• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.33 no.4A
• /
• pp.352-360
• /
• 2008

Recently Task Group (TG) 4 of the Institute of Electrical and Electronics Engineers (IEEE) 802.15a has been recommended a system with ranging capability in existence of multiple Simultaneous operating piconets (SOPs) as well as low-cost, low-power. According to the ranging service, coherent and non-coherent based ranging schemes using ternary code have been adopted as a standard. However it is hard to estimate an accurate time of arrival (TOA) in case of using direct sequence based TOA estimation method because pulse repetition interval (PRI) offered by TG is more limited than the maximum excess delay (MED) of channel. To mitigate inter pulse interference (IPI) problem, this paper proposes a non-coherent TOA estimation scheme using non-periodic transmission (NPT) pattern. The proposed receiver is based on a non-coherent energy detection considering with motivation of low rate wireless personal area network (LR-WPAN). TOA information is estimated via proper comparison with a prescribed threshold after the sliding correlation and search back window (SBW) process for reducing TOA error. To verify the performance of proposed ranging scheme, two distinct channel models approved by IEEE 802.15.4a TG are considered. According to the simulation results, we could conclude that the proposed scheme have performed better performance than the conventional method on the existence of multiple SOPs.

• Journal of the Institute of Electronics and Information Engineers
• /
• v.53 no.5
• /
• pp.25-36
• /
• 2016

The goal of the SmartGrid is to maximize energy efficiency by exchanging bi-directional real-time power information with the help of ICT(Information and Communication Technology). In this paper, we propose a "JRS-MS" (Joint Routing and Scheduling for Multi-channel SmartGrid) algorithm that uses numerical modeling methods in IEEE 802.11s based STDMA multi-channel SmartGrid NAN networks. The proposed algorithm controls the amount of data transmission adaptively at the link layer and finds a high data-rate path which has the least interference between traffic flows in multi-channel SmartGrid NAN networks. The proposed algorithm improve transmission performance by enhancing network utilization. By comparing the results of performance analysis between the proposed algorithm and the JRS-SG algorithm in the previous paper, we showed that the JRS-MS algorithm can improve transmission performance by maximally utilizing given network resources when the number of flows are increasing in the multi-hop NAN wireless mesh networks.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.38C no.3
• /
• pp.239-246
• /
• 2013

The IEEE 802.15.4 offers standard about PHY and MAC layer and features low power, low bandwidth, and low speed data communication. Because of this reason, IEEE 802.15.4 is only within a limited range such as sensor detection and home network; nevertheless, the research about transmission multimedia data like voice packet through wireless sensor networks is conducted widely. In this paper, we proposed the group communication system based on the sensor network. TDMA/TDD MAC based on the IEEE 802.15.4 PHY for voice communication on the sensor network is designed by improvement existing peer-to-peer voice communication on the sensor network and hardware is implemented for group communication. To measure the quality of designed system, mean opinion score (MOS) is obtained from the experiment and verified by using sine wave method. As a result of an experiment, we expect that a many cases of application solution can be developed using presented system.

• Journal of the Institute of Convergence Signal Processing
• /
• v.16 no.2
• /
• pp.56-62
• /
• 2015

In this study, we implemented an unconstraint ECG monitoring system on a chair. Nowadays, modern people spend most of their time sitting on the chair. Therefore, it is necessary to have an unconstraint ECG monitoring system that can be used for a long time. The implemented system can perform measurement even with clothes on and it has great advantage on motion artifacts. A pair of unconstraint electrodes are placed on the back of the chair. Amplifier and filters are designed to remove motion artifacts, The baseline noise and power line noise are filtered and very low level of bio-signal is amplified to give a final measurement. Control unit and wireless transmission unit are implemented. Analog signal is converted into digital signal and transmits biological signal to the PC and the smart phone. Therefore continuous ECG monitoring in daily life is made possible. A comparison experiment between Ag / AgCl electrode and unconstraint electrode is conducted to evaluate the performance of the implemented system. As a result, we confirm our unconstraint system can be used for daily life ECG monitoring.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.29 no.6
• /
• pp.449-456
• /
• 2018

Herein, several multibeam forming methods that can be applied to microwave wireless power transmission are presented. Because the conventional multibeam forming methods do not consider an active element pattern(AEP), an intended beam shape will contain a steering angle error when applied to an actual system. To solve this problem, a method of considering the average of the AEP and a method of considering all the AEPs by the modified Fourier series method have been proposed. We confirmed that the proposed method reduces the error with the intended beam shape in the multibeam formation. In addition, for the side lobe level(SLL) and null control, a method of multibeam forming by applying the superposition principle to the Dolph-Tschebyscheff method is proposed. We also confirmed that SLL control can be simultaneously achieved with the multibeam formation.

