• Current Photovoltaic Research
• /
• v.8 no.3
• /
• pp.102-106
• /
• 2020

In this paper, the effect of MoSe₂ on the contact resistance (R_C) of the transparent conducting oxide (TCO) and Mo junction in the scribed P2 region of the Cu(In,Ga)Se₂ (CIGS) solar module was analyzed. The CIGS/Mo junction becomes ohmic-contact by MoSe₂, so the formation of the MoSe₂ layer is essential. However, the CIGS solar module has a TCO/MoSe₂/Mo junction in the P2 region due to structural differences from the cell. The contact resistance (R_C) of the P2 region was calculated using the transmission line method, and MoSe₂ was confirmed to increase R_C of the TCO/Mo junction. B doped ZnO (BZO) was used as TCO, and when BZO/MoSe₂ junction was formed, conduction band offset (CBO) of 0.6 eV was generated due to the difference in their electron affinities. It is expected that this CBO acts as a carrier transport barrier that disturbs the flow of current, resulting in increased R_C. In order to reduce the R_C caused by CBO, MoSe₂ must be made thin in a CIGS solar module.

• Korean Journal of Materials Research
• /
• v.19 no.11
• /
• pp.596-600
• /
• 2009

Electrochemical deposition characteristics of CdSe nanorods were investigated for hybrid solar cell applications. CdSe nanorods were fabricated by electrochemical method in $CdSO_4$ and $H_2SeO_3$ dissolved aqueous solution using an anodic aluminum oxide (AAO) template. Uniformity of CdSe nanorods was dependent on the diameter and the height of holes in AAO. The current density, current mode, bath composition and temperature were controlled to obtain a 1:1 atomic composition of CdSe. CdSe nanorods deposited by direct-current method showed better uniformity compared to those deposited by purse-current and/or purse-reverse current methods due to the bottom-up filling characteristics. $H_2SeO_3$ concentration showed more significant effects on pH of solution and stoichiometry of deposits compared to that of $CdSO_4$. A 1:1 stoichiometry of uniform CdSe nanorods was obtained from 0.25M $CdSO_4-5$ mM $H_2SeO_3$ electrolytes with a direct current of 10 $mA/cm^2$ at room temperature. X-ray diffraction and electron diffraction pattern investigations demonstrate that CdSe nanorods are a uniform cubic CdSe crystal.

• Microbiology and Biotechnology Letters
• /
• v.42 no.1
• /
• pp.11-17
• /
• 2014

Selenium is an essential trace element for mammals, but it is very toxic. Therefore, the control of selenium concentrations should be precisely and effectively monitored. Selenium is naturally obtained through foods and seleno-L-methionine (LSeMet) is a major form of selenium. It has been reported that L-SeMet is only converted into Se-adenosyl-L-SeMet. However, a recent study suggested that L-SeMet was directly metabolized into methylselenol ($CH_3SeH$) in mouse liver extract by the reaction of cystathionine ${\gamma}$-lyase (CGL). The canonical reaction of CGL was known to catalyze the cleavage of L-cystathionine to L-cysteine, ${\alpha}$-ketobutyrate and $NH_3$. In the present study, we found that L-SeMet could be directly converted to $CH_3SeH$ using purified homogenous human CGL instead of mouse liver cytosol. Authentic $CH_3SeH$ was prepared by reduction of dimethyldiselenide with sodium tetrahydroborate. The gaseous product of the enzymatic reaction with L-SeMet was analyzed by GC/MS spectrometry. The GC/MS data was identical to that of authentic dinitrophenyl selenoether. We also analyzed the kinetic parameters for the formation of $CH_3SeH$ from L-SeMet by human and mouse CGL. These results suggest that human CGL is a critical enzyme which is responsible for L-SeMet metabolism.

