• Journal of The Korean Society of Integrative Medicine
• /
• v.10 no.3
• /
• pp.131-140
• /
• 2022

Purpose : Although many studies have explored the effect of seating side angles on the spinal curve and surrounding muscles during seating, only a few studies have investigated the effect of different seating face angles on different lower limb and deep trunk muscles. Therefore, this study investigated the effects of seating surface angles (0 degrees, 10 degree anterior, and 10 degree rear) on lower extremity and deep trunk muscles in healthy adults. Methods : Thirty people were asked to sit once on each seating surface three times during the day, and their muscle thicknesses were measured by ultrasound while sitting. The method of sitting was the same when sitting on the three seating surfaces. Results : From the comparison results of the muscle thicknesses according to the seating surface angles, a significant difference existed in the muscle thicknesses of the vastus medialis, vastus medialis oblique, vastus intermedius, soleus and gastrocnemius (p<.05). However, no significant difference was found in the transversus abdominis, internal obliques, rectus femoris and vastus lateralis (p>.05). Conclusion : Our findings revealed that the lower back load decreases, the leg load increases, and the legs specific muscles are affected as the body tilts forward when sitting on the seating surface inclined forward. Therefore, it is possible to suggest a forwardly inclined seating surface that reduces lower back loads and utilizes the posture-maintaining muscles of the legs when sitting in a person with a poor sitting posture or lower back pain at ordinary times.

• Proceedings of the KOR-BRONCHOESO Conference
• /
• 1972.03a
• /
• pp.2.3-2
• /
• 1972

The vestibular function test reveals the objective findings of the impairment of the vestibular labyrinth. It's purpose is based on the analysis of the findings and detect the location and etiology of the labyrinthine impairment. In the vestibular function test, the vestibulo-spinal reflex has the clinical significance upon the tonus of the striated muscles by the labyrithine stimulation and contribute to regulating the posture and the position, at rest as well as in motion. The vestibulo-spinal reflex must performe as one of the routine vestivular function test because it can be evoked in man by such weak stimuli to the labyrinth as cannot induce vestibulo-ocular reflex. Authors performed the vestibular function test such as one leg test, gait test, stepping test and vertical writing test to one hundred of healthy and young male adult and received the following results. Results 1. One leg test: In 30 seconds, the frequency of dropping the leg on the ground was between 0 to 3 times in Rt., and 0 to 5 times in Lt. The mean frequency was 0.48 times in Rt., and 0.68 times in Lt. 2. Gait test: In forward gait; the range of the deviation was distributed 0 to 100 cm and mean range was 22.5cm to the Rt., 26.1cm to the Lt. In backward gait; the range deviation was distributed 0 to 140cm and mean range was 35.4cm to the Rt., 33.0cm to the Lt. 3. Stepping test: In normal head position; forward movement war 93% and backward 5%. The angle of displacement deviated to the Rt. side in 36%, and Lt. in 50%. The angle of rotation deviated to the Rt. side in 53 %, and Lt. in 36%. The mean values: angle of displacement was 22.05 degrees, angle of rotation was 24.40 degrees, distance of displacement was 48.95cm. In backward head position; Forward movement was 94% and backward was 3%. The angle of displacement deviated in 34%, and Rt. in 55%, to the Rt. side The angle of rotation deviated to the Rt. side in 50%, and Lt. in 42%. The mean values; angle of displacement was 29.72 degrees, angle of rotation was 39.53 degrees, distance of displacement was 44.17cm. 44.17cm. 4. Vertical writing test: The angle of deviation was between 0 to 16 degrees in all cases, and was between 0 to 12 degrees in the cases of normal head position. The mean angle of deviation was between 4.15 to 5.76 degrees on each side. The direction of deviation to the Rt. side was 54~69%, Lt. was 25~40% and 3~7% was vertical without deviation.

• PNF and Movement
• /
• v.19 no.3
• /
• pp.303-310
• /
• 2021

Purpose: The purpose of the present study was to investigate the effects of the contact-relax (CR) intervention on pelvic alignment in subjects with habitual poor posture. Methods: Fifteen subjects who have habitual poor posture participated in this study. The subjects received an intervention inducing pelvic posterior depression with the elevated pelvic side. Pre- and post-intervention, and two weeks after intervention, the pelvic alignment was measured with a palpation meter (PALM) and a three-dimensional diagnostic imaging system. Results: Measuring with PALM, the pelvic height and anterior tilt angle were significantly decreased immediately after and were still decreased two weeks after intervention, compared to the pre-measurement (p<0.05). Three-dimensional pelvic alignment was also significantly different between measurement points, while the pelvic position (pelvic lateral tilt) was significantly decreased after intervention (p<0.05). Conclusion: By applying the intervention generating CR on an elevated pelvis, frontal pelvic alignment can be improved.

