• 한국전기전자재료학회논문지
• /
• 제17권5호
• /
• pp.530-535
• /
• 2004

We have studied 90$^{\circ}$ twisted nematic mode switching by fringe electric field(F-TN mode) using a liquid crystal (LC) with negative dielectric anisotropy. In the device, two polarizers are parallel each other, electrodes exist only on bottom substrate, and one of rubbing direction is coincident with polarizer axis. Therefore, the cell shows a black state before a voltage is applied. With a bias voltage generating fringe-electric field, the LC twists perpendicular to fringe electric field such that the LCs are almost homogeneously aligned except near the bottom surface since the negative type of the LC is used. Consequently, the new device exhibits much wider viewing angle than that of the conventional TN mode due to in-plane switching and relatively high transmittance since the LC director above whole electrode area aligns parallel to the polarizer axis.

• Journal of Mechanical Science and Technology
• /
• 제16권7호
• /
• pp.959-965
• /
• 2002

Effective hydraulic conductivity of a statistically anisotropic heterogeneous medium is obtained for steady two-dimensional flows employing stochastic analysis. Flow equations are solved up to second order and the effective conductivity is obtained in a semi-analytic form depending only on the spatial correlation function and the anisotropy ratio of the hydraulic conductivity field, hence becoming a true intrinsic property independent of the flow field. Results are obtained using a statistically anisotropic Gaussian correlation function where the anisotropy is defined as the ratio of integral scales normal and parallel to the mean flow direction. Second order results indicate that the effective conductivity of an anisotropic medium is greater than that of an isotropic one when the anisotropy ratio is less than one and vice versa. It is also found that the effective conductivity has upper and lower bounds of the arithmetic and the harmonic mean conductivities.

• Journal of Magnetics
• /
• 제9권2호
• /
• pp.47-51
• /
• 2004

Giant magneto-impedance (GMI) effect in zero-magnetostrictive Co-based amorphous ribbons samples in their as-quenched and stress-released states as well as with intentionally induced magnetic anisotropy were investigated. Magnetic and impedance properties of the samples exhibiting different anisotropy were compared and the optimum operation conditions for the studied samples from the view-point of their utilization as a sensor element have been determined. A design of a model of magnetic field sensor and characteristics of the constructed prototype are presented.

• 한국전기전자재료학회논문지
• /
• 제16권3호
• /
• pp.238-246
• /
• 2003

We have performed the simulation of ferromagnetic resonance spectra on the exchange coupled bilayer thin films at perpendicular configuration. Variables considered in spectrum calculation were the interfacial exchange constants per unit area, the layer thickness, and the surface anisotropy constants. In case of antiferromagnetic coupling, variation of exchange constant gave a great effect to the absorption spectra of the low and the high magnetization layer. Variation of thickness in low magnetization layer did nt nearly influenced the resonated field of the high magnetization layer. Also, the increase of negative surface anisotropy increased the resonance field of the low and the high magnetization layer.

• 한국지반공학회:학술대회논문집
• /
• 한국지반공학회 2003년도 봄 학술발표회 논문집
• /
• pp.103-110
• /
• 2003

This study is as for shale that attract recently geotechnical engineer more and more. like sedimentary rocks and metamorpic rocks, shales have many problem with anisotropy for stength and deformation and they have many problems with quick weathering progress and differential weathering of alternate bedding. In foreign countries, many renowned schalors, like Jaeger(1960),McLamore,Gray(1967),Donath(1972),Nova(1980),Hoek&Brown(1980),Ranamurthy(1985), have already studied for a variety of characteristic and announced high level results of their studies. In domestic also, there are many scholars who have announced high level research papers for shale. this study is a part of these stream. and this study not only analyzed strength anisotropy characteristic along with direction of testing(two-direction) by using point-load test(log-log method) but also compared uniaxial strength between the maximum saturated and dried condition. In this study, we also conducted slaking test. these results of slaking test show weathering characteristic of shales. also, we made the most of field data that obtained during slope stability project and we noticed that RQD measured in the field is much differ from drilled core RQD. In order to come close two different value or access to reality, we suggest new RQD method that artificially reduce RQD by separating core with light hand force.

