• Applied Chemistry for Engineering
• /
• v.35 no.3
• /
• pp.230-238
• /
• 2024

In the present work, the interaction of lipid-based zwitterionic surfactant CDP-W with the vesicle membrane of phospholipids was investigated. For this purpose, interfacial properties such as critical micelle concentration (CMC) and surface tension were measured for the zwitterionic surfactant CDP-W and lecithin S100-3. The zeta potential of 1 wt% aqueous surfactant solutions was also measured as a function of pH to determine the iso-electric point of CDP-W surfactant, where the characteristic of CDP-W surfactant changes from a cationic surfactant to an anionic surfactant. Based on the iso-electric point measurement of CDP-W surfactant, the effects of pH change and CDP-W addition on the stability of S100-3 liposome systems were studied, such as average particle size, polydispersity index (PDI), and zeta potential. The effect of CDP-W on the fluidity characteristics of liposome membranes such as fluorescence anisotropy ratio, deformability, and melting point was investigated at pH 6 where the most stable liposomes were prepared to understand the effect of the fluidity of the liposome membrane on the encapsulation efficiency of active materials and the stability of liposome systems.

• Journal of the Korean Electrochemical Society
• /
• v.24 no.3
• /
• pp.35-41
• /
• 2021

In this study, the effect of zwitterionic surfactant on Cu electrodeposition was investigated through cyclic voltammetry. With the addition of (dodecyldimethylammonio)propanesulfonate (DDAPS) as a representative zwitterionic surfactant in the electrolyte for Cu electrodeposition, the electrochemical Cu²⁺ reduction was inhibited on Cu and glassy carbon electrodes. Its inhibition effect was similar to that of cationic surfactant rather than anionic surfactant. Moreover, DDAPS interacted with chloride ion and exhibited the mass transfer-dependent inhibition behavior, which indicates that its inhibition function is associated with the formation of its surface aggregates on anion-covered Cu surface. In addition, adsorbed DDAPS slightly reduced the surface roughness of Cu electrodeposits. These characteristics were similar to those of cationic surfactant, but less obvious. It means the effect of DDAPS on Cu electrodeposition originates from the cationic head group which is shield by anionic head group.

• Korean Chemical Engineering Research
• /
• v.47 no.1
• /
• pp.31-37
• /
• 2009

A zwitterionic surfactant shows not only detergency but also mildness effect since it shows characteristics of a nonionic or an anionic surfactant above an isoelectric point, while showing characteristics of a cationic surfactant below an isoelectric point. Therefore, a zwitterionic surfactant can serve as a dual function surfactant by a single molecule through the interconversion of cleaning and softening effects depending on pH variations of the aqueous solution. In this study, physical properties of betaine surfactant such as CMC, surface tension, interfacial tension, contact angle and viscosity were measured and phase behavior study was performed. Also dual function characteristics of betaine zwitterionic surfactant were investigated by measuring an isoelectric point using QCM(quartz crystal microbalance) and zeta potential measurement. The CMC of betaine surfactant was near $10^{-4}mol/L$ and the surface tension at CMC was about 32 mN/m. The interfacial tension between 1 wt% aqueous solution and n-decane measured by spinning drop tensiometer at pH 2~10 resulted in an increase in interfacial tension until pH 5 and a decrease with pH after 5 and equilibration time showed the similar trend with an increase in pH. The isoelectric point of betaine surfactant measured by QCM experiment was found to exist between 3.0 and 3.3, which is the same as the result determined by zeta potential measurement.

• Applied Chemistry for Engineering
• /
• v.20 no.1
• /
• pp.9-14
• /
• 2009

A zwitterionic surfactant shows not only detergency but also softening effect since it shows characteristics of a nonionic or an anionic surfactant above an isoelectric point, while showing characteristics of a cationic surfactant below an isoelectric point. Therefore, a zwitterionic surfactant can serve as a dual function surfactant by a single molecule through the interconversion of cleaning and softening effects depending on pH of the aqueous solution. In this study, the dual function characteristics of an amine oxide zwitterionic surfactant were investigated by measuring the zeta potential and the isoelectric point using quartz crystal microbalance (QCM). In addition, the physical properties of an amine oxide surfactant such as critical micelle concentration, surface tension, interfacial tension, contact angle and viscosity were measured and phase behavior study was also performed. The isoelectric point of an amine oxide surfactant determined by zeta potential measurement was near 7.35 and that obtained by QCM experiment was about 7.4, where both results were found to be close to the value reported in the literature.

• Journal of the Korean Applied Science and Technology
• /
• v.21 no.3
• /
• pp.238-245
• /
• 2004

The interaction between anion and zwitterionic surfactants was investigated by means of surface tension, NMR spectroscopy, and fluorescence studies. These systems are N-tetradecyloxymethyl-N,N-dimethyl betaine ($C_{14}$, TDB), N-octadecyloxymethyl-N,Ndimethyl betaine ($C_{18}$, ODB), and sodium dodecylethoxy sulfate (SDE). These systems show a composition dependency in micellar properties. When the molar fraction of TDB and ODB was about 0.6, the cmc values of these systems showed minima, whereas the solubilized amount of a water insoluble dye, NMR line width showed maxima. These changes comes from the intramolecular complexes formed in the mixed micelles. The complexes are due to the electrostatic interaction of oppositely charged head groups of betaine and sodium dodecylethoxy sulfate. A comparison of betaine and SDE alkyl methylene group line widths to those of n-methyl group indicates that the interior of the micelle in the restricted region is more immobile than the head group.

