• Journal of the Korean Wood Science and Technology
• /
• v.36 no.3
• /
• pp.93-100
• /
• 2008

For investigation of adsoption properties of cadmium elimination by wood charcoal, $25m{\ell}$ aqueous cadmium solutions in various concentrations were treated with 0.2 g wood charcoal of Red Oak (Quercus mongolica) for 280 minutes. Almost 100% of cadmium elimination ratio was obtained in the solutions with initial concentration of 20 and 40 ppm in the treatment, whereas they were 75 and 50% in those of 80 and 160 ppm. In the effect of treatment time, the highest amount of cadmium ions was eliminated during the first ten minutes in each solution so that the elimination ratio of each case was over 70% of the maximum elimination value. From the analysis of adsorptive cadmium adsorption mechanism using the Langmuir adsorption isotherm, it was suggested that cadmium ion molecules were adsorbed at the active sites on the charcoal particle in form of one layer. The Gibbs free energy of the adsorption process was calculated in negative value for each solution. This means the adsorption processes are spontaneous which do not require the extra input energy.

• Journal of Environmental Science International
• /
• v.19 no.6
• /
• pp.681-687
• /
• 2010

Mesoporous silica was prepared from hydrothermal synthesis using gel mixture of tetraethylorthosilcate (TEOS) as silica source and cetyltrimethylammonium bromide (CTMABr) as a surfactant. In the optimum synthesis cause, molar ratio of template and silica changed. The surface and structure properties of mesoporous silica were determined by XRD, SEM, TEM and BET. Also, surface potential of mesoporous silica was measured using zeta potential. $N_2$ adsorption isotherm characteristics, including the specific surface area ($S_{BET}$), total pore volume $V_T$), and average pore diameter ($D_{BJH}$), were determined by BET. As a result, SBET of $100m^2/g{\sim}1500m^2/g$ was determined from the $N_2$ adsorption isotherm. Also, the average pore diameter was 2 nm∼4 nm. Mesoporous silica's surface potential of minus charge was determined from zeta potential.

• Journal of Nuclear Fuel Cycle and Waste Technology(JNFCWT)
• /
• v.14 no.3
• /
• pp.223-234
• /
• 2016

This study aimed to the adsorption-removal of high- radioactive iodide (I) contained in the initially generated high-radioactive seawater waste (HSW), with the use of AgX (Ag-impregnated X zeolite). Adsorption of I by AgX (hereafter denoted as AgX-I adsorption) was increased by increasing the Ag-impregnated concentration in AgX, and its concentration was suitable at about 30 wt%. Because of AgCl precipitation by chloride ions contained in seawater waste, the leaching yields of Ag from AgX (Ag-impregnated concentration : about 30~35 wt%) was less than those in distilled water (< 1 mg/L). AgX-I adsorption was above 99% in the initial iodide concentration ($C_i$) of 0.01~10 mg/L at m/V (ratio of weight of adsorbent to solution volume)=2.5 g/L. This shows that efficient removal of I is possible. AgX-I adsorption was found to be more effective in distilled water than in seawater waste, and the influence of solution temperature was insignificant. Ag-I adsorption was better described by a Freundlich isotherm rather than a Langmuir isotherm. AgX-I adsorption kinetics can be expressed by a pseudo-second order rate equation. The adsorption rate constants ($k_2$) decreased by increasing $C_i$, and conversely increased by increasing the ratio of m/V and the solution temperature. This time, the activation energy of AgX-I adsorption was about 6.3 kJ/mol. This suggests that AgX-I adsorption is dominated by physical adsorption with weaker bonds. The evaluation of thermodynamic parameters (a negative Gibbs free energy and a positive Enthalpy) indicates that AgX-I adsorption is a spontaneous reaction (forward reaction), and an endothermic reaction indicating that higher temperatures are favored.

• Journal of Korean Society of Water and Wastewater
• /
• v.18 no.4
• /
• pp.470-479
• /
• 2004

The experimental conditions and relationships between parameters such as organic matter, aeration volume, aeration time, and precipitation time for the effective treatment of domestic wastewater were investigated. With the batch systems, the adsorption amount of unit microbe was measured with the change of MLSS concentration, precipitation time, and aeration amount. Theoretical adsorption amount of microbes was then numerically formulated by use of a SPSS multiple analysis as follows: $$Y=-0.0106(X_1)+0.07310(X_2)+42.705(X_3)+62.700$$ In this study, the amount of organisms to be removed in the range of MLSS concentration 2,000~4,500 mg/l were examined. In order to investigate the optimal condition of nitrification, the upper water in the biosorption stage was used as the initial experiment water. The results showed that the C/N ratio was 1.5 and the reaction time for the optimal nitrification was 1.5 hr. When the adsorption efficiency for microbe biosorption was 66%, the optimum denitrification efficiency was 83.3%. When the optimum parameters obtained from the batch experiment were applied to the lab-scale operation, the total retention time from the flow-in to flow-out was 10 hours and the removal efficiency was 93.8% for $COD_{cr}$ and 80.9% for TN. For the full-scale operation, the total retention time was 9.0 hours and the removal efficiency was 94.4% for BOD, 89.6% for $COD_{cr}$, 88.0% for TN, and 86.2% for TP.

