• Journal of Power System Engineering
• /
• v.12 no.4
• /
• pp.57-63
• /
• 2008

The last stage blade of the low pressure steam turbine remarkably affects turbine plant performance and availability Turbine manufacturers are continuously developing the low pressure last stage blades using the latest technology in order to achieve higher reliability and improved efficiency. They tend to lengthen the last stage blade and apply shrouds at the blades to enhance turbine efficiency. The long blades increase the blade tip circumferential speed and water droplet erosion at shroud is anticipated. Parts of integral shrouds of the last stage 40 inch blades were cracked and liberated recently in a combined cycle power plant. In order to analyze the root cause of the last stage blades shroud cracks, we investigated operational history, heat balance diagram, damaged blades shape, fractured surface of damaged blades, microstructure examination and design data, etc. Root causes were analyzed as the improper material and design of the blade. Notches induced by erosion and blade shroud were failed eventually by high cycle fatigue. This paper describes the root cause analysis and countermeasures for the steam turbine last stage blade shroud cracks of the combined cycle power plant.

• Journal of Power System Engineering
• /
• v.17 no.2
• /
• pp.87-94
• /
• 2013

Applicability of organic Rankine cycle for a passenger car with 3.5 L gasoline engine to convert low grade waste heat to useful shaft power has been numerically studied. Working fluid is R134a, and the Rankine cycle is composed of boiler for recovering engine cooling water heat, super heater for recovering exhaust gas heat, scroll expander for converting waste heat to shaft power, condenser for heat emission, internal heat exchanger, and feed pump. Assuming efficiencies of 90% for the heat exchangers, 75% for the scroll expander, and 80% for the feed pump, the Rankine cycle efficiency of 5.53% was calculated at the vehicle speed of 120 km/hr. Net expander shaft output after subtracting the power required to run the pump was 3.22 kW, which was equivalent to 12.1% improvement in fuel consumption. About the same level of improvement in the fuel consumption was obtained over the vehicle speed range of 60 km/hr~120 km/hr.

• Journal of the Korean Applied Science and Technology
• /
• v.31 no.2
• /
• pp.197-202
• /
• 2014

Positive plate was composed of lead hydroxide via reaction between lead oxide and $H_2O$ and lead sulfate was formed of the reaction of lead hydroxide with sulfuric acid. And its density is $3.8g/cm^3$, $4.0g/cm^3$, $4.2g/cm^3$ and $4.4g/cm^3$ by controlling volume of refined water. Curing of positive plate is done for low ($45^{\circ}C$, 40hr, over 95% of relative humidity) & high ($80^{\circ}C$, 40hr, over 95% of relative humidity) temperature, which created 3BS & 4BS active materials. Experimental result of DOD with 100% life cycle test shows that it was not related to the density of active materials but to the low & high temperature aging of active materials. The test makes us to understand that the crystallization which is made by curing of active materials is a more of a main factor than density of active materials under the deep cycle using circumstances. The active materials which were from the high temperature curing are better for deep cycle performance.

• The Journal of Internal Korean Medicine
• /
• v.26 no.1
• /
• pp.60-73
• /
• 2005

Objectives : The aim of this study was to evaluate the effects of Loranthus parasiticus Merr. on cell cycle and expression of related genes in HepG2 cells. Methods : The MTT assay, cell counting assay, $[^3H]-Thymidine$ incorporation assay, flow cytometric analysis, quantitative RT-PCR and western blot assay were studied. Results : In the water extract of Loranthus parasiticus Merr., inhibition of cell proliferation and DNA synthesis in HepG2 cells was seen. These inhibitory effects were due to inhibition of G l-S transition in cell cycle. After treatment with the extract, expression of cyclin D1(G1 check point related gene) was inhibited particularly in dose-dependent and time-dependent manners. Conclusion : These results suggest that the inhibition of cell cycle progression by Loranthus parasiticus Merr. in HepG2 cell is due to suppression of cyclin D1(G1 check point related gene) mRNA expression and protein synthesis.

• Nuclear Engineering and Technology
• /
• v.48 no.5
• /
• pp.1109-1119
• /
• 2016

Although, the direct use of spent pressurized water reactor (PWR) fuel in CANda Deuterium Uranium (CANDU) reactors (DUPIC) cycle is still under investigation, DUPIC cycle is a promising method for uranium utilization improvement, for reduction of high level nuclear waste, and for high degree of proliferation resistance. This paper focuses on the effect of DUPIC cycle on CANDU reactor safety parameters. MCNP6 was used for lattice cell simulation of a typical 3,411 MWth PWR fueled by $UO_2$ enriched to 4.5w/o U-235 to calculate the spent fuel inventories after a burnup of 51.7 MWd/kgU. The code was also used to simulate the lattice cell of CANDU-6 reactor fueled with spent fuel after its fabrication into the standard 37-element fuel bundle. It is assumed a 5-year cooling time between the spent fuel discharges from the PWR to the loading into the CANDU-6. The simulation was carried out to calculate the burnup and the effect of DUPIC fuel on: (1) the power distribution amongst the fuel elements of the bundle; (2) the coolant void reactivity; and (3) the reactor point-kinetics parameters.

