• Elastomers and Composites
• /
• v.6 no.2
• /
• pp.73-79
• /
• 1971

As a series of the studies of EPDM-Polymer blends, the experiments are concentrated to the investigation of the physical properties of the EPDM-SBR blends. The results are shown as follows: 1. Tensile strength decreased with increase in EPDM contents and the decreasing value was good results than NR blending. 2. It was found that the aging were much improved after blending and experiments data was good results than NR blending.

• Journal of Korean Society of Transportation
• /
• v.13 no.4
• /
• pp.133-151
• /
• 1995

The collective of highly reliable traffic data is necessary for traffic signal control. This study is to test application of RTMS sensor to traffic signal control. In order to find out the possibility of its application th traffic signal control, 5 types of experiments were performed. The major findings are as follows ; -The detection are a has been changing according to degree and gain. -At the results of experiments for interference are a measure, Degree 60 is stable condition. -At the results of reliability test for volume and speed. the error rate decreases as speed increases and that of Zone 1 is lower than that of Zone 3. -Two modes are set up for reliability test of traffic volume. It founds that the detection reliability of the stopped vehicles are higher than that of the passing vehicles at sidefire-intersection mode. It founds that the results are vice-versa at sidefire-highway mode. Conclusively, this sensor cannot directly apply to colection of traffic data for traffic signal control. However, this sensor can be substituted for a loop detector which is used popularly for signal control, and freeway traffic control if above faults are made up.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.12 no.11
• /
• pp.2111-2118
• /
• 2008

This parer propose a U-dormitory management system based on 13.56MHz RFID system. The proposed U-dormitory management system consists of three parts, the RFID hardware system, the middleware, and the application. RFID hardware system uses 13.56MHz frequency which is suitable for a close range. The middleware is implemented to accept the RFID hardware system values using RS-232c communication method and forward the values to the application. The application is designed to make the DB using the forwarded Haloes, and works based on the DB. The efficacy of the Proposed U-dormitory management system is verified by means of experiments. In the experiments, we set up the system to the dormitory of Daeduk College to show the improvement results of proposed system.

• Journal of the HCI Society of Korea
• /
• v.8 no.2
• /
• pp.1-8
• /
• 2013

In previous study, we developed a guidance system outdoors for person with visual impairment to be able to walk safely to the destination. The volunteers are exposed to dangerous situations since they are performed to the experiments in the outdoors. In order to solve the problem, we propose an interactive application that monitors the volunteer wearing guidance system and warns remotely the volunteer about dangerous situations. The application is used to remote wireless communication with guidance system through Bluetooth module that is built in a laptop computer, without additional device. Therefore, we can monitor in real time user's location and guided contents to user, and it is possible to check a path to the destination and POI (Point of Interest) coordinate values. As using a proposed monitoring application, it is possible to perform safe experiment with the rapid situation awareness and fast detection of dangerous.

• KSII Transactions on Internet and Information Systems (TIIS)
• /
• v.5 no.9
• /
• pp.1544-1572
• /
• 2011

Task placement and scheduling are traditionally studied in following aspects: resource utilization, application throughput, application execution latency and starvation, and recently, the studies are more on application scalability and application performance. A methodology for task placement and scheduling centered on tasks based on virtual machines is studied in this paper to improve the performances of systems and dynamic adaptability in applications development and deployment oriented parallel computing. For parallel applications with no real-time constraints, we describe a thought of feature model and make a formal description for four layers of task placement and scheduling. To place the tasks to different layers of virtual computing systems, we take the performances of four layers as the goal function in the model of task placement and scheduling. Furthermore, we take the personal preference, the application scalability for a designer in his (her) development and deployment, as the constraint of this model. The workflow of task placement and scheduling based on virtual machines has been discussed. Then, an algorithm TPVM is designed to work out the optimal scheme of the model, and an algorithm TEVM completes the execution of tasks in four layers. The experiments have been performed to validate the effectiveness of time estimated method and the feasibility and rationality of algorithms. It is seen from the experiments that our algorithms are better than other four algorithms in performance. The results show that the methodology presented in this paper has guiding significance to improve the efficiency of virtual computing systems.

