• The Transactions of the Korean Institute of Power Electronics
• /
• v.26 no.2
• /
• pp.90-95
• /
• 2021

In contrast to AC grounding systems, the ground electrode in DC systems continuously maintains positive or negative polarity. Ground electrodes with (+) polarity proceeds by oxidation reaction. Thus, the DC current should flow opposite to the polarity of the leakage current flowing through the (+) ground electrode by using a compensation electrode, and the current flowing through the (+) ground electrode can be 0A. However, according to protecting the (+) ground electrode, the compensation electrode corrodes and gets damaged. Thus, the (+) ground electrode must be protected from corrosion, and the service life of the compensation electrode must be extended. As an alternative, the average value of the current flowing through the compensation electrode should be equal with the value of the leakage current flowing through the (+) ground electrode by using the square waveform. Throughout the experiment, the degree of corrosion on the compensation electrode is analyzed by the frequency of the compensation electrode for a certain time. In the experiment, the frequencies of the square waveform are considered for 0.1, 1, 10, 20, 50, 100 Hz, and 1 kHz. Through experiments and analysis, the optimal frequency for reducing the electrolytic damage of the (+) electrode and compensation electrode in an LVDC grounding environment is determined.

• Journal of Digital Convergence
• /
• v.11 no.5
• /
• pp.285-290
• /
• 2013

In a MPC coding using excitation source of voiced and unvoiced, it would be a distortion of speech waveform. This is caused by normalization of synthesis speech waveform of voiced in the process of restoration the multi-pulses of representation section. To solve this problem, this paper present a method of position compensation(PC-MPC) in a multi-pulses each pitch interval in order to reduce distortion of speech waveform. I was confirmed that the method can be synthesized close to the original speech waveform. And I evaluate the MPC and PC-MPC using multi-pulses position compensation method. As a result, $SNR_{seg}$ of PC-MPC was improved 0.4dB for female voice and 0.5dB for male voice respectively. Compared to the MPC, $SNR_{seg}$ of PC-MPC has been improved that I was able to control the distortion of the speech waveform finally. And so, I expect to be able to this method for cellular phone and smart phone using excitation source of low bit rate.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.12 no.9
• /
• pp.4119-4124
• /
• 2011

In a MPC coding using excitation source of voiced and unvoiced, it would be a distortion of speech waveform in case of increasing or decreasing of speech signal amplitude in a frame. This is caused by normalization of synthesis speech signal in the process of restoration the multi-pulses of representation section. To solve this problem, this paper present a method of amplitude compensation(AC-MPC) in a multi-pulses each pitch interval in order to reduce distortion of speech waveform. I was confirmed that the method can be synthesized close to the original speech waveform. And I evaluate the MPC and AC-MPC using amplitude compensation method. As a result, SNRseg of AC-MPC was improved 0.7dB for female voice and 0.7dB for male voice respectively. Compared to the MPC, SNRseg of AC-MPC has been improved that I was able to control the distortion of the speech waveform finally. And so, I expect to be able to this method for cellular phone and smart phone using excitation source of low bit rate.

• Proceedings of the Korean Society of Computer Information Conference
• /
• 2017.01a
• /
• pp.191-192
• /
• 2017

해상에서는 도로가 아닌 해상 위라는 환경 때문에 음주단속을 실시하여 음주운항을 예방하기엔 어려움이 존재한다. 원거리로 신체정보를 보낼 수 있는 음성을 통하여 음주단속을 한다면 거리가 얼마나 떨어져 있더라도 실시간으로 측정이 가능하다. VTS 무선 교신 환경을 이용하여 음성을 통신할 때도 무선 환경이 고르지 못할 경우에 클리핑이 일어나 음주가능성 판단율이 저하될 수 있다. 따라서 본 논문에서는 음성신호가 왜곡이 되어 음주 가능성 여부의 판단율 오차를 줄이기 위해 신호를 보상하는 방법을 제안하였다.

• Proceedings of the KIEE Conference
• /
• summer
• /
• pp.1202-1204
• /
• 2004

This paper propose the control algorithm for improving the power quality through the voltage compensation when source voltage is dropped. The algorithm signified occurrence of voltage drop in source voltage of each phase storing source voltage for two cycles using the concept of moving average and using the source voltage of last half cycle. If there are voltage drops in the source voltages, series active power filter compensates the differences between reference waveform and source voltage waveform. Therefore, voltage drop is compensated. It proposed series active power filter of three phases three lines to apply to the proposed algorithm and the presented experiment results verified logicality and effectiveness of the proposed algorithm.