• Nuclear Engineering and Technology
• /
• v.29 no.6
• /
• pp.488-499
• /
• 1997

The measurements of the moderator temperature coefficient (MTC) are performed to demonstrate that the calculational model produces results that are consistent with the measurements. Since negative MTC is also a technical specification value that may limit the cycle length, it is important to measure it as accurately as possible. In this report, preferred choice of test method depending on the time in cycle, best power indication and temperature definition in MTC calculation were determined based on the MTC test results taken during initial startup testing and at 2/3 cycle burnup in the Yonggwang nuclear power plant. The results show that the ratio and rodded methods provided good agreement with the predictions during initial startup testing. However, near end-of-cycle the depletion method gives better results, and so is suggested to be used in the MTC measurements at 2/3 cycle burnup. The use of primary Delta T power as a power indicator in the MTC calculations is highly advisable since it responds with good consistent results very quickly to changes unlike secondary calorimetric power. For the appropriate temperature definitions used in the MTC calculations, it is considered that the arithmetic average temperature measured simply by inlet and outlet thermocouples is preferred. Although volumetric average temperature provides better results, the improvement is not sufficient to compensate for the simplicity of calculations by arithmetic average temperature.

• The Journal of Korean Obstetrics and Gynecology
• /
• v.18 no.1
• /
• pp.169-180
• /
• 2005

Objective : Spatholobus Suberectus Dunn stems, Chinese vine plants, have been used for the relief of menstrual disorders and rheumatic arthralgia. In this study, we investigated the antitumor effect of Spatholobus Suberectus Dunn on cervical cancer in vitro. Methods : HeLA cervical cancer cell lines were used as targets. We examined the effect of water extract from Spatholobus Suberectus Dunn on cell proliferation, cell cycle regulation and cell cycle-regulating gene expression. Further, we investigated the apoptotic effects of Spatholobus Suberectus Dunn on cervical cancer cell lines. Results : Spatholobus Suberectus Dunn significantly inhibited the proliferation of cervical cancer cell lines in a dose-dependent and time dependent manner. Fluorescence activated cell sorter (FACS) analysis indicated that Spatholobus Suberectus Dunn induced G1 cell cycle arrest. Spatholobus Suberectus Dunn enhanced the expression of $p21^{waf1}$ and $p27^{kip1}$ with cell cycle arrest. Further, Spatholobus Suberectus Dunn stimulated apoptosis via caspase3 pathway. Conclusions : These findings suggest that Spatholobus Suberectus Dunn is a candidate agent for the treatment of cervical cancer. p21waf1 and $p21^{waf1}$ and $p27^{kip1}$ may play an important role in Spatholobus Suberectus Dunn-induced cell cycle arrest and cell growth inhibition.

• Proceedings of the KSRS Conference
• /
• 2003.11a
• /
• pp.735-737
• /
• 2003

The drying up of seepage in Kumagaya City was caused by the increase of impermeable area with urbanization. The project of rain fall infiltration facilities has been planned for improvement of a hydrological cycle in Kumagaya City. With GIS and remote sensing, the most suitable arrangement for the rainfall infiltration inlets was examined. Distribution maps for infiltration, evapotranspiration and groundwater recharge at each town in Kumagaya City was designed from the land cover classification map with hydrological analysis. In these distribution maps, influence of the leak from drinking water and sewage networks was counted to the hydrological cycle.

• Journal of Energy Engineering
• /
• v.10 no.4
• /
• pp.357-362
• /
• 2001

A bench type ammonia-water absorber heat exchange cycle was tested by varying the system charging concentration, refrigerating valve opening and weak solution flow rate. It was observed that the cooling capacity was increased as the system charging concentration was increased. Optimum system charging concentration was found for the coolong capacity of the system. The opening rate of refrigerant expansion valve had a direct influence on the refrigerant sub-cooling at the condenser outlet. Optimum sub-cooling was found to be 0~4$^{\circ}C$. As the weak solution flow rate increased the concentration of strong solution and the evaporating pressure decreased. There existed a optimum weak solution flow rate which maximized the cooling capacity and COP.

• Journal of Microbiology and Biotechnology
• /
• v.17 no.3
• /
• pp.520-523
• /
• 2007

Edible films of gelatin and com zein were prepared by incorporating nisin to the film-forming solutions. Com zein film with nisin of 12,000 IU/ml had an increase of 11.6 MPa in tensile strength compared with the control, whereas gelatin film had a slight increase with the increase of nisin concentration added. Water vapor permeability for both com zein and gelatin films decreased with the increase of nisin concentration, thus providing a better barrier against water. Antimicrobial activity against Listeria monocytogenes increased with the increase of nisin concentration, resulting in 1.4 log cycle reduction for com zein film and 0.6 log cycle reduction for gelatin film at 12,000 IU/ml. These results suggest that incorporation of nisin into com zein and gelatin films improve the physical properties of the films as well as antimicrobial activity against pathogenic bacteria during storage, resulting in extension of the shelf life of food products by providing with antimicrobial edible packaging films.