• 한국전기전자재료학회:학술대회논문집
• /
• 한국전기전자재료학회 2010년도 춘계학술대회 논문집
• /
• pp.15-16
• /
• 2010

We used Brewster's Law to examine the mechanism of liquid crystal (LC) alignment on an organic insulation layer when subjected to ion-beam irradiation. Brewster's Law implies that the maximum rate polarized rayon a slanted insulation layers on the substrate and it illustrates the dependence of polarization and themechanical structure on the ion beam irradiation process. The pretilt angle of nematic LCs on the organic insulation surface was about $1.13^{\circ}$ for an ion beam exposure of $45^{\circ}$ for 1 minute at 1800eV. This shows the dependence of LC alignment on the polarization ratio in a slanted organic insulation layer. We also discussed the electro-optical characteristic of twisted nematic (TN) LCD using ion beam irradiation on organic overcoat layer.

• Journal of Radiation Protection and Research
• /
• 제23권1호
• /
• pp.59-63
• /
• 1998

$Mg_2SiO_4$:Tb(MSO-S) TLD의 사용에서 부정확한 선량평가의 원인이 될 수 있는 광감수성과 방향 의존성을 조사하였다. 200 lux의 형광등과 백열등 하에서 8시간씩 노출한 경우 각각 약 11 mR과 3 mR의 조사선량에 해당하는 광감수성이 나타났다 그리고 수직입사($0^{\circ}$)에 대한 ${\pm}80^{\circ}$ 의 각도로 입사하는 경우의 열형광강도 비가 MSO-S는 약 0.8, badge형의 MSO-L은 약 0.15로서 방향의존성이 비교적 크게 나타났다.

• 한국초전도ㆍ저온공학회논문지
• /
• 제14권3호
• /
• pp.48-52
• /
• 2012

This paper describes experimental study on the orientation dependence of GM-type pulse tube refrigerator with helium and neon as working gas. A pulse tube refrigerator generates refrigeration work with gas expansion by gas displacer in the pulse tube. The pulse tube is only filled with working gas and there exists secondary flow due to large temperature difference between cold-end and warm-end. The stability of secondary flow is affected by orientation of cold-head and thus cooling performance is deteriorated by gas mixing due to secondary flow. In this study, a single stage GM-type pulse tube with orifice valve as a phase control device is fabricated and tested. The fabricated pulse tube refrigerator is tested with two different working gases of helium and neon. First, optimal valve opening and operating frequency are determined with experimental results of no-load test. And then, the variation of no-load temperature as orientation angle of cold-head is measured for two different working gases. Effect of orientation dependence of cold-head as working gas is discussed with experimental results.

• Bulletin of the Korean Chemical Society
• /
• 제30권12호
• /
• pp.3039-3044
• /
• 2009

We report the first electric field dependence IR spectra of three cytosine tautomers solvated in helium nanodroplets. By using an electric field dependence on the three lowest energy tautomers of cytosine and ab initio calculations, we are able to measure the vibrational transition moment angles (VTMAs), specifically for the $NH_2$ symmetric stretch (SS) mode in this study, with more precision; thus we have reassigned the previous $NH_2$ (SS) VTMA of 74$^{\circ}$ for the C1 tautomer to 85$^{\circ}$, which the latter is in excellent agreement with the ab initio value. Nonplanarity of the three lowest energy tautomers of cytosine has been investigated by measuring the VTMA of each vibrational mode for the tautomers.

• Nuclear Engineering and Technology
• /
• 제55권7호
• /
• pp.2474-2482
• /
• 2023

The development of fast reactors with complex designs and operation status requires more accurate and effective simulation. The Monte-Carlo method can generate multi-group cross-sections in arbitrary geometry without approximation on resonances treatment and leads to good results in combination with diffusion codes. However, in previous studies, the coupling of Monte-Carlo generated multi-group cross-sections (MC-MGXS) and transport solvers has shown relatively large biases in fast reactor problems. In this paper, the main contribution to the biases is proved to be the neglect of the angle-dependence of the total cross-sections. The flux-moment homogenization technique (MHT) is proposed to take into account this dependence. In this method, the angular dependence is attributed to the transfer cross-sections, keeping an independent form for the total sections. For the MET-1000 benchmark, the multi-group transport simulation results with MC-MGXS generated with MHT are improved by 700 pcm and an additional 120 pcm with higher order scattering. The factors that cause the residual bias are discussed. The core power distribution bias is also significantly reduced when MHT is used. It proves that the MCMGXS with MHT can be applicable with transport solvers in fast reactor analysis.