• Korean Journal of Soil Science and Fertilizer
• /
• v.30 no.4
• /
• pp.370-376
• /
• 1997

Experiments were conducted to investigate the effects of chromium application level, soil pH change, soil topping, application of some metals and application of organic matter on the absorption of chromium by radish and its growth. The results of experiments are summarized as following. Application of chromium as potassium dichromate up to 50 mg/kg did not affect the germination of radish seed. Application of chromium above this level affected the germination abversely. The dry matter yield of and absorption of chromium by radish was not affected by the application of chromium up to 100 mg/kg. Increased in soil pH decreased the uptake of chromium by radish under all range of chromium application rates. Under acidic condition (pH 5-6), the increase in the application of chromium resulted in the increase in the uptake of chromium by radish and lowering of dry matter production of radish. However, under alkaline condition (pH 7-8), increased application of chromium did not affect the uptake of chromium and the dry matter yield of radish. The application of Zn, Fe and Cu, up to 100 mg/kg did not affect not affect the uptake of chromium and dry matter yield of radish. The topping of soil with untreated soil after application of chromium up to five cm, did not affect the chromium uptake of radish, the same treatments tended to increase the dry matter yield of radish. The application of organic fertilizer(obtained from local market) up to the amount equivalent to 3000 kg/ha, although increased the dry matter yield of radish, did not affect the uptake of chromium by radish significantly. All the treatments tested in this study did not affect the translocation of chromium between root and shoot of radish.

• Economic and Environmental Geology
• /
• v.53 no.1
• /
• pp.87-98
• /
• 2020

The bird track fossil site in Haman Formation is divided into seven sedimental layers by the sedimentary structures, lithofacies and sequences. The bird tracks top on the highest layer, which includes ripple marks and suncracks. The layer has lithofacies with reddish grey siltstone and dark grey mudstone, alternately. As an analysis for the same rocks of the fossil site, physical properties show on mean values for 0.62% of absorption rate, 1.64% of porosity and 2.63 of specific gravity. Rock-forming minerals composed mainly of plagioclase, quartz, calcite, chlorite and mica. Meanwhile, we executed an experiments based on the petrography and weatherings to find a proper consolidants. In the experiments, the OH 100 reagent proved stable aspect and the lowest transition rate in terms of weight and chromaticity. Also, it showed the highest increase in ultrasonic velocity, improving the physical properties of the rocks. In the case of applying the OH 100 with antihygro, an swelling inhibitors on the sedimentary rocks, the chromaticity indicated an stable transition aspect. When it comes to the physical properties, the antihygro also decreases the porosity effectively. Thus, the most proper method for the fossil site of Haman Formation is to apply antihygro and OH 100 reagents since the rocks includes clay minerals that show swelling characteristics. However, this result is deduced from an indoor application experiments, leaving the necessity of verification how these reagents would affect the bird tracks site under the field condition.

• The Korean Journal of Applied Statistics
• /
• v.7 no.1
• /
• pp.83-102
• /
• 1994

Some optimal designs and data analysis methods based on a Gaussian spatial linear model for computer simulation experiments are considered. For designs of computer experiments, Latin-hypercube designs and some optimal designs are combined. A two-stage computational (2-points exchange and Newton-type) algorithm for finding the optimal Latin-hypercube design is presented. The spatial prediction model which was discussed by Sacks, Welch, Mitchell and Wynn(1989) for computer experiments, is used for analysis of the simulated data. Moreover, a method of contructing sequential (optimal) Latin-hypercube designs is considered. An application of this approach to the quality improvement and optimization of the integrated circuit design via the main-effects plot and the sequential experimental strategy is presented.

• Structural Engineering and Mechanics
• /
• v.77 no.3
• /
• pp.305-314
• /
• 2021

In order to reduce enormous cost of real-scale underwater explosion experiments on ships, the mechanical response of the ships have been analyzed by combining scaled-down experiments and Hopkinson's scaling law. However, the Hopkinson's scaling law is applicable only if all variables vary in an identical ratio; for example, thickness of ship, size of explosive, and distance between the explosive and the ship should vary with same ratio. Unfortunately, it is infeasible to meet such uniform scaling requirement because of environmental conditions and limitations in manufacturing scaled model systems. For the facile application of the scaling analysis, we propose a generalized scaling law that is applicable for non-uniform scaling cases in which different parts of the experiments are scaled in different ratios compared to the real-scale experiments. In order to establish such a generalized scaling law, we conducted a parametric study based on numerical simulations, and validated it with experiments and simulations. This study confirms that the initial peak value of response variables in a real-scale experiment can be predicted even when we perform a scaled experiment composed of different scaling ratios for each experimental variable.

• Proceedings of the KSRS Conference
• /
• 2005.10a
• /
• pp.597-600
• /
• 2005

The software streaming technology enables telematics software to be automatically updated through a wireless network. When the software starts running, software streaming system inspects its version and then, automatically download latest one. The software streaming system breaks the software into several pieces that are streamed to the user as needed. In this way, software streaming system can improves the telematics application load time while updating the software through wireless network. In our experiments, the application load time was reduced about 7 times compared to downloading whole software at best case.