• 한국신재생에너지학회:학술대회논문집
• /
• 2008.05a
• /
• pp.221-224
• /
• 2008

We made densified wood pellet by hemp woody core as replacing wood resource. Hemp was separated into the bast fiber and the woody core by hot steaming treatment. The hemp woody core had a similar lignin content and carbohydrate composition with hardwood. Also, the hemp had a low ash content, which resulted in a low ash formation in pellet burning. Heating value of the hemp pellet had a very similar to the pellet made by hardwoods. The hemp woody core can replace hardwood for densified wood pelletmaking.

• 한국신재생에너지학회:학술대회논문집
• /
• 2007.06a
• /
• pp.713-716
• /
• 2007

Interests have been focused to the renewable energy because energy cost of fossil fuel increased and global climate change caused by CO2 evolution became severe. To overcome these problems, it is essential to develop the energy conversion technologies of renewable resources. Therefore, production and utilization state of wood and woody waste was firstly investigated and then various technologies (pyrolysis, gasification, and combustion) converting the wood and woody waste to energy were summarized. Some case studies of woody waste utilization in europe was introduced with the policy of EU countries. Economical aspect of woody waste was compared with the current fossil fuels and the energy policy of wood and woody waste was suggested.

• Journal of the Korean Wood Science and Technology
• /
• v.20 no.1
• /
• pp.5-14
• /
• 1992

Experimental external collector type solar lumber dryer of $1m^3$ of maximum capacity with $1.6m^3$ of collector area was designed and constructed. The seasonal performance of solar dryer, including air-conditions, energy efficiency, and drying characteristics of 3cm-thick red pine and douglas-fir lumber was investigated. Also, the economic analysis was carried out. Annual average solar drying rate was about 2 times faster than air-drying rate with no significant difference in the amount of drying defects. But in initial drying stage air-drying rate in winter was much faster and those in spring and autumn were slightly slower than solar drying rate in each season. Annual average energy efficiency of solar-dryer and-collector was 25% and 57%, respectively. Fuel savings were over 50% at 15% of energy inflation rate and the payback period was estimated as 6.10 years at 30% of energy inflation rate.

• Journal of the Korean Wood Science and Technology
• /
• v.45 no.3
• /
• pp.258-267
• /
• 2017

In this study, pitch pine (Pinus rigida, PIR) and Mongolian oak (Quercus mongolica, QUM) pellets were fabricated with bark or/and drying waste liquor (DWL) of larch (Larix kaempferi, LAK) as an additive. Based on the results of fuel characteristics of the pellets, optimal conditions for producing the high-quality pellets were provided. In the analysis of chemical composition, bark contained holocelluose and lignin of 90% and over. DWL had 0.1% solid assumed to sugars which are generated from the oven-drying of LAK logs. QUM showed high ash content (2.2%) by containing of bark in the sawdust. Bark and DWL of LAK had high ash content of 4% and over. Calorific values of all specimens and additives were higher than that of the $1^{st}$-grade standard of wood pellets designated by NIFOS (18.0 MJ/kg). PIR and QUM pellets were fabricated with additive of 2 wt% based on the solid weight of oven-dried sawdust using a piston-type flat-die pelletizer, and thus ash content and calorific value of the pellets did not affect by the use of additive. Durability of the pellets increased with the use of additive. Durabilties of pellets, which were fabricated with bark as an additive and DWL as a controller of moisture content for sawdust, did not differ from those of pellets without additives and were lower than those of pellets either with bark or DWL. However, use of both bark and DWL for the production of wood pellets might be favorable because it can make a profit from the collection process of DWL. Based on the results of fuel characteristics of the pellets, QUM and PIR pellets were produced by a flat-die pelletizer. Moisture content (MC), bulk density and durability of the pellets improved with the use of additive. Particularly, sawdust MC of 10% and the addition of bark or DWL for PIR as well as sawdust MC of 12% and the addition of bark for QUM might be optimal conditions for the production of high-quality pellets. Except for the ash content of QUM pellets, other properties of PIR and QUM pellets exceeded the $1^{st}$-grade wood pellets standards of NIFOS.

• Environmental and Resource Economics Review
• /
• v.19 no.3
• /
• pp.597-632
• /
• 2010

There is general agreement that global warming is occurring and that the main contributor to this probably is the buildup of green house gasses, GHG, in the atmosphere. Two main contributors are the utilization of fossil fuels and the deforestation of many regions of the world. The burning of fossil fuels increases atmospheric carbon while the burning of fuel-wood reducing fossil fuel consumption along with its forest source maintain an atmospheric carbon level. The standing timber in the forests is a carbon sink, as are wood buildings and structures, and fossil fuel in the ground. This paper is designed to examine a number of current issues related to mitigating the global warming problem through forestry. For this purpose, we develop a modeling approach by integrating timber market, fossil fuel market and carbon cycling model. We use discrete time optimal control theory to identify optimal time paths, the laws of motion, and stationary stats solutions of endogenous variables in the model. On the basis of these results, we identify the optimal amounts of subsidies to be provided or taxes to be imposed by the regulatory agency to mitigate atmospheric carbon accumulation. We also present a numerical example to help illustrate the characteristics of variables in the model when the social cost for atmospheric carbon incrementally shifts upward. A surprising result is that the social cost function for atmospheric carbon has a very smaller impact on the optimal rotation period than previous literature suggested.

