• Journal of IKEEE
• /
• v.24 no.2
• /
• pp.435-440
• /
• 2020

ZnO:Al films with about 500 nm thick were prepared by RF magnetron sputtering. The ZnO:Al films were annealed at 100 ℃, 200 ℃, 300 ℃, and 400 ℃ for 10 h, respectively. The resistivity, carrier concentration, and mobility variation of ZnO:Al films with heat treatments were measured. The causes of the resistivity variation of ZnO:Al films with heat treatments were investigated by utilizing the results of x-ray diffraction and field emission scanning electron microscope. The energy band gap, Urbach energy, and refractive index were obtained from the transmittance of ZnO:Al films. The change in electrical properties of the ZnO:Al film was explained in relation to the optical properties.

• Journal of the Korean Crystal Growth and Crystal Technology
• /
• v.16 no.2
• /
• pp.59-65
• /
• 2006

Al-doped and F-doped ZnO (ZnO : Al & ZnO : F) thin films were coated onto glass substrate by sol-gel method. These films showed c-axis orientation in common, but different I(002)/[I(002) + I(101)] and FWHM (full width at half-maximum). In particular, the grain size of the ZnO : Al films decreased with the increase in the Al-doping concentration, while for the ZnO : F films the grain siae increased up to F 3 at% and then decreased. For the electrical properties, Hall effect measurement was used. The resistivity of the ZnO : Al films and the ZnO : F films were, respectively, $2.9{\times}10^{-2}{\Omega}cm$ at Al 1 at% and $3.3{\times}10^{-1}{\Omega}cm$ at F 3 at%. Moreover compared with ZnO:Al films, ZnO:F films have lower carrier concentration (ZnO : Al $4.8{\times}10^{18}cm^{-3}$, ZnO : F $3.9{\times}10^{16}cm^{-3}$) and higher mobility (ZnO : Al $45cm^2/Vs$, ZnO : F $495cm^2/Vs$). For average optical transmittances, ZnO : Al thin films have $86{\sim}90%$ and ZnO : F films have $77{\sim}85%$ comparatively low.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2009.11a
• /
• pp.106-106
• /
• 2009

Al-doped ZnO (AZO) thin films were grown on glass substrates by co-sputtering at room temperature. We made ZnO and Al target and ZnO:Al film is deposited with sputter which has two RF gun source. The Al content was controlled by varying Al RF power and effect of Al contents on the properties of ZnO:Al film was investigated. Crystallinity and orientation of the ZnO:Al films were investigated by X-ray diffraction (XRD), surface morphology of the ZnO:Al films was observed by atomic force microscope. Electrical properties of the ZnO:Al films were measured at room temperature by van der Pauw method and hall measurement. Optrical properties of ZnO:Al films were measured by UV-vis-NIR spectrometer.

• 한국신재생에너지학회:학술대회논문집
• /
• 2005.11a
• /
• pp.568-571
• /
• 2005

Highly transparent ZnO films with low resistivity for thin film solar cell applications were fabricated at low temperature by rf magnetron sputtering. Al-doped ZnO films were deposited on glass substrates at a substrate temperature of $200^{\circ}C$. electrical and optical properties of the ZnO:Al films were investigated in terms of the reparation conditions. The transmittance of the ZnO:Al films in the visible range is 90 %. The lowest resistivity of the ZnO:Al films is about $5.7\times10^{-4}$ $\Omega$ cm at the Al content of 2.5 wt% with the film thickness of 500 nm. After deposition, the smooth surface of ZnO:Al films were etched in diluted HCl (0.5%) to investigate the variation of electrical and surface morphology properties due to an textured surface.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2008.11a
• /
• pp.235-236
• /
• 2008

Wet etched ZnO:Al films for thin film solar cells were prepared by Facing Target sputtering(FTS) method. Wet etching has been used to produce a rough TCO surface that enables light trapping in the absorber. The ZnO:Al films for thin film solar cells were etched by HCl 0.5%. The etching performance of ZnO:Al films can be tuned by changing etching time. The etched ZnO:Al films compared to a smooth ZnO:Al thin film structure. From the results, the lowest resistivity of deposited films was $5.67\times10^{-4}$ [$\Omega$-cm] and the transmittance of all ZnO:Al thin films were over 80% in visible range.

