• 한국국방경영분석학회지
• /
• 제8권1호
• /
• pp.77-98
• /
• 1982

Experiments have been performed for estimating the individual muscle capabilities of the biceps brachii and the quadriceps femoris muscle. The surface EMG has been recorded on the bellies of the biceps brachii and the quadriceps femoris muscle during isometric contractions at $50\%,\;75\%,\;and\;100\%$ MVC. The rectified EMG amplitudes of the maximum voluntary contraction (MVC) were in the range of $2.8\~3.0\;mV\;and\;6.9\~7.2\;mV$ the biceps brachii and the quadriceps femoris, respectively. In the biceps brachii, Type S motor units were recruited in the range of $41\~49\%$ MVC; and Type F motor units were recruited in the range of $51\~59\%$ MVC, In the quadriceps femoris, Type S, Type SF, and Type F motor units were recruited in the ranges of $31\~38\%,\;33\~48\%$, and $21\~29\%$ MVC respectively.

• Steel and Composite Structures
• /
• 제14권1호
• /
• pp.73-83
• /
• 2013

In this paper Hamiltonian Approach (HA) have been used to analysis the nonlinear free vibration of Simply-Supported (S-S) and for the Clamped-Clamped (C-C) Euler-Bernoulli beams fixed at one end subjected to the axial loads. First we used Galerkin's method to obtain an ordinary differential equation from the governing nonlinear partial differential equation. The effect of different parameter such as variation of amplitude to the obtained on the non-linear frequency is considered. Comparison of HA with Runge-Kutta 4th leads to highly accurate solutions. It is predicted that Hamiltonian Approach can be applied easily for nonlinear problems in engineering.

• 한국자동차공학회논문집
• /
• 제3권3호
• /
• pp.46-57
• /
• 1995

The aim of the present study is to provide fundamental informations for the development of magneticfluid actuator. To achieve the aim, oscillation characteristics of the magneticfluid plug are investigated by experiment for the various length and position of the magneticfluid plug and the frequency of magnetic field. The oscillation characteristics are obtained. Amplitude, natural frequency, phase shift and damping ratio, are compared with theoretical values. From the study, the following conclusive remarks can be made. The experimental equation for the magnetic field is obtained. The critical magneticfluid length exists and its value is about 70mm. The range of the damping ratio and fluid loss coefficient obtained by experiment are 0.1~0.2 and 30~100, respectively. Comparison between experimental and theoretical results of oscillation characteristics shows good agreement in the high frequency range. Meanwhile, in the low frequency range, there appears little discrepancies(5% in the frequency and amplitude and 10% in phase difference and damping ratio) with each other.

• Korea-Australia Rheology Journal
• /
• 제18권2호
• /
• pp.91-98
• /
• 2006

We compare FT (Fourier Transform) and SD (Stress Decomposition), the interpretation methods for LAOS (Large Amplitude Oscillatory Shear). Although the two methods are equivalent in mathematics. they are significantly different in numerical procedures. Precision of FT greatly depends on sampling rate and length of data because FT of experimental data is the discrete version of Fourier integral theorem. FT inevitably involves unnecessary frequencies which must not appear in LAOS. On the other hand, SD is free from the problems from which FT suffers, because SD involves only odd harmonics of primary frequency. SD is based on two axioms on shear stress: [1] shear stress is a sufficiently smooth function of strain and its time derivatives; [2] shear stress satisfies macroscopic time-reversal symmetry. In this paper, we compared numerical aspects of the two interpretation methods for LAOS.

• 한국지구물리탐사학회:학술대회논문집
• /
• 한국지구물리탐사학회 2005년도 제7회 특별심포지움 논문집
• /
• pp.3-9
• /
• 2005

In order to obtain more reliable data for the information on the ground, a new site Investigation method is proposed, in which seismic waves (S-waves) generated by the Swedish Ram Sounding Test (SRS) are used. It is indicated that the energy transferred from the hammer to the rod in SRS's is much more stable, compared to SPT's. A series of SRS with measurements of seismic waves at the ground surface were carried out to clarify the characteristics of seismic wave propagation in the ground. As the results of comparison between seismic S-wave amplitudes and $N_d$ (blow count for 20 cm penetration in SRS), it was found that amplitudes of S-waves generated by SRS correlate well with $N_d$. The amplitude of the S-wave is thought to be more adequate parameter for the soil strength and rigidity than $N_d$.

