• Transactions of the Korean hydrogen and new energy society
• /
• v.30 no.6
• /
• pp.601-607
• /
• 2019

Ammonia would be formed in natural gas containing small amount of nitrogen reforming process in the process natural gas, which might damage the Pt catalyst and Prox catalyst. In the article, the effect of nitrogen contents on the formation of ammonia in the reforming process has been studied. In the experiments, Ru based and Ni based catalysts were used and the concentration of ammonia in the reformate gas at various gas hourly space velocity was measured. Experimental result shows that relatively higher ammonia concentration was measured with Ru based catalyst than with Ni based catalyst. It also shows that the concentration of ammonia increased rapidly after most of the methane converted into hydrogen. Based on the experimental results to reduce ammonia concentration it might be better to finish methane conversion at the exit position of the reforming reactor to minimize the contact time of catalyst and nitrogen with high concentration of hydrogen.

• Journal of Advanced Marine Engineering and Technology
• /
• v.34 no.3
• /
• pp.360-368
• /
• 2010

A SCR catalytic filter system is used for reducing $NO_x$ and soot emissions simultaneously from diesel combustors. The amount of ammonia (as a reducing agent) must be controlled with the amount of $NO_x$ to obtain an optimal $NO_x$ conversion. Hence, gas mixing between ammonia and exhaust gases is vital to ensure that the SCR catalyst is optimally used. If ammonia mass distribution is not uniform, slip potential will occur in rich concentration areas. At lean areas, on the other hand, the catalyst is not fully active. The better mixing is indicated by the higher uniformity of ammonia mass distribution which is necessary to be considered in SCR catalytic filter system. The ammonia mass distributions are depended on the flow field of fluids. In this study, the velocity field of gaseous flow is investigated to characterize the transport of ammonia in SCR catalytic filter system. The influence of different injection placements on the ammonia mass distribution is also discussed. The results show that the ammonia mass distribution is more uniform for the injector directed radially perpendicular to the main flow of inlet at the gravitational direction than that at the side wall for both laminar (Re = 640) and turbulent flows (Re = 4255). It is also found that the mixing index decreases as increasing the heating temperature in the case of ammonia injected at the side wall.

• Asian Journal of Atmospheric Environment
• /
• v.10 no.3
• /
• pp.125-136
• /
• 2016

In this study, the effects of the mesh barrier on the free dispersion of ammonia were numerically investigated under different atmospheric conditions. This study presents the detail and flow feature of the dispersion of ammonia through the mesh barrier on various free stream conditions to decline and limit the toxic danger of the ammonia. It is assumed that the dispersion of the ammonia occurred through the leakage in the pipeline. Parametric studies were conducted on the performance of the mesh barrier by using the Reynolds-averaged Navier-Stokes equations with realizable k-${\varepsilon}$ turbulence model. Numerical simulations of ammonia dispersion in the presence of mesh barrier revealed significant results in a fully turbulent free stream condition. The results clearly show that the flow behavior was found to be a direct result of mesh size and ammonia dispersion is highly influenced by these changes in flow patterns in downstream. In fact, the flow regime becomes laminar as flow passes through mesh barrier. According to the results, the mesh barrier decreased the maximum concentration of the ammonia gas and limited the risk zone (more than 500 ppm) lower than 2 m height. Furthermore, a significant reduction occurs in the slope of the upper boundary of $NH_3$ risk zone distribution at downstream when a mesh barrier is presented. Thus, this device highly restricts the leak distribution of ammonia in the industrial plan.

