• Membrane Journal
• /
• v.29 no.2
• /
• pp.96-104
• /
• 2019

The purpose of this paper is whether or not the in-situ restoration of the reverse osmosis (RO) membranes which its membrane function is lost is possible. The damaged RO membranes are double coated through the salting-out method by the poly(styrene sulfonic acid) sodium salt as the cationic exchange polymer and the polyethyleneimine as the anionic exchange polymer and also conducted the opposite order of the coating materials. And according to the concentration, time and ionic strength, the flux and rejection are measured for the coated membranes. Then the best coating condition is to apply for the RO membrane module of the household water purifier to know the possibility of the in-situ restoration for the commercial module. When the condition of the PEI 30,000 ppm (IS = 0.1)/PSSA 20,000 ppm (IS = 0.7) is applied, the rejection was enhance from 69% for the damaged module to 86% (90% for the pristine module).

• Environmental Sciences Bulletin of The Korean Environmental Sciences Society
• /
• v.2 no.2
• /
• pp.139-148
• /
• 1998

The charge densities of humic acid and humic extract have been determined by back titration using spectrophotometry as the method of end point detection and several cationic polymers of different charge density(copolymers of acylamide and dimethylaminoethylacrylate and polydiallyidimethylammonium chloride, PDDA), and a cationic indicator o-toluidine blue(o-Tb). The charge densities of humic acid and humic extract obtained depend on the charge densities of cationic polymers used. When the polymers of lower charge density are used, lower apparent charge density values are obtained, but for polymers of high charge density(above 2.5 meq/g), the measured values are almost identical, but also are nearly the same as that obtained for PDDA which has a high charge density(about 6 meq/g). For polymers of lower charge density, it is considered that the optimum dosage does not correspond to 1 :1 charge neutralization between anionic and cationic groups. Polymers of high charge density should be used in order to achieve a complete charge neutralization. As humic acid and humic extract are dissociable acids, their ionization is heavily pH dependent and so higher charge density values are obtaines with increasing pH.

• Macromolecular Research
• /
• v.17 no.10
• /
• pp.770-775
• /
• 2009

$\omega$-Anhydride-functionalized poly(ethylene oxide) (PEO) obtained from chain-end functionalization and anionic ring-opening polymerization of ethylene oxide using n-butyllithium with potassium t-butoxide in the presence of dimethylsulfoxide (DMSO) was found to be an efficient material for the preparation of water-soluble, polymeric pro-drugs. The reaction of $\omega$-anhydride-functionalized PEO with sulfonamide or with vancomycin provided an efficient method to produce corresponding, water-soluble, PEO-conjugated sulfonamide or PEO-conjugated, vancomycin pro-drugs. These were used successfully to prepare water-dispersible, silver nanoparticles. In this study, the particle sizes were in the range of $5{\sim}40$ nm. The resulting products were characterized by $^1H$ NMR spectroscopy, transmission electron microscopy, electron and X-ray diffraction, size exclusion chromatography, and UV/Visible spectroscopy.

• Childhood Kidney Diseases
• /
• v.19 no.2
• /
• pp.65-70
• /
• 2015

It is well known that proteins present in the primary urine are reabsorbed in the renal proximal tubules, and that this reabsorption is mediated via the megalin-cubilin complex and the neonatal $Fc{\gamma}$ receptor. However, the reabsorption is also thought to be influenced by an electrostatic interaction between protein molecules and the microvilli of the renal proximal tubules. By analyzing the charge diversity of urinary IgG, we showed that this reabsorption process occurs in a cationic charge-preferential manner. The charge-selective molecular sieving function of the glomerular capillary walls has long been a target of research since Brenner et al. demonstrated the existence of this function by a differential clearance study by using the anionic dextran sulfate polymer. However, conclusive evidence was not obtained when the study was performed using differential clearance of serum proteins. We noted that immunoglobulin (Ig) A and IgG have similar molecular sizes but distinct molecular isoelectric points. Therefore, we studied the differential clearance of these serum proteins (clearance IgA/clearance IgG) in podocyte diseases and glomerulonephritis. In addition, we studied this differential clearance in patients with Dent disease rather than in normal subjects because the glomerular sieving function is considered to be normal in subjects with Dent disease. Our results clearly showed that the charge-selective barrier is operational in Dent disease, impaired in podocyte disease, and lacking in glomerulonephritis.

