• Bulletin of the Korean Chemical Society
• /
• v.33 no.7
• /
• pp.2193-2199
• /
• 2012

A series of novel polytriazoleimides were prepared from various aromatic dianhydrides and a new kind of 1,2,3-triazole-containing aromatic diamine synthesized by the Cu (I)-catalyzed 1,3-dipolar cycloaddition reaction in DMAc, and characterized by FT-IR, $^1H$-NMR, XRD, DSC and TGA techniques. The results show the polytriazoleimides are soluble in most of strong polar solvents and have inherent viscosity values of 0.51-0.62 dL/g(DMAc). The polytriazoleimide films exhibit a tensile strength of 62.3-104.5 MPa and an elongation at breakage of 4.0-8.1%, a glass transition temperature ($T_g$) of $257-275^{\circ}C$, a decomposition temperature (at 5% weight loss) of $350-401^{\circ}C$ in $N_2$ atmosphere, and a dielectric constant of 2.47-3.01 at 10 MHz, which depend on the structure of the polymers. The polytriazoleimides perform good resistance to acid and alkali solution.

• Journal of Sericultural and Entomological Science
• /
• v.35 no.1
• /
• pp.52-59
• /
• 1993

Raw silk degumming, by which the sericin and other marterials are eliminated from fibroin, is very essential process to produce silk fabrics. Alkali chemicals and enzymes have been used for the silk-degumming process. In this paper, the effect of heat treatment was investigated on silk fibers degummed by two different methods, soap and enzymatic degumming method. The difference between these two degumming methods was analyzed on the basis of results of mechanical testing, thermal analysis and intrated spectroscopy. The tenacity and the elongation of silk fiber are decreased by the heat-treatment in wet state. This tendency is observed in both cases of two degumming methods. The peak temperature in DSC analysis, which is attributed to thermal decomposition of silk fiber, was shifted to higher value with the heat-treatment temperature for the soap degummed silk fiber, however, it was not for the enzymatic degummed one. The IR crystallinity of soap digummed silk fiber is increased with the heat-treatment temperature, while that of enzymatic degummed fiber is not.

• Journal of the Korean Recycled Construction Resources Institute
• /
• v.6 no.4
• /
• pp.95-102
• /
• 2012

The serious issue of tall building is to ensure the fire resistance of high strength concrete. Therefore, Solving methods are required to control the explosive spalling. The fire resistant finishing method is installed by applying a fire resistant material as a light-weight material to structural steel and concrete surface. This method can reduce the temperature increase of the reinforcement embedded in structural steel and concrete at high temperature due to the installation thickness control. This study is interested in identifying the effectiveness of light-weight fire protection material compounds including the inorganic admixture such as fly ash, meta-kaolin and light-weight aggregate as the fire resistant finishing materials through the analysis of fire resistance and components properties at high temperature. Also, this paper is concerned with change in microstructure and dehydration of the light-weight fire protection materials at high temperatures. The testing methods of fire protection materials in high temperature properties are make use of SEM and XRD. The study results show that the light-weight fire resistant finishing material composed of fly ash, meta-kaolin and light-weight aggregate has the thermal stability of the slight decrease of compressive strength at high temperature. These thermal stability is caused by the ceramic binding capacity induced by alkali activation reaction by the reason of the thermal analysis result not showing the decomposition of calcium hydrate. Developed light-weight fire protection materials showed good stability in high Temperatures. Thus, the results indicate that it is possible to fireproof panels, fire protection of materials.

• Journal of Conservation Science
• /
• v.18 s.18
• /
• pp.19-32
• /
• 2006

The stone pagoda of the Bunhwangsa temple made by piling small brick-shaped stones. The major rock forming stone bricks are andesites with variable genesis. Rock properties of the pagoda roof stone suffer partly including multiple peel-offs, exfoliation, decomposition like onion peels, cracks forming round lines and falling off stone pieces. The stylobates and tabernacles in all the four directions the pagoda are mostly composed of granitic rocks. Those rock properties are heavily contaminated by lichens and mosses with the often marks of inorganic contamination by secondary hydrates that are dark black or yellowish brown. Within the four tabernacles and northern pagoda body situated to relatively high humidity. There are even light gray precipitate looking like stalactites between the northern and western rocks of the body Their major minerals are calcite, gypsum and clays. The stone lion standing in the southeast and northeast side are alkali granite, while that in the southwest and northwest lithic tuff. Total rock properties of the pagoda are 9,708 pieces, among the all properties, fractured blocks are 11.0%, fall out blocks are 6.7% and covered blocks by precipitates are 7.0%, respectively. The pagoda has highly deteriorated the functions of the rock properties due to physical, chemical and biological weathering, therefore, we suggest that this pagoda has need to do long term monitoring and synthetic conservation researches.