• Tribology and Lubricants
• /
• 제38권6호
• /
• pp.261-266
• /
• 2022

Notably, laser surface patterning facilitates tribological applications under lubricated sliding contacts. Consequently, a special pattern that can reduce the coefficient of friction under contact is considered necessary for improved machine efficiency. However, inappropriate pattern designs produce higher friction coefficients and cannot reduce friction. In this study, we use cast iron pins as specimens to investigate their friction and wear characteristics. Moreover, we experimentally investigate the correlation between the friction reduction effect and the design of groove crosshatch patterns fabricated with various angles and widths. We conduct a friction test using a pin-on-disc type tribometer under grease lubrication to study the friction reduction effect of the specimens, and we observe that the average coefficient of friction changes with the crosshatch angle and width. The experiment reveals that grooved crosshatch specimens with a crosshatch angle of 135°maximize friction reduction. The coefficient of friction of the groove specimens with a width of 120 ㎛ is lower than that of the specimens with a width of 200?. The friction reduction effect of the width of the groove is attributed to the density of the groove pattern. Thus, grooved crosshatch patterns can be designed to maximize friction reduction, and the friction property of a grooved crosshatch pattern is found to be related to its width and angle.

• 한국자기학회지
• /
• 제4권4호
• /
• pp.313-318
• /
• 1994

전자빔 증착 Co/Pt 다층박막에서 증발원자의 입사방향이 자기 및 자기광학적 성질에 미치는 영향을 조사하였다. 조성변조 Co/Pt 다층박막을 증발원자의 입사방향이 $0^{\circ},\;15^{\circ},\;30^{\circ},\;45^{\circ},\;60^{\circ}$이 되도록 하여 전자빔 증착법으로 제조한 후 x-ray 회절실험, 주사전자현미경으로 구조분석을 하였고, VSM, torque magnetometer, Kerr loop tracer를 사용하여 자기 및 자기광학적 성질을 조사하였다. x-ray 회절실험을 통해 모든 시료가 조성변조 다층박막 구조로 만들어졌음을 확인하였고, 입사각이 증가함에 따라 주상구조의 성장방향은 기판 수직선에서 벗어나지만 <111> 결정방향은 기판 수직선 가까이에 존재함이 관찰되었다. 포화자화값 $M_{s}$, Kerr회전각 ${\theta}k$는 입사각이 증가하면 줄어들었는데 이는 박막의 밀도 감소 때문이다. 자기이방성 또한 입사각의 증가에 따라 줄어들었다.

• 수산해양기술연구
• /
• 제46권3호
• /
• pp.239-247
• /
• 2010

Species of fish such as striped beakperch, bluefin searobin and konoshiro gizzard shad are commercially very important due to their high demand in the Korean market. When estimating acoustically the abundance of stocks for these species, it is of crucial importance to know the target strength (TS) to the length dependence. In relation to these needs, the TS experiments were conducted on three different species in an acrylic salt water tank using two split-beam echo sounders of 70 and 120 kHz. The TS for these three species under the controlled condition was simultaneously measured with the swimming movement by a DVR system and analyzed as a function of fish length (L) and frequency (or wavelength $\lambda$). The equation of the form TS=a log (L)+b log ($\lambda$)+c was derived for their TS-length dependence. The best fit regression of TS on fork length for striped beakperch was estimated as TS=35.67 log (L, m) -15.67 log ($\lambda$, m) -46.69 ($r^2$=0.78). Furthermore, the best fit regression of TS on fork length for konoshiro gizzard shad was shown to be TS=25.85 log (L, m) -5.85 log ($\lambda$, m) -32.22 ($r^2$=0.51). The averaged TS for 12 bluefin searobins with a mean length of 24.36cm at 70 kHz was analyzed to be -41.55dB. In addition, the averaged tilt angle obtained simultaneously by a DVR system with TS measurements for 27 konoshiro gizzard shads swimming within an acrylic salt water tank was estimated at $-2.7^{\circ}$.

• 한국자기학회지
• /
• 제27권1호
• /
• pp.30-34
• /
• 2017

본 연구에서는 교환 결합력을 갖는 강자성/반강자성(AF) 박막에서 단자구 모델을 사용하여 교환 바이어스($H_{ex}$)의 각도 의존성을 계산하였으며, NiFe/MnIr 박막에서 측정한 결과와 비교 분석하였다. AF층 두께가 임계 두께 이상에서($t_{AF}$ > $t_c$) 계산한 $H_{ex}$의 각도 의존성은 전형적인 일방 이방성 특성을 보였으나, $0.5t_c$ < $t_{AF}$ < $t_c$에서는 $90^{\circ}$ 근처의 특정한 각도에서 AF 스핀의 고정에 의한 독특한 $H_{ex}$의 각도 의존성을 보였다. NiFe/MnIr(20 nm) 박막에서 측정한 $H_{ex}$의 각도 의존성은 전형적인 일방 이방성 특성을 보였으나, NiFe/MnIr(4 nm) 박막에서는 일방 이방성 특성과 AF 스핀의 고정에 의한 특성이 혼합된 결과를 보였으며, 이는 다결정 구조를 갖는 MnIr의 입도 분포 특성으로 설명되어짐을 알 수 있었다.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 2005년도 제36회 하계학술대회 논문집 A
• /
• pp.685-687
• /
• 2005

In this study, near the 3-phase power lines with branch lines were formulated. In rectangular coordinates, dependence of branch angle $\alpha$ on electromagnetic field components $B_x,\;B_y,\;B_z$ 및 $E_x,\;E_y,\;E_z$ was analyzed. The resultant electromagnetic fields B and E were discussed.