Free-space optical (FSO) systems have attracted much attention from both research and application perspectives owing to their many benefits, such as license-free operation, low-cost, and high data rates. This paper investigates the ergodic capacity of FSO systems, which is an important metric of system performance. The stochastic temporary laser-beam blockage, pointing errors, and atmospheric turbulence are simultaneously considered. The results illustrate that the link blockage causes a decreased ergodic capacity. We show that to maximize the ergodic capacity, there is an optimal value of the laser-beam radius at the waist, which largely depends on pointing errors; however, it is independent of the atmospheric turbulence and the probability of link blockage.

• Wind and Structures
• /
• v.17 no.1
• /
• pp.87-105
• /
• 2013

Modeling an equilibrium atmospheric boundary layer (ABL) in an empty computational domain has routinely been performed with the k-${\varepsilon}$ turbulence model. However, the research objects of structural wind engineering are bluff bodies, and the SST k-${\omega}$ turbulence model is more widely used in the numerical simulation of flow around bluff bodies than the k-${\varepsilon}$ turbulence model. Therefore, to simulate an equilibrium ABL based on the SST k-${\omega}$ turbulence model, the inlet profiles of the mean wind speed U, turbulence kinetic energy k, and specific dissipation rate ${\omega}$ are proposed, and the source terms for the U, k and ${\omega}$ are derived by satisfying their corresponding transport equations. Based on the proposed inlet profiles, numerical comparative studies with and without considering the source terms are carried out in an empty computational domain, and an actual numerical simulation with a trapezoidal hill is further conducted. It shows that when the source terms are considered, the profiles of U, k and ${\omega}$ are all maintained well along the empty computational domain and the accuracy of the actual numerical simulation is greatly improved. The present study could provide a new methodology for modeling the equilibrium ABL problem and for further CFD simulations with practical value.

• Atmosphere
• /
• v.21 no.1
• /
• pp.69-83
• /
• 2011

The synoptic condition of clear-air turbulence (CAT) events occurred over South Korea is investigated, using the Regional Data Assimilation and Prediction System (RDAPS) data obtained from the Korea Meteorological Agency (KMA) and pilot reports (PIREPs) collected by Korea Aviation Meteorological Agency (KAMA) from 1 Dec. 2003 to 30 Nov. 2008. Throughout the years, strong subtropical jet stream exists over the South Korea, and the CAT events frequently occur in the upper-level frontal zone and subtropical jet stream regions where strong vertical wind shears locate. The probability of the moderate or greater (MOG)-level turbulence occurrence is higher in wintertime than in summertime, and high probability region is shifted northward across the jet stream in wintertime. We categorize the CAT events into three types according to their generation mechanisms: i) upper-level front and jet stream, ii) anticyclonically sheared and curved flows, and iii) breaking of mountain waves. Among 240 MOG-level CAT events reported during 2003-2008, 103 cases are related to jet stream while 73 cases and 25 cases are related to the anticyclonic shear flow and breaking of mountain wave, respectively.

• Journal of Korean Society for Atmospheric Environment
• /
• v.15 no.5
• /
• pp.639-647
• /
• 1999

Experimental methods of plume dispersion in convective boundary layer using a composite turbulence water tank have been established through (ⅰ) manufacturing of water tank system, (ⅱ) providing of tracer whose volatility is relatively low, (ⅲ) development of software for image processing of dispersed particles in fluid, and (ⅳ) application of appropriate similarity law. Using these methods, the vertical dispersion coefficient $$\sigma$_2$ at long distances on mesoscale and the centerline height $Z_c$ of plumes have been measured. Measurement of $$\sigma$_2$ have been validated through comparison with CONDORS field experiments, and analysed with respect to the intensity of heat flux and mechanical turbulence as well as plume release height. Downwind distance where plume center height approaches to final level has also been analysed in respect of these three parameters.