• Journal of Advanced Marine Engineering and Technology
• /
• v.38 no.7
• /
• pp.799-805
• /
• 2014

Recently, the regulations of the Local and Global for a variety of air pollution prevention has been enhanced by the steep rise in fuel oil prices. So, the appearance of Gas Fuelled Ships became necessary. In this study, we configured a regasification system which uses Eglycol water as a heating medium to evaporate before being supply fuel to the DF engine, then we analysed the system properties according to the Eglycol water mixing ratio. The results were as follows. When pressure, temperature, and flux of natural gas(NG) which are supplied to DF engines are uniformly kept, the higher mixing ratio of Eglycol is, the lower mixing specific heat of Eglycol water. And the cycle flux and electric power were 1.65 and 1.54 times more required. respectively, than water was used as the heating medium. Basic variables including mass flux according to the mixing ratio of Eglycol water, required electric power of operating fluid pumps, the temperature of natural gas which is supplied to the engine, and the heat exchanger's capacity were drawn from the gotten results.

• Transactions of the Korean Society of Mechanical Engineers B
• /
• v.37 no.10
• /
• pp.933-940
• /
• 2013

In this study, we evaluated the heat release performance of two extruded-type and two swaged-type heat sinks used in an inverter for solar power generation. The number of fins and heat transfer areas of the two swaged-type heat sinks, namely S-62 and S-98, are 62 and 98 and $2.8m^2$ and $5.3m^2$, respectively. Those for the two extruded-type heat sinks, namely, E-38 and E-47, are 38 and 47 and $1.8m^2$ and $1.9m^2$, respectively. The heat release fractions of S-62 and S-98 were measured as 82.7 % and 86.3 %, respectively. Those of E-38 and E47 were measured to be 79.6 % and 81.6 %, respectively. In this experiment, despite the mass flow rates of air entering the heat sinks being almost the same, the heat release fractions increased with heat transfer area. Furthermore, despite S-62's heat transfer area being 47.4 % higher than that of E-47, its heat release fraction was higher by only 1.3 %. We believe that this indicates the better heat transfer property of the extruded-type heat sink. S-98's heat release is only 4.4 % higher than that of S-62, but its heat transfer area is 89.3 % higher; this suggests that its heat transfer area need to be optimized.

• Journal of Plant Biotechnology
• /
• v.35 no.2
• /
• pp.155-161
• /
• 2008

This paper reported the establishment of mass production system of adventitious roots of Codonopsis lanceolata through shake flask and bioreactor culture. Induction of adventitious roots was started from the explants of leaf, stem and root on 1/2 strength Murashing and Skoog (MS) solid medium. Stem segments were the best explants for induction of adventitious roots compared to leaf and root segments. Among the different auxins tested (NAA, IBA and IAA), number of adventitious root per explant was highest on solid medium with 1.0 mg/L IBA, and produced $9.9{\pm}1.2$ roots per explant. However, growth of adventitious roots was fast in the presence of IBA at low concentration (0.1 mg/L). In shake flask culture, maximum production of adventitious roots (fresh weight) was obtained in half-strength MS medium compared to full-strength and one-third MS medium. When the adventitious roots produced in shake-flask culture were transferred to 5 L air-lift bioreactor, 16 times of fresh weight increase was gained after one month of culture. These results indicate that this protocol for the production of C. lanceolata adventitious roots can be applied to large scale culture for practical application.

• Journal of Korea Technical Association of The Pulp and Paper Industry
• /
• v.44 no.5
• /
• pp.72-79
• /
• 2012

In this study, to understand the aging factor and mechanism in different partitions of the beeswax-treated volumes, the duplicated beeswax-treated volume was artificially aged at $80^{\circ}C$ of temperature and 65% of relative humidity and then a physical and optical properties of an aged volumes was analyzed. Also, the degraded components of the beeswax samples isolated from different partitions of aged volumes was measured using a gas chromatography/mass spectroscopy (GC/MS). In results, the surface of beeswax-treated volume which is primarily affected by a main aging factors such as light, oxygen, moisture was more deteriorated than the inside of that volume. However, unlike inside of the book volume which was made from paper, the inside of beeswax-treated volume wax was also considerably deteriorated. The inside of the beeswax-treated volume is largely unaffected by the oxygen and humidity during aging due to the water repellency and the air permeation resistance of beeswax. Therefore, it is confirmed that aging factors and mechanisms in the inside of the volume are different from thats of the outside of the volume. This fact was also verified by the results of GC/MS analysis of an beeswax samples which was sampled from different partitions of aged volumes. As result as GC/MS analysis of the beeswax extracted from the outside of the aged volume, the low molecular compounds with a carbon length of $C_9-C_{20}$ (fatty acid, etc) were increased and the compounds with a carbon length of above $C_{34}$ (ester, etc) were also increased. But the compounds with a chain length of $C_{21}-C_{36}$ (hydrocarbon, alcohol, etc) were decreased. In case of the aged beeswax of inside, the low molecular compounds with a carbon length of $C_9-C_{20}$ (fatty acid, etc) and the compounds with a chain length of $C_{21}-C_{36}$ (hydrocarbon, alcohol, etc) were increased. While, the compounds with a carbon length of above $C_{34}$ (ester, etc) were decreased.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.19 no.8
• /
• pp.8-13
• /
• 2018

