• 한국정밀공학회지
• /
• 제12권10호
• /
• pp.40-49
• /
• 1995

This paper presents the performance and problems in analysis method and testing system of Electronic Speckle Pattern Interferometry (ESPI) method, in measuring two - dimensional in-plane displacement. The anyalysis result of measurement by ESPE is quite comparable to that tof measurement by strain gauge method. This implies that the method of ESPE is a very effective tool in non-contact two-dimensional in-plane strain analysis. But there is a controversal point, measurment error. This error is discussed to be affected not by ESPE method itself, but by its analysis scheme of the interference fringe, where the first-order interpolation has been applied to the points of strain measured. In this case, it is turned out that the more errors would be occurred in the large interval of fringe. And so this paper describes a computer method for drawing when the height is available only for some arbitrary collection of points. The method is based on a distance-weighted, last- squares approximation technique with the weight varying with the distance of the data points.

• 대한전자공학회:학술대회논문집
• /
• 대한전자공학회 2001년도 하계종합학술대회 논문집(4)
• /
• pp.151-154
• /
• 2001

In this Paper, a new harmonic imaging technique is proposed and evaluated experimentally. In the proposed method, a weighted chin signal with a hanning window is transmitted. The RF samples obtained on each array element are individually compressed by correlating with the reference signal defined as the 2nd harmonic (2f0) component of a transmitted chirp signal generated in a square-law system. The proposed method uses the compressed 2f0 component to form an image, for which the crosscorrelation term with f0 component should be suppressed below at least -60dB. After experiment, the 6dB pulse width and peak sidelobe level of the compressed 2f0 component were 0.7us and -60dB, respectively. This result shows that the proposed method can successfully eliminate the f0 component with a single transmit-receive event and therefore is more efficient than the conventional pulse inversion (PI) method in terms of frame rate. We also observed that the 2nd harmonic compont starts to decrease for source pressure higher than 210kPa in water, which implies that SNR of the 2nd harmonic imaging using short pulses cnanot be incresed beyond a certain limit.

• Journal of the Korean Data and Information Science Society
• /
• 제21권6호
• /
• pp.1171-1180
• /
• 2010

회귀함수의 비모수적 적합에서 공변량의 차원이 증가함에 따라 추정량의 극한성질이 좋지 않음이 잘 알려져 있다. 이러한 문제점을 극복하기 위한 방법중의 하나는 단일지표모형의 추정을 이용하여 공변량의 차원을 1차원으로 줄이는 것이다. 단일지표모형에서 계수 추정 방법으로는 반복적으로 해를 계산하여 근사치를 구하는 방법인 준모수적 최소제곱법과 비반복적으로 계산하여 구하는 도함수 가중평균법이 있다. 두 추정 방법 모두 모수적인 방법과 같은 수렴비율로 정규근사한다고 알려져 있지만 실질적인 성능에 관한 비교는 이루어지지 않았다. 본 논문에서는 모의실험을 통해 두 방법에 의한 추정치의 분산을 비교하여 어떠한 방법이 좋은지를 파악하고자 한다.

• Wind and Structures
• /
• 제19권4호
• /
• pp.371-387
• /
• 2014

Probability plotting positions are popular and used as the basis for distribution fitting and for inspecting the quality of the fit because of its simplicity. The plotting positions that lead to excellent approximation to the mean of the order statistics should be used if the objective of the fitting is to estimate quantiles. Since the mean depends on the sample size and is not amenable for simple to use closed form solution, many plotting positions have been presented in the literature, including a new plotting position that is derived based on the weighted least-squares method. In this study, the accuracy of using the new plotting position to fit the Gumbel distribution for estimating quantiles is assessed. Also, plotting positions derived by fitting the mean of the order statistics for all ranks is proposed, and an approximation to the covariance of the order statistics for the Gumbel (and Weibull) variate is given. Relative bias and root-mean-square-error of the estimated quantiles by using the proposed plotting position are shown. The use of the proposed plotting position to estimate the quantiles of annual maximum wind speed is illustrated.

