• Journal of the Korean Solar Energy Society
• /
• v.30 no.4
• /
• pp.79-85
• /
• 2010

The uncertainty in WindCube LIDAR measurements, which are specific to wind profiling at less than 200m above ground levelin wind resource assessments, was analyzed focusing on the error caused by its volume sampling principle. A two-month SODAR measurement campaign conducted in an urban environment was adopted as the reference wind profile assuming that various atmospheric boundary layer shapes had been captured. The measurement error of LIDAR at a height z was defined as the difference in the wind speeds between the SODAR reference data, which was assumed to be a virtually true value, and the numerically averaged wind speed for a sampling volume height interval of $z{\pm}12.5m$. The pattern of uncertainty in the measurement was found to have a maximum in the lower part of the atmospheric boundary layer and decreased with increasing height. It was also found that the relative standard deviations of the wind speed error ratios were 6.98, 2.70 and 1.12% at the heights of 50, 100 and 150m above ground level, respectively.

• Journal of Wind Energy
• /
• v.14 no.3
• /
• pp.5-13
• /
• 2023

Floating LiDAR systems (FLSs) are used in many countries because they are easier to install than stationary weather towers, have low maintenance costs, and can be installed in deep sea areas. However, FLSs are rarely used in Korea due to a lack of clear evaluation criteria to verify the reliability and uncertainty of their measurements. This study is the first to verify the reliability of FLSs in Korea with one-year simultaneous observation of six lidar systems - two fixed and four floating systems - in sea areas of Gunsan and Yeonggwang. The reliability of FLSs measurement data was verified by comparison between fixed and floating systems. Moreover, differences between existing wind resource maps and the data observed from the six points were analyzed and wind resource maps were calibrated. The results show a return rate of more than 95 % of the observed data and strong correlations between fixed and floating systems (average R2 of 0.977). Additionally, errors in wind speed predictions to produce a wind resource map could be significantly reduced from 5.7 % to 0.6 % after calibrations with the observation data.

• Journal of the Korean Solar Energy Society
• /
• v.36 no.1
• /
• pp.27-37
• /
• 2016

A simple but practical Ensemble Prediction System(EPS) for wind power forecasting was developed and evaluated using the measurement of the offshore meteorological tower, HeMOSU-1(Herald of Meteorological and Oceanographic Special Unite-1) installed at the Southwest Offshore in South Korea. The EPS developed by the Korea Institute of Energy Research is based on a simple ensemble mean of two Numerical Weather Prediction(NWP) models, WRF-NMM and WRF-ARW. In addition, the Kalman Filter is applied for real-time quality improvement of wind ensembles. All forecasts with EPS were analyzed in comparison with the HeMOSU-1 measurements at 97 m above sea level during Typhoon Bolaven episode in August 2012. The results indicate that EPS was in the best agreement with the in-situ measurement regarding (peak) wind speed and cut-out speed incidence. The RMSE of wind speed was 1.44 m/s while the incidence time lag of cut-out wind speed was 0 hour, which means that the EPS properly predicted a development and its movement. The duration of cut-out wind speed period by the EPS was also acceptable. This study is anticipated to provide a useful quantitative guide and information for a large-scale offshore wind farm operation in the decision making of wind turbine control especially during a typhoon episode.

• 한국신재생에너지학회:학술대회논문집
• /
• 2009.11a
• /
• pp.453-455
• /
• 2009

The wind speed measurement is performed using SODAR and LIDAR to evaluate availability of remote sensing in assessment of wind resource. The intercomparison comprises time series, correlation analysis and recovery rate. It shows that LIDAR is more effective than using SODAR to measure wind speed in ambient disturbance.

• Journal of the Korean Solar Energy Society
• /
• v.33 no.5
• /
• pp.1-8
• /
• 2013

Wind resource data of short-term period has to be corrected a long-term period by using MCP method that Is a statistical method to predict the long-term wind resource at target site data with a reference site data. Because the field measurement for wind assessment is limited to a short period by various constraints. In this study, 2 different MCP methods such as Linear regression and Matrix method were chosen to compare the predictive accuracy between the methods. Finally long-term wind speed, wind power density and capacity factor at the target site for 20 years were estimated for the variability of wind and wind energy. As a result, for 20 years annual average wind speed, Yellow sea off shore wind farm was estimated to have 4.29% for coefficient of variation, CV, and -9.57%~9.53% for range of variation, RV. It was predicted that the annual wind speed at Yellow sea offshore wind farm varied within ${\pm}10%$.

