• Proceedings of the Korean Society for Technology of Plasticity Conference
• /
• 2008.10a
• /
• pp.71-74
• /
• 2008

The clad sheet is the sheet metal that joined the one or more material with the different property by rolling process. In this study, it is investigated about the mechanical property or formability of SUS-Al-Mg clad sheet. The clad sheet was formed at elevated temperature because of their poor formability at room temperature. The tensile test was confirmed at various temperature and the reduction of strain rate above $250^{\circ}C$. LDR(Limited Drawing Ratio) was obtained through deep drawing test to confirm the formability of the clad sheet. The FE analysis is performed to compare prototype products.

• Proceedings of the KIEE Conference
• /
• 2000.07b
• /
• pp.660-662
• /
• 2000

It is demonstrated that the torque performance of the flux barrier type synchronous reluctance motor(SynRM) can be improved in terms of geometric parameters. Torque ana power factor are related to the difference of inductances and the saliency ratio. And these inductance characteristics are determined by the geometric parameters of rotor: the number of layers. the width of iron to the width of flux barrier($K_w$). slot number and shape, airgap, bridge, etc. The relationship between geometric parameters. especially, $K_w$ and motor performance will be studied. This paper shows that torque and power factor are improved through redesign with considering geometric parameters. Performance comparisons of proto type SynRM and improved SynRM are given by FEA(Finite Element Analysis).

• JSTS:Journal of Semiconductor Technology and Science
• /
• v.14 no.1
• /
• pp.117-123
• /
• 2014

The fabrication and characterization of a Si/ZnO thin film heterojunction ultraviolet photodiode has been presented in this paper. ZnO thin film of ~100 nm thick was deposited on <100> Silicon (Si) wafer by atomic layer deposition (ALD) technique. The Photoluminescence spectroscopy confirms that as-deposited ZnO thin film has excellent visible-blind UV response with almost no defects in the visible region. The room temperature current-voltage characteristics of the n-ZnO thin film/p-Si photodiodes are measured under an UV illumination of $650{\mu}W$ at 365 nm in the applied voltage range of ${\pm}2V$. The current-voltage characteristics demonstrate an excellent UV photoresponse of the device in its reverse bias operation with a contrast ratio of ~ 1115 and responsivity of ~0.075 A/W at 2 V reverse bias voltage.

• International Journal of Automotive Technology
• /
• v.8 no.5
• /
• pp.593-598
• /
• 2007

A new continuously variable transmission for bicycles(B-CVT) is developed by using a traction drive mechanism having inner and outer spherical rotors. The B-CVT has high power efficiency, large torque capacity, improved drivability and good packageability. The ratio change mechanism for the B-CVT is very simple, in contrast with other traction drive CVTs. After completing a conceptual design, a performance analysis and a detail design, a prototype of the B-CVT has been manufactured. The prototype has rated power of 100 watts, pedal speed of 6 rad/s and an overall speed ratio of 1.0-4.0. A bench test and an actual bicycle test have been performed to verify the practicability of the B-CVT.

• International Journal of Highway Engineering
• /
• v.17 no.4
• /
• pp.1-9
• /
• 2015

PURPOSES : The purpose of this study is to revise the weight to power ratio of the representative truck in S. Korea. So far, S. Korea has been using the unit lb/hp, and the construction machines were not considered in the evaluation of the performance of trucks. METHODS : This study was performed to recommend the use of ISO system of units, and to analyze the weight to power ratios of the representative trucks in S. Korea, including the dump trucks, concrete mixer trucks, and asphalt and concrete diffusers. RESULTS: From this study, the 85 percentile value of the weight to power ratio of the trucks in S. Korea's was found to be 103.6 kg/kw. CONCLUSIONS : The performance standard for the representative truck has to be increased upward, considering the travel pattern of the dump trucks, concrete mixers, and asphalt and concrete diffuser trucks, travel distances, narrow area (work zone) of operation, and the saving in construction budget for climbing lane. Based on this study, the weight to power ratio of the representative truck in S. Korea could possibly be revised to 100~110 kg/kW.

