• Journal of the Korean Institute of Telematics and Electronics D
• /
• v.34D no.11
• /
• pp.20-24
• /
• 1997

We have successfully fabricated high power (~20W) laser diode array, which are useful for pumping Nd:YAG lasers. The laser diode aray has 20 100.mu.m-wide cahnnels of which space was adjusted to 350.mu.m to improve thermal characteristics. And channel width is 100.mu.m. For an uncoated LD array, the output power of 15.66W has been obtained at 41A under quasi-CW operation, which results in about 0.42W/A slope efficiency. After aR(5%) and HR (95%) coatings on both facets, the output power was improved up to 21.18W at 40A under the same operation as above and the slope efficiency was 0.795W/A. On the other hand, by using a near field measurement system consisting of objective lens, eyepiece, CCD camera and image processing board, the typical near field patten of 1*20 LD array was observed.

• Proceedings of the Korean Society of Postharvest Science and Technology of Agricultural Products Conference
• /
• 2003.10a
• /
• pp.221.2-222
• /
• 2003

The relative retrogradation of Jeungpyun investigated with different millimg methods of rice flour. The relative retrogradation of Jeungpyun was reduced in order that of W-C, W-P, D-M, D-J in DSC(Differential Scanning Calorimetry) method while W-C, D-M, D-J, W-P in Diastase method. In wet milling method, the relative retrogradation of Jeungpyun by Pin mill(W-P) was lower than Jeungpyun by colloid mill(W-C). In dry milling method, the relative retrogration of Jeungpyun by jet mill(D-J) was lower than Jeungpyun by micro mill(D-M). The relative retrogradation of Jeungpyun by DSC method was similar to the Diastase method. The relative retrogradation of Jeungpyun was decreased with decreasing particle size and setback value for amylogram and increasing damaged starch.

• Journal of the Korean Chemical Society
• /
• v.17 no.6
• /
• pp.428-433
• /
• 1973

The quantitative separations of a mixture containing equal amount of each anion such as Si(IV), As(V), P(V), S(VI), W(VI) and Cr(VI) are carried out by the elution through 20${\times}3.14cm^2$ column of anion exchange resin, Dowex 1${\times}$8. The eluents are a mixture of 0.07 M hydrochloric acid and 0.03 M sodium chloride (pH = 1.30) for Si(IV), As(V) and P(V) species, a mixture of 0.6 M sodium chloride and 0.3 M sodium hydroxide for S(VI), W(VI) and Cr(VI) species, and 0.1 N sodium sulfite (pH = 3.48) for P(V) and As(V) species. The subsidiary anions in a standard mixture such as Si(IV), As(V), S(VI), P(V) and W(VI) are separated together from large amount of Fe(III) by the elution through 30cm${\times}3.14cm^2$ column of the resin, Dowex${\times}$50w${\times}$12, using a mixture of 0.1 M sodium nitrate and 2 percent dimethylsulfoxide aqueous solution as an eluent. Si(IV), As(V), S(VI), P(V) and W(VI) eluted together are separated quantitatively under the same conditions as in the separations of the anion mixture. By the conditions obtained in the separations of the standard mixture, Fe(III) and all of the subsidiary anions in steel are quantitatively separated.

• Proceedings of the KIEE Conference
• /
• 2015.07a
• /
• pp.1018-1019
• /
• 2015

Recently, standby power reduction techniques of AC/DC adaptor were developed, consuming power almost arrived to 300mW level. The standby power losses are composed of the input filter loss 11.8mW, the control IC for AC/DC adaptor 18mW, the switching loss 9.53mW and the feedback loss 123mW. And there are the standby power reduction techniques. In this paper, in order to reduce the standby power of SMPS more, the loss due to a voltage difference between input and output is reduced by the control circuit which is composed of the low voltage driving circuit and voltage regulator. The low voltage driving circuit operates on the low voltage of input and off the high voltage. The low voltage driving IC was produced by the $1.0{\mu}m$, high voltage DMOS process.

• Journal of the Korea Society of Computer and Information
• /
• v.18 no.10
• /
• pp.63-70
• /
• 2013

In this paper, we investigated frequency synchronization through computer simulation of digital M/W transmission system in multipath fading channel. we suggested frequency offset correction algorithm against frequency offset between transmitter and receiver, then evaluated the degree of constellation performance enhancement. From the performance evaluation, in case of large frequency offset, although adopting frequency offset correction scheme, residual frequency offset degraded system performance. As a result, according to frequency offset value between transmitter and receiver residual frequency offset affects system performance significantly. The results of this paper should be utilized for frequency synchronization criterion when frequency band of broadcasting system is rearranged.