• Applied Chemistry for Engineering
• /
• v.27 no.3
• /
• pp.265-269
• /
• 2016

Ammonia gas as a hydrogen source has received great attention since the importance of hydrogen gas as a clean energy source increased. However, ammonia is toxic and corrosive to metal such that the absorbent that can store and transport ammonia became an important issue. As an effort to solve this, a large pored covalent organic framework, COF-10 was proposed as an adsorbent for storage and safe transportation of ammonia. During the ammonia adsorption process, boron in COF-10 structure can act as a Lewis acid site and bind with ammonia. In this study, COF was synthesized and its structure was identified by BET, XRD and FT-IR. The adsorption characteristics of COF were investigated by TPD and adsorption isotherm. The COF-10 showed an excellent adsorption capacity for ammonia (9.79 mmol/g) which could be utilized as an ammonia adsorbent.

• Journal of Microbiology and Biotechnology
• /
• v.13 no.2
• /
• pp.217-224
• /
• 2003

Previously, we developed a CHO cell line (CHO-OTC1-Al9) that expresses the first two enzymes in the urea cycle and exhibits a higher ammonia-removing ability and faster growth rate than a vector-controlled CHO cell line (CHO-neo-5). The current study was undertaken to develop a cell line with an ammonia-removing ability higher than the cell line developed previously. To accomplish this, CHO cell lines expressing the first three, first four, or all five enzymes of the urea cycle were constructed using a stable transfection method. Finally, the CHO-AS-16, CHO-AL-19, and CHO-Arg-11 cell lines expressing the first three, first four, and all five enzymes of the urea cycle, respectively, were selected and found to exhibit higher ammonia-removing ability than the CHO-OTC1-Al9 cell line. Among the three selected cell lines, CHO-AL-19 showed the highest ammonia-removing ability and highest cell viability at a higher cell density, with 40% and 15% lower ammonia concentration in the, culture media than that of CHO-neo-5 and CHO-OTC1-A19 cell lines, respectively. CHO-AL-19 also showed 44% and 10% higher cell viability than the CHO-neo-5 and CHO-OTC-Al9 cell lines, at a higher cell density, respectively. The ammonia concentrations in the culture media were expressed as the ammonia concentration/cell, and the CHO-AL-19 cells revealed 45-60% and 20% lower ammonia concentration/cell than the CHO-neo-5 and CHO-OTC1-Al9 cells, respectively.

• Journal of Korean Society of Environmental Engineers
• /
• v.22 no.4
• /
• pp.651-659
• /
• 2000

The characteristics of ammonia removal by natural neutralizer were studied by using a scrubber type equipment. As operation parameters, neutralizer dilution ratio, neutralizer inlet flowrate, air flowrate and initial ammonia concentration were selected and their effects on ammonia removal efficiency were investigated. The optimal removal effect was achieved at neutralizer dilution ratio of 1.0% and neutralizer inlet flowrate of $60m{\ell}/min$. On the other hand, with respect to air flowrate and initial ammonia concentration, there was no significant effect on removal efficiency, when loading rate was considered. In addition, ammonia removal reaction was investigated by analyzing the ammonia oxides, such as nitrites and nitrates, after reacting ammonium solution with natural neutralizer. The result shows a partial oxidation by natural neutralizer besides dominant absorption of ammonia.

• Journal of the Korean Institute of Gas
• /
• v.19 no.6
• /
• pp.1-7
• /
• 2015

An ammonia fuel system is developed and applied to a 1 liter gasoline engine to use ammonia as primary fuel. Ammonia is injected separately into the intake manifold in liquid phase while gasoline is also injected as secondary fuel. As ammonia burns 1/6 time slower than gasoline, the spark ignition is needed to be advanced to have better combustion phasing. The test engine showed quite high variation in the power output to lead high increase in THC emission with large amount of ammonia, that is, higher than 0.7 ammonia-gasoline fuel ratios.