• 한국농공학회:학술대회논문집
• /
• 한국농공학회 2001년도 학술발표회 발표논문집
• /
• pp.306-309
• /
• 2001

The objective of this study is to evaluate the changes of hydraulic environment after the construction of Saemangeum sea-dikes. Numerical simulation on the tidal condition of dated 17 Apr. 1999 is performed with and without sea-dike construction status for the comparison. Results show the tidal amplitude is reducing approximately 20 cm after the construction of sea-dike during spring tide condition of 6.9 m amplitude. Currents after construction of sea-dikes along the alignment, the northern part shows 50% (inner), 90% (outer) and the southern part shows 10% (inner), 50% (outer) of the current before construction.

• 한국군사과학기술학회지
• /
• 제20권2호
• /
• pp.272-278
• /
• 2017

In this paper, we consider a single-channel amplitude comparison monopulse system(SCACMS). The monopulse ratio curve(MR-C) of the SCACMS can be controlled by an amplitude difference between sum and different signal, a phase difference and the coefficient of the signal processor. We first propose the SCACMS with multiple variables, and then apply a genetic algorithm to optimize the multiple variables in terms of minimizing a root mean square error. The simulation results show that when three variables of the SCACMS are jointly optimized, the linear region of the MR-C can be extended approximately 187 % compared to that of two variables.

• 한국정보디스플레이학회:학술대회논문집
• /
• 한국정보디스플레이학회 2003년도 International Meeting on Information Display
• /
• pp.95-98
• /
• 2003

The positive column discharge characteristics in the long gap (440 ${\mu}m$) are investigated based on the voltage distribution among three electrodes. In particular, the effects of the amplitude and width of the short pulse applied to the address electrode on the positive column discharge characteristics are examined intensively. By proper controlling of the amplitude and width of the address short pulse, it is found that the positive column discharge in the long gap is well constructed. As a result, under the stable static voltage margin condition, the firing and sustaining voltages are as low as those of conventional short gap(60 ${\mu}m$) discharge($V _f=220V$, $V_s=150V$) and the color purity is improved. Moreover, the luminous efficiency increases up to 60% in comparison with the conventional case.

• 대한기계학회논문집
• /
• 제2권3호
• /
• pp.62-68
• /
• 1978

The influences of the large amplitude free vibrations of simply supported Timoshenko beams with ends restrained to remain a fixed distance apart and with no axial restraints, which cause a longitudinal elastic force and a longitudinal inertia force, respectively, are investigated. The equations of motion derived by an appropriate linearizarion of the nonlinear strain- displacement relation have nonlinear terms arising from large curvature, longitudinal elastic force and longitudinal inertia force. The fourth order nonlinear partial differential equations for the deflection, can be reduced to the nonlinear ordinary differential equations by means of Galerkin procedure and a modal expansion. The general response and frequensy-amplitude relations are derived by the perturbation method of strained parameters. Comparison with previously published results is made.

• 한국방송∙미디어공학회:학술대회논문집
• /
• 한국방송공학회 2009년도 IWAIT
• /
• pp.450-455
• /
• 2009

Amplitude-only logarithmic Radon transform (ALR transform) for pattern matching is proposed. This method provides robustness for object translation, scaling, and rotation. An ALR image is invariant even if objects are translated in a picture. For the object scaling and rotation, the ALR image is merely translated. The objects are identified using a phase-only matched filter to the ALR image. The ratio of size, the difference of rotation angle, and the position between the two objects are detected. Our pattern matching procedure is described, herein, and its simulation is executed. We compare matching scores with the Fourier-Mellin transform, and the general phase-only matched filter.