• Journal of Animal Science and Technology
• /
• v.47 no.2
• /
• pp.305-316
• /
• 2005

This study was conducted to determine the total amount and type of seleniwn (Se) in the Se-enriched mushroom and its spent mushroom composts (SMC), and to investigate the metabolism in relation to Se accwnulation in the mushroom. Mushrooms, Flammulina velutipes, used in this study were grown for 60 days by adding 2 rng of inorganic Se (Na2Se03) per kg of mushroom composts (MC) on as-fed basis and were compared with normal mushrooms grown on the non Se-supplemented Me. Total Se contents for Se-treated mushrooms were significantly increased (P < 0.0001) by 20-fold (4.51 $\mu$/ g of dry) compared to Se-untreated (0.23 $\mu$/ g of dry). On the contrary, organic Se ratio was significantly lower (P < 0.0001) in the Se-treated mushroom (72.3 %) than the Se-untreated one (100 %, not analytically detected of inorganic Se). Se distribution upon a length in the Se-treated mushrooms was the highest in the bottom part (6.86 $\mu$/ g of dry) near to MC, and top and middle parts were significantly lower (3.71 and 3.01 $\mu$/ g of dry, respectively; P < 0.001) than the bottom. In the SMC from Se-treated mushrooms, the significant amount of Se (5.04l1g/g of dry) was remained, but that from the Se-untreated mushrooms was significantly low (P$\mu$ / g of dry. Se-treated SMC showed a high ratio of organic Se (65.67 %), suggesting that the significant amount of inorganic Se in the SMC was converted to organic Se by mushroom mycelia. Prior to mycelia inoculation in the mushroom culture, the sterilization of MC brought approximately 18% of Se loss in the MC. Apparent and net accumulation rates (%) for Se into mushrooms were 14.81 and 10.14 %, respectively, resulting from the Se volatilization into the air via metabolic process of mushroom itself. The result of this study shows that inorganic Se addition to MC for mushroom improved the organic Se contents in the mushroom and SMC. This study showed the possibility that Se in Se-enriched mushroom and SMC could be utilized as Se sources of food for human as well as feed for livestock.

• Analytical Science and Technology
• /
• v.16 no.5
• /
• pp.399-406
• /
• 2003

This study was conducted to find out the analysis condition of selenium(Se) in oil refinery wastewater with a high concentration of Se using the atomic absorption spectrometry with hydride generation system (HG-AAS). From various experiments that reduced Se(VI) to Se(IV), the optimum pretreatment condition was determined to be a sample volume of 10 mL, HCl 10 mL, with a 30 min heating time in a water bath. In oil refinery wastewater, as the concentration of organics and constitution became higher, the recovery rates of Se decreased. Therefore, three acid digestion methods ($HNO_3/HClO_4$ digestion, $KMnO_4$ digestion, and microwave acid digestion) were tested on the recovery rates of Se in reference to the digestion of organics, petroleum and oxidation from organic Se(org.), Se(IV) to Se(VI). The experiment results showed that the average recovery rate of Se was the highest in microwave acid digestion, although all of the digestions were more than 90%. In consequence, the pretreatment procedure of microwave digestion followed by HCl addition was the most suitable for selenium analysis in oil refinery wastewater by using HG-AAS.

• Journal of Sensor Science and Technology
• /
• v.8 no.6
• /
• pp.476-480
• /
• 1999

PbSe thin films were grown using PLD method on the p-Si(100) substrate. To determine what crystalline structure of PbSe thin films have according to the growth temperature, the films were prepared under a substrate temperature changing between a room temperature and $400^{\circ}C$. As a result of analyzing XRD patterns of PbSe thin films prepared at various substrate temperatures and FWHM of PbSe(200) rocking curve, it was found that PbSe thin film obtained at the growth temperature of $200^{\circ}C$ was best crystallized. In addition, the surface morphology of PbSe thin film observed using AFM found itself having the most regularly arranged particles in case of growing the film at $200^{\circ}C$. The measurement of Hall effect indicated that PbSe thin films were n-type semiconductors and that current-voltage characteristic curve exhibit the typical p-n junction phenomenon. In addition, electric conductivity of PbSe thin films was found somewhat higher than that of general semiconductors.