• Economic and Environmental Geology
• /
• v.31 no.4
• /
• pp.291-296
• /
• 1998

Pedogenic hematite is a well known agent for sink of pollutants and nutrients and for aggregation of particles in soils. Changes in physical and chemical properties of two sandy loam soils (Anahuac and Crowley soils) from the Southern Coastal Plain, the United States of America, were tested after adding finely ground crystalline hematite prepared for drilling fluid weighting material. There was an increase in hydraulic conductivity (HC) of the soils with addition of up to 3% by weight of hematite but a decrease in HC with addition of more hematite. The aggregate stability (AS) of the soils was not affected by adding hematite. Anahuac soil with higher content of organic matter and lower sodium adsorption ratio (SAR) had higher values of HC and AS than Crowley soil. Adding hematite also resulted in a slight increase in zinc (Zn) adsorption by the soils, but had no influence on the adsorption of phosphate.

• Clean Technology
• /
• v.7 no.2
• /
• pp.133-140
• /
• 2001

The adsorption characteristics of binary-component Volatile Organic Compounds(VOCs) with benzene and toluene were studied in a fixed bed backed with activated carbon. The adsorption intensites of benzene and toluene resulted from equilibrium adsorption capacity led to roll up phenomenon in a fixed bed and behaved benzene as non-key component which meant the smaller affinity to the activated carbon of the two. From comparion with breakthrough curves between binary-component and single component systems at the same concentration conditions, the stoichiomertic breakthrough time of toluene in both systems had no difference, but that of benzene as non-key component had a tendency to shorten 130min than 200min of single component. In the breakthrough characteristics of binary-component adsorbates, the magnitude of roll-up of the non-key component increased with the increasing of non-key component ratio and aspect ratio(L/D) of fixed bed, while decreased with the increasing of interstitial velocity. Especially, the roll-up phenomenon was more conspicuous with the increasing of mole fraction of key component.

• Journal of Korean Society of Water and Wastewater
• /
• v.33 no.4
• /
• pp.251-258
• /
• 2019

The physical treatment such as chemical precipitation or adsorption was usually added after biological treatment in wastewater treatment process since it was enforced to reduce the concentration of phosphate for wastewater effluent to 0.2 mg/L as P which was well known as one of main nutrient causing eutrophication in waterbody. Therefore, the new material functioned for both adsorption and disinfection was prepared with Fe and Cu, and $TiO_2$, respectively, by changing the ratio of concentration referred to tri-metal (TM). According to SEM-EDS, $TiO_2$ was 30~40% composition for any TM regardless of any synthesis condition. However, the ratio of composition for Fe and Cu was dependent on the initial Fe and Cu concentration, respectively. The removal efficiency of phosphate was obtained to 15% at low initial concentration and the maximum uptake (Q) was calculated to ~11 mg/g through Langmuir isotherm model using TM1 which was synthesized at 1000 mg/L, 1000 mg/L, and 2 g (10 g/L) for $Fe(NO_3)_3$, $Cu(NO_3)_2$, $TiO_2$, respectively. In disinfection test, the efficiency of virus removal using TM was increased with increase of dosage of TM and can be reached 98% at 0.2 g.

• Proceedings of the Korean Fiber Society Conference
• /
• 2003.04a
• /
• pp.311-312
• /
• 2003

Activated carbons (ACs) are widely used in adsorption for the removal of gaseous and aqueous pollutants[1]. Although a wide range of carbonaceous materials can be converted into ACs, the coal and lingocellulosic materials are the most commonly used starting materials for the production of commercial ACs. Recently, there are a quite large number of studies regarding the preparation of ACs from various polymeric materials because of high carbon yield and low ash content In this work, ACs are prepared from polystyrene (PS) by chemical activation with potassium hydroxide and the effect of the KOH-to-PS ratio to adsorption of ammonia is investigated. (omitted)

• Journal of Environmental Science International
• /
• v.10 no.6
• /
• pp.451-459
• /
• 2001

Adsorption characteristics of triadimefon and diniconazole(pesticide) by natural zeolite($CLI_N$) and several synthetic zeolites were Investigated. The synthetic zeolites used En this study were as follows: Faujasite synthesized from coal fly ash($FAU_F$); Zeolite synthesized from the mixture of FAU and Na-Pl synthesized from the ratio of Cheju scoria 6 to coal fly ash 4 by weight($(FAU + Na-Pl)_{SF}$); waste fluid catalytic cracking catalyst($FCC_W$). The distribution coefficient, $K_D$ and Freundlich constant, $K_F$ decreased in the fellowing sequence : $FCC_W ＞ FAU_F ＞ (FAU + Na-Pl)_{SF} ＞CLI_N$ among the zeolites. The distribution coefficient and the adsorption capacity of $(FAU + Na-Pl)_{SF}$ for pesticides were 4.4 and 2.6 times higher for triamefon, and 2.0 and 2.4 times higher for diniconazole than those of $CLI_N$, respectively.

• Journal of Biomedical Engineering Research
• /
• v.14 no.3
• /
• pp.209-220
• /
• 1993

Microspheres are expected to be applied to biomedical areas such as solid-phase immunoassays, drug delivery systems, Immunomagnetic cell separation. To synthesize micro-spheres for biomedical application, "two stage shot growth method" was developed. The uniformity ratio or synthesized microspheres was always smatter than 1.05. And the surface charge density (or the number of ionizable functional groups) of the microspheres synthesized by "two stage shot growth method" was 6-13 times higher than thats of the ml crospheres synthesized by conventional seeded batch copolymerization. As a previous step for biomedical application, adsorption experiments of bovine albumin on microspheres were carried out under various conditions. The maximum adsorbed amount was obtained in the neighborhood of pH 4.5. Isoelectric point of bovine albumin Is pH 5.0, so experimental result shows that it shifted to acid area. The adsorption Isotherm was obtained, the plateau region was always reached at 2.Og/L (bulk concentration of bovine albumin ) . The effect of the kind and the amount of surface functional group was also examined.p was also examined.