• Applied Chemistry for Engineering
• /
• v.23 no.6
• /
• pp.561-566
• /
• 2012

PtRuW/C catalysts were prepared with the different molar ratios of Pt : Ru : W and their compositions were analyzed by energy dispersive X-ray (EDX). The uniform distribution of particles was observed using transmission electron microscopy (TEM). An average crystalline size of 3.5~5.5 nm was calculated based on x-ray diffraction (XRD) data. The electrochemical properties such as electrochemically active surface areas, current densities, specific activities and poisoning rates, were analyzed via CO stripping, linear sweep voltammetry and chronoamperometry. From the analysis, we observed that ternary alloy catalysts, except $PtRu_2W_2/C$, have higher current densities, specific activities and stabilities than those of commercial binary catalysts. Among all in-house catalysts, Pt5Ru4W/C showed the highest specific activity of $121.05mA{\cdot}m^{-2}$ and the lowest poisoning rate of $0.01%{\cdot}s^{-1}$.

• JSTS:Journal of Semiconductor Technology and Science
• /
• v.16 no.6
• /
• pp.842-846
• /
• 2016

This paper presents a DC-DC buck converter which uses a sleep control to improve the power efficiency in a few mW light load condition. The sleep control turns off analog controller building blocks to reduce the static power losses during the off-duty period of pulse width modulation. For verification, a buck converter has been implemented in a $0.18{\mu}m$ CMOS process. The power efficiency has been improved from 76.7% to 82.5% with a 1.2 mW load. The maximum power efficiency is 95% with a 9 mW load.

• Journal of Communications and Networks
• /
• v.10 no.1
• /
• pp.1-4
• /
• 2008

This paper reports the design of a multiwavelength fiber laser source that utilizes a linear cavity of hybrid Brillouin/Erbium fiber laser (BEFL). The output power, threshold power and free running cavity modes were investigated against the pump powers. The structure exhibited low threshold operation of 4 mW at 2.3 mW injected Brillouin pump power. The optimization of Brillouin pump wavelength, power and Erbium gain led to a maximum possible number of channels generated. Simultaneous and stable operation of 21 channels with 10.88 GHz channels spacing were obtained from this architecture at 1 mW injected Brillouin pump power and 90 m W Erbium doped fiber pump power in the 1555 nm region.

• Journal of the Korean Graphic Arts Communication Society
• /
• v.7 no.1
• /
• pp.65-72
• /
• 1989

Modified phenolics can have a retarding effect on the gelation of wood oil. Modified phenolic resins can be used in media for paint, varnishes, primers, overprinting varnishes, litho, letterpress and rotogravure inks. Varnishes based on rosin phenolic are faster drying, have better durability, are harder and glosser, and have greater resistance to water than ones based on ester gums. These physical properties is concerned with molecular weight distribution of rosin modified phenol resin. This paper was studied about molecular weight distribution of rosin phenolics which were prepared between $130~250^{\circ}C$. The results were as follows: 1) Average molecular weights inereased with increasing reaction temperature. 2) $M_w/M_n$ were from 3.43 to 46.44 with increasing reaction temperature and so the molecular weight distributions were changed from random distribution to broad distribution. 3) The relation ship between intrinsic viscosity and weight average molecular weight was follows: $[{\;}{\;}]={\;}1{\times}{\;}10^{-6}M_w,{\;}M_w=M_w$ 4) Esterification reaction between the acid group of rosin and polyol was started about $230^{\circ}C$$.

• Proceedings of the KIEE Conference
• /
• 1999.07e
• /
• pp.2459-2461
• /
• 1999

FDTD(Finite-Difference Time-Domain) 방법을 이용하여 마이크로웨이브 오븐 내부 전자파를 해석하였고, 열전달방정식을 이용하여 부하의 열 분포를 해석하였다. 다양한 형태의 오프닝구조를 갖는 캐비티에 관하여 수치계산을 수행하였고, 서로 다른 종류의 부하가 존재할 때 부하의 온도 분포가 어떻게 변화하는지 알아보았다. 또한 마그네트론의 안테나와 캡이 존재하는 실제 웨이브가이드를 모델링하여 수치 계산한 후, 적외선사진에 의한 부하의 온도분포와 비교하였다.