• 한국전기전자재료학회논문지
• /
• 제17권8호
• /
• pp.888-892
• /
• 2004

It is necessary to develop soft magnetic layer with high saturation magnetization 4 $\pi{M}_s$ and in-plane magnetic anisotropy field Hk for soft magnetic underlayer of perpendicular magnetic recording media with high signal to noise ratio. Fe-Co-B layer with high 4 $\pi$Ms of about 23 kG deposited on Ni-Fe and Ni-Fe/Si seedlayer exhibited very high in-plane magnetic anisotropy filed Hk of about 280 and 380 Oe, respectively, In-plane XRD studies clarified that the lattice spacing of planes along the easy axis direction was longer than that along the hard axis direction in the Fe-Co-B layers with high Hk. These results indicate that high Hk of Fe-Co-B/Ni-Fe and Fe-Co-B/［Ni-Fe/si］ layers were resulted from magnetoelastic anisotropy owing to a residual stress. Moreover, the high Hk in the Fe-Co-B/Ni-Fe layer was maintained until 30$0^{\circ}C$ annealing temperature.

• Progress in Superconductivity
• /
• 제9권2호
• /
• pp.183-187
• /
• 2008

We have studied superconducting properties of $Mg_{1-x}Al_xB_2$ single crystals from reversible magnetization measurements. It was found that the upper critical fields $H_{c2}$ were decreased for both H // c and H // ab as Al is substituted for Mg. As a result, the large anisotropy of $H_{c2}$ observed in pure $MgB_2$, which is considered as one of the characteristics of two-gap superconductor, was decreased with Al doping. On the other hand, the irreversibility fields $H_{irr}$ were increased for x = 0.1 and were significantly decreased for x = 0.2. In contrary to the anisotropy of $H_{c2}$, the anisotropy of $H_{irr}$ was increased as Al concentration increases.

• Bulletin of the Korean Chemical Society
• /
• 제33권3호
• /
• pp.1015-1019
• /
• 2012

The direct calculation method is generalized to the excited-state diffusion-influenced reversible reaction of a neutral and a charged particle under an external field with two different lifetimes and quenching in three dimensions. The present method provides an alternative way to calculate the binding probability density functions and the survival probabilities from the corresponding irreversible results. The solutions are obtained as the series solutions by the diagonal approximation due to the anisotropy of the unidirectional external field. The numerical results are found to be in good agreement with those of the previous study [S. Y. Reigh et al. J. Chem. Phys. 132, 164112 (2010)] within a weak field limit. The solutions of two approaches show qualitatively the same overall behavior including the power laws at long times.

• 한국초전도ㆍ저온공학회논문지
• /
• 제20권1호
• /
• pp.1-10
• /
• 2018

The improvement of critical current properties of $REBa_2Cu_3O_{7-x}$ (REBCO) coated conductors by introducing artificial pinning centers (APCs) is examined with respect to the field-angle anisotropy, high-field performance and relaxation property with time. Nano-rods along the c-axis introduced by PLD method and isotropic nano-particles introduced by TFA-MOD method are treated. The theoretical analysis is also shown to understand the effect of APCs quantitatively. The effects of superconducting layer thickness that influences the high-field performance and relaxation property are also discussed. It is shown that the upper critical field, which is another important factor to determine the high-field property, can be improved by introduction of APCs through electron scattering at interfaces with the superconducting matrix. The optimum critical current property can be obtained by properly designing the morphology and number density of APCs and the superconducting layer thickness.

• Journal of Magnetics
• /
• 제19권3호
• /
• pp.237-240
• /
• 2014

For heat-assisted magnetic recording, magnetization reversal probabilities of nano-Pt/MnSb multilayer film with perpendicular magnetic anisotropy under thermal pulse activation were investigated numerically by solving the Landau-Lifshift Gilbert Equation. Magnetic parameters of nano-Pt/MnSb multilayer were used with anisotropy energy of $3{\times}10^5$ erg/cc and saturation magnetization of 2100 G, which offer more than 10 y data stability at room temperature. Scheme of driven magnetic field and thermal pulse on writing mechanism was designed closely to real experiment. This study found that the chosen material is potential to be used as a high density magnetic storage that requires low writing field less than two-hundreds Oersted through definite heating and cooling interval. The possibility of writing data with a zero driven magnetic field also became an important result. Further study is recommended on the thickness of media and thermal pulse design as the essential parameters of the reversal magnetization.