• Bulletin of the Korean Chemical Society
• /
• v.35 no.12
• /
• pp.3601-3608
• /
• 2014

RGB light emitting ZnSe based nanocrystals: ZnSe (blue), ZnSe:Cu (green) and ZnSe:Mn (red) were synthesized by capping the surface of the nanocrystals with oleic acid. The obtained nanocrystal powders were characterized by using XRD, HR-TEM, ICP-AES, FT-IR, and FT-Raman spectroscopies. The optical properties were also measured by UV/Vis and photoluminescence (PL) spectroscopies. The PL spectra showed broad emission peaks at 471 nm (ZnSe), 530 nm (ZnSe:Cu) and 665 nm (ZnSe:Mn), with relative PL efficiencies in the range of 0.7% to 5.1% compared to a reference organic dye standard. The measured average particle sizes from the HR-TEM images for those three nanocrystals were 4.5 nm on average, which were also supported well by the Debye-Scherrer calculations. The elemental compositions of the ZnSe based nanocrystals were determined by ICP-AES analyses. Finally, the drawn CIE diagram showed the color coordinates of (0.15, 0.16) for ZnSe, (0.22, 0.57) for ZnSe:Cu, and (0.62, 0.35) for ZnSe:Mn respectively, which were fairly well matched to that of the RGB color standards.

• Proceedings of the KIEE Conference
• /
• 2006.10a
• /
• pp.55-56
• /
• 2006

We investigated the diffraction grating efficiency by the DPSS laser beam wavelength to improve the diffraction efficiency on AsGeSeS & Ag/ AsGeSeS thin film. Diffraction efficiency was obtained from DPSS(532nm)(P:P)polarized laser beam on AsGeSeS, Ag/ AsGeSeS and AsGeSeS/Ag/AsGeSeS thin films. As a result, for the laser beam intensity, 0.24 mW, single AsGeSeS thin film shows the highest value of 0.161% diffraction efficiency at 300 s and for 2.4 mW, it was recorded with the fastest speed of 50 s, which the diffraction grating forming speed is faster than that of 0.24 mW beam. Ag/ AsGeSeS and AsGeSeS/ Ag/ AsGeSeS multi-layered thin film also show the faster grating forming speed at 2.4 mW and higher value of diffraction efficiency at 0.24 mW.

• Journal of the Korean Magnetics Society
• /
• v.24 no.2
• /
• pp.41-45
• /
• 2014

By M$\ddot{o}$ssbauer spectroscopy and x-ray measurement $(Fe_{0.95}Ni_{0.05})_7Se_8$ has been studied. The crystal structure of $(Fe_{0.95}Ni_{0.05})_7Se_8$ is found to be a triclinic superstructure of the NiAs sturcture while $Fe_7Se_8$ has a orthohexagonal superstructure. Abrupt changes of quadrupole shifts near 125 K for $(Fe_{0.95}Ni_{0.05})_7Se_8$ suggests that the spin-rotation transition proceeds abruptly, in contrast with the gradual transition reported for $Fe_7Se_8$ with a triclinic superstructure. Isomer shifts indicate a ferrous state for the iron ions at all four states.

• Clinics in Shoulder and Elbow
• /
• v.17 no.3
• /
• pp.107-113
• /
• 2014

Background: Sonoelastography (SE) is a new technique that can assess differences in tissue stiffness, the purpose of this study was to evaluate the ability of SE to assess the long head of biceps tendon alteration. Methods: Forty shoulders of 36 consecutively registered patients with clinical symptoms and conventional ultrasonography findings of biceps tendinitis or tendinosis, and 40 asymptomatic shoulders of 20 healthy volunteers were assessed with SE. Transverse and longitudinal images of long head of biceps tendon were obtained using SE. SE images were performed by one orthopedic surgeon and evaluated by two orthopedic surgeons using an experimentally proven color grading system. Results: The transverse images of SE showed a sensitivity of 87.5%, a specificity of 95.0% and a accuracy of 91.3%, the longitudinal images of SE showed a sensitivity of 92.5%, a specificity of 90.0% and a accuracy of 91.3%. Inter-observer reliability of SE was in 'almost perfect agreement' with a weighted kappa coefficient of 0.83. Conclusions: SE is valuable in the detection of the intratendinous and peritendinous alterations of biceps tendon, and has excellent accuracy and excellent correlation with conventional ultrasound findings.