• Textile Coloration and Finishing
• /
• v.17 no.1
• /
• pp.7-13
• /
• 2005

Continuous and intense UV irradiation on PTT film using two types of UV bulbs at different irradiation power level was carried out to modify surface characteristics of the film including zeta potential, wettability, surface energy, and dyeability. ESCA analysis of the irradiated film showed higher O/C ratio than the untreated film indicating photooxidation of outer surface layer. ATR analysis showed that the ester bonds were broken and some new groups were produced such as carboxylic acid, phenolic hydroxy, and other esters, implying that ester bonds of PTT was responsible for the observed photooxidation effect. The surface of the treated PTT film became more hydrophilic and wettable to water, coupled with increased surface energy. Polar component of the surface energy increased and nonpolar component decreased with increasing irradiation energy. The treatment also decreased zeta potential of the modified surface and nanoscale roughness increased with increasing irradiation. The dyeability of the treated films to catonic dyes was significantly improved by electrostatic and polar interaction between dye molecules and the anionic film surface. The UV irradiation seems to be a viable polymer surface modification technology, which has advantages such as no vacuum requirement and continuous process unlike plasma treatment.

• Korea-Australia Rheology Journal
• /
• v.14 no.1
• /
• pp.1-9
• /
• 2002

Steady and dynamic shear properties of two hydrophobically modified alkali soluble emulsions (HASE), NPJI and NPJ2, were experimentally investigated. At the same polymer concentration, NPJ1 is appreciably more viscous and elastic than NPJ2. The high hydrophobicity of NPJ1 allows hydrophobic associations and more junction sites to be created, leading to the formation of a network structure. Under shear deformation, NPJ1 exhibits shear-thinning behaviour as compared with Newtonian characteristics of NPJ2. NPJ1 and NPJ2 exhibit a very high and a low level of elasticity respectively over the frequency range tested. For NPJ1, a crossover frequency appears, which is shifted to lower frequencies and hence, longer relaxation times, as concentration increases. Three different surfactants anionic SDS, cationic CTAB, and non-ionic TX-100 were employed to examine the effects of surfactants on the rheology of HASE. Due to the different ionic behaviour of the surfactant, each type of surfactant imposed different electrostatic interactions on the two HASE polymers. In general, at low surfactant concentration, a gradual increase in viscosity is observed until a maximum is reached, beyond which a continuous reduction of viscosity ensues. Viscosity development is a combined result of HASE-surfactant interactions, accompanied by constant rearrangement of the hydrophobic associative junctions, and electrostatic interactions.

• Journal of the Korean Society of Clothing and Textiles
• /
• v.24 no.3
• /
• pp.385-392
• /
• 2000

The adsorption ability of dyes on chitin, a natural polymer was investigated for decolorization of dye wastewater. Chitin was manufactured in lab by decalcification in dilute aqueous HCI solution and deproteination in dilute aqueous NaOH solution with shrimp shells. Absorbance of residue solution of dyebaths after dye adsorptions of chitin were measured in varieties of dye concentration and dipping periods. Four kinds of dyestuffs were used, C.I.Acid Blue 29. C.I.Direct Blue 6, C.I.Reactive Orange 12 and C.I.Basic Red 18. When chtin 1g was dipped in 0.05% of dyebath with stirring, maximum adsorption ratio of each kind of dyes was exhibited as 91.6% for C.I.Acid Blue 29, 95% for C.I.Direct Blue 6, 58.2% for C.I.Reactive Orange 13 and 75.8% for C.I.Basic Red 19. It shows that chitin has better adsorption abilities of ionic dyes of acid, direct and basic dye than non-ionic reactive dye. And chitin has better adsorption abilities of anionic acid direct dyes than cationic basic dye because of the presence of nitrogen atoms. All kinds of dyestuffs used showed speedy absorption effects by chitin, so chitin can absorb much amount of dyes in 5 mimutes reach to equilibrium of adsorption in 2 hours after dipping. Basic dye was absorbed the most speedily in 5 minutes, although maximum adsorption ratio is not high. That reason can be thought that chitin surface is essentially negatively charged due to polar funtional groups.