• Korean Journal of Food Science and Technology
• /
• v.15 no.2
• /
• pp.189-194
• /
• 1983

Raw and extruded barleys prepared by three different conditions were powdered and stored for four months at ambient $(25^{\circ}C)$ and accelerated temperatures $(40^{\circ}C)$ with $A_w$ of 0.31 and 0.71, respectively. The stability of the these samples with respect to lipid oxidation was studied. The lipid oxidation of all samples, as measured by the lipid diene conjugation of the extracted oil, increased with increased $A_w$ and temperature and with the storage time elapsed. The ratio of unsaturated to saturated fatty acids (U/S ratio) tended to decreased as the $A_w$ and temperature were increased. The raw sample had a greater increase in lipid conjugation diene but a decrease in U/S ratio than the extruded samples. The extruded sample containing the added sucrose had greater lipid stability than the other extruded samples. Lipid free-amino group content in all samples decreased with increased $A_w$ and temperature.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2000.04a
• /
• pp.145-147
• /
• 2000

The secondary electron emission coefficient y of MgO single crystal according to the gas mix-ture ratio of Xe, $N_2$ to Ne have been investigated by $\gamma$-focused ion beam system. It is found that the MgO single crystals of (111) crystallinity has the highest $\gamma$ for operating Ne(Xe) ions ranging from 50eV to 200eV throughout this experiment. And it is found that the $\gamma$ for gas mixtures are much smaller than pure Ne ions.

• Journal of Nutrition and Health
• /
• v.17 no.4
• /
• pp.297-304
• /
• 1984

The effect of dietary fish oil ( mackerel oil : MO, eel oil : EO) on energy utilization in rats was studied with measurements of various tissue lipoprotein lipase( LPL ) and live and heart mitochondrial respiration. Fatty acid composition of mitrochondrial inner membrane matrix was also investigated. Dietary fat level was 10%( w/w) and reference groups were fed soybean oil (SO), repeseed oil ( RO) and beef tallow( BT ). Activity of LPL was about 60% higher in post-heparin plasma and 2 to 3 times higher in adipose tissue of BT group than fish oil or vegetable oil group. But there was no significant difference between fish oil and vegetable oil groups. Inclusion of EO above 2% (w/w) in dietary fat with fille oil of BT, markedly reduced both post -heparin plasma and adipose tissue LPL. Effects of MO and EO were not different in adipose tissue LPL, but EO was more effective than MO, in reducing post -heparin plasma LPL when mixed fat with varying amount of fish oil was used. Hepatic mitochondria isolated from fish oil-fed group showed the lowest rate of respiration but had P/O ratio comparable to SO and BT groups. On the other hand, cardiac mitochondria of fish oil group showed no difference in all the mitochondrial respiration parameters observed RO group had lowest P/O ratio both in hepatic and cardiac mitochondria. Fatty acid compositions of mitochondrial lipid differ between SO, RO, BT and MO groups, notably in the content of $C_{22:1}$ fatty acid.

• Proceedings of the Korea Concrete Institute Conference
• /
• 2001.05a
• /
• pp.301-306
• /
• 2001

This study was _ performed of rheological properities for slurry of ultra fine cement using admixtures. An experimental parameter is W/B and superplasticizier ratio and different water-soluble polymers. As a results, it's strongly appeared to rheological properties of slurry as particles ratio, it's know that rheological properities affected by admixtures.

• KSCE Journal of Civil and Environmental Engineering Research
• /
• v.32 no.3B
• /
• pp.153-159
• /
• 2012

In this study, we proposed modified settling basins transformed by substituting the downstream sill for low head weirs such as generic labyrinth weir and inclined crest labyrinth weir worked as internal baffles. Laboratory experiments were carried out to understand hydraulic characteristics inside of the settling basin to improve the efficiency of sedimentation rate. For a quantitative analysis, we suggested the headwater ratio($H_t/P$), the magnification ratio(L/W) and the inflow rate per total crest length($q_L$) as primary analysis indexes for sedimentation efficiency. Six different types of settling basin were used for labscaled pilot tests by distinguishing with internal structures. Based on results, the variation of headwater ratio with the change of magnification ratio would highly affect the deposition efficiency(%) and it was improved under specific condition that repeating arrange number(N) of labyrinth weir was between 2 and 4. Also, the regression analysis showed that initial condition and shape for improving sedimentation efficiency were plotted on the graph for both $q_L{\geq}3.5cm^2/s$ and $L/W{\leq}3.5$. It would be expected that the geometrically optimized labyrinth settling basin could be designed with proper deposition efficiency for inflow rates of influent and required area of settling basin utilizing the proposed analysis index in this study.