• The Journal of The Korea Institute of Intelligent Transport Systems
• /
• v.15 no.1
• /
• pp.95-101
• /
• 2016

Vehicular communications is system which can be applied for transmission of various safety messages or Intelligent Transportation Systems(ITS) applications by combining vehicle/road technology with Information and Communication Technology(ICT). In recent years, a variety of ITS services are available such as driving information, road conditions, V2X messages as well as navigation and traffic jams notification. In general, vehicular communications can be used for vehicle-to-vehicle and vehicle-to-infrastructure communication by adopting IEEE802.11p/1609 standard which is commonly known as wireless access in vehicular environments. In this paper, WAVE communication standard based on the IEEE802.11p is explained and signal characteristics in WAVE communication is introduced. Also, The H/W and S/W characteristics in Road Side Station and On Board Equipment for the Vehicle to Everything communication are analyzed. Received Signal Strength which is power of receiving signal of communication equipment is measured in test road to estimate the real WAVE communication's performance. It is shown that the implemented WAVE communication technology is satisfactory to provide ITS services.

• KSII Transactions on Internet and Information Systems (TIIS)
• /
• v.10 no.9
• /
• pp.4549-4567
• /
• 2016

To cope with the complex electromagnetic environment of wireless communication systems, anti-jamming decision methods are necessary to keep the reliability of communication. Basing on the rule-reduced genetic algorithm (RRGA), an anti-jamming decision method is proposed in this paper to adapt to the fast channel variations. Firstly, the reduced decision rules are obtained according to the rough set (RS) theory. Secondly, the randomly generated initial population of the genetic algorithm (GA) is screened and the individuals are preserved in accordance with the reduced decision rules. Finally, the initial population after screening is utilized in the genetic algorithm to optimize the communication parameters. In order to remove the dependency on the weights, this paper deploys an anti-jamming decision objective function, which aims at maximizing the normalized transmission rate under the constraints of minimizing the normalized transmitting power with the pre-defined bit error rate (BER). Simulations are carried out to verify the performance of both the traditional genetic algorithm and the adaptive genetic algorithm. Simulation results show that the convergence rates of the two algorithms increase significantly thanks to the initial population determined by the reduced-rules, without losing the accuracy of the decision-making. Meanwhile, the weight-independent objective function makes the algorithm more practical than the traditional methods.

• The KIPS Transactions:PartD
• /
• v.10D no.3
• /
• pp.359-366
• /
• 2003

Although the reuse of the cached data for scrolling the map reduces the amount of passed data between client and server, it needs the conversions of data coordinates, selective deletion of objects, cache compaction and object structuring step in the clients. The conversion is a time- intensive operation due to limited resources of mobile phones such as low computing power, small memory. Therefore, in order to control the map efficiently in the vector map service based mobile phones, it is necessary to study the methods which reuse cached objects for reducing wireless network bandwidth and overwhelming the limited resources of mobile phones as well. This paper proposes the methods of reusing pre-received spatial objects for map control in the mobile vector map service system based on client-server architecture. The experiments conducted on the Web GIS systems with real data show that the proposed method is appropriate to map services for mobile phone. We also analyze the advantages and drawbacks between the reuse of cached data and transmission of raw data respectively.

• Journal of KIISE
• /
• v.42 no.6
• /
• pp.807-816
• /
• 2015

The Internet of Things (IoT) has recently been showered with much attention worldwide. Various kinds of devices, communicating with each other in the IoT, demand multiple communication technologies to coexist. In this environment, mobile devices may utilize the vertical handover between different wireless radio interfaces such as Wi-Fi and Bluetooth, for efficient data transfer. In this paper, an IoT broker is implemented to support the vertical handover, which can also support and manage heterogeneous devices and communication interfaces. The handover is activated based on RSSI, Link Quality values, and real time traffic. The experimental results show that the proposed handover system substantially improves QoS in Bluetooth and reduces power consumption in mobile devices as compared with a system using only Wi-Fi.

• The Journal of the Institute of Internet, Broadcasting and Communication
• /
• v.14 no.2
• /
• pp.73-79
• /
• 2014

Visible light communication is a communication method using an LED having a high-speed ON / OFF rate data to be transmitted, it is used as a wireless high speed data transmission. VLC system evolves, the problem of basic research is intended to improve performance and ensure reliability of the communication. The nature of the visible light communication, communication is performed only in the reach of the light, which indicates a big difference by the emission angle of the light. Therefore, in this paper, in the case of indoor environments generally, with the attributes of the multiple LED is equipped, was applied to a MIMO (Multiple Input Multiple Output) communication system. and analyzed SNR performance and total power can be obtained on the reception side by changing the emission angle of the transmitter. As a result of the simulation was run against this, it was confirmed that there is a significant impact on the performance of BER and SNR performance by the emission angle of the transmitter.