Nitrogen oxides (NOx) have recently been very influential in the generation of ultrafine dust, which is of great social interest in terms of improving the atmospheric environment. Nitrogen oxides are generated mainly by the reaction of nitrogen and oxygen in air in a combustion gas atmosphere of high temperature in a combustion apparatus such as thermal power generation. Recently, research has been conducted on the combustion that recirculates the exhaust gas to the cylindrical burner by using a piping using a Coanda nozzle. In this study, three types of burners were carried out through computational fluid analysis. Case 1 burner with the outlet of the combustion gas to the right, Case 2 burner with both sides as gas exit, Case 3 burner with left side gas exit. The pressure, flow, temperature, combustion reaction rate and distribution characteristics of nitrogen oxides were compared and analyzed. The combustion reaction occurred in Case 1 and Case 2 burner in the right direction with combustion gas recirculation inlet and Case 3 burner in the vicinity of mixed gas inlet. The temperature at the outlet was about $100^{\circ}C$ lower than that of the other burners as the Case 2 burner was exhausted to both sides. The NOx concentration of Case 1 burner at the exit was about 20 times larger than that of the other burners. From the present study, it could be seen that it is effective for the NOx reduction to exhaust the exhaust gas to both side gas exits or to exhaust the exhaust gas to the opposite direction of inlet of recirculation gas.

• Korean Journal of Animal Reproduction
• /
• v.17 no.2
• /
• pp.149-157
• /
• 1993

A new technique was established to maximize the numbers of follicular oocytes recovered from the ovaries obtained at the slaughter house. And their further developmental capacity was demonstrated. There recovery techniques were used; aspiration (ASP, control), slicing (SLC) and slicing combining aspiration (ASP+SLC). Recovered oocytes were cultured in TCM 199+15% FCS+gonadotrophins in an atmosphere of 5% CO$_2$ in air at 39$^{\circ}C$ for 24 h. The nuclear maturation was detemined with chromo-some configuration by rapid staining. And cytoplasmic maturation was examined by the formation of female pronuclei with parthenogenetic activation of the matured oocyte after 18 h of co-culture with granulosa cell monolayer. Total 1,641 bovine follicular oocytes recovered from 245 ovaries. The number of oocytcs per ovary was 1.87 in ASP, 11.05 in SLC and 7.88 in ASP+SLC, respectively. SLC would yield 5.9 folds increase, compared with ASP. The rate of maturation were 92.9% in ASP, 79.1% in SLC and 71.7% in ASP+SLC, respectively. Although the maturation rate in ASP was the highest, metaphase II oocytes per ovary in SLC was 5 times higher than that of ASP. The rates of pronuclei formation upon ethanol activation were 75% in ASP, 67% in SLC and 62.5% in ASP+SLC, respectively. The results demonstrate that it should be possible to maximize the number of the follicular oocyte from the ovary for mass production of bovine embryos. Thus the established technique may provide efficient supply of bovine embryos for biochemical and molecular study of early bovine embryos.

• Korean Journal of Fisheries and Aquatic Sciences
• /
• v.42 no.6
• /
• pp.621-627
• /
• 2009