• Biotechnology and Bioprocess Engineering:BBE
• /
• v.10 no.6
• /
• pp.516-521
• /
• 2005

Drug delivery to the lymphatic system may be important in terms of the treatment with lymphatic involvement, such as tumor metastases and immunization. Especially, drug transport via the intestinal lymphatics after oral administration has been attracted lots of interests. The purpose of this study was to prepare cyclosporin A (CSA)-loaded liposomes, with different characteristics, and evaluate their mucoadhesivity. Three liposome preparations were formulated: cationic stearylamine liposomes (SA-Lip), anionic phosphatidylserine liposomes (PS-Lip), Polymer (chitosan)-coated liposomes (CS-Lip), and characterized. The liposome preparations were found to be spherical in shape, with PS-Lip being the smallest. The liposome preparations exhibited entrapment efficiencies in the order: PS-Lip $(52.5{\pm}2.9%)$ > SA-Lip $(48.8{\pm}3.3%)$ > CS-Lip $(41.7{\pm}4.2%)$. Finally, mucoadhesive tests were carried out using rat intestine, with SA-Lip (67%) showing the best adhesive rate of the three preparations (PS-Lip: 56%, CS-Lip: 61%). These results suggest that a positive charge on the surface of drug carriers may be an important factor for the intestinal drug delivery.

• Journal of Korea Technical Association of The Pulp and Paper Industry
• /
• v.47 no.6
• /
• pp.154-163
• /
• 2015

Because of acute or chronic intoxication by carbon disulfide, viscose rayon industry is strictly subjected to environment regulatory approval. Recently, non-wood fibers are frequently considered as a raw materials for the manufacture of specialty paper for the higher physical strength and functionality. Among the non-wood fibers, hemp bast fiber is one of the most widely used materials in viscose rayon yarn industries. In this study, the handsheet for manufacturing the viscose rayon yarn was prepared with wood pulp fibers and hemp bast fibers. The proper mixing ratio of wood fibers and hemp bast fibers with dry-strength agent and nano-celluloses was analysed in terms of physical and mechanical strength of sheet for viscose rayon yarn. The papermaking conditions for high mechanical strength of sheet were obtained by mixing the SwBKP and HwBKP fibers with freeness level of 200 mL CSF. The dual polymer system by controlling the addition ratio of PVAm and anionic PAM was also important. The addition of nano-cellulose into wet-end furnishes increased the physical strength of sheet, and improved the paper structure for the production of viscose rayon yarn.

• Textile Coloration and Finishing
• /
• v.5 no.4
• /
• pp.60-66
• /
• 1993

Aqueous polyurethane(PU) anionomer dispersions were prepared from isophorone diisocyanate (IPDI), polytetramethylene adipate glycol(PTAd) and dimethylol propionic acid(DMPA) as potential anionic centers. The effects of polyol molecular weight(Mn) on the state of dispersion, thermal, mechanical, and viscoelastic properties and swelling of emulsion cast film were determined. With increasing Mn of PTAd, particle size of emulsion and soft segment T$_{g}$ decreased, and solvent swell, emulsion viscosity, and hard segment $T_{g}$ increased. Tensile strength showed minimum with PTAd 1000, and elongation at break generally increased with the Mn of PTAd. These results were possibly nterpreted in terms of soft segment-hard segment phase separation and crystallization of high molecular weight PTAd.