• 한국신재생에너지학회:학술대회논문집
• /
• 2008.10a
• /
• pp.310-314
• /
• 2008

The exploitation of the wind energy resource is a rapidly growing area world-wide. The number of installed units is continuously increasing, and it is important to respect and to deal with the impact of wind turbine. This paper addresses the power quality characteristics of U57 Wind Turbine. 750kW gearless type wind turbine for low wind speed, named U57, is developed by UNISON. The power quality measurement system consists of measuring WTG output current, line-to line voltage and wind speed signal. With using measured data, power quality measurement is evaluated about maximum power, reactive power, voltage fluctuation, harmonics according to IEC 61400-21.

• Journal of Industrial Technology
• /
• v.29 no.B
• /
• pp.173-180
• /
• 2009

Simulations using two well-known commercial codes, WAsP and WindSIM, were performed to predict the wind resources in complex terrains of Korea. The predictions from the codes were compared with the measured data. Cross predictions were performed for two closely located measurement sites. The results from WindSIM were found to be more accurate than those from WAsP. The predictions for wind velocity and direction in five different sites of complex terrain from WAsP and WindSIM were also compared. It was found that if the self prediction of the wind velocity and direction from WAsP is close to the measured wind data, the discrepancies between WAsP results and WindSIM results are also close.

• 한국신재생에너지학회:학술대회논문집
• /
• 2010.11a
• /
• pp.190.2-190.2
• /
• 2010

LIDAR는 레이저를 대기에 송출하여 미세먼지의 이동에 의한 도플러 위상차를 검출함으로써 3차원 풍속벡터를 측정하는 원격탐사 장비로, 한국에너지기술연구원은 국내최초로 WindCube LIDAR를 도입하여 운영 중에 있다. LIDAR의 장점은 이동성, 설치의 편리성 외에도 현재까지 풍황탑이 모든 범위를 측정하지 못한 풍력발전기 블레이드 회전면 최고 높이인 지면 150m 까지의 풍속분포를 상세하게 측정할 수 있다는 특장점이 있다. WindCube LIDAR는 총 10개의 측정 고도를 설정할 수 있으며 1Hz로 원시자료를 획득하여 10분 평균자료로 저장한다. 이러한 측정자료를 통하여 기존 기상탑에서 불가능하였던 풍속분포의 정확한 이해와 난류특성의 파악이 가능하게 되었으나 반대급부로 급증한 측정자료의 정리와 분석에 많은 시간과 노력이 필요하게 되었다. 이에 한국에너지기술연구원에서는 LIDAR 측정자료의 가공 및 분석에 편리성을 제공하기 위해 KIER-$LidarWind^{TM}$ 프로그램을 개발하였으며, 2차원 등치선도 및 3차원 풍속분포 그래프를 시각함으로써 입체적인 가공 및 분석이 가능하도록 하였다.

• Journal of the Korean Solar Energy Society
• /
• v.29 no.2
• /
• pp.22-30
• /
• 2009

In order to clarify predictive accuracy for the wind resource predicted by running WindPRO(Ver. 2.5) which is software for wind farm design developed by EMD from Denmark, an investigation was carried out at the northeast region of Jeju island. The Hangwon, Susan and Hoichun sites of Jeju island were selected for this study. The measurement period of wind at the sites was for one year. As a result, when the sites had different energy roses, though the two Wind Statistics made by STATGEN module were used for the prediction, it was difficult to exactly predict the energy rose at a given site. On the other hand, when the two Wind Statistics were used to predict the average wind speed, the wind power density and the annual energy production, the relative error was under ${\pm}20%$ which improved more than that when using only one Wind Statistics.

• The Transactions of The Korean Institute of Electrical Engineers
• /
• v.59 no.9
• /
• pp.1560-1565
• /
• 2010

The renewable resource are getting more attentions with increased concerns on the depletion of fossil fuels and several environmental issues like emission problem. Wind power is a representative option among several renewable sources and the generation capacity using wind power is being increased. However, the wind generation is so volatile on its output characteristic, so it is required to assess the grid impact of wind power generation by measuring the fluctuation effect more precisely. This paper proposes the method for measuring the generation output according to IEC 61400-21(Measurement and assessment of power quality characteristics of grid connected wind turbines) to assess the power quality of wind turbine generation. In addition, it shows an application case to a small-scale wind power generator. In the case study, it suggests a structure design of the proposed measurement instrument both on hardware and software aspects, which is composed of a remote monitoring & data analysis program and an FPGA based real-time signal processing device.