• 대한전기학회논문지
• /
• 제34권5호
• /
• pp.201-209
• /
• 1985

This paper describes a method for the state estimation by a modified fast decoupled estimation method and system decomposition. The state values are gained by using the weighted least square estimation method, fast decoupled estimation method, and modified fast decoupled estimation method. The estimated values of each method were compared about effectiveness of state values, respectively. This paper investigated the effects of impedance of well-condition or ill-condition into lines. The characteristics of state estimation were gained through hierarchical state estimation. Each method was applied to three model power systems, and, the results of test for the proposed method are given.

• 산업공학
• /
• 제11권3호
• /
• pp.15-22
• /
• 1998

A new improved algorithm in edge location to subpixel accuracy using decent-based weight to spatial information is proposed in this paper and applied to automated visual inspection(AVI) system. An application of the new edge operator as an edge detector is also provided and compared with Tabatabai and Lyvers edge detectors. The existing algorithms located edger to subpixel accuracy using least-square or moment-based methods. The algorithms also use only spatial information or grey-level values to locate edges. However, the proposed algorithm consider the weighted sum of grey-levels values of each edge pattern. The results show that the proposed algorithm is relatively less biased and has smaller standard deviation than the edge operations developed by Tabatabai and Lyvers in the presence of noise.

• International Journal of Contents
• /
• 제12권3호
• /
• pp.22-28
• /
• 2016

Tensor with missing or incomplete values is a ubiquitous problem in various fields such as biomedical signal processing, image processing, and social network analysis. In this paper, we considered how to reconstruct a dataset with missing values by using tensor form which is called tensor completion process. We applied Tucker factorization to solve tensor completion which was built base on optimization problem. We formulated the optimization objective function using components of Tucker model after decomposing. The weighted least square matric contained only known values of the tensor with low rank in its modes. A first order optimization method, namely Nonlinear Conjugated Gradient, was applied to solve the optimization problem. We demonstrated the effectiveness of the proposed method in EEG signals with about 70% missing entries compared to other algorithms. The relative error was proposed to compare the difference between original tensor and the process output.

• 대한전기학회논문지
• /
• 제35권5호
• /
• pp.193-198
• /
• 1986

In this paper, 1-168 hours ahead load prediction algorithm is developed for power system economic weekly operation. Total load is composed of three components, which are base load, week load and weather-sensitive load. Base load and week load are predicted by moving average and exponential smoothing method, respectively. The days of moving average and smoothing constant are optimally determined. Weather-sensitive load is modeled by linear form. The paramiters of weather load model are estimated by exponentially weighted recursive least square method. The load prediction of special day is very tedious, difficult and remains many problems which should be improved. Test results are given for the day of different types using the actual load data of KEPCO.

• 전기학회논문지P
• /
• 제54권1호
• /
• pp.34-40
• /
• 2005

This paper presents a frequency transfer function synthesis for simplifying a high-order model with time delay to a low-order model. A model reduction is based on minimizing the error function weighted by the numerator polynomial of reduced systems. The proposed method provides better low frequency fit and a computer aided algorithm. And in this paper, we present a design method of PID controller for achieving the desired specifications via the reduced model. The proposed method identifies the parameter vector of PID controller from a linear system that develops from rearranging the two dimensional input matrices and output vectors obtained from the frequency bounds.

• 응용통계연구
• /
• 제2권2호
• /
• pp.61-78
• /
• 1989

정상조건에서 수명이 상당히 긴 개체의 생명검사(Life Test)를 현실적으로 수행하기 위하여 제안된 충격생명검사에 관하여 고찰하였다. 생명검사의 결과로 얻는 자료의 통계적 분석을 위하여 이미 제안된 모형의 검토와 이들을 일면 포함하는 모형을 제시하고 그에 따르는 통계적 추론 과정을 최대우도추정법과 가중최소자승법을 사용하여 토의하였다. 한편 검사를 계획할 때 발생하는 실험설계의 문제를 검토하고 단순 계단적 충격검사에서 잘려진 자료(Consored Data)를 포함한 경우를 연구하였다.