• Fisheries and Aquatic Sciences
• /
• v.24 no.2
• /
• pp.89-98
• /
• 2021

The accumulation of ammonia, a consequence of intensive aquaculture activity, can damage cultured animals. We analyzed the survival rates, growth, antioxidant responses, and immune responses of abalones, Haliotis discus hannai (mean shell length 70.2 ± 4.9 mm; mean body weight 36.9 ± 3.6 g), biweekly for four weeks, to determine the accumulated concentrations of ammonia (0, 0.1, 0.2, 0.4, 0.8, and 1.6 mg/L). In our biweekly measurements, a survival rate of ≥ 95% was observed for all concentrations of ammonia. The specific growth rate (SGR) decreased at ≥ 0.8 mg/L (p < 0.05), but the daily increment in shell length (DISL) showed no significant change (p < 0.05). Regarding antioxidant responses, the superoxide dismutase (SOD) activity of the hepatopancreas was increased at ammonia concentrations over 0.8 and 0.2 mg/L (p < 0.05) at two and four weeks, respectively, and the SOD activity of the gills increased at concentrations over 0.4 and 1.6 mg/L (p < 0.05) at four weeks. The catalase (CAT) activity of the hepatopancreas and gills increased at ammonia concentrations > 0.8 mg/L (p < 0.05). Phenoloxidase (PO) activity increased at ammonia concentrations over 0.8 mg/L (p < 0.05), and Lysozyme (LZM) increased at concentrations over 0.8 and 0.4 mg/L (p < 0.05). Overall, our findings indicated that ammonia concentrations over 0.8 mg/L in seawater might damage the SGR, antioxidant responses, and immune responses in H. discus hannai. Our findings suggest the necessity of improvement or reinstallation for abalone aquaculture systems and can be used to assess the toxic effects of ammonia on H. hannai.

• Journal of the Korean Wood Science and Technology
• /
• v.31 no.1
• /
• pp.52-60
• /
• 2003

The physical properties of small hardwood and softwood specimens treated with liquid ammonia were investigated. The specimens treated for 4 or 18 hours were compared with the controls. The EMCs of the liquid ammonia treated specimens were higher than those of the controls when conditioned at the same humidities. However once oven-dried they didn't show any significant differences in EMCs. With the increase of liquid ammonia treatment time specimens shrank in radial and tangential directions, but not in longitudinal direction. As liquid ammonia treatment time increased the ultrasonic velocities of specimens decreased and their densities increased, thus their dynamic MOEs decreased. For chestnut specimens the presteamed were more plasticized than the liquid ammonia treated. Incising on the surfaces of specimens didn't improve liquid ammonia permeability in both hardwoods and softwoods. Liquid ammonia treatment was very effective for plasticizing 5 mm thick softwoods. Relative dielectric constants and thermal conductivities were measured with both liquid ammonia treated and control specimens.

• Journal of Climate Change Research
• /
• v.10 no.3
• /
• pp.237-242
• /
• 2019

Ammonia is main precursor gas of secondary particulate matter and contributes almost 78% of total ammonia emission from the agricultural sector in Korea. The current method of estimating ammonia emission from fertilizer application, which contributes 7% of the total emission, has high uncertainty and needs to be improved to better predict PM2.5 concentration. In this study, we suggest an improvement method for ammonia emission quantification from fertilizer application. The first improvement was in the emission factor of NPK fertilizer by conducting a field study to verify the currently used factor. The improved NPK emission factor of 52.2 kg NH ton-1N was confirmed by comparing with the value from the EEA (European Environment Agency) and adjusting the value for the Korean climate and soil conditions. We also improved the amount of fertilizer usage by including the sales amount to the fertilizer supply amount of the Korean Farmers Association, increasing total fertilizer usage by 39.8%. As the statistical data on fertilizer supply and sales are compiled yearly, we estimated monthly emission of ammonia by considering cultivated areas and timing of fertilization for each crop. In summary, we suggest a novel and practical method to improve estimation methodology of ammonia emission from the field of fertilizer application: 1) emission factor of NPK fertilizer was reconfirmed; 2) total amount of fertilizer use was revised considering fertilizer sales; and 3) monthly emission of ammonia was realized by considering different crop practices. A bottom-up approach to compile activity data is needed to increase the estimation accuracy of monthly emission of ammonia, which is very helpful for predicting PM2.5 concentration.