• Journal of The Korean Society of Agricultural Engineers
• /
• v.58 no.6
• /
• pp.1-8
• /
• 2016

Crop damages due to agricultural drought has been increased in recent years. In Korea, water resources are limited indicating that proper management plans against agricultural drought are required for better water-use efficiency in agriculture. In this study, irrigation intervals and amounts for various crops and soil physical properties (sandy and silt loams) were estimated using the IWMM model. Five different crops (soybean, radish, potato, barley and maize) at the Bangdong-ri site in Chuncheon were selected to test the IWMM model. IWMM assessed agricultural drought conditions using the soil moisture deficit index (SMDI), and irrigation intervals and amounts were determined based on the degree of agricultural drought (SMDI). Additionally, we tested the effects of surface irrigation and sprinkler irrigation methods and various irrigation intervals of 2, 3, 5 and 7 days. In our findings, the irrigation intervals of 5 and 7 days showed the minimum rrigation amounts than others. When we considered that the intervals of 3 or 5 days are usually preferred to fields, the interval of 5 days was determined in our study. The estimated irrigation amounts for different crops were shown as maize > radish > barley > soybean > potato, respectively. The irrigation amounts for maize and barley were highly affected by soil properties, but other crops have less differences. Also, small differences in irrigation amounts were shown between the surface and sprinkler irrigation methods. These might be due to the lack of consideration of water loss (e.g., evapotranspiration, infiltration, etc.) in IWMM indicating model structural uncertainties. Thus, possible water loss (e.g., evapotranspiration, infiltration) need to be considered in application to fields. Overall, IWMM performed well in determining the irrigation intervals and amounts based on the degree of agricultural drought conditions (SMDI). Thus, the IWMM model can be useful for efficient agricultural water resources management in regions at where available water resources are limited.

• Food Science of Animal Resources
• /
• v.40 no.6
• /
• pp.1044-1054
• /
• 2020

This study was performed to investigate the effects of lotus leaf hot water extracts treatment on the quality and stability of eggs using impregnation treatment through ultrasonication during storage. A total of 480 eggs were categorized into four treatment groups (n=30 each)-non-treated (CON), soaked for 30 min in lotus leaf hot water extracts without ultrasonication (T1), sonicated in distilled water (T2), and sonicated in lotus leaf hot water extracts (T3)-and stored for 15 d at 30℃. The egg weight, Haugh unit (HU), egg grade, albumen height, yolk color, eggshell thickness, eggshell breaking strength, and weight loss were measured for egg quality assessment. 2-Thiobarbituric acid reactive substance (TBARS) and volatile basic nitrogen (VBN) contents were measured as stability indicators. Additionally, total phenolic contents (TPC), total flavonoid contents (TFC), and 1,1-diphenyl-2-picrylhydrazyl (DPPH) radical scavenging activity were evaluated. The HU, egg grade, albumen height, and yolk color of T3 were significantly higher than those of CON (p<0.05). No significant differences in eggshell thickness and eggshell breaking strength are observed among the groups. The weight loss of T3 was significantly lower than that of the other groups during storage (p<0.05). The application of lotus leaf hot water extracts also significantly reduced TBARS and VBN (p<0.05). The TPC, TFC, and DPPH radical scavenging activity of T3 were significantly higher than those of the other groups (p<0.05). These results suggest that lotus leaf hot water extracts may be useful as a natural ingredient for improving the quality and stability of eggs during storage.

• Journal of Ecology and Environment
• /
• v.29 no.6
• /
• pp.581-584
• /
• 2006

The tissue water relation parameters were compared to assess the resistance of representative three gardening tree species to water stress. Zelkova serrata showed a strong resistant characteristics to water stress compared to Betula platyphylla var. japonica and Liriodendron turipifera. Turgor pressure at turgor loss point in Z. serrata was -2.54 MPa, whereas those of 5. platyphylla var, japonica and L. turipifera were -2.24 and -2.03, respectively. In addition, Z. serrata showed less reduction in pressure potential to decrease of free water content in the leaf tissue, indicating effective shrinking of the cell wall compared to others. On the other hand, L. turipifera indicated a weak resistance to water stress, which has low turgor potential at turgor loss point and cell wall elasticity. These results suggest that Z. serrata would be suitable for relatively dry conditions of location and humid conditions of location would be suitable for L. dendronas plantation.

• Applied Chemistry for Engineering
• /
• v.5 no.1
• /
• pp.63-73
• /
• 1994

Weight loss accelerating agents, TDACW and TTAMW were prepared by adding water to n-tetradecyldimethylbenzylammonium chloride(TDAC) and n-tetradecyltrimethylammonium methyl sulfate(TTAM) synthesized in our lab. On weight loss finishing of PET fiber with NaOH and TDACW or TTAMW, TDACW showed much more weight loss than TTAMW. Optimum concentration was about $8g/{\ell}$, treatment time 60~90min and treatment bath ratio 1:40~1:50. Density and crystallinity increased with weight loss and tensile strength decreased with weight loss. From the reaction mechanism of weight loss accelerating agent and PET fiber, weight loss accelerating agent was proved to function as a catalyst and the surface structures of PET fibers treated with weight loss accelerating agent were characterized with SEM.