• Korean Chemical Engineering Research
• /
• v.50 no.3
• /
• pp.455-463
• /
• 2012

In this study, the measurement of physical properties of ethylene oxide-propylene oxide adducted zwitterionic surfactants were measured such as critical micelle concentration, surface tension, interfacial tension, contact angle, viscosity and foam stability. Also, the dual function characteristics of a zwitterionic surfactant were investigated by determining an isoelectric point, which were obtained using zeta potential measurement and QCM (quartz crystal microbalance) experiments. The isoelectric point of DEP-OSA82-AO zwitterionic surfactant determined by zeta potential measurement was close to that obtained by QCM experiment and both results have shown almost the same trend as that determined by the frictional property measured using an automated mildness tester. In particular, it has been observed that DEP32-OSA82-AO and DEP34-OSA82-AO surfactants provide better softening effect at a pH of acidic or neutral condition than at an alkaline condition. This result indicates that both surfactants act as a cationic surfactant at a pH of acidic or neutral condition and thus provide good softening effect during a rinsing cycle in the detergency process.

• Applied Chemistry for Engineering
• /
• v.23 no.1
• /
• pp.112-118
• /
• 2012

In this study, physical properties of synthesized DE7-OSA82-AO and DEP52-OSA82-AOQ82 zwitterionic surfactants were measured such as critical micelle concentration, surface tension, interfacial tension, contact angle and viscosity. Phase behavior study was also performed. The dual function characteristics of a zwitterionic surfactant were investigated by determining an isoelectric point, which was attained using zeta potential measurements and QCM (quartz crystal microbalance) experiments. The isoelectric point of DE7-OSA82-AO surfactant determined by the zeta potential measurement and QCM experiment was about 7.2 and 7.4, respectively. On the other hand, the isoelectric point of DEP52-OSA82-AOQ82 surfactant determined by the zeta potential measurement and QCM experiment was about 10.9 and 11.0, respectively. The frictional property measured using an automated mildness tester showed that DE7-OSA82-AO surfactant can provide a good softening effect at an acidic or neutral condition. On the other hand, DEP52-OSA82-AOQ82 was found to provide a good softening effect to a fabric surface at a pH below its isoelectric point of 11.

• Korean Chemical Engineering Research
• /
• v.50 no.6
• /
• pp.960-968
• /
• 2012

In this study, the measurement of physical properties of 3 different ethylene oxide adducted zwitterionic surfactants were measured such as critical micelle concentration, surface tension, interfacial tension, contact angle, viscosity and foam stability. Also, the dual function characteristics of the zwitterionic surfactants were investigated by determining an isoelectric point, which were obtained using zeta potential measurement and QCM (quartz crystal microbalance) experiments. The isoelectric point of the synthesized zwitterionic surfactant determined by zeta potential measurement was close to that obtained by QCM experiment and both results have shown almost the same trend as that determined by the frictional property measured using an automated mildness tester. In particular, it has been observed that all three surfactants used during this study provide better softening effect at a pH of neutral condition than at an acidic or an alkaline condition. This result indicates that the synthesized surfactants act as a cationic surfactant at a pH of neutral condition and thus provide good softening effect during a rinsing cycle in the detergency process.

• Applied Chemistry for Engineering
• /
• v.27 no.3
• /
• pp.291-298
• /
• 2016

In this study, zwitterionic surfactants were added to liposome systems at different pH conditions to understand the effect of surfactants on liposome characteristics. For this purpose, amine oxide surfactants having different hydrocarbon chain lengths were synthesized and the structure of the resulting product was elucidated by using $^1H$ NMR, $^{13}C$ NMR, and FT-IR. In addition, the physical properties of newly synthesized surfactants such as critical micelle concentration (CMC), surface tension and isoelectric point were measured. The stability characteristics of liposome systems including average particle sizes and zeta potentials were measured by varying pH and hydrocarbon chain lengths of an amine oxide surfactant. Effects of the pH and hydrocarbon chain length of an amine oxide surfactant on fluidity of a liposome membrane were also examined by measuring the deformability and the binding degree between the surfactant and liposome.

• Journal of the Korean Applied Science and Technology
• /
• v.31 no.4
• /
• pp.612-622
• /
• 2014

In this study, we investigated the solubilization 4-chlorobenzoic acid in a wide range of temperature using a zwitterionic surfactant of lauryl sulfobetaine(LSB) and mixed surfactant systems. The effects of temperature and alkyl-group's length of surfactant molecule on the solubilization of 4-chlorobenzoic acid have been measured. The solubilization constants ($K_s$) were taken by the UV/Vis spectrophotometric method, plotting the total absorbance of the solution versus the surfactant concentration. The results show that the values of ${\Delta}G^o_s$ are all negative within the measured temperature range and decrease by increasing temperature, And also the measured values of ${\Delta}H^o_s$ and ${\Delta}S^o_s$ are all positive and increase by increasing temperature. The values of $K_s$ and thermodynamic parameters are simultaneously dependent on the temperature and the kinds of surfactant molecules. From the results we can postulate the solubilization site of 4-chlorobenzoic acid within the micelle.