• Journal of the Korea Institute of Military Science and Technology
• /
• v.22 no.2
• /
• pp.233-240
• /
• 2019

High-altitude ElectroMagnetic Pulse(HEMP) is a high-power electromagnetic pulse caused by nuclear explosions at altitudes above 30 km. This pulse can cause serious damage to the electrical/electronic device. Therefore, there are a lot of studies on the effects of HEMP in the literature. When conducting studies on the effects of HEMP, it is essential to measure the simulated HEMP. Depending on the need for measurement, this paper focuses on the HEMP measurement method. This paper proposes a measurement method using frequency domain compensation to extract the correct waveform and solves the offset problem more efficiently than the conventional methods. The proposed method is verified by experiment using HEMP simulator and measurement system in ADD.

• The Transactions of the Korean Institute of Electrical Engineers
• /
• v.32 no.3
• /
• pp.76-83
• /
• 1983

This paper describes the method of operating the phase controlled rectifier by controlling the firing angle in III, IV quadrant to absorb the lrading reactive power and of improving the waveform of ac current by driving dual converter. The system is intended to compensate the reactive power for any lagging load. Also, by the above method this paper enables us to improve the power factor and waveform referred to the source current and the dc output voltage in the converter.

• Journal of Internet Computing and Services
• /
• v.19 no.6
• /
• pp.1-7
• /
• 2018

This paper present an 8kbps ACLMS-MPC(Amplitude Compensation and Least Mean Square - Multi Pulse Coding) coding method integrated with ACFBD-MPC(Amplitude Compensation Frequency Band Division - Multi Pulse Coding) and LMS-MPC(Least Mean Square - Multi Pulse Coding) used V/UV/S(Voiced / Unvoiced / Silence) switching, compensation in a multi-pulses each pitch interval and Unvoiced approximate-synthesis by using specific frequency in order to reduce distortion of synthesis waveform. In integrating several methods, it is important to adjust the bit rate of voiced and unvoiced sound source to 8kbps while reducing the distortion of the speech waveform. In adjusting the bit rate of voiced and unvoiced sound source to 8 kbps, the speech waveform can be synthesized efficiently by restoring the individual pitch intervals using multi pulse in the representative interval. I was implemented that the ACLMS-MPC method and evaluate the SNR of APC-LMS in coding condition in 8kbps. As a result, SNR of ACLMS-MPC was 15.0dB for female voice and 14.3dB for male voice respectively. Therefore, I found that ACLMS-MPC was improved by 0.3dB~1.8dB for male voice and 0.3dB~1.6dB for female voice compared to existing MPC, ACFBD-MPC and LMS-MPC. These methods are expected to be applied to a method of speech coding using sound source in a low bit rate such as a cellular phone or internet phone. In the future, I will study the evaluation of the sound quality of 6.9kbps speech coding method that simultaneously compensation the amplitude and position of multi-pulse source.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.21 no.1
• /
• pp.67-79
• /
• 1996

This paper presents a composite luminance signal processing system for NTSC, PAL and SECAM standards. Eaxh of the three standards employs its own specifications of subcarmier bandwidth and luminance signal waveform. The proposed system, compatible to the specifications of the three standard and B/W TV, implements variable freqneucy characteristics by controlling filter coefficients. The major features of the system are a luminance/chroma separation unit and an aperture compensation unit. The luminance/chroma separation unit employes a notch filter selection a trap freqneyc to atenuate unwanted color signals in luminance signal bands. The aperture compensation unit comprises two subunits, to provide clear color definition for each of the three standards: a primary compensation circuit and a variable compensation circuits. The proposed system yields a 40 dB gain from the chroma/luminance separation and a 10 dB gain from the aperture compensation unit.

• 한국정보디스플레이학회:학술대회논문집
• /
• 2004.08a
• /
• pp.331-334
• /
• 2004

A new measurement scheme is proposed to generate an optimized boost table for video rate LCD response time compensation. This method, which closely follows basic theory, enables up to a 90% reduction in the lookup table creation time compared to conventional methods. Furthermore, while conventional approaches require all measurements to be repeated in order to load the entire LUT whenever key parameters such as refresh rate or boost intensity are modified, the method proposed in this paper allows the new table to be calculated by utilizing saved waveform data without the need for any repeated measurements.