• Journal of the Korean Vacuum Society
• /
• v.22 no.1
• /
• pp.20-25
• /
• 2013

ZnO:Al thin films deposited by RF magnetron sputtering were post-annealed and the electrical and optical properties of ZnO:Al thin films were investigated before and after anneling. We confirmed that the ZnO:Al thin film was affected by post-annealing temperature. As post-annealing temperature increases, crystallinity and transmittance in visible area (400~800 nm) of ZnO:Al thin films decreased. While sheet resistance of thin films increased sharply with increasing to $400^{\circ}C$. This result is due to reduce of carrier concentration caused by absorption of $O_2$ or $N_2$ at surface of thin film.

• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.18 no.2
• /
• pp.116-119
• /
• 2005

Al doped ZnO thin films (ZnO:Al) were deposited on poly carbonate (PC) substrate by rf magnetron sputtering. In addition, the electrical, optical properties of the films prepared at various conditions were investigated. As the sputter power increased, the resistivity of ZnO:Al films decreased, regardless of substrate types. However, the resistivity of the films increased with the sputter pressure. The ZnO:Al films were increasingly dark gray colored as the sputter power increased, resulting in the loss of transmittance. High quality films with resistivity as low as 1.43${\times}$10$^{-4}$ Ω-cm and transmittance over 80 % have been obtained by suitably controlling the deposition parameters.

• Korean Journal of Materials Research
• /
• v.16 no.7
• /
• pp.449-454
• /
• 2006

Al-doped zinc oxide (ZnO:Al) films for transparent electrodes in thin film solar cells were deposited on glass substrates at a low temperature of $200^{\circ}C$ by rf magnetron sputtering. The transmittance of the ZnO:Al films in the visible range was 87%. The lowest resistivity of the ZnO:Al films was about $5.8{\times}10^{-4}{\Omega}$ cm at the Al content of 2.5 wt%. After deposition, the surface of ZnO:Al films were etched in dilute HCl (0.5%) for the investigation of the change in the electrical properties and the surface morphology due to etching.

• Journal of the Korean Ceramic Society
• /
• v.33 no.2
• /
• pp.149-154
• /
• 1996

ZnO and Al-doped ZnO thin films were prepared by sol-gel dip-coating method and electrical and optical properties of films were investigated. Using the zinc acetate dihydrate and acetylaceton(AcAc) as a chelating agent stable ZnO sol was synthesized with HCl catalyst. Adding aluminium chloride to the ZnO sol Al-doped ZnO sol could be also synthesized. As Al contents increase the crystallinity of ZnO thin film was retarded by increased compressive stress in the film resulted from the difference of ionic radius between Zn2+ and Al3+ The thickness of ZnO and Al-doped ZnO thin film was in the range of 2100~2350$\AA$. The resistivity of ZnO thin films was measured by Van der Pauw method. ZnO and Al-doped ZnO thin films with annealing temperature and Al content had the resistivity of 0.78~1.65$\Omega$cm and ZnO and Al-doped ZnO thin film post-annealed at 40$0^{\circ}C$ in vacuum(5$\times$10-5 torr) showed the resistivity of 2.28$\times$10-2$\Omega$cm. And the trans-mittance of ZnO and Al-doped ZnO thin film is in the range of 91-97% in visible range.

• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.21 no.3
• /
• pp.242-248
• /
• 2008

The structural, optical and electrical properties of ZnO films doped with 1.5 at% of 3A materials(B, Al, Ga, In) were studied by sol-gel process. The films were found to be c-axis (002) oriented hexagonal structure on glass substrate, when post heated at 500 $^{\circ}C$. The surface of the films showed a uniform and nano size microstructure and the crystalline size of doped films decreased. The lattice constants of ZnO:B/Al/Ga increased than that of ZnO, while ZnO:In decreased. All the films were highly transparent(above 90 %) in the visible region. The energy gaps of ZnO:B/Al/Ga were increased a little, but that of ZnO:In was not changed. The resistivities of ZnO:Al/Ga/In were less than 0.1 $\Omega$cm. All the films showed a semiconductor properties in the light or temperature, however ZnO:In was less sensitive to it. A figure of merit of ZnO:In had the highest value of 0.025 $\Omega^{-1}$ in all samples.