• Clean Technology
• /
• v.24 no.4
• /
• pp.323-331
• /
• 2018

The results of an experimental investigation on the co-firing characteristics and slagging behavior of dried and hydrothermal carbonization sewage sludge, sub-bituminous coal, and wood pellet in a fluidized bed were presented. Combustion tests were conducted in a lab-scale bubbling fluidized bed system at the uniform fuel-air equivalence ratio, air flow rate, and initial bed temperature to measure bed temperature distribution and combustion gas composition. 4 different fuel blending cases were prepared by mixing sewage sludge fuels with coal and wood pellet with the ratio of 50 : 50 by the heating value. $NO_x$ was mostly NO than $NO_2$ and measured in the range of 400 to 600 ppm in all cases. $SO_2$ was considered to be affected mostly by the sulfur content of the sewage sludge fuels. The cases of hydrothermal carbonization sewage sludge mixture showed slightly less $SO_2$ emission but higher fuel-N conversion than the dried sewage sludge mixing cases. The result of fly ash composition analysis implied that the sewage sludge fuels would increase the possibility of slagging/fouling considering the contents of alkali species, such as Na, K, P. Between the two different sewage sludge fuels, dried sewage sludge fuel was expected to have the more severe impact on slagging/fouling behavior than hydrothermal carbonization sewage sludge fuel.

• 한국연소학회:학술대회논문집
• /
• 2013.06a
• /
• pp.19-20
• /
• 2013

The cofiring of renewable fuel in coal fired boilers is an attractive option to mitigate $CO_2$ emissions, since it is relatively low cost option for efficiently converting renewable fuel to electricity by adding biomass as partial substitute of coal. However, it would lead to reduce plant efficiency and flexibility in operation, and increase operation cost and capital cost associated with renewable fuels handling and firing equipment. The aim of this study is to investigate reduction of carbon dioxide at varying percentage of biomass in fuel blend to the boiler biomass, and estimate operation and capital cost. Wood pellet, PKS (palm kernel shell), EFB (empty fruit bunch) and sludge are considered as a renewable fuels for a cofiring with coal. Several approaches by the cofiring ratio are chosen from past plant demonstrations and commercial cofiring operation, and they are evaluated and discussed for CO2 reduction and cost estimation.

• Solar Energy
• /
• v.18 no.3
• /
• pp.161-167
• /
• 1998

The effects of some additives(black liquor, wood and lignin) on the conversion of coal and product were investigated in the lab-scale, high pressure reacting system around $375^{\circ}C$. The addition of lignin to coal during liquefaction significantly increased the depolymerization of coal and enhanced the quality of the liquid products. Coprocessing of wood and coal at $400^{\circ}C$ increased yield of liquid product about 8%, but higher temperature above $400^{\circ}C$ reduced liquid product due to increase of gas products. The addition of black liquor resulted in an enhancement in coal conversion yields, however, the observed increase is lower than that obtained in the presence of NaOH because lignin present in black liquor is not very effective due to the $OH^-$ presence.

• Journal of the Korean Wood Science and Technology
• /
• v.35 no.1
• /
• pp.1-10
• /
• 2007

This study was reviewed on the bioethanol production from biomass resources and feedstock supply in America. U.S. Department of Energy (USDE) and the u.s. Department of Agriculture USDA) are both strongly committed to expand the role of biomass as an energy source. They support biomass fuels and products as a way to reduce the need for oil and gas imports, to strengthen the nation's energy security and environmental quality. And it was envisioned a 20 percent replacement of the current U.S.transportation fuel consumption in 2030. Also it was reviewed policies to encourage the expanding of Bio-based fuel use to replace gasoline, such as Clean Air Act, Federal Clean Fuel Program and American Jobs Creation Act. In feedstock supply it was assumed forest biomass will be supplied in 368 million dry tons yearly and the agriculture derived biomass adopted by new technologies and land use change will be supplied in 998 million dry tons, including highly 818 million dry tons of lignocellulosic biomass such as perenial crops (hybrid trees, grasses) corn stover, other crop residues. This amount is 5 times to the amount from based current agricultural technology and crop land.

• Journal of the Korean Society of Industry Convergence
• /
• v.22 no.2
• /
• pp.163-171
• /
• 2019

Recently, rural housing in urban areas has been increasing due to the improvement of income level. With the increase of the construction of the power house, the installation of the heating system using the harmonious fuel for the purpose of heating and the beauty of the room is increasing rapidly. In addition to the increasing use of firewood heating equipment, the incidence of fire is also increasing. Analysis of the National Fire Data System of the Fire Department The result of the analysis of the National Fire Data System Many parts of the fire are incinerated by the accumulation of tar due to the incompleteness of periodic cleaning inside the cylinder. The distance between the fire extinguisher and the combustible materials such as ceiling, Resulting in fire. In addition, it was found that much of the fire of the firewood heating system in the time zone occurs during the sleeping and resting time and there is not enough time for the residents to cope. This, in turn, causes serious harm to the lives and property of the users of the pyrotechnic heating system. Therefore, in this study, domestic and foreign standards and laws related to fuel oil heating facilities were analyzed and 12 cases of fire accidents were analyzed. Through the revision of the fire prevention and firefighting facilities installation and maintenance law, the installation standards of the alarm and fire extinguishing facilities were presented.