• Journal of Institute of Control, Robotics and Systems
• /
• v.7 no.6
• /
• pp.523-531
• /
• 2001

This paper describes and automatic mirror adjustment system that rotates a pair of side mirrors and the room mirror of a car to the optimal position for a driver by using the locating of the driver\`s pupils. A stereo vision system measures 3D coordinates of a pair pupils by analyzing the input images of stereo B/W CCD cameras mounted on the instrument panel. this system determines the position angle of each mir-ror on the basis of information about the location of the pupils and rotates each mirror to the appropriate po-sition by mirror actuators. The vision system can detect the driver\`s pupils regardless of whether it is day-time or nighttime by virtue of an infrared light source. information about the pair of nostrils in used to im- prove the correctness of pupil detection. This system can adjust side mirrors and the room mirror automati- cally and rapidly by a simple interface regardless of driver replacement of driver\`s posture. Experiment has shown this to be a new mirror adjustment system that can make up for the weak points of previous mirror adjustment systems.

• International Journal of Automotive Technology
• /
• v.5 no.4
• /
• pp.277-285
• /
• 2004

This paper describes an intelligent mirror adjustment system that rotates a pair of side mirrors and the room mirror of a car to the optimal position for a driver by using the location of the driver's pupils. A stereo vision system measures the three-dimensional coordinates of a pair of pupils by analyzing the input images of stereo B/W CCD cameras mounted on the instrument panel. This system determines the position angle of each mirror on the basis of information about the location of the pupils and rotates each mirror to the appropriate position by mirror actuators. The vision system can detect the driver's pupils regardless of whether it is daytime or nighttime by virtue of an infrared light source. Information about the pair of nostrils is used to improve the correctness of pupil detection. This system can adjust side mirrors and the room mirror automatically and rapidly by a simple interface regardless of driver replacement or driver's posture. Experiment has shown this to be a new mirror adjustment system that can make up for the weak points of previous mirror adjustment systems.

• Journal of Forest and Environmental Science
• /
• v.39 no.4
• /
• pp.254-260
• /
• 2023

A sensor system has been developed that uses an ultrasonic sensor to detect the downhill slope on the side of a forest road and prevents a vehicle-type forest machine from rolling down a mountainside. A specular reflection of ultrasonic wave might cause severe issues in measuring distances to targets. By investigating the installation angle of the sensor to minimize the negative effects of specular reflection, the installation angle of lateral monitoring ultrasonic sensor could be determined based on the width of road shoulder. Obstacles such as small rocks or piece of log in a forest road may cause the forest machine to be overturned while the machine riding over due to excessive its posture change. It was determined that the laser sensor could be a part of a sensor system capable of specifying the location and size of small obstacles. Not only this sensor system including ultrasonic and laser sensors can issue a warning of dangerous sections to drivers in forest forwarders currently in use, but also it can be used as a driving safety sensor in autonomous forest machine or remote-control forest machine in the future.

• Physical Therapy Rehabilitation Science
• /
• v.12 no.1
• /
• pp.19-25
• /
• 2023

Objective: Patients with scoliosis complain of various symptoms such as muscle imbalance, dysfunction, back pain, abnormal posture and gait abnormality. The most basic treatment for scoliosis is to observe the progress based on conservative treatment. Therefore, in this case report, the effect of cytoskeletal manual therapy (CMT), a soft tissue mobilization technique, on pain intensity, muscle thickness, and pressure pain threshold (PPT) in a patient with scoliosis was investigated. Design: A case report Methods: A 25-year-old male diagnosed with scoliosis visited the Neuromusculoskeletal Science Laboratory with chronic back pain. In the laboratory, scoliosis was confirmed through the X-ray image used for his diagnosis, and it was confirmed again through Adam's forward bending test. Pain, pressure pain threshold and muscle thickness were measured to compare the immediate effects of CMT applied in the laboratory for 40 minutes. Treatments were visited two weeks after the first visit and outcome measures were assessed after a total of two visits. Results: After receiving CMT up to the second session, the pain intensity decreased by 4 points and the screening angle decreased by 15 degrees. Muscle thickness decreased in all but 10 mm on the dominant side of the thoracic spine. All of the PPTs increased, and the greatest increase was 3.1 lb on the dominant side of the thoracic spine. Conclusions: CMT showed positive improvement in pain during trunk flexion, spinal curvature, muscle imbalance, and pressure pain, which is considered as an ancillary treatment option for scoliosis management.