• Journal of Korean Society of Environmental Engineers
• /
• v.30 no.8
• /
• pp.768-774
• /
• 2008

To evaluate the effect of the solidified/stabilized sewage sludge on landfill sites, lysimeter tests were conducted. Lysimeters (LR1, LR2, and LR3) were filled with the material(Compost : Fodder : Sand = 10 : 10 : 80) and covered with different types of the cover soils, the G solidified sludge produced from the neutral solidifying chemical agent(LR1), the A solidified sludge produced from the alkali solidifying chemical agent(LR2), and the weathered granite soil(LR3). Those lysimeters were kept at the temperature controlled room with 30 $\pm$ 2$^{\circ}C$ for about 450 days. As the results, it was appeared LR2 > LR1 > LR3 that total gas production rate(L), gas production rate(L/VS(kg)) and cumulative gas(CO$_2$ + CH$_4$) production. There were not significant differences at decrease of the COD$_{Cr}$ in the leachate from LR1 and LR3. Thus, it had been shown that the use of the G solidified sludge as cover soil did not affect the COD$_{Cr}$ in the leachate. The COD$_{Cr}$ from LR2 had been increased since around 250 days because solidified/stabilized sewage sludge became re-slurry. T-N and T-P from LR3 also were higher than LR1 and LR2. Also were, the use of the solidified/stabilized sewage sludge as a cover soil, therefore, did not affect the T-N and T-Pconcentrations in the leachate.

• Korean Journal of Food Science and Technology
• /
• v.25 no.1
• /
• pp.22-27
• /
• 1993

Crude ${\beta}-glucan$ extracted from Barley was purified by stepwide enzyme treatment with thermostable ${\alpha}-amylase$, amyloglucosidase and protease. The thermal properties of Barley ${\beta}-glucan$ were investigated by Differential Scanning Calorimetry. Three endotherms have been observed on DSC thermograms of Barley ${\beta}-glucan$. The first endotherm which produced the gelatinization phenomena commonly observed in Barley ${\beta}-glucan$ became the focus of this study. The temperature range and the enthalpy of gelation exhibited maximum values with increasing concentration of Barley ${\beta}-glucan$. Gelating Barley ${\beta}-glucan$ registered an enthalpy of approximately 0.23 cal/g and exhibited onset temperature (To), peak temperature (Tp) and conclusion temperature (Tc) of $48.8^{\circ}C,\;61.2^{\circ}C\;and\;78.5^{\circ}C$ respectively. The temperature and enthalpy of gelatinizing Barley ${\beta}-glucan$ at both alkali and acid conditions were lower than those at pH 7. With salt present, the Tp and Tc of gelating Barley ${\beta}-glucan$ produced lower temperatures than in conditions where salt was absent, and the enthalpy abruptly decreased. However, increasing salt concentrations did not affect the gelation temperature and the enthalpy of Barley ${\beta}-glucan$. The 'true melting' temperature of Barley ${\beta}-glucan$ was near $184^{\circ}C$ and the melting enthalpy was approximately 34.6 cal/g. The Barley ${\beta}-glucan$ decomposition temperature was in the range of $316^{\circ}C{\sim}346^{\circ}C$.

• Journal of the Korea Organic Resources Recycling Association
• /
• v.20 no.1
• /
• pp.71-77
• /
• 2012

In order to find a feasibility of applying an agricultural biomass to the anaerobic digestion system, the effects of pre-treatment of rice straw was investigated by different sizes,temperatures, ultrasonic frequencies, and with/without NaOH treatment on the change of soluble organic matter, which is generated most dominantly in Korea. It was observed that SCOD(soluble chemical oxygen demand) as the index for the decomposition of rice straw increased with the smaller particle size, higher reaction temperature and alkali treatment. With treatment of 5% NaOH, it was shown that the highest concentrations of SCOD were observed at 9,000 mg $L^{-1}$ and 6,000mg $L^{-1}$ at $35^{\circ}C$ and $55^{\circ}C$, respectively. Agitating with ultrasonic irradiation could be enhanced SCOD of rice straw less than 3 cm with 40 kHz of ultrasound. Optimal RPM in this study was at 150 rpm regardless of reaction temperatures.