• Transactions of the Korean Society of Automotive Engineers
• /
• v.6 no.6
• /
• pp.113-131
• /
• 1998

The objective of the present study is to investigate the characteristics of the dividing flow in the laminar flow region. Using glycerine water solution(wt43%) for Newtonian fluid and the polymer of viscoelastic fluid(500wppm) for non-Newtonian fluid, this research investigates the flow state of the dividing tube in steady laminar flow region of the two dimensional dividing tube by measuring the effect of Reynolds number, dividing angle, and the flow rate ratio on the loss coefficient. In T- and Y-type tubes, the loss coefficients of the Newtonian fluid decreases in constant rate when the Reynolds number is below 100. The effect of the flow rate ratio on the loss coefficients is negligible. But when the Reynolds number is over 100, the loss coefficient with various flow rate ratios approach an asymptotic value. The loss coefficient of the non-Newtonian fluid for different the Reynolds number shows the similar tendency of the Newtonian fluid. And when the Reynolds number is over 300, the loss coefficient is approximately 1.03 regardless of flow rate ratio or the dividing angle. The aspect ratio does hardly influence the reattachment length and the loss coefficient of both Newtonian and non Newtonian fluid. The loss coefficient decreases as the Reynolds number increases. The loss coefficient of Newtonian fluid is larger than that of non-Newtonian fluid.

• Tribology and Lubricants
• /
• v.27 no.5
• /
• pp.275-280
• /
• 2011

Automotive wheel bearing grease helps to reduce stresses and prevent wear of wheel bearings. But it is easily contaminated by water and other contaminants. In this study, we investigated the property change of automotive wheel bearing grease under water contamination. The result showed that some properties such as dropping point, work penetration and oxidation stability were not influenced by water content. However, most of properties such as work stability, water washout characteristics, leakage tendency, oil separation, evaporation loss and rust protection became worse after water was added. This is thought that added water makes the interaction weak between thickener and base oil of grease.

• Textile Coloration and Finishing
• /
• v.13 no.2
• /
• pp.42-42
• /
• 2001

Following the prior studs regarding that 1.0g of cotton fabric cound be dyed uniformly with a reactive dye in the solvent mixture of 2㎖ of water and 23㎖ of dichloromethane, silk fabric was dyed with C. I. Reactive Blue 203 in the water/dichloromethane two-phase immiscible solvent media. In order to minimize dye loss due to its hydrolysis, the reactive dyeing was carried out in dichloromethane containing a small amount of water. With only 3㎖ of water in 22㎖ of dichloromethane, 1.0g of silk fabric could be dyed perfectly. The uptake ratio was increased greatly, compared with that of normal reactive dyeing in a water medium. It would seem that the one of hydrophobic solvents, dichloromethane, can assist the even dyeing as it disperses a small amount of dye-dissolved water phase and conveys this water phase to the fabric entirely and uniformly.

• Proceedings of the KIEE Conference
• /
• summer
• /
• pp.270-272
• /
• 2004

At the water supply field, high voltage induction motor is main facility of a load equipment. The motor is often out of order and its noise, generated heat, loss etc occurred occasionally. especially, transmission motor for flux control generates an amount of the harmonics then have a bad influence upon the electric power system. In this study, to analyze the total harmonics distortion of the water supply field receiving high voltage, the harmonics measured and analyzed using the PQA(Power quality Analyzer) according to the electric power system and electrical load and the reduction method presented.

• Horticultural Science & Technology
• /
• v.18 no.5
• /
• pp.612-620
• /
• 2000

In developing soil wetting agent using polyoxyethylene octylphenyl ether [$C_8H_{17}O(C_2H_4O)_{10}H$, POE], the effect of mixtures of POE and polyoxyethylene+polypropyleneoxide tridecylether (1:1, w/w, CM-1), polyoxyethylene+polypropyleneoxide tridecylether+propyleneglycol monomethylether (1:1:2, w/w/w, CM-2) or glycerin+ditridecyl phthalate (1:1, w/w, CM-3) on changes of concentration of POE, initial wetting, evaporative water loss, water infiltration, and changes of physical properties in root media were determined. The mixtures of POE and CM-1, 2, or 3 with zeolite or vermiculite as carrier had high concentrations of POE in root media during 6 elution times, but those after 6 times decreased rapidly indicating unstable elution of POE. The commercial AquaGro was more effective than the mixtures of POE+CM-1, 2, or 3 in water retention during 18 hours. Root media incorporated with POE+CM-2 held more water than any other treatments at 84 hours after watering, but the differences among treatments except control were not significant. In the treatments with zeolite as a carrier, POE+CM-3 had the greatest evaporative water loss followed by POE+CM-2, AquaGro, control, and POE+CM-2. In the treatments with vermiculite as a carrier, POE+CM-1 had the highest evaporative water loss followed by POE+CM-3, AquaGro, control, and POE+CM-2. In the effect of mixtures with zeolite as a carrier on infiltration of water into root media, the treatment of POE+CM-1 had the highest amount of water infiltrated followed by POE+CM-3, AquaGro, POE+CM-2, and control. In the effect of mixtures with vermiculite as a carrier on infiltration of water into root media, the treatment of POE+CM-3 had the highest amount of water infiltrated followed by AquaGro, POE+CM-1, POE+CM-2, and control.

• Journal of Digital Convergence
• /
• v.6 no.4
• /
• pp.53-61
• /
• 2008

Organizations can experience serious financial and/or reputational losses if business activities are disrupted by an incident of information systems under the current business environment. The loss includes the intangible decline in brand image, customer separation, and the tangible loss such as decrease in business profits. Thus, it is necessary to take proactive initiatives by managing many kinds of risks an organization may have. Therefore, the enterprise risk management has been received a special attention by some advanced private companies, but not many public organizations. This paper describes an approach and some issues when the enterprise risk management was introduced in a domestic public organization.