• Physical Therapy Rehabilitation Science
• /
• v.9 no.3
• /
• pp.191-196
• /
• 2020

Objective: Congenital muscular torticollis (CMT) is a disease with abnormal head and neck posture in infants. It affects the child's movement and development and can lead to complications. Therefore, this study aims to find out what factors influence the rehabilitation treatment duration of infants with CMT. Design: Cross-sectional study. Methods: The subjects were 63 infants under 90 days of age who were diagnosed with CMT. Age, thickness of the sternocleidomastoid muscle (SCM) on the affected and non-affected side, head tilt angle, and head rotation angle of the affected head in infants were collected. The ratio of muscle thickness was calculated from the thickness of the affected SCM and the thickness of the non-affected SCM (A/N ratio). All subjects underwent conservative physical therapy twice a week for 30 minutes, and the end of the treatment was when the angle of head tilt was normal or less than 5 degrees, and the treatment duration was calculated. Results: Age, thickness of affected SCM, and head tilt were significantly correlated with treatment duration (p<0.05). The thickness of the non-affected SCM, A/N ratio, and head rotation angle did not show any correlation with treatment duration. The factors affecting the treatment duration were head tilt and age, showing 21% explanatory power of adjusted R². Conclusions: The main factors affecting the treatment duration of infants with CMT are head tilt and age. Therefore, more attention should be directed to the infant's head tilt and age for effective physical therapy of infants with CMT.

• Korean Journal of Applied Biomechanics
• /
• v.13 no.3
• /
• pp.293-309
• /
• 2003

The purpose of this study was to analyze the kinematic variables of the right-straight punch(RSP) in boxing with three-dimensional analysis technical methods. The subjects are boxers who have been playing in national boxing representative team and the RSP is their special favorite technique, The right-straight punches were filmed on 16mm video cameras(30frames/sec.) The kinematic variables were temporal, postural and center of gravity(COG). The mean and the standard deviation of variables have been obtained and used as basic factors for examining characteristics of the RSP by out-boxers. From the data analysis and discussion, the following conclusions have been drawn. 1) Temporal variables It is a significant characteristic that LDJ and KDM s' the amount of elapsed time(EF) needed for both an attack and a defense were similar : ET for stretch-out of attack-arm was $0.52{\pm}0.04\;sec$. and return was $0.54{\pm}0.01\;sec$. Therefore, a defense motion is as important as an attack motion. 2) Posture variables When the subjects performed a RSP, the significant characteristic of the ankle angle was that it wasn't completely returned to the original position after stretching-out. Therefore it is necessary to do supplementary exercises, such as side steps, to move the center of gravity more effectively. The hee angle was not fully stretched either. In regard to the hip angle, it should be rotated with all strength to harmonize with the direction of movement. 3) Center of Gravity(COG) variables When both LDJ and KDM performed a RSP, a significant characteristic was the transformation of sagittal view rather than transverse or frontal views.

• Journal of the Korea Institute of Military Science and Technology
• /
• v.15 no.4
• /
• pp.424-434
• /
• 2012

This paper presents a path planning algorithm of the unmanned aerial vehicle for the neutralization of the enemy firepower. The long range firepower of the ememy is usually located at the rear side of the mountain which is difficult to bomb. The path planner not only consider the differential constraints of the Unmanned Aerial Vehicle (UAV) but also consider the final approaching angle constraint. This problem is easily solved by incorporating the analytical upper bounded continuous curvature path smoothing algorithm into the Rapidly Exploring Random Tree (RRT) planner. The proposed algorithm can build a feasible path satisfying the kinematic constraints of the UAV on the fly. In addition, the curvatures of the path are continuous over the whole path. Simulation results show that the proposed algorithm can generate a feasible path of the UAV for the bombing mission regardless of the posture of the tunnel.