• Journal of the Korean Society for Marine Environment & Energy
• /
• v.12 no.3
• /
• pp.143-150
• /
• 2009

Fuel oil mostly used for a ship is made from crude oil by refining process. In order to produce plenty of high-quality fuel oil, the Fluid catalytic cracking(FCC) method is widely adopted to many refinery factories during the decomposition process from high molecule into lower molecule. The major constituents in spent FCC catalysts are Si, Al, Fe, Ti, alkali metals and some others. The spent catalyst is also composed small amounts of rare metals such as Ce, Nd, Ni and V. The big problem in FCC oil is mixing the catalyst in the oil. This reason is unstable separation of FCC catalyst in separator. Such a FCC catalyst will become a reason of heavy wear down in moving parts of engine. The impurity in oil is ash and deposit compound, such as Al, Si, Ni, Fe and V, which will accelerate the wear down on fuel pump, fuel injection valve cylinder liner and piston ring. It is important to find a basic reason of an engine trouble for preventing similar troubles anymore. Insurance compensation will be different according to the reason of an engine trouble which might be natural abrasion or other external causes. In this study, types and reasons of engine troubles related to fuel oil will be covered.

• Microbiology and Biotechnology Letters
• /
• v.7 no.2
• /
• pp.75-89
• /
• 1979

One strain of Penicillium sp. (175-66-B), isolated from soil, was able to produce a substance that has a strong inibition activity against the Agkistrodon and Trimeresurus venoms. In this experiment, the chemical and biological properties of the sample were investigated. As an inhibitory substance, it was effective to the proteinase, hemorrhagic and lethal factors of Agkistrodon and Trimeresurus venoms, and also effective to several fractions of the proteinases and hemorrhagic factors of Agkistrodon halys blomhoffi venom. Moreover, in the addition of prednisotone, it was more effective for the cure of the mouse envenomated with the venom amount of two fold of MLD$_{100}$. This substance was very stable to the acid, alkali and heat. Its melting point was high enough to sublime at 222$^{\circ}C$ without any decomposition. This sample was easily dissolved only in hot water, but not in several organic solvents except for a little dissolution in elate. It did not have the chelating activity. It had very strong specificity to the snake venoms. but its activity was depressed by the addition of zinc or cupric salts. This sample had no acute toxicity to the mouse. Its chemical formula was $C_{16}$ $H_{12}$$N_2$ $O_{10}$ with the molecular weight of about 392. It has two epoxy groups and four carboxyl radicals, but amino, nitrite and nitrate radicals, unsaturated bonds and aromatic ring were not detected. Theuchemical configuration of this sample was suggested to be;

• Korean Journal of Environmental Agriculture
• /
• v.23 no.4
• /
• pp.220-227
• /
• 2004

This study showed that thermophilic anaerobic acid fermentation of food wastes had an enhanced hydrolysis capability and improvement of acidification efficiency. Influence of pH on the anaerobic hydrolysis and acidogenesis was investigated to determine the proper alkalinity in the thermophilic fermentation of food wastes. The results of putting NaOH as alkali to evaluate hydrolysis and acid fermentation efficiency In acid fermentation process of food wastes showed that the food wastes pretreated with 0.05 g NaOH/g TS had the maximum 12,600 mg/L of VFAs concentration during HRT 3 days in $55^{\circ}C$ thermophilic condition and the maximum 9,700 mg/L of VFAs concentration during HRT 5 days in $35^{\circ}C$ mesophilic condition. The accomplishment of high VFAs concentration resulted from that the main component of food wastes such as cellulose, lignin and etc. is performed active chemical decomposition by alkali in thermophilic condition. The major components of VFAs produced from the thermophilic acid fermentation process of food wastes were the short chain fatty acids such as acetic acid, butyric acid, and propionic acid.