In order to standardize the juvenile abalone rearing technique, we selected sample farms by region in East, West and South coasts of Korea and Jeju island. We also have reviewed previous literature and visited farms to survey on the management of abalone juvenile production, spawning, hatching and so forth. Results of investigation are as follows: The light colors of tanks for larvae breeding are good for a frequent examination of larvae behaviour changes during the breeding period. The tank for the abalone juvenile production is a rectangular form in general and its size should amount to 3.5 m in length and 1.2 m width. It also should be built with proper drainage. The best age and size of adult for juvenile production are 3-6 years old individuals, with 9-12 cm separate burial and 125-150 g average weight. To induce spawning, the use of the exposure on air and ultraviolet ray together was the most effective. The density of larvae by plate should be 150-300 individuals and the proper stocking density was est imated and amount to 10-30 individuals. It has been shown that a correlation between water surface size($X_1$) and number of plates ($Y_1$), when producing abalone juveniles, is quite high and it is described by equation $Y_1=138.88X_1-5,736.8\;(R^2=0.9028)$. In addition, it has also been shown that a correlation between production of abalone juveniles ($Y_2$) and number of plates ($X_2$) is high and it is described by equation $Y_2=4.554X_2+12,493\;(R^2=0.8818)$. In Jindo region where a mass production of juveniles abalone has been done, it was shown, that a correlation between rearing water surface size ($X_3$) and production of juveniles abalone ($Y_3$) is very high and this relationship was described by the equation $Y_3=747.03X_2+94,359(R^2=0.9809)$. It has also been shown that a correlation between water surface size ($X_4$) and production of abalone juveniles ($Y_4$) in nationwide is high and the relationship between this variables was described by equation $Y_4=635.85X_4+99,923\;(R^2=0.9020)$.

• Journal of Satellite, Information and Communications
• /
• v.3 no.1
• /
• pp.41-47
• /
• 2008

Line-of-sight communications cannot easily support korean armed forces because of mountainous terrain. ADD(Agency for Defense Development) introduced ANASIS(Army Navy Air-force Satellite Information System) to meet the Korean warfighter's operational needs. Currently, army's military satcom terminal is designed for either fixed site or on-the-pause operation. The US army is under development of multi-band integrated on-the-move satellite terminals to let the army's communication capability to keep pace with globally deployable Joint Task Force for network-centric application. In this paper we analyzed X-band and Ka-band link and subsystem requirement. Our focus here is to describe key technical issues. Especially, On the basis of 3dB beam width of 0.9m antenna, Tracking accuracy and disturbances compensation signal processing on-the-move of Antenna Tracking system is analyzed. Also, protocol is analyzed that minimize blockage on the move due to an obstacle. when the received signal blocked, it stop to transmit burst signal and retransmit when blockage removed through received synchronization signal monitoring. Analyzed specification will be used to make prototype terminal to analyze risk for mass production

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.17 no.7
• /
• pp.616-622
• /
• 2016

The heating load using solar hot water is lower in summer than in the other seasons. This decreased heating load leads to the overheating solar collectors and related components. To prevent overheating of the solar collectors, air cooling and shading shields were used. On the other hand, it requires additional mechanical components, and reduces the system reliability. The geothermal heat dump system to release the high temperature heat (over $150^{\circ}C$) transferred from the heat pipe solar collectors was investigated in the present study. Research on the heat dump to cool the solar collector is rare. Therefore, the present study was carried out to collect possible data of a geothermal heat dump to cool the solar collector. A helical type geothermal heat exchanger was buried at a 1.2m depth. Experimentally and numerically, the geothermal heat dump was investigated in terms of the effects of parameters, such as the quantity of solar radiation, aperture area of the collector and the mass flow rate. A pipe length of 50m on the geothermal heat exchanger was suitable with a 0.33 kg/s flow rate. The water reservoir was a possible co-operation solution linked to the geothermal heat exchanger.

• Journal of Korean Society of Environmental Engineers
• /
• v.22 no.10
• /
• pp.1825-1832
• /
• 2000

Column experiments were conducted by using soil columns, to investigate feasibility and efficiency of in-situ ozone enhanced remediation for diesel-contaminated soil. The injection of gaseous ozone into soil column revealed the enhanced decomposition of ozone due to the catalytic reaction between ozone and metal (e.g., Fe, Mn etc.) oxides as evidenced by as much as 25 times shorter half-life of ozone in a sand packed column than in a glass beads packed column. Substantial retardation in the transport of and the consumption of ozone were observed in the diesel contaminated field soil and sand packed columns. After 16 hrs ozonation, 80% of the initial mass of diesel (as diesel range organic) concentration of $800{\pm}50mg/kg$, was removed under the conditions of the flow rate of 50mL/min and $6mg-O_3/min$. Whereas, less than 30% of diesel was removed in the case of air injection. Analysis of the residual TPH(total petroleum hydrocarbon) and selected 8 aliphatics of diesel compounds in the inlet and the outlet of the column confirmed that diesel nonselectively reacted with ozone and then shifted to lower carbon numbered molecules. Water content also was found to be an important parameter in employing ozone to the hydrocarbon-contaminated soil.